My son's 2001 Prius (Gen I) has squeaky noises in the front end. When I had the two front tires replaced yesterday, I asked them to see if they could diagnose the problem and he said he thought it could be the control arm because he had had the same noise in his Toyota Camry and that was what it was.
View 1 RepliesLooks like my struts and springs are getting old that they're making squeaky noises over the bumps. Had a shop checked to make sure and they suggested replacing them. I've been wanting to do air ride but not a lot of good shops in town have done that before. So far by searching, most complete kits run around $4k or so without installation. Is that about right? How complicate is it to do the installation?
My second option was to purchase coilovers and put them in myself. Cheap and easy. But again, there are 4-5 brands out there? Megan, D2, BC, K-Sport, etc? I want it mildly lowered and not too bouncy. What spring rates should I get?
2001 Chevy Silverado, 1500 4wd. 135k miles. Front passenger wheel squeaks when rolled forward or back. Checked brakes and they are fine. While I had it apart, I could hear the squeak which sounded inside. I don't know the terminology, but there is a bar between two rubber boots. The squeak sounded as if it was coming from the boot near the center of the truck where there are four bolts.
View 1 RepliesOkay so I recently replace the rear shock absorbers and now every time I take a corner or when I'm going on a surface that's not flat or just if I go over a bump too quick. I here squeaking sounds I replace the shock absorber as well as the strut mount to no avail I've found the noise I've located location of the squeak if where coil meets the mount. I don't want to replace the coil it does look like it might need some replacing the protective metal sheet is gone on the top some of the bare metal is exposed but I would hate to replace the spring and have noise again
Car is a 2003 nissan maxima with 144k ....
I have a squeaky front end on my 2005. I have changed the front struts but it still squeaks when turning or when going over a bump.
View 5 RepliesSo I already changed the Driver Side upper Control arm. But there is still squeaky noises coming from the trunk area, esp at low speeds going over small hills and small pot holes. I saw this is common on our cars and wanted to know which parts were to be replaced. At 110k, is it worth repairing piece by piece or should I do the shocks, ball joints and such at once.
View 1 RepliesI have a 2003 Camry 'SE Automatic with almost 18,000 miles - that's right, low mileage. This week the steering wheel started making squeaky noises when I turn it. It doesn't matter which way I turn, it will squeak and it doesn't happen all the time. Should I be worried and what can I do about it?
NOTE: This started happening the day after we had got an 1 or 2 of snow. That morning when I opened the door to get the brush/scraper and little snow fell in the driver's side of the car. Perhaps a little fell on the steering wheel.
I figured out what was causing my small clunking noises in the front end.. They were faint, but you could hear them at low speeds..
Front sway bar bushes and end links.. Replaced mine with auto7 bushes and moog endlinks.. They didnt "feel" loose or wobbled but replacing these parts got rid of my clunks..
Only downside was the bushes are really hard to replace, need to remove the rack, subframe, etc..
My car has about 150k miles, and the bushes were a little oval..
I have a 2001 f250 4x4 about 4 months ago I replaced my pass. side front wheel bearing unit and here recently about 3 to 4 weeks ago I get a grinding/ rubbing sound when ever I turn right it gets louder the harder the right turn I do not seem to notice it as much moving at speed but driving through parking lots and slow speed right turns I can hear it. I have checked everything and nothing is loose and I can not see any signs or fresh rub marks on anything. I am getting to the point of just buying a new unit and replacing the one I just replaced. What my problem could be?
View 3 RepliesMy steering wheel has a squeak when turning either left or right slightly from center.. I usually notice the squeak while stationary or parking. It's louder and more noticeable when it's hot outside.
Listening carefully, it seems to be coming from inside the steering column, not from linkages or joints from under the car. Looking for a exploded diagram of the steering column components, perhaps it's just a U joint (tilt?) that needs some lubing to make it quiet.
I have seen a few separate threads regarding a front rattle/knocking noise on some Gen II Prius. This is not the engine mount metallic-knock sound but rather a subtle rattle coming from the front end when going over smallish bumps at low speeds and sometimes accompanied by a slight knock in the steering wheel.
View 17 RepliesDisconcerting noises from my engine that began suddenly around 198,000 miles.
Nobody listening seems to think it's bottom end, and I did check valve clearances and found them all to be on the tight side (ten within tolerance on the tight side, and six just-out-of-tolerance tight).
I also saw what looked like less oil on the #4 exhaust cam lobes and I'm wondering if there could be some kind of oil delivery issue. (#4 exhaust was also an area that had stuck out to the stethoscope before I took the cover off).
