Prius (Gen 2) :: 2004 - Clicking Sound When Brake Pedal Depressed
Oct 7, 2012
I have another small issue with my 2004 Prius. I just noticed yesterday that the second I very lightly depress the brake pedal, a little clicking sound is made down below. It sounds like it might be coming from the brake pedal itself or somewhere underneath the hood. It's only when I depress the pedal slightly and it makes pretty much the same sound when I release the pedal. I just had a 5000 mile service done to the car and there were no issues then.
View 14 Replies
Advertisement
Sometime the car is fighting to move forwards when I start to depress accelerator pedal and it sounds like "click click CLICK..." the sound changes from lower to louder depending on how I depress accelerator pedal... (like the car is trying to hard to move)...
View 3 Replies
I have recently purchased a 2007 Gen 2 Prius and sometimes it emits a very annoying squeak. It occurs when the car is stationary, with the brake pedal fully depressed. When inside the vehicle it seems to be coming from behind the glove box. When on the outside and facing the car it seems to be coming from below / behind the electric motor. I have made a recording of it with the noise in question being audible for a couple of seconds at 0:13, and then again at 0:22 until the end. It could be nothing I guess, but this is my first hybrid and I am not too sure what is perfectly normal and what is not.
View 14 Replies
2002 camry. The car will not accelerate. The throttle body makes a clicking sound when pedal is depressed.
So.. I took it apart and cleaned the contacts in it. In the mean time located a spare throttle body from a 2003 from a local yard. The old throttle body has a part number 22030-28030 and the replacement has a part number 22030 0H010. The replacement throttle body wouldn't even move when the pedal was depressed.
I put the old one back on.. and now it doesn't click anymore but the car in Park only revs to 2000 rpm's. Its not sticking or having any mechanical issue.
I checked the parts site for Toyota and the replacement is the new number. Superseded. Does the throttle body after replacement need to be reprogrammed? Or whats the deal. I wish I was more Toyota literate when it comes to this.
View 1 Replies
I have a 2012 Elantra limited. About 2 weeks ago I've started to hear a clicking noise coming from the gearbox when brake pedal is pressed and let go. This only happens when the car is at standstill. I took it in for service today and sales rep said its a normal clicking noise and his sisters car makes same sound. He said its an actuator motor engaging to allow the car to shift when brake is pressed. The thing is, the clicking was never there before or maybe not so loud. So what should I do? Car is still under warranty, should I demand for them to replace the actuating motor? Maybe call Hyundai and complain that they said the noise is normal ?
View 4 Replies
Brake pedal to the floor... And a lot of fluid on the ground.
I was coming home (empty fortunately) last evening when I noticed the brake pedal give an initial resistance, then slowly sank all the way to the floorboard when slowing down to turn onto my street. When I got to the house, I noticed a hissing sound each time as the depressed brake pedal sank to the floor. When I got out, there was a lot of brake fluid on the ground on the left rear side. It appears to be between the fuel tank and frame rail. From the side it is the section between the fuel filler to just ahead of the left rear wheel. The tank and frame rail is drenched and dripping DOT 3.
I am lucky to not have been pulling my 5th wheel when this happened! However, I have a camping trip coming up in a few weeks, but now my TV is broken. What has happened, and an estimate for repairs? Where is the best place to have it fixed, dealer or specialty shop? I just bought this vehicle in January and it has 102,500 miles, and came complete with full and meticulous repair records. The P.O. was incredible at upkeep, so this is something curious and flukey to me. But do I need to worry about the other side now, too?
View 2 Replies
Ok, I changed my front brake pads and rotors last week and since then everytime I get in the truck and drive for about the first 2 or 3 miles when I push the brake pedal it feels like my ABS sytem is activating. Then it stops and the ABS light comes on but the brake pedal stops pulsating when depressed. Is my ABS going bad or did I possibly do something wrong? I have changed the rotors and pads before without problems....
View 3 Replies
2013 tdi 6mt. I am noticing that my clutch clicks when the pedal is depressed. it does not happen when I first start driving in the morning, but it seems that once the cabin is warmed slightly it starts then clicks each and every time. It is annoying and it appears to be related to the different temps outside vs the cabin. I did not notice it during summer or early fall but it is cold here now.
View 24 Replies
I've noticed lately that my Prius (2008) sometimes decides to keep the ICE running even though the engine is warm and the gas pedal is not depressed. I can pulse and glide (with the engine off during glide) the first 5-10 minutes of driving, and then all of a sudden the ICE starts running constantly. I have to press the EV button to be able to glide. Quite annoying... I bought the Prius just to get rid of the ignition jerking.
View 7 Replies
I can press on the brake pedal when car is off or on and there is a kind of quirky sound made. I can hear a pump sound and then a squeaking or quirky sound. It happens every time I press the pedal when it is stopped, either on or off.
View 2 Replies
03 F250 7.3. I busted a brake line last week somehow, Got it replaced and fixed up, Bled that line and everything was somewhat good.
Now, when i hit the brakes hard, I have pressure. If I let off even a little, My pedal will start to sink till i apply more pressure. I am gonna fully bleed my brakes when I'm home to see if this could solve the problem.
View 7 Replies
My brake pedal clicks when depressed, only at the start of pressing down on it. (This is a 2007 Corolla CE.) It only does this when the car is cold and started doing this during the very cold below freezing weather. The brake lights are all working, nothing else seems to be a problem -- brakes work fine, no vibration, etc. Brakes were checked out two months ago.
