Passenger front seat belt - the buckle will not go in the groove. When I look in the groove, there is a piece of metal. I press the orange release button and the metal does not move. So the buckle can't fit in there.
I don't know what is involved, I know it isn't body work, not sure who I can take it to.
It's Nissan Altima 97. My friend need to take her road test so I let her borrow my car this weekend to do some road practice (I was in the car with her). Besides all the heavy braking, and sudden acceleration. She did alright. Because she is from VT, so she was practicing this VT Turn Around (I have never heard of it before today). She turn the wheel all the way to the right and back up.
I heard a small popping noise, and didn't pay too much attention to it at that moment. However, After she finish that VT Turn Around, we started to driving down the hill, and heard this metal-on-metal noise. It lasted for 10 ft, then went away. The noise is coming from my driver side front wheel. When I got off the car, I found the center of the wheel cover pop off.
(see this link for the pictures) [URL] .......
Now here are my questions. What just happened? and do I need to get it look at immediately, or can I wait until the next oil change?
So for a couple months now, my ride has been making some weird noises.
When I start the car up after anything longer than a couple hours of use, it sounds as if I have a piece of loose metal banging/moving around. I hear it sporadically on shifting through the gears, and when I'm at a stop.
Car has been in to the dealer three times, and I took the foreman on a test drive...of course it wouldn't make the sound at all.
I took a look under the hood today and noticed that the coolant level is low...filling it back up tomorrow. That got me thinking about the transmission fluid....I looked and looked, and can't find the transmission dipstick anywhere.
Any clue where I can find some way to check the level?
I commute 180 miles a day, 6 days a week. I noticed metal on metal grinding noise(more noticeable) at high speed above 75mph especially on asphalt road. I'm sure noise is there at low speed but not enough to notice. My car has 50,000 miles. Tires? Electric motor?
View 7 RepliesI recently worked on a 2006 with 140K miles that presented with the following symptoms:
The hybrid battery was at 1 bar; the ICE would not start; the car was in Ready, but there were no codes. As I let it roll off the flatbed wrecker in Neutral, it felt lumpy. If you have ever pushed a car (or run out of gas in one) with a manual transmission that was in a high gear, engine off, it felt just like that.
I popped the hood and could see that the engine crank was turning while the car was being pushed in Neutral. What else turns with the wheels? MG2, or more specifically, the MG2 ring gear. What is the only way that the wheels could turn the ICE crank? The planetary carrier pinions were locked to the ring gear.
Surprisingly, while I was looking at things, it did manage to start the ICE pushing it around must have freed the carrier pinions, so I let it charge the hybrid battery. It was basically the worst metal-to-metal noise that I have ever heard! I pulled the drain plug and saw about a teaspoonful of large metal chips on the magnet. The fluid condition itself was very good, not the black factory fill that I am used to seeing come out.
I have a 2011 Prius with about 32K miles on it. I've been hearing light metal on metal grinding noise for a few days now. So I decided to take it to a stealership and they told me my ceramic pads and brake rotors both need to be replaced for all 4 wheels. I thought Prius brakes don't need to be replaced for 100K miles.
View 7 RepliesI have a question about my C Four with 16" wheels. When the steering wheel goes all the way to a stop there is a thunk that feels like metal on metal. It is like there is no rubber bump stops. If this is normal. I am used to cars that have a nice cushioned bump at the steering limits.
View 1 RepliesI own a 2010 Toyota Prius that recently developed a metal-on-metal whining scraping sound when moving. It does not make sound when the vehicle is stationary, and it's intermittent - which makes me discount the rock-in-disc-rotor idea (not eliminate it, mind you). It's quite loud when it occurs, able to hear it over the stereo. Luckily I was near work at the time, so I went there - but the shop can't even look at it until Monday evening - so I am a bit panicked.
View 8 RepliesI heard some scraping under my car and pulled over to check it out and the plastic piece under the car was hanging down. I took it off all the way so it wouldn't get damaged any more, and took it to the dealer. The piece was torn off in almost a perfect straight line, which they told me was from the piece being bent for oil changes. They didn't have the part in stock and I was going on a long trip the next day, so they put the piece back in place with new clips and zip ties. The dealer said it should be replaced at the next oil change which will be 60k for me.
View 11 RepliesMy wife came home today and asked me to take a look at something on her brand new 1 month old Prius V 5. I asked her was there something wrong with her car. Of course she told me no, everything is fine. She opens up the driver side front car door, (she has a Barcelona Red V with Bisque faux leather interior) and points out some small scratches on the plastic silver/gray plastic piece that surrounds the power window buttons. It looks like while she was driving she probably put her hand on that area with her wedding band and diamond most likely scratching the area. This is only a guess at what caused it. I can't believe something as placing your hand down would scratch it that easily. That area probably shouldn't be plastic or should of been protected a little better.
View 6 RepliesToday when I am driving the 2007 Prius, suddenly heard some noise. I managed to come home and checked. There is a black plastic piece hanging and touch the ground, the noise was from this black plastic piece touching the ground. Attached is the picture.Is this a big problem? Can I continue to drive the car to repair shop to get this fixed?
