Prius (Gen 2) :: Removing / Installing Cables From Inverter To Transaxle?
Sep 27, 2014
I have an 06 Prius that I got needing a transmission. I picked up a used transmission from the junkyard, and I started working on it today, but I am having a problem. The big orange cables that go from the inverter to the transaxle have been cut. So I need to swap over my good cables (from the bad transmission) over to the new transmission. I need to know how the cables are removed/installed from the transaxle side. They don't seem to want to pull out.
View 8 Replies
Advertisement
I just got a 2006 Prius and I brought to Toyota dealer to do a regular oil change. After that, been told that I'll need a Inverter Coolant and Transaxle fluid change in next maintenance point.
This prius already has 111,000 mile now.
View 19 Replies
My 07 Prius is leaking transaxel fluid into the inverter cooling system. Transaxel fluid is sweating through the inverter coolant hoses. Before my taking ownership of this vehicle, it had previously been in a front end collision (that’s a whole other story). Anyhow – if I replace the radiator, should that take care of this problem? Are there any other ways these two cooling fluids could become cross contaminated?
View 16 Replies
I have a 2010 Prius, currently at around 69,000 miles. Back in Feb 2015 (when it was just under 60,000) I was driving on a city street and hit the accelerator once a stoplight turned green - immediately as I took off (at a normal rate of acceleration) my 2010 Prius made a loud noise and I got the red triangle of death, with a "Check Hybrid System" message. The car quickly shifted into "limp home" mode and I was able to make it back home as I was only about a mile away.
Got towed to the nearest dealer the next morning and after tons of testing and going back and forth, they replaced the transmission and inverter (was able to get it covered under powertrain warranty), and I was on my merry way. No issues until last night.
Yesterday evening, I am on a city street and get a warning beep. I look at my dashboard and this time I have a yellow exclamation mark with the "Check Hybrid System" message yet AGAIN. Towed the car to the nearest dealer and am now waiting on next steps. Only update I've gotten so far is that they are still trying to diagnose the issue, and are getting 4 error codes in this process, 2 of which are new. I am waiting on the technician to tell me what the actual codes are - hopefully should get them tomorrow.
I would hope if it's another issue with transmission or inverter, it's covered under warranty given I replaced both less than a year ago. However I'm not sure and am worried that it's going to be $$$ in case it's something else that failed. Plus I'm getting serious doubts as to the safety of my car - what if I had been moving at a high speed on the highway during either of these situations?
View 9 Replies
My DDM HIDs came in the mail today and fellow vortexer D.Passat00 was kind enough to meet up with me and do the needed vag-com adjustments. So firstly a shout out to him, he's a solid dude and really nice
Now: Is there a DIY for headlight removal? I can't seem to find one, and without removing the headlights I'm afraid there just isn't enough room to install the new HID bulbs without dinging/touching them.
I have a 2010 2.0t Passat and I got the 35w 6000k DDM HID kit
View 6 Replies
Has actually removed the block plug (from where ever it is) and installed a heating rod...I'm fairly mechanical, just not sure of the steps or tools needed.
View 14 Replies
If the Prius 12 volt battery (the one that is like all other car batteries, not the hybrid battery) goes out, can you use jumper cables to start it like any other car?
View 9 Replies
I bought an '01 prius with more than 160,000 miles last year , until now it's been a great car , averaging 46-ish mpg , now , a couple days ago I used it to jump-start a diesel truck connecting the cables directly to the auxiliary battery , the truck started after a 2 or 3 mins, the next day the known red triangle and the red car with the (!) appeared , the dealer reads code p3009 (hv leak) but were not able to give me any subcodes. Is it possible that the computer interpreted the sudden "pull" of current from the converter (via the 12v battery) as a hv leak ?
I got the reading of the 19 modules of the traction battery and all are within 0.5 volts of each other , so I hope they are all within tolerance , and the car seems to run just fine.
View 6 Replies
My mechanics found today when the car is on the lift, that the transaxle oil is leaking a little. I can see the fresh oil there (not dipping though). He said to open the transaxle and change the gaskets probably will cost $300.
View 5 Replies
Took my 2007 Prius into the local Valvoline where they said they could drain and refill the transaxle fluid. The guy undid the bolt a bit and said he got fluid mixed with water, no odor. He closed it back up and refused to further service it due to liability. I think he opened the drain for the inverter coolant, not the transaxle fluid drain plug. When I called them back, the guy said he used a standard wrench to remove the bolt. NOT a 10mm hex key.
I drove the car home about 3 miles, but now I'm concerned about possible damage to the engine, how much fluid he let out, but the inverter coolant tank appears full.
