Prius (Gen 3) :: 2010 - Engine Check Light On / Loss Of Power And Decrease In Acceleration
Jul 19, 2010
I was driving my 2010 Prius on the Highway (less than 2 miles) and the engine check light came on.... shortly after the ! (triangle with exclamation light came on and then started flashing). I exited the highway and was going back home. On the way home, I noticed a decrease in acceleration and then a message 'Hybrid...'
I was able to coast into an apartment complex and then got a ride home.
After about a couple of hours, I went back to the Apartment Complex. I reviewed the manual and one of the options was to check the gas cap. I filled the tank up last weekend and haven't driven it since today.
View 19 Replies
Advertisement
We have a 2004 Saturn Vue that has been in the shop FOUR times for a loss of power issue. The check engine light will come on and almost simultaneously the loss of power light will come on and the car will pretty much come to a stop. So far they have replaced the computer, gas pedal, wiring to the computer, cat converter...it is still doing it!
View 30 Replies
I changed plugs wires and car started drove 32 miles to work started loosing power fuel pump seems to b fine check engine came on then started flashing worked 10 hours and car won't start 98 Buick v6 3.8....
View 3 Replies
2002 Passat GLS, 1.8T, 98K miles.
Was driving home tonight and nearly didn't make it. A few miles down the road I hit the gas hard going up a hill but the Passat kind of lunged a little and lost a lot of power and the engine emblem starting blinking. Coasted down a hill and it stopped and all was well again. From here on I am going careful up hills and not accelerating too fast.
I drive about 30 miles, 10 miles to go and I have to pull a tall hill. Going up this hill the light starts blinking again and I lose most of my power, engine feels like its not hitting on all cylinders and the turbo must be out. Barely make it home going about 40 mph. My check engine light has been on for quite some time, in fact I have had reset about 6-8 times with replacing sensors, air mass meters, etc. Could this be the timing belt?
View 9 Replies
I have a 06 f250 king ranch with 6.0 . A few days ago my scangauge showed a code P0405
I changed my egr and after it showed two codes : P0405 and P0404
It still has a hesitation and loss of power , although better than before the Change.
View 3 Replies
My girl friends car is doing something interesting, well it started off the car died while she was driving home from work, so I towed it with my truck home, the alternator had went bad so i changed that, but no here is where the problem comes in that i cant figure out, the car will start and run for about 3 miles than it will die in and out, loose power but not kill the engine and the check engine light flashes, and now the radio does not work at all (at idle or running) and the head lights are dim.i tested the battery, it was with in ranges for cold starting, output while the car is on and a few other thing, i re checked my belts and they are all tight and in the correct alignment ...
View 9 Replies
I have a 2004 santa fe with a 2.7 v6. I have had a little misfire issue lately. I had a major power loss with a check engine light on it lasted for just a minute before it settled itself out. Had the code pulled at a local parts store. P0301 so I checked the plugs and they looked worn out. I pulled the upper intake and replaced the plugs and wires plus the upper intake gasket. I cleared the code and that seemed to correct the problem. Two days later, same thing happened. The engine seems to be running fine now. I wiggled the wiring harness to the injector and to the coil, no change in the way it runs. I was thinking it could be an injector or a coil pack.
View 6 Replies
Well I had the dreaded loss of power and EPC/Check Engine light happen on Monday. Was driving down the Interstate and all of sudden we just lost power. It did not go completely dead, but it ran like crap. Called the local VW and they advised to bring it in, still under warranty (27k, 26mths) and it turned out to be the high pressure fuel pump. They replaced the pump and the replacement was bad! Luckily they tested it before they got it out the door back to me. Provided me with a loaner and the dealer had to get a replacement pump overnight. Picked up the car yesterday and everything drives the way it should again.
I had already had the software update, but according to the service advisor that was for the fuel pump in the tank, not the one on the engine. Not sure if that is correct, but that is what the advisor told me..
View 3 Replies
2000 Ranger 2wd 3.0 ... I bought my truck last summer for $1k from my neighbor, it has hit a deer so the grill is busted,front drivers fender bent up and bumper is bent all to heck. The old girl is rock solid reliable though and gets decent mileage with cruise heat and ac so I'm happy.
Anyways on to the point, I am having two big issues with it, the check engine light randomly comes on and causes it lose power sometimes at others you don't notice it. I have not been able to get codes read because it goes off every single time I go to someplace with a scanner. The light will usually go off if you floor it for a long stretch maf maybe?
The other issue is the transmission, I don't know for sure which tranny it is but the overdrive button does not work at all even though the fuses are good and when I drive down the highway second gear you have to let off for it to shift sometimes ( I've been leaning towards the valve body gasket for that) and lately it has started a horrible vibration kicking out of overdrive or just downshifting on hills etc.?
I forgot to mention it has 255k miles on it and I don't know the history besides the balljoint I replaced this week and radiator when I bought it.
