Prius (Gen 1) :: Red Triangle With P3009 After Connecting Cables To Auxiliary Battery
Sep 22, 2010
I bought an '01 prius with more than 160,000 miles last year , until now it's been a great car , averaging 46-ish mpg , now , a couple days ago I used it to jump-start a diesel truck connecting the cables directly to the auxiliary battery , the truck started after a 2 or 3 mins, the next day the known red triangle and the red car with the (!) appeared , the dealer reads code p3009 (hv leak) but were not able to give me any subcodes. Is it possible that the computer interpreted the sudden "pull" of current from the converter (via the 12v battery) as a hv leak ?
I got the reading of the 19 modules of the traction battery and all are within 0.5 volts of each other , so I hope they are all within tolerance , and the car seems to run just fine.
View 6 Replies
Advertisement
I picked up a 2004 Prius with 150k. It has no check engine light and no codes with a scangauge. I hooked it up to a mini-vci with techstream and found the following: P3009-526, C1310 and B1421. The car will only start if you reset codes, then after a few minutes of running the red triangle comes back.
View 10 Replies
If the Prius 12 volt battery (the one that is like all other car batteries, not the hybrid battery) goes out, can you use jumper cables to start it like any other car?
View 9 Replies
A warning came on the display with the words "PS Main" and a picture of a battery. I took it to a dealer and he gave me the bad news: I allegedly need a new hybrid (main) battery. The diagnostic code was P3009--I didn't know about sub-codes, so I didn't ask if there were any. P3009 means that there is an electrical leak from the main battery.
View 9 Replies
I have a 2008 Prius and have been thinking I should be changing the auxilliary battery soon as a preventative measure. I've changed plenty of batteries in other vehicles before but I was wondering if there's anything that's much different in these cars that I should be aware of?
View 9 Replies
I left my car for a week in the garage and the battery ran down. I had it re-charged but now even running the radio for a ten minutes with engine off runs down the 12v. The panel check says that its charge is over 12.4 v. What is going on? How do I prevent having to jump start the car every day or so even after running for 20+ miles at freeway speeds?
View 5 Replies
I just bought a certified 2010 Prius and have had it for 3 months now. Twice within one month, there was absolutely no power to start the car because the aux battery went dead overnight. I'm pretty sure I didn't leave any lights on and don't think I did anything differently when exiting the car for those 2 times. I took it into the dealership, and they couldn't find anything wrong. They said the battery was good. What is draining the battery overnight?
View 5 Replies
My dad's 2004 Prius start despite the auxiliary battery being fully charged. No lights come up on the dash, except for the door ajar light and the blinkers when the car is locked with the key fob. Also, we cannot scan any codes because the car doesn't power on at all.
View 6 Replies
Jumped into the Prius this morning to discover dash lights working, no radio etc so vehicle would not turn on. Replaced the auxiliary battery (about 5 years old.) Now all dash light, radio etc are looking great BUT:
- Enngine will not engage
- Message stating Check Hybrid System
- Various waning lights on dash (yellow waning triangle, swerve icon on left)(battery, brake, chech engine, steering wheel?) and abs!!!on the right)
View 6 Replies
I left the key on and drained my auxiliary battery(It was weak before) and when I jumped it it started and then shut off after ~20 seconds. I tried various different things and all I succeeded in doing was draining my HV battery from starting it so many times. So I disassembled the pack and recharged it and now it starts and runs but it is misfiring. It throwing 4 codes:
P0300: Random/Multiple Cylinder Misfire Detected
P0302: Cylinder 2 Misfire Detected
P0304: Cylinder 4 Misfire Detected
P1305: Ignition Coil 2 Primary Feedback Circuit
I inspected the igniters and plugs and they seem to be OK and I'm not sure where to look next. I'm not sure if the battery issue is related or not but I did replace the auxiliary battery.
View 11 Replies
I bought a new auxiliary battery online and installed it. I reset the driver's side power window. But my CD changer now beeps four times, all the lights turn green and orange, and I cannot play a CD from the changer or eject any of the discs. Both discs currently stuck in it are store bought Third Eye Blind CDs with no stickers, labels, etc.
