Prius (Gen 2) :: ABS / VSC / Lights Constantly On After Hub Bearing Replaced
Jun 4, 2012
Our Prius is a second generation from 2006. Over the weekend the right front hub bearing was replaced. This was their diagnosis after we reported hearing "humming" noise from the front side of the car. They did a test drive around the block and they said that this was the problem. True enough, the noise went away after they have done the procedure. Unfortunately, the ! ABS VSC lights are now constantly on. I noticed this when I drove the car going home (about a mile away). I reset the jumper pins 4 and 13 on the DLC together with pumping the brake pedals.
This immediately solved the problem with the lights. They were off now and everything was back to normal. I then did a test drive, and lo and behold, when I hit on the brakes, no matter how soft, the car jerks as if the ABS was engaging. This happened twice before the ! ABS and VSC lights again went off. As soon as the error lights went back on, braking became normal once more - no more jerky and intermittent braking.
I then drove home and did the jumper procedure again to make sure that the first attempt wasn't just a fluke. I had the same experience as before, car braking became intermittent and jerky. The ! ABS and VSC lights again turned on - and right after, braking became normal.
View 6 Replies
Advertisement
I replaced all the bearings and put in a rebuilt transmission and still have bearing like noise , seems like the front, directly increasing with speed . Same in neutral, no change with turning or breaking. Getting worse over the past few months.
View 1 Replies
Got into my car this morning turned on the car and the hazard lights started to blink . Thought I might have pressed the hazard lights button , so of course I press the button into the lower position and the lights are still on .. Then I press the button again into the raised position and put the car into drive and now the hazard lights start to blink faster as I accelerate ( now my Prius Became a police cruiser ) it's obvious I have a short some where , or the relay went bad . If it's the relay, where can I find the relay in the car? Looked in both fuse boxes and I couldn't find it . I've since pulled the fuse on the hazard/ signal lights. I'd rather try to fix this my self before I have to pay Toyota to rob me blind .
View 2 Replies
Some years back my "farm" '05 prius when a host of bells and whistles went off, cooling fan ran more than normal, and I lost power a couple of times. Turned out this farm prius had an accumulation of dirt, dog hair, hay and other debris that needed to be cleaned out. You got me through the whole process, and the car's run fine until.... . Fast forward a couple of years to 200,003 miles. Now the cooling fan is running pretty constantly, the red triangle stays lit, the check engine light comes on, the (!) is on, and the VSC light is on. Haven't hooked it up to check codes, but did check cooling fan and it's clean. Would it possibly possibly better to change the 12 volt battery?
View 19 Replies
So just to sum it up. Past few days I had been hearing a grinding/clicking noise from my left front tire. I had an accident on that side a few months back. Went to the mechanic and they said it is most probably the wheel bearing and possible the hub also.
They took it apart and changed the wheel bearing. After two days of getting the wheel bearing changed the noise is back. It is not nearly as loud but it is definitely there.
What it could be? Could it be the hub itself? I have a 07 Sonata with 100k+ miles on it
View 2 Replies
Just replaced 12 volt battery from a dealer nearby. Got it in OK, but my "!", ABS, and VSC and Brake lights are still on. Pads and shoes look fine. Is there a reset button or mode for these lights. I was under the impression that the display voltage test of 9 volts (dying battery) was causing the lights to come on. Just want to make sure there is no reset on the lights (like after an oil change) before I move on to other testing or the mechanic. The other symptom I've had along with these lights is the yellow arrows coming from the battery don't stop when I come to a stop. I have to put in neutral or park to get them to stop not matter how hard I press on the brake. This happened a couple years ago, along with the lights above, but went away. I wrote it off at the time to a bad connection somewhere.
View 13 Replies
I have a 2003 Buick Lesabre Custom, 146K miles on it
1st problem was that the passenger front wheel bearing went bad, I replaced it with a new bearing from Napa(cheaper one) drove it 1 day everything seemed fine, next day it was raining, and Traction control and abs light came on and continues to do so almost everytime I run the car. My Mechanic friend said this was a defective wheel sensor and that i should get a new one, I do not know if I should get the better one, every time I've ever changed the wheel hubs I have had this problem except when I use the more expensive hubs. Maybe I answered my own question on this one!!
Today when my wife was driving the car, the Service engine Soon light lit and it started bucking and shuddering going uphill, and it threw a code that said that TCC was stuck etc. I had been running the failing hub for a few weeks prior to this with no problems but when I changed this the other day, I started having problems.
View 2 Replies
I have replaced the Traction battery AND the 12volt battery. I clear all codes by disconnecting the 12 volt battery for a short period of time. I reconnect 12v battery and no warning lights. I drive for 10 miles and RED TRIANGLE, Check Engine and the Brake lights also come on the dash. 2006 Prius 130K miles.
View 16 Replies
2005 Prius I picked up a few weeks ago decided to eat both of it's batteries for lunch and leave me high and dry. I replaced the aux battery yesterday which I was lucky to get at cost at the toyota dealer since the aux battery was original. Put it in and all was well with the car for the rest of the day. Got in it today and headed out and was welcomed with the big stupid "!" triangle, the regen brake warning, check engine light, "PROBLEM" written on the display with a picture of a "!" inside a car outline, and some severely reduced performance. So I looked online and found a place with a bunch of low mileage batteries out of smashed up 2009's.
