Prius (Gen 3) :: Brake And Traction Control Lights Went Off While Driving
Nov 1, 2013
2010 Prius 98,000 miles - No Accidents
I was driving on the freeway cruising about 65-70mph.. Not using the brake at all. All the sudden the car starts beeping loudly with the Brake light going off, traction control light going off, and the ((!)) light as well. So I wanted to pull over to the side and realized my brakes were not working . It was the same as if you're trying to brake the car when the car is turned off. I slowly pulled off the freeway. Tried to reset the ECU, battery, everything, thinking at the traction control is just going crazy.
View 19 Replies
Advertisement
I had not driven the Prius in a few weeks, and even then, that was for less than five miles, and had the low tire pressure indicator come on late last week when the temperatures cooled down, which I fully expected given my opportunities with the Toyota Dealer properly inflating tires. We were away for another week and returned today and I decided to check the tires and add air, and in addition to the tire pressure indicator, the ABS, Traction Control, and Brake Indicator lights were on. As soon as I filled all the tires to the specified PSI, that indicator disappeared but the brake related ones all stayed on.
View 10 Replies
Started my 2010 Prius the other day and the traction control, brake light, abs light and a yellow Astrix light came on and wouldn't go off. The car drives and handles just fine, brakes feel normal. I have tried resetting the lights with a trick with a paper clip someone else posted, but it didn't work for me.
View 7 Replies
Evertime I turn left the brake light, traction control and stability control lights come on and the car starts dinging. Mechanic says it could be front wheel bearings because they are tied to the ABS system??? But I have been seeing alot about wheel speed sensors?
Second, everytime I brake suddenly, a cloud of smoke comes from the front end and there is a burning oil smell. The oil is fine and no leaks. Again mechanic says it could be a cracked CV boot throwing grease?
Lastly everytime I put in reverse or when I lightly put pressure on the brakes when driving I get this noise like a humming (errrrrrr) noise. Its not the grinding/squealing noise you would get when brake pads needs replaced. I only have 60k miles on this.
View 30 Replies
My college son's 2014 Charger V6 has developed three issues since he purchased it used in late May. The cruise control has stopped working and the anti lock brake and traction control lights are constantly on. Any possible cause?
View 15 Replies
This morning after starting my accent the abs, e-brake, and traction lights all came on. What could this indicate, and should I not drive the car till it is fixed? I checked brake fluid levels for the of it, and they were fine.
View 6 Replies
I have recently had a problem with my 2004 Prius - the brake lights came on while I was driving (both the red exclamation mark and the orange exclamation mark to the left of the speedometer) ...
The Toyota service center told me that I need to replace the skid Control ecu - the part number that they quoted is 89540 47050.
View 1 Replies
My traction control lights is on and stays on during driving. Any reason for this?
View 9 Replies
My uncle (school district mechanic) and I recently replaced the front brake pads and front rotors on my 2003 Dodge Stratus. Within the last couple weeks, the dash lights for my ABS and Traction Control have remained on while I'm driving. I have also noticed a grinding noise on the front, driver side wheel, similar to what I'd hear when I applied my brakes on an icy section of road. I am concerned that my brakes may fail. My uncle and I have not been able to figure out what the problem might be.
View 4 Replies
So a little while ago I had my parking brake, ABS, and traction control lights all come on at the same time. There was no change in performance, but they have been on ever since. I looked in to it online and a bunch of people said this was a common problem with damaged tone rings, so I checked them out, but they were fine (as far as I could tell anyway). So I scanned the vehicle using a buddy of mine's Snap On scanner, and it came up with the following code:
B1342 Faulty Control Module
We tried to check the fault code through Mitchell OnDemand but it said that this code was for a faulty Parking Assist Module. I don't have any kind of Parking Assist system on this vehicle however. I looked around a little more and this seems to be a pretty generic code for brake system faults with Fords. Also, if the control module for the ABS is the same one that handles traction control?
View 3 Replies
I am the owner of a 2011 Hyundai Sonata GLS. It has approx 35,700mi to date.
Ive been apart of the forum for quite some time now. Ive been having an issue for a couple of months now with my Traction Control light being stuck on and intermittent flashes of the Brake light (as if parking brake were engaged) and ABS Lights simultaneously.
I'VE ALREADY HAD THE BRAKE SWITCH FAILURE RECALL PERFORMED. When i was having problems shifting and with my cruise control.
This all started this past winter during a bad snow and ice storm we had here in St. Louis, MO. I was on my way to work and the roads were slick with ice and snow. I was traveling no more than 15-20mph on a freeway and as i was approaching a light it suddenly changed to red and i had to slam on my brakes and make a swift right turn in order to avoid hitting anyone in the intersection. Ever since that moment, I've been stuck with these lights on in my dash.
Let me start this by saying I've done a couple of mods to my car. Hids, aftermarket remote start (professionally), aftermarket stereo, amps, new speakers all around, led lights inside, cup holder mod and led tail lights. That's all of my electrical mods.
Ive taken my car to the dealer several times for this problem. They tried hooking my car up to their code machine and they said the car wasn't communicating with machine and it was the first time they've seen something like this before.
They tried pinning the problem on my alarm and stereo. (as they usually do) They said it was a corroded ground. The dealer cleaned that up and said that fixed the problem. In actuality, it didnt. The issue still was there.
Ive had both the alarm and stereo removed to see if this were the cause my issues. NO...the problem still exists.
Here's a pic ....
View 12 Replies
My 2012 F250 6.7 once again (third time in 2k miles) got stuck in park with no brake lights or traction control. I found that removing the shroud from the steering wheel allowed me to manually activate the solenoid and get into gear but could only drive in manual shift mode.
