2015 prius package 5 w tech package and HUD display, I found a flasher mounted up between the fuse box/ module assembly mounted on a clip! I have a led replacement flasher, but clip mounts and pin locations don't line up? I watch the video but I have nothing in area! Or I just need to install the resistors? Or it could be a combination circuit assembly where multiple function module all in one ?
View 1 RepliesExactly where that part is, pictures would be useful. Pretty much just had my whole dash apart with no luck. Switched to leds, and can't stand hyper flash like I thought I could. Trying to pull it to make sure I order the right part to correct it.
View 11 RepliesSo with 172,000 miles my truck has started a new trick. When I turn on the turn signals theyll flash or interrupt normally for a few times then stop. After I turn the signal lever off and back on again they start to flash again only to stop after several times. This happens to both the left and right hand sides. The emergency flashers seem to work alright. Is this a function of the indicator flasher SF631? If so, were exactly is it located?
View 5 RepliesWhere is the signal flasher relay located. I can hear it but can't track it down.
View 5 RepliesI towed my friends car hauler yesterday for a short distance for him. I had no turn signals or 4 way flasher while towing. After dropping off the trailer still no signals or 4way flasher. I parked and checked fuses all were good and signals started to work. But still no 4ways. Any thoughts on what to look for. Never had this before. I have blown a fuse before and always been able to find and fix.
View 13 RepliesI want to install some LED turn signal bulbs and lights but the flasher will flash twice as quick because of the burnt-bulb detector.
I have taken the flasher apart and tried all the tricks on the book to isolate each pin on the IC and changed the timing resistor without avail. I do not want to put in load resistor on the bulb end to fool the detection circuit.
I want to modify/cut off the detection circuit?
I have an '07 Azera and the turn signal sound is intermittent. The signals flash normally, but sometime I hear the flasher sound inside the car and sometime it is dead silent. Cannot seem to correlate it to temperature or other factors. Any way, I assume as the lights flash with no sound that either the flash or the sound is electronically generated, but cannot be like an old school mechanical flasher. What makes the flasher sound in the Azera and where is it located?
View 1 RepliesMy 97 F150 4X4 's turn signal flasher buzzes all the time except when brake is depressed or turn signals or hazard signals are active. The flasher is a 5 prong one. What to check?
View 9 RepliesI'd like to put in a louder turn signal flasher on my 2007 F150 - where is it located and where I can get a louder one ?
View 1 RepliesTurn signal flasher doesn't work in the heat. What gives?
All lights work. Turn signal stalk works fine. It just flashes a couple of times, then stays on. Everything works fine in cool weather, but it rarely works at all when the temperature outside is above 90 degrees. Very annoyed.
I have a '97 AWD and my brake light, turn signals and emergency flasher have stopped working. I've checked all the bulbs, checked all the fuses (under the dash) replaced the flasher just in front of the fuse box...nothing. All the running lights work, and the 3rd brake light above the rear door window works.
View 3 RepliesWe have a 2015 Sonata 2.4 Sport that has developed an intermittent turn signal problem. When the left turn signal is turned on, the right signal will blink. When the right signal is turned on, nothing blinks. A new symptom that recently started is sometimes neither turn signal will turn on regardless of the position of the turn signal stalk. I managed to get the car to dealer #1 while the LEFT=RIGHT & RIGHT=NOTHING issue was happening but while troubleshooting it, they ran across an inactivated aftermarket alarm system that dealer #2 that sold me the car had installed. I guess the alarm they install is so cheap, it's not even worth removing if they are unsuccessful in upselling you at the time of purchase.
Since dealer #1 would not troubleshoot any further unless the alarm was removed, I retrieved the car and took it back to the original dealer #2 I bought it from. They removed the alarm and the turn signals started working again, however, this lasted about 2 weeks before the symptoms returned. I booked an appointment at the dealer #1 to bring the car in & half way during the drive there, the turn signals started working again. With nothing to show them, I didn't drop off the car. Now the problem is back. Since it tends to come and go, I have try and time when I can drop the car off so it's happening when they get it.
I'm having an electrical issue that is driving me nuts. I have an '01 F-250 Super Duty that I just put a new battery in today. The truck normally runs great, I drive it to work everyday with no issues. Today, there is a noise coming from under the dash that sounds like the turn signal flasher, and the clock on my radio flashes in time with the noise from under the dash. All my lights are working ok, and all the idiot lights come on as usual when I put the key in the ignition and turn it to the on position. However, my truck won't start. It won't even turn over. I get nothing but a dead switch when I turn it to the start position. The starter solenoid doesn't even click. Like I said, yesterday everything was just fine. I knew my battery was going bad (6 years old), so I changed it.
View 4 RepliesI am planning to install the WebElectric DRL-2P ( Sequential Turn Signals, One Touch Turn Signals, Challenger Sequential Taillights, Sequential Tail Lights, Mustang, Dynamite Stick Sequential, Pulsing Brake Light Pulser Flasher, One Touch Convertible Top, Dynamite Stick, One Touch Turn Signals, Dayt ) which uses the front turn signals as a DRL. Because the turn signal lights will be on all of the time, I am going to convert the turn signal bulbs to LEDs.
This will require changing the turn signal flasher (I don't want to use a resistor because of the current draw and heat issue), since the LEDs are seen as a burnt out bulb and causes a quick flash. What is the location of the turn signal flasher on the 2010? There is a thread for the 2009, but I am not sure it is the same. I would rather not take panels apart until I know that what I am looking for is underneath. What is the correct flasher to use? The closest I have seen is: LED Flasher Unit CF18-08 Specifications
One final question: Where can I locate a circuit in the engine compartment that I can tap into which is live only when the car is in the "Ready" mode. I want to use this as the trigger to turn on the DRL circuit. I have seen people suggest the windshield washer circuit, but was wondering if there is a better choice.
Just wondering if its possible to have 2015 Sonata SE Headlights to turn Off when turn signal on and turn On when turn signal is Off...
View 6 RepliesWhere the turn signal relay is located? I want to change my stock turn signals to LED. However, I don't want to use those "load resistors" or "cancelers". iJDMtoy sells an LED relay for the 14' IS (confirmed). After looking through the manual and at all 3 fuse/relay locations I can't locate it.
View 3 RepliesI need locating a wiring diagram for the GX 460 to accomplish the following.
(The wire must be connected to a point that is at ground voltage when the turn signal is ON. You must find a point that is ground when the turn signals are on to make the unit work.)
I cant find the location of the Turn signal relay, its not in the Relay box under the hood nor is it on the fuse panel under the dash, i'm planning on installing LED blinkers and i want to switch out the relay to a LED compatible one, where it is?
2008 Santa Fe GLS ....
So I had to replace a front ten signal bulb the other day and with almost no pressure, one of the small plastic tabs on the bulb socket broke off when I was trying to seat the new bulb into the headlight housing. The plastic socket looks like it's own piece that's removable from the wiring harness, but my dealer tells me it comes as a kit with the whole headlight housing and I'd have to replace the whole thing.
View 1 RepliesI have a hearing disability called Hyperacusis. if its possible or knows how to disable the turn signal sound as it causes me physical pain in my ears. Its for a 2016 model.
View 4 RepliesLong story short, my truck's front turn signals and rear turn signals/tail lights won't work. I am thinking that the relay is burnt. Whenever I look in the manual I can't seem to find the location for this relay. Is is built into the flasher?
Also, I am just assuming because the rear turn signals and tail lights are the same bulb that fixing this should clear up both problems. Am I right in thinking that?
I have already checked all of the fuses. Also, the Hazards don't work either.