Prius (Gen 3) :: Plastic That Covers Bottom Of Motor Compartment Seems Missing
Jan 4, 2013
Yesterday I want under my 2011 for the first time . Successfully installed an engine block heater ! when I was under there I noticed an opening in the plastic that covers bottom of the motor compartment It was under what looks like the transmission on the driver side of the car . I was working through the access door to the oil filter of course. Is there supposed to be two doors under the car and one just is not been replaced ?
View 4 Replies
Advertisement
I had the fuel pressure sensor recall done recently, and I got the car back with 2 plastic pins missing from the engine compartment covers.
Car went in with all of the pins in place. No big deal, I have a bag of pins and I can replace them.
But then I wonder, if they're careless about small things like pins, are they putting my engine back together with all the bolts and screws???
My dad once told me a story about a coworker who used to work the Ford assembly line. They would sometimes put in 3 bolts where 4 were required.
One day, if my engine fails, it may be hard to prove the dealership was the cause.
View 3 Replies
I just joined up after purchasing a CPO 2010 Prius IV. Love the car but after taking a closer look I noticed that one side of the bottom black plastic cover was drooping on one side. Upon closer inspection I noticed that there was a screw and plastic Grommet combination that was not locked into place. After unscrewing the screw, I tried to put the grommet back in place but noticed that it couldn't fit because (I believe) the white bumper portion where the grommet goes broke off. I compared it to the other side of the car and yes it does seem like part of the plastic top portion that is connected to the bumper broke off.
I inspected the bottom some more and it seems like there are a good number of screws missing and a large plastic piece that is the front tire well is also very loose.
View 2 Replies
My 2000 GTI and 2001 Passat have dull headlights plastic covers. I did try a kit from autozone with sand papers and a liquid polish without good results - It was a great workout.
View 1 Replies
How to remove the plastic engine cover that covers the engine? I'm know some of them are just held in place with friction plugs and only require a good tug, but I've thought that about other things in the past which have resulted in expensive noises.
View 8 Replies
How do I change my license plate bulbs? I can't seem to get the plastic covers to pop off without worrying about breaking something. Even reading about people saying the puddle lights were hard to change, i did mines in 10 minutes in the dark with a small flashlight lol.
This was a lot easier old my old g37/350z ....
View 3 Replies
The drivers-side black plastic strip on the roof of my '07 Prius is 'missing'. Should I have a body shop take care of this, the dealer, can I do it? It looks pretty straight forward to replace, but I'm concerned about how it's molded to the windshield 'gasket', like it's one piece.
View 2 Replies
I have noticed oil spots under my 06 lately and finally got under it to see where it's coming from. It's collecting and dripping from the bottom motor mount but it's hard to determine exactly where it's coming from. I can't tell if it's coming from higher up or down low and running back and up from the wind. I just cleaned it with degreaser and have it running to hopefully dry it and be able to see where it's coming from.
View 11 Replies
So I cold started our V today and the electric motor turned on. When it switched over to the gas motor when I turned the heat on in the car, there was a violent plastic on plastic clunking or clanging type of noise. Sounded like something sheered itself off the motor. Then after about 5 seconds, it went away. Drove the car for a while, no check engine lights, no other weird noises, no problems. Engine seems like it has been ticking a bit in all this cold weather but I figure it was just lifter noise so I ignored it. Car is a 2012 with approximately 17k miles on it. Going to try to see if the same thing happens when I cold start it tomorrow morning in the frigid air. Car just had its 15k service and the dealer said it was perfect.....I don't get it. This noise was freaking loud. We LOVE this car btw...never thought I would say this about a hybrid because I am a HP nut, but this is the best, most functional car we have ever owned so far.
View 5 Replies
I just bought 2004 Elantra GLS with 64 000 miles on it. Great small car. Suddenly when I parked the car I felt smell of burned plastic from engine compartment. I checked,no smoke just smell. Also,when I drive and press the breaks the car slows down fine after I release the brake pedal and just before to stop I can feel small pushes. What is happening.
View 2 Replies
So when i open my trunk and look into the left, after i open that side hatch inside, the floor of the compartment is plastic. And then you can take the floor off.What is this for? It seems too small for a battery!
[URL]
View 2 Replies
In the 2007 Touareg V6 Automatic, directly at the bottom of the shifter pole, under the middle counsel plastic there is a black piece of plastic that recoils and unfolds as you shift gears what is that and where can I find that little piece of plastic
View 1 Replies
Mine is missing. My wife's knees have had enough as I keep opening the glove compartment to keep the cd changer door shut. Where it retracts to? Part number?
View 8 Replies
I just had my tork converter and flex plate replaced on my 2002 Explorer XLT, it has the v8 with 5 speed auto trans. My question is this : on the bottom of the bell housing under the tork converter is a round hole aprox 1 1/2 or 2 inches in diameter. Should there be a plug or cover of some sore to keed dirt and debri from getting in ?
View 4 Replies
Recently purchased a CPO 2009 F250SD 6.4L. Happy with the truck overall but this AM I noticed a slight burning plastic smell so I opened the hood and looked around closely. Didn't really find the culprit(I don't think) but noticed that the engine compartment heat shield/barrier appears to be falling down above and behind the turbos (pictures linked below). How big a deal is this? Would it be covered under the CPO warranty? It almost seems like a safety issue. I also wonder if the insulation material, now exposed without the metal reflector material, is what is causing the smell....
View 14 Replies
I bought a 99 f250 super duty with v-10. Ran great then I decided to hose off engine compartment. No pressure washer just running water trying to get all the dirt off now the engine sounds like its missing. Could I have a coil pack that got wet or is something else wrong.
View 3 Replies
I have water leaking from bottom of motor it's look like coming from oil pan its chevy1500 1999 4/4with a v6 motor but not for sure looked at oil no water in oil it's really comes out when motor is running.
View 12 Replies
What it is or why there is a three inch pull handle hanging down on the bottom of the Diesel Tank on my niece new 2012 F350??? It is sitting hanging there begging to be snagged and ripped off the bottom of the tank!!!!! I'm at least going to Gorilla Tape it up to the bottom of the Tank.
View 10 Replies
I have a 2000 f150 knocking cant figure out what it is I thought maybe it was rod knocking so I pulled the plug wires and it continues to knock sounds like its coming from the bottom of the motor could this be crank shaft problems ?
View 3 Replies
Bought a dealer demo last may. Truck has been wonderful. Had less the 1500 miles on it. Noticed when I was installing the lock on my tailgate that some of the plugs that cover up the holes in the plastic piece inside the tailgate were missing. Maybe some of the screws, not sure. Dunno if it's supposed to be that way or what. Just started to get a horrible feeling about it, Taft maybe something major happened. Any way to find out or round they have told me? Mebbe I'm over thinking this.
View 6 Replies
My 2006 AWD LTD 500 has about 52000 miles on it; a slight rattle/clunking noise is intermittently heard on driver's side in engine compartment. Took it in to dealer who says motor mount is cracked and front stabilizer bar joints are worn and both need replacing. Car has only been driven on highways or for short trips (3-4 miles) and has had no impacts nor been driven over rough roads or run over any potholes or such. Should the motor mount be damaged? At 52K miles?? Never heard of such a thing. Ditto, the stabilizer bar joints: worn out in under 60K miles? What can I do about this? Who seek relief from? Ford warranty is, of course, over, and supplemental warrenty will only cover motor mount replacement but not stab bar. Are these parts routinely wearing out at such an early date that repair shops can reap the rewards???
View 4 Replies