Something is causing the brake switch fuse to blow. When I replace the fuse all is well for maybe 1k miles then it happens again! After the second time I replaced the brake switch thinking it was the cause but no deal. It happened a third time. The dealer who fixed it the first time could not find the cause.
This is frustrating and downright dangerous! What in the circuit could be causing the short?
View 14 Replies
I need to troubleshoot a problem with the ABS & Traction control lights on a 2006 Mountaineer Premium with 126,000 miles. During the year that I have owned the vehicle this problem has occurred every time it is driven on a long trip. The previous owner never drove on longer trips so has no experience with this problem.
When you drive the vehicle around town and on shorter trips (less than an hour) there are no indications of problems. The ABS and Traction control lights come on as part of the start-up check cycle and go off. The ABS and Traction control work in low traction conditions and the lights function correctly when either one is activated.
The unusual behavior occurs on trips longer than an hour. Typically after about 1 1/2 hours at highway speed both the ABS and Traction control lights come on as well as the Wrench symbol in the message panel. It you hit "Reset" the Wrench symbol goes away but the ABS and Traction control lights stay on. The brakes work normally. I do not know if the ABS and Traction Control will work. I have never been in a low traction condition when the lights are on.
Both lights stay on until you stop the vehicle and turn off the ignition. When you restart the vehicle the ABS light is on but not the Traction Control light. When you start to drive the vehicle the ABS light goes out immediately.
After about 1/2 hour of driving both lights come on and the Wrench symbol displays in the message panel. Whenever you stop the vehicle and restart during the trip the cycle repeats. The day after you finish the long trip everything is normal for driving around town and on short trips.
View 3 Replies
So four lanes, divided, with a left turn lane, five lanes at the intersection. I'm down ~15 mph, maximum turn speed and one car is just clearing intersection and and +100 yards from next approaching slug of traffic. Keeping the speed, I make the left turn confident no problem then halfway through turn:
feels like a soft tuck
traction light flashes
already to straighten out
everything normal
This is the second time I've seen this in a year. Pavement dry, 48 hours since last rain; ~8:00 AM so rush hour is on. Before doing some parking lot tests, any clue about how to replicate?
My dashcam SD card did not play.
View 14 Replies
My 2010 Subaru Outback recently surprised the hell out of me by simultaneously turning on the brake warning light, the traction control light, the check engine light and (just for a bonus!) disabled my cruise control while flashing the cruise control light. I pulled over, quickly surmising that all of those systems could not have failed at 70 MPH without instantaneous death to either me or the vehicle. Both apparently still being alive, I tried turning the car on an off to reset the lights. No go. Subaru was not going to miss this chance to get me to the dealership! (who I had avoided to this point!) As I was far away from home and the car being very healthy, it seemed, I decided to drive on. I proceeded to put a couple of hundred more miles on the car before I got back to town.
My car had 39,000 miles on it, 3,000 miles beyond the warranty end. I learned that I have an error code of P0171, "Fuel Trim Malfunction (Air/Fuel too lean)". So I guess I'm wondering about a few things...why would this sensor set off every light on my dashboard and disable my cruise control? Seems a bit overblown for running a bit lean. My gut tells me Subaru has a sensor/software problem they are not owning up to. I'm a big fan of conspiracy theories and this really smells like one...
Second, jeez, I'm only 3K miles over warranty, don't you think they'd cut me some slack. I mean I love my Subaru, or did anyway, until this happened. Now it's just another POS car that breaks for no apparent reason...
View 10 Replies
Just put new wheels, tires on my car...19's with tires 235/35/19, soon as i put them on and took it out to see any issues, the driver side rear wheel/tire making some horrible squeaking noise that just kept getting worse as i just drove the car around the block..ABS light and traction control both came on and stayed on as well (doesn't sound good, expensive) my H20 is ruined it seems.
View 1 Replies
Recently I started to have my EPC and Traction Control Lights come on once in a while (no CEL). And when that happens, it looks like my Passat is going into limp mode, because it drives, but it hardly has any power.
VagCom confirmed that the problem was coming from Throttle Body (I don't remember the exact code), I replaced the throttle body, did Throttle Body Adaptation, but I still have the same problem.
Here is the most recent VagCom screenshot:
Address 01: Engine Labels: 03H-906-032-BLV.lbl
Control Module Part Number: 03H 906 032 C HW: Hardware No
Component and/or Version: P 3.6-FSI-LEV2 G00 8030
Software Coding: 0000075
Work Shop Code: WSC 00028 028 00001
1 Fault Found:
000290 - Throttle Position Sensor (G69): Signal too Low
[Code] .....
View 4 Replies
From what I've read it seems this combo of lights usually stops the awd from working. However the lights came on and as a test I did a few hard 1-3 pulls listening for wheel spin... Nothing, all traction and pull.
What may be causing these lights? Hopefully I can get my vag com to work so I can scan it. Planning on checking the fuses and connections on the battery too.
View 3 Replies
I put in a new air filter today, 2003 GTI vr6 24v, and three lights (Check Engine Light, Electronic Control Power, and ABS) all turned on and haven't turned off yet, I'm not sure if I plugged in the sensor wrong or if there is something else that needs to be done. None of the lights were on before.
View 4 Replies
New problem this evening went to start Santa fe and ABS and Traction Control lights are on tried to shut ignition off and restart and both remain on. Drove the vehicle and noticed no brake control problems, tried to push the traction control switch and no on off control of light remains on. I believe in a situation such as this a good computer diagnose at the dealer is in order.
View 9 Replies
I have an 05 Malibu Maxx and while driving it the other day the ABS, traction control, and Brake lights came on. After doing some looking online several said it could be a speed sensor or wiring to sensor in one of the wheel hubs. Took it to have codes run and was told it was the back left, checked the wires then replaced the hub but still have same issue.
View 1 Replies