View 18 Replies
I just acquired a 2006 Prius with 96000 miles. My local service station said he did not want to change the transaxle fluid. He said he had changed it for someone and the car stopped working. My son the mechanical engineer said there is a risk that changing the fluid can dislodge particles that were not a problem and cause a problem. I don't drive many miles -maybe 3000 per year, so car will be 19 years old by the time I get over 130,000 miles. So I am not looking for the transaxle to last 200,000 miles or so.
View 14 Replies
I have an 08 Prius it has done 190,000 miles last week it suddenly started shaking from what felt like the transaxle. The car still drove and seem to shake a lot worse when it was in park or reverse it definitely felt like it was a bearing or something mechanical broken in the trans unit. After a bit of research I decided to remove the trans, strip it down and have a look convinced that I would find fragments of bearing or something blatantly wrong. Yesterday I removed the unit (nothing to be scared of, dead easy really) and today I have stripped the transaxle down (after viewing a very useful youtube video) much to my disappointment I cannot see anything wrong I am now thinking I was a bit too hasty and maybe it could be something else.
View 16 Replies
I have a 2007 Prius 3 Touring Edition. I purchased it new in Dec. 2006. I have had NO issues with my favorite car of all time, and currently have 90,600 miles. I have noticed a high pitch for a long time coming from the transaxle during acceleration. The pitch is only present when MG1 or MG2 is engaged. The pitch stops in stealth mode. My finance also has a 2007 Prius, and her's does not make the noise or whine when I drive her vehicle.
I have changed the transaxle fluid at 65,000 miles, but I did not see the plug when it was changed so I don't know how much, if any, shavings were stuck to the magnetic bolt. If you are wondering, yes, the high pitched noise was present before the fluid change. Also, as I accelerate and increase speed, the noise pitch increases.
Is my transaxle displaying a tell-tale sign of imminent failure?
View 8 Replies
What this error code is? I've been told its a faulty transaxle! what actions to take!
View 7 Replies
I'm still trying to get my project 2001 Prius to attempt to start the ICE. I can drive the car around electric only, so MG2 is OK. I see a pulse of current going to MG1 as it does it's startup tests. So I'm thinking maybe the MG1 position sensor is faulty. Where on the transaxle the MG1 position sensor wire is located?
View 9 Replies
How to do the transaxle fluid change and finally did it myself. I dropped and clean the pan and put new gasket. The MPG dropped a little, I was getting 44.6 before fluid change and after fluid change it dropped to 43.3 ... Why this happened.
View 1 Replies
My 2004 Prius Transaxle overheats and causes a warning on the dash. When I checked the fluid level I found pink foam in the resevior. Do I need to replace the fluid or bleed the system. Also the AC shuts down when this condition occurs.
View 11 Replies
I'm trying to change my trans fluid on my 2010 Toyota Prius I, but I go under there and look, and there's NO drain plug and NO filler plug! It's just completely solid, with a black electrical thing on the front (looks like an electric pump or sensor of some kind). I've watched videos, read articles, read manuals! I would just hate to have to take it in to the same dealer who's telling me "it's good way past 100k miles..." .
View 19 Replies
I seem to have gotten a hum coming from the front end when I reach 40mph & higher. Todate, I have not gotten any warning lights, red trinagle etc, but wanted to see if maybe there were some codes thrown.
Lastnight, I put the front on jack stands & had my wife put the car in D & step on the gas while I was laying under the car. The noise is coming from the transmission where the axles plugin. My fear is I need a new tranny.....but if its a code related to the hybird system, I might be covered under warranty.
By the way, my Prius is a 06 w/ 108xxx miles. I changed the CVT fluid around 70xxx miles.
View 19 Replies
Car was deemed a total loss. I didn't think the damage was too bad and one of my friends at a bodyshop told me to go ahead and do a car buy back that I can't go wrong with a prius. My mother said $20 gas a week. So I did and gave my mom the difference. The Car drives going forward and in reverse just find. Besides the body damage I got underneath the car and I see a bent tie rod end and maybe a lower control arm. The thing is when I hop inside to move the car I notice the car reads transaxle disengaged and battery system won't charge in neutral.
View 19 Replies
I have a 2010 Prius and need to change the Transaxle fluid. I have the Haynes repair manual, but it only shows the drain and fill plugs for the Gen II. I have found what looks like the drain plugs but am not sure of it. Fill appears to be right next to the CV axle and the drain is straight down from the CV axle. Are these the correct fill and drain plugs?
Also, this transaxle seems to have a whine to it. Whines only at kind of a neutral throttle. Throttle pressure or backing off on the throttle reduces the whine. Is this normal or what?
View 2 Replies
