Prius (Gen 1) :: 2002 - Replace MG2 Without Removing Transmission
Dec 21, 2013
I am trying to replace the MG2 on my 2002 Prius. I have to lower the Engine to get access to MG2. I have already lowered suspension member (sitting on ground with rack on top of it but still connected on sides), removed the torque rod and moved the inverter enough to get access to the LH engine mounting nut. My plan is to start lowering the engine from LH side to get access to MG2 without removing anything else. Is this going to work or should I remove more things?
View 3 Replies
Advertisement
The molding around my windshield on my 2007 Prius is looking pretty bad, looks like dried out Sun damage but doesn't leak. Is it replaceable without removing the windshield?
View 3 Replies
Just bought a 2010 Prius II. The engine was overheated. Question, is there enough clearance to remove the engine alone, or will I need to drop the engine and transmission as an assembly? Looks Ike there is room. Mechanic at the dealer is telling me there isn't.
View 11 Replies
How to take the door panels off ? I have to take mine off to replace the mirrors the wires run into the panel. Just thought id ask before I have at it.
View 2 Replies
Need to replace fuel pump. How do I remove seat bottoms.
View 5 Replies
I have a 2009 Camry XLE with the split reclining rear seats and the retractable (stupid) sunshade. I bought new 6x9's to replace speakers all around (Infinity 9632) with adapter plates. Got the door speakers replaced easily enough, but for the life of me I cannot figure out the rear deck. It is all one piece of plastic, no removable speaker grills. And of course the speakers are screwed in top down. Most of the posts I have found on the internet are either for previous gen Camry's or people who have the folding down rear seat.
So after a lot of manual labor I was able to remove the back seat completely and the center console. I can pop the front of the back plate up and peek in, but cannot get it to come out. I think something is odd with the models with the retractable sunscreen and reclining seats.
I have scoured the internet endlessly. Closest post I found was "take off the rear side panels (by the back window) and the deck should pop out. There are airbags in there, not very keen on forcing anything.
The car has the "premium" JBL sound system which I found to not be so "premium" and was a serious step down from my last car's factory stereo.
View 6 Replies
I am in the nasty position of having to remove my 6-spd manual transmission to investigate the nasty whine in it. The dealer says $2300 to fix it and the parts are $100, so I am going to do it myself. I have been unable to find a repair manual yet for the 2010 Camry and I was wondering for step by step for removal of the tranny. I don't need a lot of detail, but it is nice to know the order in broad strokes.
View 7 Replies
How do you remove the front seat in a 2002 Passat?
View 2 Replies
I'm a rural mail carrier and have been looking for a Sport Trac for a work truck. It's size seems to be ideal. I recently found a 2002 model in excellent shape but it has that large console down the center that has an a/c duct in it for the back seat. For me to be able to use this truck, that would have to be completely removed.
Is this possible? I really need to know as that is the only deal breaker I have with this otherwise fine looking truck.
View 14 Replies
Several times it would have been nice just to pull the plastic grills off and clean out the bugs. What are the details on how you can do this?
Using a tube to vacuum tube through the grill holes can result in bending the fins. Attached is an example hack at a coin op on a road trip. Need a better way.
View 6 Replies
A small piece (triangle shape, about 1/2 inch in the base and maybe 3 inches long) of gasoline station paper towel got stuck in transmission dip stick and went inside the transmission when the dip stick was put back. It happened very quick. When I pulled out the dip stick, the paper towel piece was gone. I'm assuming it went in or stayed in the tube where the dip stick is housed. Drove the van about 230 miles to go home in a combination of highway and city driving. So far, no change in transmission performance.
1. Is it harmful to the transmission and if so how could I remove the paper towel debris?
2. Will changing the transmission fluid and filter (not flush) work?
(Btw, I read that it is not a good idea to do a transmission flush for cars with 100K miles or above) I'm hoping the paper towel piece will disintegrate in the fluid and therefore I don't need to do anything. Or perhaps if it doesn't integrate, it will remain harmless.
View 5 Replies
06 6.0 How do I remove the trans cooler lines from under the truck? I've got the lines hanging free they're unscrewed from the transmission and trans filter but I can't seem to snake them out to replace them. How is this accomplished?
View 7 Replies
Took my 2003 Honda civic hybrid to a budget tune and lube. They said that I needed my fluid changed, I agreed, they changed it (did not flush it). It has 95k on it. Later that night the car broke down, I took it to honda they're telling me that I need a new transmission, there are pieces of a chain in the fluid that they drained. Supposedly the budget tune and lube used a CVT fluid called "Full throttle" honda is telling me that you cannot use anything but honda fluid and the tune and lube is not taking responsibility. Could this have destroyed the transmission?
View 18 Replies
I have a 2008 Honda Fit. It is a manual transmission. I'd like to convert it to an automatic. Is this possible?
View 15 Replies
I have a 2002 Prius can't find the posting for the older Prius' second battery is dead need to get in to garage to change battery how to unlock trans?
View 4 Replies
2002 F150 5.4... I thought that I saw on here before a link that explained how to replace the heater core without removing the entire dash console. Looking for a link for this or get some good directions on how to replace the heater core?
View 1 Replies
96 3.1 V6 grandam se......I need to replace the transmission mount on the drivers side of the car. This is the one with the rod mounted on the transmission the goes thru the transmission mount thats bolted to the car frame....I see 4 bolts holding the mount and one center bolt thru the rod to hold bushing in place. cant get the mount to clear the cars frame..
View 3 Replies
I have a 1993 F150, 302 with E4OD, I've replaced most everything I can think of to address the engine bogging in reverse (TPS, EGR, VSS, replaced the trans filter, tune-up and MLPS). It does not bog every time and seems to do it more when the engine is warm.
I pulled the ECU and opened it up. There was nothing obvious inside that looked burned, damaged, etc. Since it is almost 20 years old and the truck has 197K miles, should I go ahead and replace the ECU as well??
View 2 Replies
Would it work? I saw this on CL 2000 Ford F250 6 speed manual 2wd transmission. It says it is for 2WD but I don't think that matters because the transfer case is what make it 4WD anyway right?
I don't love automatics. With a manual trans, some new gears and the dully conversion this thing would be like driving a giant sports car. Any computer related problems?
View 14 Replies
We have a 2003 Honda Civic EX with a manual transmission (5spd). Two of my daughters are close to getting their drivers license, however, they don't drive stick and are hesitant to learn how. My wife is asking me how difficult or expensive it would be to have an automatic transmission placed in the car so they can use it. The car is in excellent shape. It only has 67,000 miles. Is this feasible? Why or why not? If it is feasible who could do it?
View 19 Replies
I would like to know how to replace the front parking lights on a 2002 745 i .
View 3 Replies
