It has the typical Triangle of death, brake light, check engine in the dash, along with the PS, main battery and exclamation on the main screen.
The car won't start. 12V battery is newer.
when I try to check the codes on both my scanners, they go wacko. One refuses to connect and the other goes blank, so I can't get any codes.
I plan to be buying a 2000 F250 V10 in a couple of hours.
I had my boss run by and take a picture of the door tag so I could determine the axle code. What he sent me was this:
Other than giving me the knowledge of how bad of a photographer he is, it doesn't tell me much else. The axle code area is blank, what gives? Am I just going to have to crawl under the truck when I get there after work?
I have a 2005 Sport trac, just recently, I started my truck and my check engine light was on and my trip counter and odometer went blank, not off, just dashes going across the panel. I recall noticing that my rpms were a little high. I turned off the truck and restarted and after a few minutes it came back to normal. Check engine light went off and my miles were displayed again.
A few days later, it happened again, except this time the rpms were normal, just the dashes and check engine light. I happened to have an obd II with me and I immediately scanned it for any codes. NONE. Few minutes later, back to normal. Scanned again, NOTHING. Its been happening more frequently now, every time i turn on the truck when its been sitting for a while. Like I said, it takes about 3 minutes or so and it goes away. Nothing unusual happens during this time. Motor sounds fine and runs smooth.
A friend who is a mechanic told me that it could be a ground cable for the COIL? that could be loose or damaged? He said its more than likely a ground because it happens when its cold and takes time to warm up and goes away. That if it was a hot it would happen all the time. I have searched online for something similar and have found similar problems but no exact match. I just changed the motor about a week ago. I had problems with the timing chain and broken oil pump.
Due to the amount of damage, cost and time to repair and amount of miles on the truck (180K) I decided id be better off putting in a new(used) motor with 67K miles in half the time for labor. I dont think this makes a difference though, because the first incident happened about a week before the truck broke down and the second about two days before. So Im guessing that the change of motor has nothing to do with it.
I am unable to connect to a 2005 Prius. I have an Actron CP9190/CP9185 Elite Autoscanner. I have used it many times on other cars and many other Prii but it won't connect to this particular car. ( I have a small car lot and keep 8-12 2004-2009 Prii in inventory) I tried 3 other Prii that I have on my lot and they connect immediately and power up but this one won't.
When I first got this car in it had some lights on and I hooked it up and it worked intermittently. I had to hold the connection just right or I would lose connection. This car had some aftermarket Bluetooth or GPS system that was removed before they traded it and I had my mechanic remove the bird's nest of wires next to the OBD connector that weren't connected to anything. This was about a month ago. This car is a 2005 with 129k.
I had the battery rebuilt before I sold it. The new owner has put over 2000 miles on it since. Now the CEL and triangle are on again and I am trying to see what the codes are but can't connect. Is there a fuse that powers the connector? or is one of the pins a power supply?
I took the Prius on a ski trip and halfway to our destination the speedometer display went blank and has not yet come back to life. It was fairly cold outside (-5 F) and I have seen other people blame the cold weather for a Generation II Prius.
View 19 RepliesThe MFD in my '04 has gone blank. Completely. Not the intermittent or weird problems listed in the infamous TSB, just Blank! I get the Prius splash screen, dimly,for about a second, then... nothing. However, the functions still work! For example, touching the screen at the approximate spot where, say, the fan control would be... and the fan setting changes (and you hear a beep). Car has only 40K miles....
View 5 RepliesThe battery went dead on my 2010 Prius and when I had AAA jump start the car the clock plus the display with odometer, mpg, hybrid battery graph etc, no longer light up. Everything else seems to work.
Is there any easy way reset it other than taking to the dealer? (Could a fuse have blown etc.?)
My scan gauge has begun to go blank every minute or so. Any fix?
View 5 RepliesScan gauge II keep going blank !
View 4 RepliesiPhone 5 won't connect through USB
View 3 RepliesI don't like the idea of Safety Connect, and already have AAA membership. How can I disable Safety Connect? I'm only a few months into a trial membership, do I call toyota to cancel? Or can I just disconnect some fuse?