View 6 RepliesI have a 2007 hyundai sonata, this car is my daily driver. I put 180 miles on it a day around trip. Currently has 180,200 miles on it. Last Friday on my trip home when i turned right I heard a metal on metal sound. I slowed down went straight and it went away. Talked to a few people and I think it may be the wheel bearing. Even if I hit a road reflector it starts up. It's the front left wheel. Get on the breaks it goes away.
So my question is... Wheel bearing??? And can I replace the whole hub and fix the problem or do I have to try and press the bearing out?
I got some coilovers installed last night, they are ksports. i have them on fairly low height as of now but i have noticed every time I hit bumps, I hear a kthunk (metal hitting metal noise) from my front driver side. is it from the coilover nuts itself or something wrong with my control arm? the sound ONLY comes from the front DRIVER side.
View 4 RepliesI have a 2003 Toyota Solara 4 cyl. auto. transmission. I recently had the head replaced. Now it is making a metal on metal sound near the drivers side of the engine. It makes the sound during idle, when I change gears, and the sound increases when I rev the engine. What could it be?
View 8 RepliesI thought i heard this yesterday when i left work but i was tired and said its in my head, THEN i go to leave right now and sure enough its a real sound, you can hear it very well through the front grill and then if you turn the volume up you can hear a ticking sound ever half a second or so, it also speeds up when i was pulling on the throttle cable. And after the truck fully warms up it goes away.......
View 14 RepliesI replace my brake pads and rotors in the fall of 2015 with EBC parts. Now almost 13,000 miles later, I started hearing grinding and metal-on-metal contact in the front. So I went out and got PowerStop pads to replace the EBC (EBC had way too much brake dust). I took off the front wheels and noticed that the DF pads had about 1/32 left on them, ok I guess its time to change them out. Onto the PF pads, I find that there is almost no material left, in fact I could scrap off what was left of the material. I decided to do a rotation while I am at it and noticed that the rear brake pads on both sides look like I never used them!! Is it really that possible to have 2 stuck calipers, both on the rear at the same time?
View 2 RepliesWhat we have is a 2011 F-350 with the ambulance package (obviously) and it has started making a very annoying sound from the front end. It has been into two different Ford Dealerships and they have not been able to remedy this issue. What happens is, when we are backing and turning, the front end makes a bad metal on metal grinding noise. When going straight down the road no issue just turning while backing. I know this is an ambulance and has the ambulance package but I think from the cab forward should just be all ford right?
View 2 RepliesMy Elantra's HVAC fan has always been a quiet thing, even on 3.....we won't mention level 4 and the fact it sounds like a 747 at takeoff.
I kid you not, the very evening I hit 60,000 miles and the general warranty expired, the blower motor started making noise like it was throwing a bearing and definitely sounded like some light metal-on-metal rubbing. After I became irritated at this, the noise went away and didn't come back until just a few weeks ago. I could make it stop by smacking on the bottom of the fan assembly a few times but I want a more permanent solution.
Tonight I dropped the blower out which was stupid easy except for the fact you're upside down in the dark with your head in a hole. But three screws and an electrical connector later, I dropped the assembly to find no serviceable components. I mentioned this to friend of mine who's into Volvos suggested spraying some lithium grease on the hub of the blower and letting it run long enough to quiet it down. I'll do this over the next few days and report back but part of me thinks a new blower may be in my future.
My 2011 2.4l Sonata made a metal on metal sound suddenly the other day. About 4 days ago, I drove about 2 hours away from where I live, Mostly highway, about 80mph to a go kart race. Got out of the car for a while and came back in and was pulling away to run the store and as i started to approach the first stop sign maybe 500-600 ft from where i was parked, i heard a bad metal on metal sound, came to a complete stop at the sign and it stopped. Went back to the race after driving to the store about 5 miles away.
Got in the car to leave and same thing, just to the stop sign 500-600ft away. Drove home like i said mostly highway, and didn't hear a thing. Today, about 4 days later, I drove to Chicago O'hare airport, about 30min away, and it was fine the whole way there. However on the way back, after about 20-25min, I heard it again. So I came to complete stop as I was forced to by a traffic light as I was taking my exit off the highway, and It started making that sound again. So i came to a complete stop at the light and started moving again when it turned green and couldn't heard a thing.
I have a base v6. When I turn the steering wheel (for example, to make a left turn), it sounds like there is metal-on-metal rubbing. The wheel is not extended (turned all the way til it stops)...
View 2 RepliesI have an '02 Taurus. For the last year or so it has intermittently produced a metal on metal grinding noise while failing to start up. I'm told this is due to teeth being missing on the flywheel between the starter and the transmission. It's taken as many as six tries to get the car going. But the car has always started in the end.
My questions are: Is the problem flywheel worth replacing at this point at this price? Is it likely to fail totally any time soon?
Also, might the March '09 replacement starter be implicated?