Prius (Gen 3) :: Indents On Front Bumper - No Holes
Aug 8, 2016
I need to put a front license plate on my Prius. I notice there are a couple little indents on my front bumper but no holes . Do I need to drill holes or something else here to mount a plate ?
View 13 Replies
Advertisement
I bought the car from dealer, there are now FOUR! holes on the front bumper. I don't understand why they couldn't just use the existing holes to put the license plate holder. Now I'm stuck with these holes and I'm looking for a cheap alternative to fill them. I like the clean look of the front end without the plates and don't want to spend a fortune at a body shop, but I also don't want 4 dots either. What I can do/use?
View 3 Replies
What I should use to fill the holes on my front bumper? I know how to get paint to make it blend in but what should I use as a filler?
View 1 Replies
How do I get rid of license plate holes on my front bumper? I took my front plate off and now I am stuck with annoying holes drilled into my front bumper. Its not noticeable but i know its there so it irritates me.
View 4 Replies
I just bought a 2011 GTI in Steel Gray Metallic. The first thing I did was remove the front license plate holder.
Doing that revealed 3 large holes (about 8mm), and 2 small screw holes. I'd like to repair this myself or have a shop do it.
Is there a relatively easy way to fix this myself (other than putting the holder back on)?
View 8 Replies
replacing the entire front bumper.I have removed the front license plate holder, and would like to fill the holes where it was screwed into the front bumper.
View 8 Replies
I'm having the bumper cover replaced on my 350 (stupid mistake on a number of fronts it's starting to look like...) and the indy shop that I chose in my town to do the job (Lexus dealer is 100 miles away and this shop was recommended by the guys that take care of all the Lambos/Ferraris/Porsches etc) told me that they had to drill the holes in the bumper cover to retro fit the sensors. Is this correct?
View 2 Replies
I know the front and rear emblems have holes behind them. Looking for pictures of the holes in the body of the car?
View 10 Replies
I recently purchased a used 2010 Prius. I noticed that there are two holes on the floor in front of the passenger seat.
View 4 Replies
Looking for info on these replacements and is there any manuals out there to assist with the process?
View 1 Replies
How to remove front bumper?
View 1 Replies
I want to install a large screen just in front of front bumper with enough height to protect windshield from rocks thrown up on the gravel sections of the road. I can weld a frame (or use a window screen frame), but how to affix it to the front of the car? Are there solid attach points I can use?
View 4 Replies
Have an '04 Prius and banged up the front bumper cover. Wanted to know if a Toyota Matrix front bumper cover from the same year would fit on it (without extensive mods, I know anything could fit, but would it bolt right up?).
View 4 Replies
So I have a 2009 metallic Prius and I just recently got into an accident. I ran over a fire hydrant. My front bumper went through a front collision. The left part of my front bumper is pretty much destroyed.
View 10 Replies
I have a 2008 Touring Package 6 which has served me perfectly for the last 55,000 miles. Today while driving a paving stone fell off the landscaping truck in front of me and (luckily) only came in contact with the black plastic air dam under the painted front bumper. The corner of the air dam is damaged and it looks like a 1 piece unit to replace. What is the part number of this piece?
View 3 Replies
Entrance way to my office parking garage is VERY steep. Aside from careful entry/exit is there a protective shield/device that I can apply to prevent paint damage to under carriage of front bumper?
View 7 Replies
I recently replaced the front wheel well liner on the passenger side. The old one was shredded and I figured it had come loose. I put a new one in and made sure all fasteners are used (bought new fasteners). Still during some freeway driving the liner did not stay behind the lip of the front bumper and rubbed a small hole in it from the tire. Any way to prevent it?
View 17 Replies
How to modify this light so that it can stay on with the low beams? This light only works in "auto" mode.
View 1 Replies
Was talking to a cab company running over a hundred Prius, they like the gas mileage.
Biggest problem running a hundred plus Prius in LA is the skirt front bumper is so low to the ground (for better aerodynamics) ... less than 5 inches ground clearance when loaded ... it hits the ground and bows the side moldings of the bumper.
View 5 Replies
I have a 2005 Prius. I came home the other day and parked the car in the garage. I came back out the next morning to find a large puddle of water in the garage and the car still dripping. The drip is from the PS front bumper area just ahead of the front PS wheel. This is not the typical AC water puddle; we have two Prius so I am familiar with that one. I searched here and found a few threads on water pump issue but the description did not quite match what I have going on.
View 7 Replies
I plan to remove the front license holder from my car, fill the holes, and paint/clear coat/sand them. Any recommendation as to what to fill the holes with (I'm not going to use a plug.) Exactly what the bumper cover is made of, I can find the right material to bond to it.
View 2 Replies