View 3 Replies
I have a 2008 FX2 5.4L F150. Recently it began to lose power on a friend driving it out of town. He got a check engine light then it just progressively became unable to produce power. It ran but he got down to 10 mph before he could get to a firestone. I got it to a local Ford dealer and they say i need a new engine. They gave me codes for cam sensor and timing and #5 and #6 misfire. (344, 345)
No oil in radiator, no water in oil. The crazy thing is it runs like the day i bought it in Park. But once in gear it begins to cough and then eventually shudders and dies. I haven't changed plugs ever. I know... At about 75 miles it began to idle rough at times and in reverse. But once I revved up it went away.
I replaced both cam sensors but no luck. Today i put it on a tow truck to get a second opinion from a local engine shop. I actually backed it down my driveway, and pulled up to the tow truck with no issues. weird...
View 2 Replies
I took delivery of my 2012 FX4 Eco in January and about a month or so later I began experiencing a loss of power and the check engine light would come on then go off again. This happened the first time in Houston traffic one day so I was pretty concerned needless to say but then it cleared itself shortly thereafter. However, heading back home it occurred again on the highway while I was trying to pass and she just didn't have the power. I took it to a Houston dealer late in the afternoon before I left but no codes were found and when I got it back to my local dealer it was determined the left side catalytic converter was bad and it was subsequently replaced. Well, it happened again and it's back in the shop while I am offshore so they have plenty of time to take care of it.
View 2 Replies
A couple of weeks ago, I went out in the evening after work, started my car and the CEL came on. It was fairly cold, probably 20 F. The car idled fine, but lacked power under acceleration. After the engine warmed up, it ran fine. The light stayed on for about a week, with the same symptoms. This week, we got a warm spell, 50s and 60s, and the light has gone out. This would seem to imply some malfunction of a temperature sensor, presumably coolant. It seems that when the engine is extremely cold, it is not adjusting the mixture appropriately, after it warms up, it is fine, or at least acceptable. I have an appointment to bring it in to the dealer. I assume they will be able to retrieve the code even if the light is not currently on.
View 4 Replies
Last Fri the check engine light came on so the first thing I did was check the gas cap. It was loose so I retightened it and went on my way expecting the lght to eventually go out. It was still on several hours and a couple of stops later so I called my dealer and explained to my service rep what was going on. He told me to give it a few days and to call him if it didn't go out by today. He said it takes a few days for the computer to reread the system. So we drove it all weekend and it finally went out this morning (Tues). With just under 145000 miles I'm wondering if I should get them to put it on the scanner anyway. It's$130 to do the scan so it's a bit of a ding in the budget. Do the hybrid batts need to be checked,indicator light or not? Here in Ca I think they have a 150000 mi warrenty?
View 15 Replies
Started my 2010 gen 3 Prius 3 the other day and got a bunch of what I thought was engine clatter and the check engine light came on.
The next time I started it, no noise. Anyways brought it to dealer and they diagnosed it and ordered a new manifold.
The next day when the part arrived, I brought in the car. Talked to the mechanic, a great guy, and he explained what happened. Apparently, the clatter is actually the springs rattling in the clutch mechanism of the starter motor/electric motor and not the valves like I thought.
View 11 Replies
I have a 2010 gen 111 with nav system etc, the other day a orange check engine light came on, I took it to our Toyota Dealer and they said that I had mud and gravel up in the car, near the fuel intake area, and that the carbon capture canister/switch was damaged by the dirt and I need to get it replaced. I asked if I could simply not make the repair due to the fact that the electronics system would eventually not be able to read the H Carbon readings and the car would burn more fuel.
View 1 Replies
My check engine light went off last month and when I had it looked at my dealership they said it was due to the seal where the gas cap locks into I believe. Anyway, a week later my light went off again and now they are saying it is the charcoal cannister which I found out is very expensive. Here are my two questions. First of all, can I get this part replaced and installed at a non-dealership? My second question is since they reset my check engine light, it came back on a few days later for two days and then turned off completely. Should the light have turned off on its own? Should I be concerned that it is no longer on? It just makes me wonder if they diagnosed this issue correctly or not.
View 7 Replies
Lately having the following issues with my Tig.
When starting up the engine on cold start (or after having the car sit for about 30 minutes) after about 10 - 20 seconds; pretty much right after first acceleration the car all of a sudden looses all power. RPM fall down even when accelerating. Accelerating more only let's the engine stall more.
5-10 seconds later the engine functions normal again.... What problem could that be ?
View 24 Replies
I installed an Injen cold air intake and 2 days later, the check engine light went on. I had it reset at the dealer and next day, again. Am I stuck with this or is there a way to keep it off, other than putting back the original air box?
View 18 Replies
Check engine light and P0010 code in my Gen III 2010 Prius...
View 2 Replies
I plugged in a OBD2 reader and its show misfire on Cylinder 1.
I haven't driven the car for 4 days, and when i started the engine this morning, the engine show knocking when the regular engine kicks in (rough). i will be bringing the car in tomorrow (dealer). my car is a 2011 with 16k miles, strange for this to happen so early in age.
View 2 Replies
Got a 2010 Prius with about 61000 miles on it. Starting yesterday the check engine light stay on all the time (As soon as I started the car). I tried open and tighten the gas cap but no luck and check engine light still stay on all the time. What could be the problem? Will any ODB scanner able to diagnose the check engine light code or need a specific one?
View 6 Replies
