Prius (Gen 2) :: 2004 Will Start But Only Runs A Few Seconds
Jan 12, 2013
My 2004 Prius is due in the shop Tues for a hybrid battery replacement. Codes indicate only one cell bad BUT...It is obviously having some problem running. We were very low on gas yesterday but wife filled it before she came home.
She parked it in garage. The Hy Batt indicated all green bars. She may not have pressed the Park button before Power - I do that a lot too.
This AM I changed the spark plugs before I tried to start it. I then started it (ICE & started-sounded OK) and backed it DOWN the driveway into the street and started down the street. The ICE stopped.
The batt indicated one blue bar so the batt would not propel it. After trying a couple times to make it run, I disconnected the 12v grd and let it sit for an hour. Then I reconnected the batt and the ICE again started showing hybrid at 4 blue bars and stopped after a few seconds. Tried it once or twice more, same thing.
View 2 Replies
Advertisement
This applies to a 2001 F-350 with 73,000 miles on the engine. Engine oil level is good, batteries charged, HPOP reservoir is full and passes Cody test with flying colors. Fuel pump runs for 20 seconds at key on. Start takes about 6 seconds. If I shut the key off and restart immediately it starts in under 2 seconds but if I wait about 30 seconds it's a 6 second start. Here is an AE that I ran on it, it has me stumped. FWIW it seems to start quicker when AE is hooked up. ?? An odd whir type of noise comes out from somewhere under the hood when I first turn the key on and when I clear the codes with AE.
View 14 Replies
My car was sitting outside and wasnt started for about 4 months. It has a brand new battery so when I went to start it, it started right up first crank, ran smooth for 10 seconds then you hear the sound of a ton of water being bubbled and pushed out the exhaust, then the car studders and turned off. There was a big puddle of water near the exhaust. I tried starting the car the day after a few times and all it does is crank but will not start, battery is 100% and its cranks with no problem but will not start at all, it's like dead, the check engine light went on after trying to crank it today too. I'm lost. I figured there was too much water pressure in the exhaust but nope won't start now, the battery is good, electronics are good, has fresh gas, not sure about the lines but like I said it started right up yesterday.
View 5 Replies
Not really sure where to go with this one. Was going to start with the fuel filter but I am not sure where it is at?
View 3 Replies
My 04 Touareg V-6 will start, but will die about 10 seconds after or if I give it gas. I'm pretty sure it's one of the fuel pumps just not sure which one.
View 5 Replies
I've got 200k on my Lariat. Engine was replaced 60k ago. It's in outstanding shape and is driven a lot. Suddenly this morning I start as usual and it runs about 5 seconds then stalls out. Every start, same thing. So it seems I am getting fuel pressure to start but it doesn't last.
I did replace the Fuel Pump Module within the past two years, due to corrosion of the FPM housing. At that time the truck would no start at all. Could it have gone bad already? I'm thinking this must be an electronics failure. It was perfect all day yesterday. 2004 Lariat 5.4...
View 14 Replies
Car starts runs rough for a few seconds then shuts off (spark plugs and 2 coils were replaced a few months ago). Coolant reservoir level was way low so I filled to the full line, kept the cap off to cycle. During the time the car starts, the coolant from the reservoir violently "boils" over (out of the reservoir). Huge amount of white smoke from the rear exhaust and a burning smell.
Used Techstream and got the following codes:
Engine and ECT: P0117, P0302, P3190, P3191
Hybrid Control: P0A0F
Intermittently get misfile codes but this time around they did not return.
View 10 Replies
My 2001 Prius (230,000 miles) is unusable. I can clear the codes. The engine will start up fine. After a few seconds it starts bucking and jerking as if the engine is trying to engage something that won't turn and finally stalls. It is similar to a manual transmission car's action if you fail to push the clutch in when you stop the car. What the engine is trying to engage? I don't have any scanner to read the codes.
View 7 Replies
My car was driving good when i had an accident just the fender and door was hit, but i loved the car in the body shop for 1 1/2 years now i went to pick it up and the battery is low, the gas engine start and stall in 3 or 4 seconds . Can i tow the car with the wheels on the ground and been pressing the brakes a little to re charge the battery, 2007 prius 120000 miles.
View 7 Replies
About a month ago my 2009 Prius - 35500 miles - started acting up intermittently. When I first start the car I am getting a red warning triangle for just a few seconds and I feel/hear a soft thump under my foot that is on the brake pedal, there is a few second pause - the warning light goes away and the car starts just fine. This does not usually recur until the car has shut off for a few hours or so. I have had the car to my Toyota dealer twice and they could not reproduce the warning light even after it had been sitting all nite. That was about a month ago - and the problem has been very intermittent. Then yesterday we had a pretty cool morning and when I started the car I got the red warning triangle and a Warning on my screen -- something to the effect that "There is a Park and Transmission Lock" - I turned the car off and started again almost immediately - no warning triangle - no warning message. It happened again once this morning.
View 3 Replies
Ever since I've had the car, I've noticed after the gas engine kicks on, it runs a little rough for maybe 10-15 seconds. Only when it's sat for a while, hours or overnight. Replacing the plugs didn't work. Now, its not bad, not really a problem, but I'm wondering if the injectors might need cleaning.
View 19 Replies
When I start my Audi car it runs on few seconds. However when i take it for dealers they said there is no such problem in battery. So what should i do now, my car is not running properly.
