Prius (Gen 3) :: Removing Tanabe (strut Tower) Brace To Change Fuses?
Dec 2, 2013
I have given this scenario a careful study and developed a few tools and techniques for access to the fuse box cover on a Gen III Prius with a Tanabe strut tower brace installed.
1. The left hand bracket can be removed and reinstalled without removing the wipers, wiper motor and the two splash pans.
2. A 14mm offset custom made long box wrench or "ring spanner," a long flat blade screw driver and an extension magnet is needed to remover and install the bracket nuts.
There is enough space, using a long offset box wrench to loosen and tighten the 14mm flange nuts holding the bracket.
View 6 Replies
Advertisement
We have spread it as much as we can and it's come up about 2 inches - then stops,
View 8 Replies
So I installed my H&R lowering springs about 2 months ago and I am very happy about the stance, ride, and handling up until about 2 weeks ago. The car always had a bit of a spring clunk coming out of the driver's side strut tower, but it has become more apparent and pronounced over the last few days. I already tightened the strut nut and shock tower bolts, what else is there to check out?
View 14 Replies
Any noted 2.0T, B6 experience/solutions for squeaking/creaking suspension noises seeming to originate from shock/strut tower areas? I purchased new in 2009, 37K mi ago. VW dealer service persons think they hear it sometimes. Been chasing this problem for a year or more, mostly notable in cold weather. Condition evident driving on uneven pavement, dips in the road etc. Passengers ask "what is that squeaking".
View 7 Replies
I'm getting my struts replaced tomorrow on all corners, but the mechanic said my sway bar might break and may require replacement because my car is around 10 years old, is this true?
View 8 Replies
I have a 2007 sonata, 4cyl, and just installed new KYB340022 gas,,, front struts. No other work was performed, just new strut installation. ABS and ESC warnings lights are now on since installation.
View 2 Replies
I have a 2005 F-150 4x2 with 4.2L mojo. If I change the struts, is an alignment required due to slight changes in the top mount location? I plan on having it aligned but timing wise I may not be able to get it all done at the same time.
View 1 Replies
I have a 2010 5.3 silverado, extended cab 2WD with 100K Miles on it. It's time to change the transmission fluid and Filter. It looks like there is an exaust pipe that runs about 3-4 inches under the transmission pan. Can I drop the pan without removing the exhaust pipe so i can change the filter?
View 2 Replies
Owner's manual says under the steering wheel but I don't see a compartment anywhere (the center console outlet is dead; I assume it's a fuse).
View 4 Replies
A dealership is attempting to charge me several hundred dollars to replace blown fuses that they claim is a result of an overpowered attempt at charging a seemingly dead 12V battery. The interesting part is that after also replacing the air/fuel ratio sensor (which they initially claimed was the cause of a check engine light even after replacing the fuses) Toyota is telling them that the ECM should be replaced in order to extinguish the check engine indicator.
View 8 Replies
My cousin's 2009 Prius won't start and jump starting did nothing for them. In fact, when they tried it, they got sparks when they hooked up the ground cable and the headlights came on and stayed on the entire time they were attempting to jump it. Try again, and same thing but now I know they didn't go about it incorrectly or anything. There are also at least three blown fuses, I believe she said they corresponded to the smart key system, electronic throttle control (both up front) and then one in the trunk for the hybrid system.
View 14 Replies
I have a 1993 Toyota Celica GT I removed the strut tower to replace the upper tower mount and replaced the wheel bearing. my problem is that when i torque the axle nut tight the tire can be moved by pushing it up or down.
View 2 Replies
So I bought two new HID bulbs for my 2007 prius. Mostly it had been the left one that turned off after a while. So i put a new bulb in and it goes out after about 10 seconds. So i put the other new bulb in and it goes out after 10 seconds too.
View 4 Replies
I need to replace these as they are weakening. Can I get replacements at my FLAPS or are they a Toyota-only item? I'm asking because on another vehicle, I could not get the strut from a FLAPS due to the length not being a standard length with the proper connectors.
View 1 Replies
I had my friend of mine who is a mechanic change my struts out this weekend. I had clunking noises from the right strut Toyota and also a tire place said I needed new struts. So I got them replaced now both sides are clunking see the YouTube video.
View 7 Replies
I was going to put on some lowering spring on my prius last night but i couldnt figure out how to get the top bearing off. Looking for pictures or a guide or something?
View 1 Replies
I've been (for the first time) changing my struts on my 08 prius, having read a couple of threads, have manual, etc. The fronts went in fairly easily, but I noticed that when taking out the rear (left), it (the spring) was under a fair amount of compression when it "dropped" out. I was thinking, "how will it go back in once I swap out the strut?".... Also, it seems to me that the stud/spindle is in the way, making it very difficult to get the strut back in as well. I believe I have the vehicle jacked up in the same manor that Patrick Wong shows, with the 2x4 under the axle, and a 2nd jack as well. What is the trick to get this back in???
View 6 Replies
I replaced my front struts today and afterward the ABS and "(!)" light came on as soon as I turned on the car. I checked the speed sensor lines and they all look okay so I didn't damaged them in the process. The car brakes quite soft but still works and the regenerative braking still works. The mechanic pulled the following codes: C1300 and C1319. I went ahead and reset the ABS light by crossing pin 4 and 13 on the OBD2 connector technique. That reset the lights, and the brake also works as normal as well. After driving around a bit, turned off the car, then turned it back on the lights came back on again.
View 6 Replies
We have a fleet of Prius's with 11k miles on them. Windshield wipers don't work and cigarette lighter plugs don't work. I'm guessing this is due to blown fuses. Where the fusebox is? I'm getting fed up with this. Also, is there a diagram somewhere that shows which fuses are for which circuits? (IE Which number fuses protects windshield wiper circuit) so I can finally see in the rain...
View 8 Replies
Recently I have noticed a rattling noise from the left front strut. Looking up parts online I can see the strut, as well as an upper strut mount, either of which might be the culprit.
View 2 Replies
My driver side rear strut/shock has started leaking recently (I've attached a pic). Its counterpart on the rear passenger side is bone dry. My Prius is a 2010 with 78,000 miles, mostly city driving.
View 19 Replies
