Prius (Gen 3) :: Eco Savings Record - Change Default Value To Higher
Dec 13, 2013
How to change the default value to something higher? 200 is the default. I would like to increase it to 500.
View 5 RepliesHow to change the default value to something higher? 200 is the default. I would like to increase it to 500.
View 5 RepliesEach time I turn on the A/C, the fan seems automatically to be in the highest position even though the inside and outside temperature is only one or 2 degrees apart. Can this be changed? I know I can manually slow the fan down but seems like i have to do that every time I start the AC.
View 19 RepliesJust traded in our 2010 Prius (III with nav) for a Prius v (Five) with display audio. Love it, and glad we made the switch.
On our old Prius, the display would simply change back to the map view after ~5-10 seconds. The new car does not seem to do this. No luck searching the manuals or the Internet. Is it possible?
new 2014.5 Camry SE owner. Had the car about a week now and I've noticed every time I turn on the car, it defaults to recirculated in-cabin air, even when I've last turned off the car with it set to fresh outside air. Is it possible to change this default, either from recirculated to "last setting", or from recirculated to outside?
View 14 RepliesThe backup camera defaults to normal backup mode and you have to manually select the parking assist functionality. Is there a way to change the default operation to the parallel parking mode? I have looked in the owner's manual and can't find the information. I will admit that I could have missed the information, but I don't think I have.
View 5 RepliesDon't know how to change the default screen setting so that it stays in either radio or Media screen. It automatically reverts to map after pressing the radio or media button.
View 3 RepliesI would like to record Xm radio directly from my Prius Xm interface. I see capabilities like the following when using a specific Xm tuner.
Recording XM Radio with Replay Radio
I could see plugging in a cable or a custom a/b switch wired to the car's xm interface that would connect to a garage computer. A side benefit might allow distribution of the PC's audio throughout the house.
I just got my 2016 ES300 and I noticed that every time I start the car, the default view goes straight to the navigation screen. Is there a way to change it to something else or to the last screen it was before I turn off the car?
I ask is because in my previous car (Avalon), if I was on the radio screen and I turn off the car and turn it back on again, the radio screen would come up.
Only had my 2011 LS about a month now.
Other cars I have seen will allow you to use the remote and close all windows and moon roof. Looking at the LS460 manual it looks like the dealer can program our remote to open the windows and moon roof with the remote. But it does not say anything about closing.
Also a question on the Navigation. Can you change the default screen to the Information screen? Mine always goes straight to the map when I start up. Could not find a place to change it.
It's been three days since I topped off my tank in my Plug-In and I have been running almost entirely in EV Mode. Today, I had gone 153 miles so I topped off my tank again. The pump clicked off at 0.37 gal. I squeezed the pump handle two more times and got the gas up to 0.49 gal. That comes out to 312 MPG. When I entered it into Fuelly, it did not register the MPG. The last time it did when it was 112 MPG. I guess 312 MPG is way out of range of what Fuelly will accept.
View 8 RepliesJust bought a 2014 PIP Base and really want to set up that cool feature that tells you how much money you're saving compared to your old car. How to do it? I can't find the feature anywhere in any menu system nor can I find it in my manual.
Perhaps the answer is the PIP base doesn't have that feature?
I have recently noticed that the ODO meter of the car does not work i.e. it is stuck at the reading (57735 km) it was on when I got the car and does not record/show the increase in mileage. the trip A and B are working perfectly fine. I took the car to the local Toyota dealer but he has no clue what is wrong with it, the guy there suggested that ECU is working fine but the ODO meter is damaged and needs replacement.
I am not sure what the guy at the dealership suggested is correct because what i think is that if ODO gets damaged then the whole speedo meter should mal function.
I have a 2011 xle camry with navigation that I cannot change the clock with daylight savings time. It is still an hour off.
1) I have already configured it for daylight savings time.
2) Tried to earlier time zone
3) I have adjust time zone by an hour
Is there a firmware update to make this happen? What am I missing?
I have a camry 2000 automatic transmission with 150 K on it. For last few months I am having this sporadic issue with it having difficulty to change the gear from lower to higher gear(from the first to second, i guess). It goes like this, when i start speeding up the car, its having difficulty to move to higher gear, it just revs up to like 5 - 6 K rpm and with a jerk it shifts the gear. And at the same time check engine light goes on. And during the time this check engine light is on, it does this same thing a couple of times or so.
Then after some time the check engine light goes away and the car runs just fine without any issues for some tine and then the same thing happens again and after some time the issue and the check engine light goes away and the car runs just fine again. this keeps happening every few weeks. So I took the car to the mechanic (check engine light has gone away at this time, who told the code was showing some "speed sensor" issue and they replaced this. After that the car ran just fine for a couple of months. But its starting to do the same thing again.
I have the Gen3 with auto dim mirror. The factory default is ON everytime the car starts. I prefer to keep it at Off by default because it is too dark for me during day time. I may be misreading the instructions Page 93 on the Owner's Manual and I can't get it to stay on Off by default.
View 2 RepliesIs it possible to leave the audio screen on all the times. Usually it is the map that is always on, and when I press the audio button, it reverts back to map after a few seconds.
View 3 RepliesIs there any way to make the power mode default when I start up?
View 3 RepliesWhenever I start my car the default screen is the map, whether I am using nav or not. Is there a setting somewhere where I can make the audio the default screen?
View 4 RepliesFor the second-generation Prius : I was wondering if there is some way to make the screen stay on the mode that you are in and not switch back to consumption/ energy by itself all the time? For example you push audio to see the radio station info or the CD track info and it will stay in audio mode until you change it. Or if you want it to stay in climate mode and not Have it change back to energy/consumption after about five or 10 seconds.
View 2 RepliesI have a 2007 Prius with about 150,000 miles. This has happened a couple of times in the past 2 months : Our Navigation system seems to be resetting itself- this morning it happened for the second time in the past 2 months:
Volume resets
Search location changed
All “previous” destinations are gone.
Not sure if any other settings changed, but those are the 3 that are obvious- it is almost as if it reverted to some kind of default settings. The nav does work just fine, however. This happened about 2 months ago, and it happened again today.
Is there a way to change the default difference on the dynamic radar cruise control from 3 bars to 1 bar?
I think it's annoying to have to change it every time that I start the vehicle and activate cruise control.