View 6 Replies
2010 Cobalt, LS 2.2 Ecotec, with 13.7k miles. Oil level normal and battery voltage = 12.5V.
I've bought the car new in Feb. 2001. Car started and ran normally for the work commute on Friday, 9/2. Today the Cobalt starts normally, runs for 2-3 seconds, and then stalls. The accelerator has no effect. It's already been towed to the dealer..
View 1 Replies
I just put new rear air shocks on my Buick Lucerne. I noticed the back in my car bounced more than once when I tested them. After starting the car I hear the air compressor run for about five seconds. This seems to have no effect on my new shocks. The old shocks had holes in the bladder. What tests can I perform to figure out what's wrong?
View 8 Replies
I am not sure what is going on .......My 2004 Prius ICE runs all the time now , the fan on my HV runs a lot too .......temps are 106 degree plus now. I have no check engine dash light yet. My scangauge race thru a bunch of codes. I have Engineer 4kw v6 installed too.
View 8 Replies
I start the car - a 2001 Ford Focus 4 cyl DOHC. It runs fine for 30 seconds then stops, as if it is no longer getting fuel. I can't start it again for a couple days then the same thing happens over again. FWIW, I parked the car for 8 months before this happened and only started it once in that time. But it ran fine then and before I parked it. What can this be?
View 1 Replies
One of my friends recently asked me to change the timing belt on his 2004 Passat 1.8T. I put on everything as instructed by the manual that the parts department gave me. However, when I start the engine, it runs perfectly for about three seconds, then starts rattling, and stalls out. I took the belt off and put it back on three times and yet, it still continues. This rattling seems to be coming somewhere from within the exhaust system near the engine and sounds like a back-fire. The check engine light also appears when this begins happening. I replaced everything, water pump, pully, tensioner, and etc. Note, I am a professional mechanic and have worked on several Volkswagen cars, including my own, but I never encountered a problem like this one.
View 7 Replies
My truck started fine my truck was running good. One morning while working from a hotel I went to start it in the morning and it started and stalled more than a few times but eventually ran fine later it did the same thing. The next morning it would not crank at all. I deduced it was the ficm and ordered a replacement the dash was acting funny and tach dropped before it died. I ran the. Test on the dash it swooped the gauges acted fine. I checked and wiggled sensors wires. I also checked were a splice at the crank sensor was it looked good then I bought a meter and the ficm seemed to have the correct volts it was a upgrade. Had 57volts at 1 screw koeo and while cranking.
PCM and replacing the crank and cam sensors. I don't really think it is the harness it will now crank and shut off crank and shut off like it did at first. He said it's stalling because it looses ficm sink. I haven't put new ficm on it ...the harness was allot better than the first. Could the crank sensor splice be wrong it is done its soldered together and heat shrink ... is it the ficm or the dash. I'm out of my comfort level I was also reading it only needs ficm sink to start. Not run. In addition #2 injector is throwing a code. I asked him if he thought the fuel was getting pressurized and his reply was the fuel has nothing to do with ficm sink. Also, I swapped relay out with my other 6.0. And its running fine This is everything I got ....
View 2 Replies
I have an 84 Bronco II with a fuel injected 302 in it. I was out wheeling with it the other day, and it was doing great until about 3:00. I got out to see that my brothers radiator had sprung a leak. When I got back in my Bronco and put it in gear, it just stalled. I started it back up and it ran for about 10 seconds then shut off. It kept doing that over and over again. Finally, I got tired of it and had someone get my truck and tow me out of there. Why would it run for about 10-15 seconds only and then shut off like it was getting no fuel (yes, it does have fuel in it)? I have a feeling it might be fuel pressure regulator valve because it was acting up a while ago..
View 10 Replies
Having some problems with my 92 Nissan NX2000. i just finished changing the clutch on the car now its acting horrible.
When i start the car, it will run decent for like 2 or 3 seconds then the idle drops down till it almost dies, catches itself, idle goes up to about 500 were it will pulse around for a few seconds until it dies. If i rev it it will stay running, kept it running for about 2 mins. but as soon as i let off it will pulse at 500 until it dies
After i changed the clutch it started up fine, it ran great for about 20 seconds before it just died. when i started it after is when the problem arose.
I took a video of the car running, which can be seen here. [URL] .... (It has never caught itself like that before and jumped up to 1000 rpms before. It normally will die at that point)
The video is really quiet, not sure what happened there. if need be i can get a video of the engine bay so its louder, was mainly focused on the RPMs.
Here's a few things i tried: Checked fuses, Changed spark plug wires, made sure they were all seated good, MAF wires were rubbed a bit so i cut the MAF pigtail off one of my other sentras and soldered it on,Changed to a good battery, Changed fuel filter, Added more gas (in cause gauge is broken), Made sure all connectors are plugged in, Checked around for vacuum leaks, found that one of the large hoses coming off the intake going to the engine had separated so i plugged them back in and nothing.
View 4 Replies
2004 Malibu 3.5 v6. 101,000 miles. In order to get engine running gas pedal has to be pushed all the way down to get it started. Engine will not start by turning key. Car initially starts sputters and then dies. Pedal to the floor while cranking engine fires and runs. Which direction do I go first at. Ignition or Fuel. What should the fuel pressure be with key on engine not running ?
What should pressure be at while running ?
What is the time frame pressure should hold at and for how long ?
Ignition, Coil,Wires,Plugs. Are these the only ignition parts to look at?
Check engine light is on but has leak in exhaust. Exhaust needs to be welded. All parts above are original. Neither Fuel Pump nor Ignition Component have not been changed. Which do I do first ?
View 10 Replies