There's a dark brown varnish pretty much everywhere on the top deck (photo in other thread), pretty much as a thin coat that doesn't rub off easily, but I saw a few flat flakes coming off here and there, and wonder if that stuff might occlude an oil passage.
I've picked up a product called Auto-RX that I've never used before. From reading its patent I think there at least might be something to it (an ester of a fatty acid that's claimed to dissolve varnish and sludge without the other effects of more conventional solvents).
2006 Prius has a strange intermittent tweeting sound that appears to come from the front drivers side, maybe in the console. Mechanic says it is in the tires. But I just can't go with that. The sound almost is like a cricket...
View 3 RepliesMy car is a 99.5 Jetta 2.0 5 speed. Recently it had developed a squeak coming from the front right wheel. It speeds up/slows down based on vehicle speed. I jacked up the car to examine and once the wheel was off I checked everything and it appeared fine. Wheel bearing, tierod, and ball joint all replaced a few months ago, and brake pads and rotors replaced a week ago.
With the wheel off I spun rotor and it did still make the noise. That being said it rules out the possibility of anything to do with the wheel or any bushings. Obvious answer would be the brakes but they are brand new and appear fine. Anything missing?
I've noticed when my car is first driven it squeaks LOUDLY like an old Lincoln in the front when I go over speed breakers. I only have 9k miles on it so I'm wondering if this is common or something else to have checked out at the 10k service.
View 7 RepliesI'm considering buying a used '06 Sonata LX with 137k miles, and the front suspension squeaks badly. I read the entire thread about replacing upper control arms to see what I might get into if I purchase as-is, and while it honestly doesn't seem too bad I know other problems may lurk. Would you buy this car with a squeaky suspension, or would you expect the seller to fix it first? Would you insist on them replacing all front UCA + LCA + struts + mounts + alignment at the same time? Any issues to worry about with the rear?
The car was amazingly clean and well-cared for overall. It was parked outside and the interior and exterior look better than my '05 Magnum that was garaged! I did notice rust on the wiper arms, one screw that was out of the passenger rear grab handle (above door). Also the seller told me the front passenger door lock won't work electronically 98% of the time, and the drivers rear lock won't work 70% of the time. I'm assuming the solenoids are bad or something is stuck - I can see the locks twitch a little bit when I depress the lock/unlock switch, but not enough to actuate the locks.
2006 GLS w/just over 100k on it...
In the winter time the front passenger side is very squeaky, esp when going over bumps...
I had it into a shop to have a wheel bearing done and they said the balljoints needed to be replaced...
Well, all that did was firm things up, the ride was just as squeaky...
Now in summer, it's not nearly as bad... First thing in the morning there's some squeak over bumps but nothing like it is in the winter...
What the heck would this be?
For the last couple weeks its been really cold and in the mornings my suspension would be really squeaky loud.. i paid no mind to it cuz it thot sinceit was cold the springs were frozen nd metal makes a noise when its cold, but now the temps are back up to the 70's80's nd the suspension is still squeakin like a mofo! Is there something wrong with my suspension? And it just seems to sound like its coming from the front...rear seems ok.
View 8 RepliesI noticed earlier this afternoon that when I opened my front passenger door to reach in and get my phone out, the hinge creaked/squeaked. Everytime I would open/close the door it would make the sound. This door has only been opened about 5 times since I bought the car on April 30th. I have never heard tell of this on a new car, so it is disappointing. Had I had a passenger in the car and they heard that, well it would have been a little embarrassing on a brand new car. It sounded like a 30 year old car that had never had its door hinges oiled. It may just need some grease or something, but I would think this should have been lubed properly during assembly.
View 7 RepliesSo I replaced the stabilizer bushing on my 2005 Dodge Caravan, as there was a bit of clunking and some wobble in the front end. I'm sure there's more to do (other suspension parts to replace), but the bushings were obviously worn when I looked at them. The clunking is gone, and the suspension feels better, but now the bushings make a scrunching rubber sound when I drive over uneven pavement and also when I first accelerate. I assume its the stabilizer bar flexing, but also assume I shouldn't be hearing it. After all, who would want new noisy bushings? Nothing else is new on the front end (except rotors and pads).
View 19 RepliesJust got an alignment done on my truck because it was squeekin and wandering on the interstate. I read the thread on the control arm / ball joint fix and was going to do the job since I thought they were probably shot with 187k mi. on them. I'm second owner so I dont know if orig owner ever had them replaced. I squirted some grease in the pitman arm boot and one of the ball joints that had a tear in it. I was wondering if any one tried drilling and tapping in a zerk fitting where they are accessible on the center link. There is a raised top on the joints that looks like it might be made for doing that but I dont know how thick the metal is and dont want to ruin it.
View 3 Replies