View 19 Replies
I have a 2007 Prius. We left for vacation for 2 weeks. Came home. Started the car and then all the lights came home. I thought the battery must have drained. But the lights are all on with a new battery. Is there a way to clear all these?
View 8 Replies
last week I got a whole array of warning lights, including the triangle of death. Took it in to my local mechanic who diagnosed it and told me it was the HV Battery. So, as a temporary fix, we did some DIY and just replaced the bad cell. Everything went well, just some minor troubles toward the end with the engine not turning on, which we fixed by switching the orange switch on the battery and disconnecting and then reconnecting the 12V battery. It was driving great, until u got to work this morning and all the lights came on again. What am I missing?
View 13 Replies
My 2007 Prius suddenly lost power and all lights on the dash board light up. I had a "problem" error as well. Eventually a message came up stating there was a transmission P lock mechanism problem.
Long story short, realized the 12volt was dead and replaced it. However, the car is still not running after replacing the battery. It went once around the block fine, and then the same thing happened with all the lights (check engine, VSC, brake system, and !) and P lock mechanism warning. Disconnected the battery for 15 minutes and tried again. No luck.
View 15 Replies
2006 Toyota Prius 93000 miles
On 3/8/13 my Prius would not start. I read some information online and came to the conclusion I needed a new battery.
I started the car, and it immediately started up. I drove it for a very short time and parked it in the garage.
Today I started the car and drove it for about 5 minutes to a restaurant. I did some shopping and about 3 hours later I started the car and A Big Red Triangle appeared along with a yellow circle with an exclamation point in the center and the check engine light.
I immediately drove it to the Toyota Dealer 5 blocks away.
View 3 Replies
I took my Prius to get one of the air pressure sensors replaced on a front tire. When they returned it to me they told me that the ABS and the VSC lights were on and did I know that. I told them that was not on before. Anyway they told me they could not fix it an I needed to take it to the dealer to get it re-calibrated which i did.. How can I prove that this happened when the tire was being worked on, or can I?
View 4 Replies
I am completely lost now, spent alot of time trying to get the pulley off to replace the bearing, finally got that done, turned on the car, and it dies almost instantly unless i have my foot on the gas.... it runs really rough until i rev it up to at least 2K.
View 8 Replies
I had the front right wheel bearing replaced on my Toyota Corolla (60,000 miles) replaced a couple days ago. One day after the repair, I heard a high pitched clicking noise which was noticeable around 20-30 mph. Yesterday, I still noticed the high-pitched sound but also a grinding/popping sound in front left side when coming to a stop upon every rotation of the tire. Took the car back to the shop to let them listen to the noise, but really weren't very compliant since it doesn't sound like a wheel bearing problem.
Here is YouTube link to noise car is making : [URL] .....
View 5 Replies
I bought two new factory fresh speed sensors to replace the ones. So, after work tonight I get the car up on jack stands and replace both sensors in about 45 minutes. Get it off the jack stands, torque down the rims and reset the dash lights. Nice clean dash display with no warning lights.
I drive it down the street, nice speedometer display and then, after about 100 yards, the warning lights come on and the speedometer flickers from 22mph to 2 then 10 then 1 then zero. I drive it back home, check the sensors and the connections, reset the lights again, drive it down the street and, same story.
View 6 Replies
I have a 2001 f250 v-10 4wd with 117,000 miles. I just replaced drivers side front hub bearing assy and not sure if it's the new bearing or what but now I keep hearing this crazy noise from suspension area. It has had bangs and pops for a while now. It almost sounds like abs motor going off but louder. Does it going slow fast or whatever. Brakes on or off. Trucks ball joints were done about two months ago and new shocks, trac bar replaced this summer only thing not done was tie rod ends and all bushings. Brakes are good new rotors and pads this summer also. It's like taking two inflated balloons and rub them together real fast. It may be the timken bearing maybe bad from get go.
View 14 Replies
I replaced a water pump on a customers 2013 5.0L truck this week. The bearing was totally shot and lost all the coolant. Truck only had 46000 miles on it, is this common?
View 7 Replies
Tested and replaced 2 bad battery cells in my 2007 Prius... Got everything put back together and now all dash lights are on and engine won't start... When i try to shift into drive or reverse it goes directly into park... I tested the battery without removing the safety key and the inside terminals are at 220 volts and the outside terminals are at 0 volts as shown by photo... Maybe due to a fuse somewhere?
View 19 Replies
I bought a 1999 1.8T Passat B5 about 10 months ago. The BRAKE and the ABS lights both were constantly on. The car also beeped at me everytime I turned it on. Obviously, the ABS control module was bad. Then, I bought an used ABS control module online, replaced it and the BRAKE light went off and the beeping stopped as well. The ABS light still stayed on.
Next I had the car scanned (VAGCOM). Below is what it reads. Both right front and rear ABS sensors were bad. I replaced them. The ABS light still stays on. I am wondering what this means:
18258 - Powertrain Data Bus: Missing Message from ECU
P1850 - 35-00 -
Is the replaced ABS control module still non functional?
Should I have the car scanned again and reset the light since I replaced both faulty wheel sensors? Is it obvious that the ABS control module still needs to be rebuilt?
VCDS Version: Release 10.6.4
Data version: 20110418
Tuesday,07,June,2011,18:29:06:63737
Chassis Type: 3B - VW Passat B5
Scan: 01 02 03 08 15 16 17 19 35 36 37 46 47 55 56 57 58 75 76 77
[Code] ....
View 7 Replies
