I have a 2012 prius c and just replaced the body control module - no problem there, but now the ac and fan will not turn on. Fuses visually look ok (I don't have a tester) and they had been working previously. I live on Molokai - no prius mechanic on the island so I do my own repair when I can - how to diagnose the problem?
View 4 RepliesI bought a 2012 Prius C with 17,000mi on it in February this year(2015). The body control module apparently went out about a month after buying the car. The start-up screen would not say "ready" and shortly after turning the power on, the warning came on: stop the car immediately, something wrong with hybrid system, get to nearest dealer, etc.! it also appeared there were suddenly a number of other malfunctions in various systems as various warnings came up, one of which concerned the power steering.
View 3 Replies2000 GM Buick Regal. Parked the car overnight and in the morning could not start the car. Mechanic said the BMC memory was completely lost. I would like to avoid this happening again. Car battery is 6 months old and strong. What would cause a total memory loss in a BCM when parked in a lot overnight.
View 2 RepliesI own a 2014 F-150 XLT 3.5 L 6 cyl Twin. Saturday afternoon I tried to start the truck once and it didn't start like it normally does. It started on the second try, but the A/C didn't work and I got a "Starting System Fault" warning on my screen. When I shut the truck off, it would not start at all. All the lights and gauges worked, just no start.
Had to tow it to Ford Dealer, where the service department had already closed for the day (of course). Today it was determined by the service department that the Body Control Module had malfunctioned. I was told that the tech tapped on the control module and the truck started. Now waiting two days for a replacement part to come in. Luckily, I'm just under 36K miles and three years. Is this a common occurrence?
2004 Hyundai Accent
- Car won't start ...
- Remote key unlocks the car fine
- When put the key in the ignition and turn 'on' the little key indicator on the cluster doesn't come on.
- Left overnight and tried again in the morning, key indicator come on and then disappeared and wasn't able to start car.
- Key indicator now won't come on.
I spoke to mechanic and he said replace the immobilizer control module and reprogram key..
2004 f150 - Airbag light was flashing. Received recall letter. Dealer replaced a wiring harness. Dealer did not confirm functionality of airbag prior to leaving shop. Light continues to flash. New diagnostics from dealer says error code 1885 - the control restraint module needs replacing in P&L. Does the code match the fix? Can a novice mechanic replace the module?
View 2 RepliesI would like to know where's the tpms control module located ... I got a camry se v6 ...
View 2 RepliesI have a 2012 6.7 with a Spartan tuner. Threw this code a few months ago. Reset everything, trucks runs great, no issues. Never had this code come up again. I've looked it up and it says, "Internal Control Module Torque Performance". I'm just not sure what this means.
View 2 RepliesGot told by the dealer I need to replace my Mass Air Flow Sensor...to the tune of $657 dollars. And get a throttle body cleaning.
View 14 RepliesThis is a 2008 Prius with no check engine light or other operational issues. The car runs fine. When doing a health check with a Techstream scanner (new toy), it shows the code U0073 along with U0123, 124, 126, and 293. Need to further diagnose what may be wrong?
View 7 RepliesI just replaced two bad modules in my 2006 (125K mile) traction battery. I replaced one other module a year ago successfully. I installed the battery last night and tried to charge it with my Hybrid Automotive charger. The charger would not go into charging mode. So I decided to check the idiot lights on the dash - plug in key and push the power button - every light on the dash lit up and stayed lit. The battery charge indicator in the display on the dash had most of the blue bars filled. I left the power on for several minutes and the engine never started (usually does regardless of state of battery charge for a minute or two when you first power up the Prius).
View 19 RepliesI have a 2005 Prius Gen II with 114,000 miles on it. I was driving last week when it suddenly displayed a Christmas tree of lights that included VSC and the triangle of death....and of course the battery fan kicked into high gear.
Hooked it into a OBD II scanner:
P0A80 "Hybrid battery pack over temperature"
P3019 "battery block 7 becomes weak"
P3000 "DSL solenoid circut low"
P0300 "random misfire detected"
P000A "engine position system performance- bank 1"
Also C1241, C1242, c1249, c1259, c1310, c1357
I went ahead and cleared the codes. The angry lights went away but came back within minutes of driving. The car went into limp mode but I was able to make it home.
02 f350 5.4L Where is the body control module located?
View 1 RepliesHow to fix SES P0670?? I understand there's a whole procedure on checking fault.
P0670:GPCM Glow plug control module control line failure. Open/grounded circuit, open/shorted GPCM, failed PCM
But how did you resolve problem? replaced GPCM, found open circuit, short --if so where?-- or replaced with updated harness.
(4C3Z-12B568-AA connector upgrade kit as in picture)???
Looking for info on replacing ABS module themselves? I was wondering how difficult this job can be.
View 4 RepliesI need to replace the body mounts in my Ex. How do you do it?
View 14 RepliesThrottle body failures on the 5.4L 3v are more common than you think, luckily it will pop a code for the throttle body more often than not working with diagnosis. Symptoms include start and dies, no start, a really rough idle, surging idle up and down more so in park, poor brake assist due to rpm fluctuation and wrench light on. How to change the throttle body and reset the pcm to learn the new idle trims. [URL] .....
View 2 RepliesWhile driving home my yellow wrench light came on and I had no power at the pedal, even though the engine was idling smoothly. This happened with no warning and went away when I turned the truck off and restarted it. About 4 miles later it did it again. I immediately went to a nearby dealership only to find out my electronic throttle body needs replaced. Needless to say at this time of year 500+ dollars is not readily available, although I need my vehicle for work.
I do not know a thing about ETB's but did a little research online and found many aftermarket ones at a much better price than Ford's(surprise). My question I guess is what are my alternatives to factory replacement? Can I remove and clean this component or replace it with something of better quality? I'm not into high performance with my truck but if I could get a little better throttle response or gas mileage I'm all ears. My truck is a 2004 Supercrew 4x4 XLT w/ 5.4 Triton. Around 74,000 miles and well taken care of. Miles are nearly all highway.
2004 Prius, 98K miles ... I recently replaced the coolant control valve (received code P1121) and added coolant. Trouble codes were cleared. I am now getting the red triangle intermittently. When I drive the car, after a few minutes, the red triangle comes on. I can shut off the car, and turn it back on, and the red triangle comes back after a few minutes. The car seems to drive normally.
View 3 RepliesI have recently had a problem with my 2004 Prius - the brake lights came on while I was driving (both the red exclamation mark and the orange exclamation mark to the left of the speedometer) ...
The Toyota service center told me that I need to replace the skid Control ecu - the part number that they quoted is 89540 47050.
I own a VW GTI 2010. I replaced my abs module from 1K0 907 379 AM to 1K0 907 379 BE which is compatible with Park assist 2.0. I tried to code it with the previous coding with 00 added at the end but it got rejected. Since, then I've been trying very hard to code it.
I've tried at least 20 different coding some on which were provided by "16 D", a member friend in the forum, but they were all rejected. I still don't understand why other people were able to recode their module with the same previous code with 00 added at the end but I cannot. Is there any chart for generating such long coding?