Prius (Gen 3) :: 2013 - ODB II Scanner Caused Check Hybrid System Error
May 17, 2013
I purchased a Bluetooth ODB II scanner off of Amazon which had all positive reviews, plugged it into my 2013 Prius this AM and the car immediately started beeping with the "Check Hybrid System Stop The Vehicle In A Safe Place" error. The car is functioning just fine but I'm concerned.. Is this normal? Should I have not plugged it in while the engine was on? I want to see if I can clear the error but I'm afraid to plug the module in again...
View 18 Replies
Advertisement
I added fog lights, and I removed the fuse box and body computer to do so. I disconnected the 12V battery for most of the work, but later I did pull a couple of under-the -dash connectors with the battery connected.
Now I get the screen saying "check hybrid system", "don't drive". I've tried the turn-the-key-on-three-times technique, and I disconnected the battery for 30 mins. Still the message persists.
Using my Torque app, I can clear the ECU fault and the message disappears. However, when I start the car the next time, the message is back. Everything else seems ok.
I checked all the cabin fuses and most of the engine compartment fuses. I took everything apart again, and double checked the fit of all the connectors under the dash. It seems that I have thrown a code which keeps popping up every time I turn the ignition on.
View 13 Replies
So I bought a 2010 Prius IV from a nearby dealership today. I had test driven it twice before buying, but when I was taking it home I got the error "Check Hybrid System," and the car slowed to a stop. I had to call the dealership to come tow it back and it's being serviced right now. I'm mostly venting, but also more than a little concerned. I checked the orange clip/wire in the back and it was connected properly. What this could be and how big of an issue it really is?
View 19 Replies
I got "check Hybrid System" error with all sensors are yellow on the dashboard of my 2011 Prius with 80k odometer reading. Currently no Hybrid system, only petrol engine works.
View 2 Replies
I have a 2007 Camry Hybrid and got the front and rear rotors and pads changed last Friday at a shop. On Monday morning, I drove the car to a Pharmacy drive-thru and briefly stopped it. It would not start a few minutes later and showed - Check VSC System Error. Push it out of the way and then I tried re-starting, and it did. Since then it has happened a couple of times again. A little push and then it restarts. Otherwise, all error lights come on when attempting to start the car. I check the brake fluid- it is at Max or slightly higher. The driving seems ok when it is driving. What could be happening? Is there a reset button or do I have to take it to the dealer to get it scanned? I disconnected the 'positive' terminal of the battery (the negative was hard to reach) but that did not seem to change things.
View 17 Replies
I just bought a used 2012 Toyota Prius iTech from a country town 3 hours away. About an hour into the drive home, the display informed me to "Check Hybrid System" and then "Check PCS System". The car continued to function for a little while, then eventually lost acceleration, so I pulled over. I turned it off and on again; the warning light remained but the car started and continued to work, but soon after I lost acceleration again. This happened one more time.
Then I Googled the problem and discovered that you could "turn it off and on again three times to reset the computer". I did this and the problem disappeared and did not resurface for the remainder of the trip, and has not happened again since.
View 1 Replies
I have a 2008 Camry Hybrid and recently got a "Check VSC System" warning light. A diagnostic resulted in a C0210 error code. The code is for a right rear speed sensor malfunction.
I had a local shop look at it and he replaced the hub accembly including the speed sensor. It didnt work. He and I took a ride and on his diagnostic tool, the speed reading for the right rear wheel was all over the place.
The next day he replaced it thinking that the new sensor was bad. This worked, however only for a day. Now the light had come on again with the same error.
View 2 Replies
So tonight I was parking the car next to the wall in front of my garage like always and an orange error light came on to check BSM system what is that? Although, I turned the car off and on it stayed on I took it for a drive down the street and it went away now every time I turn the car on its not there anymore. Is there a malfunction with the computer or something? Car has less than 5k miles ..
View 10 Replies
So with all of the snow we've been having in the north east this is usually an error message I get almost every week. Normally this is due to the front sonar sensors being covered in ice or snow and will go away once it melts when I'm parked in the garage or is washed off.
However the past few days, I've had the car washed a few times to make sure the salt is off of the sonar on the front bumper but I'm still getting the error message stating to check the front sonar. If I leave the park assist on it works for the sides but not the front and the error message still stays on the screen. I've hand-washed the sonar sensors several times and 'massaged' them in place to maybe break up some ice behind the bumper or get the sensor to work but I've gotten nothing. Upon further inspection, one of the sensors has a deep scratch in it to where you can see past the paint of the car slightly.
I'm really not looking forward to taking the car to the dealer to have them look at the sensor because they will most likely charge me a ton. I saw a few other posts on the forums about the LS400 from '99-'00 having a similar issue and it cost them $550 to get it fixed. Obviously it's not the same car but I'm expecting a similar quote. I'm assuming the paint scratch is what is causing the issue as another post for the LS mentioned the same thing and said they had to scratch all the paint off of the sensor to make it work again.
