The check engine light came on in my 05 so took my local shop and they checked the code and said it was the Idle Sensor. They were not able to make the repair. Since then the light went off for a few days then came back on. I now notice the gas motor does not turn off when I stop at a traffic light.
View 14 RepliesJust picked up a Toyota certified 2010 Prius III....less than a week later, the check engine light comes on. Took it right back to the dealer...in which they said its the air/fuel sensor. Toyota warranty services was closed, so they need to check tomorrow if its covered by the remaining warranty or not.
View 2 RepliesMy wifes 2008 prius check engine light just came on. Its the control valve sensor. My question is, does that have any serious impact on safety? I've heard mixed on what this valve does (overheating etc).
View 6 RepliesI own a stock 2008 Prius.
My car didn't move for 1-2 months so I needed a boost this morning. I noticed there's the check engine light on and a red triangle.
Also, the car won't go on electric mode.
It came on 2 months ago, took it to dealer, code said "erratic idle", it idled fine, smooth as it always has been, dealer turned of lite, said let him know if it comes on again.
View 2 RepliesI have a 06 chevy 3500 express van with a 6.0 engine. The engine light came on about the O2 sensor bank 1 sensor 1 and bank 2 sensor 1 came up on the on the scan tool. It run great. how do I fix it
View 4 RepliesI had a check engine light pop up and I went and got it checked out. Comes to be its a IAT sensor or bad connection with this sensor. I change the sensor and made sure the wires on it is all good. The question is, I still have the check engine light up, does the code need to be deleted? And what happens if the code gets deleted and problem is not fixed?
View 3 RepliesMy check engine light just came on around 7000miles on my 2014 IS350. Dealer says that I need a new O2 sensor. Just wanted to see if this is common and O2 sensor replaced within the 1st year?
View 7 Replies1989 toyota 4runner. O2 sensor is bad and has the check engine light on. No need to spend $100+ on the sensor. Is there a way to disable it so the light goes off?
View 19 RepliesI recently purchased a 3.5 V6 Santa fe. The Check engine light keeps going on. I took it to a few shops and I am getting the same code. It is the O2 sensor in bank one. (I think the the code was po170.) The light keeps going on and off. All I can find are the same problems with different Santa Fe engines (2.7, etc. )... My SUV has 100,050 miles on it.
View 1 RepliesThe check engine light came on yesterday. 2004 with 115K. Auto Zone read the codes and they are as follows:
Definition:
Idle Air Control Valve control circuit.
Probable Cause:
Open or short circuit condition.
Poor Electrical Connection
Failed IAC motor
I have an 04 gx with a check engine light on I had the code read at auto zone. That tells me o2 sensor bank 2 sensor 1. I have already changed the sensor they said it was and still have the code. What is the correct location of this sensor?
View 2 RepliesMy 2009 Camry check engine light is on. Dealer said the two O2 sensor both are dead and need to replace. After dealer reset the check engine light I have driven two days for 50 miles and the check engine light doesn't come back. If the O2 sensor is bad how long does it take for check engine light on again? Is it possible the check engine report on by mistake since two O2 sensors got bad at the exact same time is really rare.
View 13 RepliesOk so I just replaced my mass air flow sensor about a week ago. My check engine light just came back on and when I scanned it it said mass air flow sensor. What could be causing this to happen again? The codes are P0102, P0440, P0440.
View 4 RepliesI recently bought my new (For me) R32, the first owner of the car remove the 2 catalyst from the car and now I have the check engine light on. When my friend put the vagcom on the car it shows an oxygen sensor fault. What can I do to fix this? can I just buy a MagnaFlow exhaust?
View 11 Replies2004 XC90 T6. Local Volvo dealer (Bangkok at the time) said my check engine light was due to the O2 sensors going bad. I changed out the one under the car, then my wife threw out (accident) the other so I didn't change the one accessible from the hood. The check engine light went away so I figured that was that.
Fast forward a year later, I buy an Autel Maxiscan MS509 and now I'm getting check engine code P0455 which is probably the O2 sensors I didn't replace. Other than deductive reasoning, is there some way to look at the data on my OBD reader to confirm which O2 sensor is bad?
Wife has a 08 solara 2.4 auto. Check engine light is on for bad knock sensor in bank 1. Now car is not pulling itself, it takes off fine then shifts and falls on its face, I think its missing 2nd and going to 3rd. It is also not shifting into 5th so its staying in 4th and using a lot of gas. I tried manually shifting but it still goes to 3rd and will not go to 5th. I have been told this knock sensor could be causing it all. Cant clear code, I hit clear but nothing happens. We don't have a lot of money to pay the Toyota dealer to fix it and I can do all the work but they wont even show me where the knock sensor is.
View 5 Replieslast fall, the check engine light came on- Autozone states the knock sensor is bad. At the same time, odometer/cruise would work off and on. Now as months have gone by, the odometer RARELY works. Could all the electrical issues be connected? Is odometer controlled by Speed Sensor on the transmission or somewhere else?
View 2 RepliesIf you don't have a high flow cat on, will it throw ur check engine light on, saying its the rear 02 sensor....
View 14 RepliesSo this little gem of an SUV has been good enough to me over the year that I have had it, but it is one of those used vehicles that has me scared to look underneath cause there is always something a miss.
I have been having some power problems and the OBD check engine light has been coming on. The engine like to putter like if it's not getting enough fuel from a clogged fuel filter when it gets going, hot or cold. Have confirmed that the fuel pump is with proper voltage and pressure. Though haven't noticed a big difference with the new filter. The check engine light cycles a code of 21, which is refinanced to the O2 sensor, both upstream and down stream. That tells me that there are TWO O2 sensors for this model. And research has confirmed this. One ahead of the cat and one behind the cat.
Here's the kicker, I only have one O2 sensor at the head of the cat and the location of where the second one would be located is only a solid section of pipe from cat to muffler. I haven't been able to track down the plug connection for the second sensor and these codes and problem only came after I gave the Jeep a tune up.
1994 Jeep Grand Cherokee Limited V8
I have a 2012 hyundai accent. The check engine light came on. The code read knock sensor. Before I could get it into a shop, it went off. It didn't come back for 11 months. When it did come back, the same code was read. Again, it went off the following day before it could be looked at and hasn't been seen since. The shop says that even though there is a history code, it would be hard to diagnose since it isn't an active code. I noticed absolutely no difference in performance when the code was active. Both times it went on, the car was idling for several minutes with the ac on, and it came on as i accelerated onto a highway immediately afterwards. However, it has idled like that many other times without the light coming on as well.
View 11 Replies