I'm assuming that the CD player needs to be reset. Someone in another thread mentioned unplugging the battery for 20 seconds, while someone else said I need to enter a code that I can get from the dealer. I can go without the changer but the beeping is maddening.
View 3 Replies
2005 Prius shows a C1241 code, which can mean abnormally high or low positive voltage in the auxiliary battery. In my case it appears to be abnormally high, because my voltmeter showed the battery charged to 18 volts with the car off, and when running it showed 20 volts going to the battery. There's also a POA80 code (hybrid battery pack) but I'm not convinced yet that it's a hybrid battery problem. What would cause the overcharging of the auxiliary battery?
View 8 Replies
I have an 1983 F150 on a little island, so I have to be the mechanic. Yesterday the truck started then stalled and wouldn't start. I opened the hood and the battery cables, the fender mounted solenoid and the cable from the solenoid to the starter were too hot to touch. The battery was dead in about five minutes. I didn't have time to charge the battery, had to get back to the mainland. I bought a new solenoid and a new ignition switch today but where the problem might lie. I won't be able to get back to the truck until the weekend.
View 5 Replies
I'm pretty new to working on cars let alone a diesel truck, so this could well be something simple and / or dumb. Hopefully it is.
Batteries recently replaced. Started cleaning terminals on driver side and realized I needed a couple of fasteners. Between getting them, the weather going bad and getting sick that battery was unconnected for several days, truck not driven.
Finished cleaning the terminals this afternoon, went to connect the positive cables and they're sparking. Driver side negative cable is unattached. Neither of the two positive cables sparks when touching positive battery post alone. They only spark when they are brought together.
View 11 Replies
What gauge wires the battery cables are on these trucks? Son in law has some really corroded cables on the Excursion. I was going to pick up some welding cable and replace them, but a quick glance looks like different sizes for different cables.
Looking for a list of gauge and length for each one to save me a little time?
View 14 Replies
I purchased a 2000 7.3 dually 4x4 and the driver side battery is missing with the cables snipped.
I noticed the headlights do not function, neither do the brights, the air does not blow. Is this related to the missing battery? Someone said they are on same circuit and dont do separate tasks.
Still starts runs drives fine...
View 6 Replies
Working on a 2010 with 156k miles that threw a P0A80 on two separate occasions. Once before the 12v battery was changed, then the day after the 12v change. Decided to change the HV traction battery today with one from a wrecked 2014 with 56k miles.
After changing the HV batt I started getting the yellow triangle with no code associated with in. I would clear the code and drive the car a few minutes and then the triangle "check hybrid system" would appear.
View 14 Replies
I have an 07 and replaced the HV battery. Before swapping battery, I had Red Triangle, (!), VSC, Check Engine (took car to dealer who diagnosed it as needing HV battery). Now new battery is in but error-icons remain. The LCD display shows battery as more that half-charged. I connected an old Actron ODB2 scanner (circa 2000), but it doesn't Read any codes and doesn't Erase the codes causing the problem.
View 5 Replies
I had my Prius check out and gave me these trouble codes couples battery's low he has a red triangle ....
P0A78
P3000
P0A80
P03014
P0315
The battery's rating 13.5 volts. Will always trouble codes go away after replacing the battery I added inverter to it because it was it was dying after 50 miles per hour then it slowed down??
View 3 Replies
I recently cleaned all of the corrosion off the copper bus bars on my traction battery. When I got everything put back together I went to start the prius up and got the red triangle. I then remembered that I forgot to plug the master orange switch back in. After doing so I still had the red triangle so I turned the car on and off a couple times and it went away. Is this normal behavior from forgetting to put the master switch back in an attempting to turn the prius on?
View 6 Replies
I replaced the battery because I was getting the red triangle with no screen powerup. This is a slight improvement but I'm stuck as to what the "Problem" indicator on the MFD is about.
I've checked the battery in maintenance mode, reading 12.6V.
View 5 Replies