View 5 Replies
After replacing at a Toyota dealer in my country the JBL 6CD audio system under warranty (was not responding on the commands from front panel, the unit was faulty), I've found some error codes left in System Check Mode and I don't know what is their meaning. What those codes show, especially 380H error code? Here is how to look ...
View 4 Replies
I was driving my NHW11 in the hot sun this afternoon when, about 30 minutes of pleasant and unhurried driving, I got the dreaded 'hybrid system error' message...
View 10 Replies
I was trying to install the invisicord cable for my escort radar detector thru the auto dimming/homelink mirror, I shorted it and homelink no longer has any power, a couple minutes later i got a check hybrid system.
Now question how do i restore power to the homelink mirror, is there a fuse to replace? And that warning and all the other warnings that i got related to the short. I read somewhere here that if power to the homelink mirror was off that you get no power to some systems, not sure where is that post, cant find it the car starts.
View 7 Replies
So a little over a month ago, I was driving my 2010 Prius (about 42k miles) when the Check Hybrid System light came on. I lost power and my car was stuck on the road, as I was unable to get it into neutral. So I called a tow truck and was towed to my local dealership. The dealership ran some tests, thought it might have been the throttle body. They switched my throttle body with a loaner prius to see if this fixed the problem. The new throttle body worked in my car and my throttle body was put into the loaner and functioned fine. Then they ended up fixing a TSB for the electronics in the car. I was told the problem was resolved and I could pick up the car about a week later.
After picking up the car a week later, before I could even drive away from the dealership, the Check Hybrid System warning came on again. I talked with the service manager and left my car to be fixed again. They checked all the systems and were still unsure what the problem was. Eventually they made sure all the connectors were properly seated and test drove the car and ensured the problem was gone. About two weeks later, I was told the car was fixed and I could pick it up.
After picking up the car, I was still unsure the problem was fixed, but I was told that was all I could do. After having the car, for about a 1.5 weeks I was on the highway. Once again, the check hybrid system light came on and I lost engine power. Luckily, I was able to pull over from the left lane without causing an accident. Once again, I had the car towed to the dealer and now I am waiting to hear back from them.
View 4 Replies
2013 Prius C THREE 67k miles
Got out of my car after using it friday. hopped back in to go to work tuesday was getting," Check Hybrid System, stop and pull over immediately". I put about 30k miles a year on my car so i run it hard and I am probably due for oil change and tranny fluid drain and fill but other than that because the car was working fine friday. I tried going into accessory mode then holding brakes and powering up, I forget what that's called, but no luck
Towed it to my mechanic, he said that he was getting generator errors (and tsp or tsb things?) and that he could most likely do the work but that I should make the dealer do it because it may be under warranty and didn't charge anything. So got it towed to the dealer and after the hybrid tech got in they said they see some generator error but they can't reset it. But also mentioned they got the car to come on.
View 19 Replies
I jumpstarted a friends car and now I'm getting a check hybrid system warning and my 2010 prius won't start.
View 19 Replies
I was going through a bad day today with my 2010 Prius Gen 3. I was on highway driving at 68MPH behind another car, at the time I step down on gas pedal for overtaking, all a sudden both "Check PCS system" and "Check Hybrid system" appears on the Console display and gas pedal had no response from the engine at all. The car was not moving and I had to stop aside and "P" the car. I tried to turn off the car, turn back on more than 10 times. Both warning signal "Check PCS system" and "Check Hybrid system" display on console and the car can not go into "ready" mode hence the car can not drive. I could put shift to "P","N" but just not "D". Had to call tow truck to tow back to toyota dealer, and they said will look into it on Monday.
View 5 Replies
I ran out of gas in my 2011 Prius and immediately all warning lights came on as well as the "check hybrid system" light. After filling the gas I read similar threads on here and trouble shooted the battery. 12v Battery tested good, so now what is the next step? I also did a reset on the 12v battery and that didn't work.
View 19 Replies
i un plug the battery and change the speedometer from US to CANADIAN. on a 2010 prius. Now the car dont start .The hybrid orange symble lights up and Check hybrid system shows on my desh.
View 8 Replies
Just started up my car and the "Check Hybrid warning system" came on, along with a check engine light. The car starts and moves, but I'm unsure if I should drive it to the dealer two miles away without doing any further damage to the vehicle or have it towed. The car has 130000 miles and is serviced every 5000 at the dealer with all recommended maintenance performed.
View 11 Replies
I have a 2013 Prius Persona with about 5,300 miles on the vehicle. Just recently had the 5,000 mile service taken care of at a local toyota dealership. The very next day I tried to start my vehicle with no prevail. My instrument panel indicates "check hybrid system" (!) the car will not start, nor will it shift into drive or reverse, only into the neutral position. Made several attempts to turn vehicle on and off and tried to jump start. Still no luck. Had the car towed back to the dealership. Mechanics are still trying to identify the problem. What may be the cause?
View 5 Replies
Searched for threads about this error message, didn't find much substantive except 'check your gas cap'.
View 7 Replies