View 4 Replies
2003 echo , automatic, 168,000 km's
When I press the brake pedal when in the car is in PARK , I can hear a click in the plastic transmission housing beside your knee, where you change gears. It clicks when you press and clicks again when you release, almost sounds like a relay clicking. It only happens when in park, not in neutral or drive or reverse. It seems to click right when the brake lights go on and again when they go off.
Possible shift lock solenoid or control unit?
View 4 Replies
I just got a used low-milage 2013 LS460, and noticed that every time I tap the break pedal I hear a "clicking" sound coming from under the dash or hood. This seems to happen every time I touch or press on the brakes, at seemingly any speed. It sounds almost like an actuator of some kind... perhaps like the type which allows the transmission to shift out of park. Is this normal, or an indication of a an issue?
View 14 Replies
I have an 02 rodeo ls 2wd with 110k miles.. I am having a lot of brake issues. 3 months ago i had front pads rotor and rear shoe's installed.then i started to feel maybe once a day a hard chatter in the brake pedal and a clicking sound coming from the dash area..so i took it back to pepboys and they said it was warped drum..so they installed new drums as well.
Well the clicking noise behind the dash is still there and the chatter in the pedal still happens.....when the pedal chatters the truck wont stop so it's kindda scary.
Also sometimes (it will last for a day or 2 then disappear) when coming to a slow stop the brakes make a rubbing noise like a waa waaaa waaa waaa as the tire rotates to a stop..I've been to pepboys 4 times and of course the noise never happens for them.
View 1 Replies
But when I take my foot off the brake pedal , its just seems rather noisy (clunky). As if VW forgot to put some rubber or something to prevent this clunky sound. (it just sounds cheap)
My jetta and tiguan never seemed like this. Have to stick my head under there and see whats up
View 2 Replies
I have a 2003 Passat GLX 4Motion that was fine Monday...Having heavy rain Monday and with brake pedal depressed unable to get out of park..I have brake lights but when I got into car and started it I have airbag light and esp light on as well as check engine light...Is there a way to by pass the shift lock solenoid so I can move car into my garage...
I cleaned connections as was suggested and had a tough time as Bentley Manual states to remove console one must put lever into 3 which as lever is stuck in PARK was impossible...I tried pulling out the shift knob button as described and when I still couldn't get any response found that when I pushed the button back in that I was finally able to get shift lever to respond and finally come out of park...
I now get code for no TCM Signal P1626 No Powertrain Data Bus Signal Missing Message from TCM which now triggers ABS , Airbag ,ESP , and Check Engine light all with the cause no TCM Signal .... Now wondering if any easy way to test for data bus signal ?
View 2 Replies
I have a 2005 Excursion 4x4 Limited 6.0 diesel. I had someone pull alongside me today and tell me my brake lights were out. Sure enough. I double checked and nothing at both lower lights and also nothing at the third brake.
So... here's the short version of the things I've checked so far:
1. no brake lights when pedal depressed.
2. running lights work fine
3. turn signals work fine
4. hazards work fine
5. brake lights DO illuminate when I press the brake button on my trailer brake controller
6. checked power to the green with red tracer wire going to the brake light switch on the pedal. 12 v present continuously
7. checked power to light green wire. 12 v present when pedal is depressed. 0 v when pedal is released.
8. checked power to tail lights (wish I had tried the trailer brake controller sooner, this step would have been unnecessary). voltage present (I think 10-12 v) when the running lights were turned on. 0 v when brake pedal depressed. I suspect now that I would have 12 v when squeezing my trailer brake controller button.
I was pretty convinced it was the brake switch at the pedal. But since I'm seeing the voltage pass through the light green wire when depressed.... I know the wiring to the lights are good because they work when pressing the trailer brake controller button.
So... Do I need to dig into the multifunction switch that I've been reading about? Does the power go from the pedal switch to the multifunction, then to the trailer brake controller? I'm really hoping that I don't have to dig into the column to check that multifunction switch!
View 6 Replies
We purchased the vehicle (2013 GX460) in September 2012, and had the car for 6 weeks before my wife was hit by an oncoming car who missed a stop sign. 8 weeks later and 23k of repairable damage to driver fender, front bumper, grille, hood, frame, and all components within those major areas, we received our vehicle.
The vehicle is wonderful and a joy to drive. When the brake pedal is depressed at low speeds (i.e., maneuvering in parking lot, entering driveway), there is a slight vibration to the pedal (similar to the vibration from a cell phone) and a noise that suggests an electric motor is working. The vibration is not like ABS; ABS is a profound vibration. The vibration we experience is very slight. The vibration is not apparent at highway speeds.
I do not recall either the vibration or the noise prior to the accident, and I suspect that this is a result from the accident or from the repairs. I have already brought the GX back to the dealer for this problem and they were quick to dismiss it, but I am really concerned that this is a real problem, and I want the dealer to re-assess.
View 13 Replies
My brake pedal is making a creaking noise when depressed and can also be heard when letting off the pedal. The noise is not coming from the brakes themselves (front/back are like new) but the pedal area or somewhere behind it. This noise doesn't start until I've driven the car for a little while. The brakes work fine for the most part but sometimes feel a bit spongy if making a sudden or hard stop. The fluid levels are fine.
I'm taking it in on Friday and hoping that the brakes just need to be bled a little or maybe the pedal just needs lube, but I'm worried it might be the booster or master cylinder---if it is one of these?
View 4 Replies
Why is there a sensor on the brake master cylinder? Most other cars and trucks I've seen have tied the cruise control into the brake light (and clutch interlock if Manual transmission.) switch so that when the pedal is depressed, the cruise control cuts out.
In the Ex, could I tap the brake pedal enough that the brake lights come on yet I don't trigger the pressure sensor in the master cylinder to cut the cruise control?
View 5 Replies