View 9 RepliesMy wife on her way home from work called me to say that the MID screen was blank - not working. I asked if she could drive the car, she could, but the energy monitor screen that she has on usually was not coming on. Her concern while driving was that she could not tell how fast she was going.
Fortunately, just a week ago I had installed Scangauge II in her car and had her convert one of existing gauge to MPH. This is a new 2012 Prius IV that is about 2 months old. I'm pretty sure that MID can't be turned off.
Went to a meeting one evening last week with my 2010 Prius, everything working well. After the meeting we drove away and noticed that most of the dash display was "dark". Driving home and feeling a little gloom as I wondered what it might cost to fix the display problem.
I noticed the poster announcing the meeting we attended was laying on the dash and was pushed up to the display screen. I pulled the poster back an inch and the display came back on !! Pushed it forward and when it got within 1/2 inch of the display, it would blank out ??
It appears the dash display is some sort of bottom projection system to the display screen. Pushing anything up to the display screen blocks that bottom projection and blanks the screen.
I have a 2008 Prius, MFD died one day, screen completely dark and all buttons on it are unresponsive. I used a voltmeter to check the 12v battery which had troubles last winter (had to jump it once) and it was at about 10.6v so I just replaced it with an Optima battery. Sadly the MFD is still blank.
The MFD actually came on for a second a couple weeks ago which led me to believe it was still functional and just not getting enough power from a failing 12v.
How to connect the EVSE without charging? I'm planning to be away for a couple of days and I want to leave it plugged in but keeping the battery empty. Then I want to start the charging remotely so that when I get back, I can immediately drive off with a full charge. Unfortunately, I haven't been able to figure out a way to connect the EVSE w/o charging.
View 7 RepliesI have one of the versions of TS and Mini VCI. I've been trying to get this to work for weeks. I've uninstalled, then reinstalled the driver and the software about a dozen times. Figured it must be a faulty cable. So I ordered another cable(BTW, the first cable is an X-Horse, the second cable is a Mongoose.) Same result with the second cable.
I have the X-Horse firmware updater tool installed, so I can check that the cable is indeed recognised by and connected to the computer. When I launch TS, I check the setup, and can see that TS recognises and is connected to the cable. But when I try to connect to vehicle, I get the "Cannot connect to VIM" error.
I'm looking to run a refrigerator, a laptop and a lamp during a power outage. What inverter I would need and how to connect it.
View 10 RepliesI bought a fully loaded 2004 Prius last summer with Navigation and bells and whistles. (I love it - even with 110,000 miles!) At the time I had a 3G Iphone (AT&T) and the bluetooth worked for phoning and the cord that came out of the compartment under the stereo worked for me to plug in my phone and play music. Of course there was no music display and I had to get the music going first and I couldn't view it at all while it was plugged in. (Meaning if I wanted to see the song or change to a new playlist I had to unplug it.) But nonetheless I was STOKED to have my iphone music playing. It also charged my phone.
A few months I upgraded to an Iphone 4S, and now when I plug my phone in I can't play ANY music!! (Bluetooth for phone works fine.)
Questions:
1. So I always assumed the cord came with the Prius although I guess the first owner could have put it in? Do that model came with one?
2. Most importantly: How can I play music from my 4S phone the simplest easiest way.....
I have a Sprint HTC Hero. It worked fine on my Prius. I upgraded the phone from Android 1.5 to 2.1. I thought all was OK because the phone would connect to the car. The problem is that when I make a call or someone calls me everything looks OK until someone talks. Nothing. No voices. I can't hear the other person and they can't hear me.
View 6 RepliesI was able to pair a Sky 4.0 (Android 4.2.2) phone to my 2014 Prius 3, but can not establish a connection.
View 2 RepliesThis is a video on how to connect smartphone to toyota prius head unit via bluetooth, it shows the steps in details on both the car and the phone for easy connection. I hope its useful.
View 9 Replies