So I got my 2012 Prius started worked for a while, then loss of power and got this code P0A0F. A big black cloud also came out of the exhaust. What it means?
Just changed the oil, there was way too much of it, it also smelts like petrol and now I'm going to get new spark plugs as they are in very bad condition and are wet.
I went to the workshop of Toyota in Iraq to repair the car. But do not have engineers repairing Prius cars. And they examine the device to detect faults only... These numbers faults
(P0A0F)Engine failed to start.
(P261C)water pump.
So I replaced my battery about 20k miles ago, so I know that's fine. I always throw a P0420, but I'm told that's fine too. So I was driving, and I lose power suddenly. The red triangle comes on, and I plug my scangauge II in, which tells me it's P0121, or the throttle body sensor. I reset the codes to make it home - my battery DID charge just fine on the way home, making it up to a 63.5 state of charge. Now when I start it, and press the gas, it tends to rev up, rev down, and repeat. I haven't gotten the red triangle again yet but I also haven't driven it since then.
View 2 RepliesReally scary, had my son in the car. Dash read "Check hybrid system". Reading some posts make me think that it may just be the 12V. Had it towed to my house.
60k GEN3 2010 Prius III
I have a 2005 Prius. After driving home from a 95K routine maintenance inspection, the car (with the display indicating 50% in the gas tank) went to limp mode and then stopped entirely and had to be towed back to the dealer. The codes pulled were
P0A0F (Engine failed to start)
P3000 (Battery control system)
B2799 (Immobilizer Malfunction)
P3190 (Poor engine power).
The techs concluded that the car was simply out of gas and the display incorrectly showed I still had gas in the tank due to a broken sender in the tank. They also said they added 1 1/2 gallons, and the car ran fine again.
However, I keep meticulous records of when I get gas, and according to my numbers I had at least 5 gallons left in the tank. Sure enough, the tech topped the tank up, which only took 4 gallons, so clearly my tank was not empty when this happened.
I was driving my 2010 Prius on the Highway (less than 2 miles) and the engine check light came on.... shortly after the ! (triangle with exclamation light came on and then started flashing). I exited the highway and was going back home. On the way home, I noticed a decrease in acceleration and then a message 'Hybrid...'
I was able to coast into an apartment complex and then got a ride home.
After about a couple of hours, I went back to the Apartment Complex. I reviewed the manual and one of the options was to check the gas cap. I filled the tank up last weekend and haven't driven it since today.
My 2011 has 62k miles and has been throwing P0401 codes, which results in losing power. I assume the EGR cooler is clogged. So I went to the dealership to see if it's covered, and was told there's no warranty coverage.
I would rather blockoff the EGR cooler than repair it. I would also like the extra performance from a tuner like the MiniMaxx. I do prefer the stock exhaust and not real excited about the drone/smell that comes with deleted DPF.
Will I have issues if it's tuned with the EGR blocked off, and stock exhaust? Or am I better off doing a full delete at this point?
My car has been throwing a code P2178
P2187 System Too Lean at Idle (Bank 1) DTC.
Checked the intake, checked maf, checked injectors.
Today after leaving show n go. Stopped at a gas station (never turned off the car) leaving the gas station the car was loosing power, I thought I was in 3rd instead of first. No, I was in 1st. Driving and car was sputtering and wasn't getting any power. After a few blocks it sounded like its gonna shut off. Pulled over to the side. Car died, doesn't wanna start again. Got spark, got fuel to the injectors, discoed the sensor to maf, still cranks but doesn't start. Got it towed to NY from NJ. Still no start. Few people said crankshaft sensor, starter, clogged cat or fuel filter. Car isn't throwing any codes now (probably cuz the motor didn't start) any clues on what it can be?
I am getting a P1150 code on a 06 Prius (240k). Red Triangle and temp light come on after about 15min of driving (no heat). I have taken it to the dealer. They said the Coolant control valve (stuck) and waterpump (leaking) needed replacing. I replaced both of these myself along with the temp sensor and radiator cap, but the problem persisted.
Coolant is also shooting out of the overflow hose in the reservoir tank when car warms up. I just took it to a different shop yesterday because I was assuming I could not get all of the air bled out of my system. They charged me $200 and said there was quite a bit of air in the system. The first thing I did when starting my Prius was to check the heat, no heat. I drove it home and immediately noticed there was yet again coolant spitting out of the overflow tube. I didn't want to believe this was happening again. I drove it to work this morning (15min drive) and the red triangle and temp light came back on.
I now have been driving it with the radiator cap loose so the pressure does not build up and spit the coolant out. This works for short drives, but I've noticed my coolant is disappearing quickly. No visible coolant on the ground or anywhere in the engine bay.
2004 2.4L Hyundai Santa Fe here, died whilst travelling, lost all power and then wouldn't start. Sounds like its trying to turn over.
The fuel cut off seems to have been activated as it clicked when I pushed it but the car still wont start.
I do not have any engine management lights but when connecting the code reader I got P0320, however the code was stored but not present... and still the car will not start. I cleared the code and the code didn't re appear but the car will still not start.
As the code isn't immediately present does this mean the sensor is at fault or do I have other problems?
When I bought the car a few weeks ago, there was a p0507 code for a high idle in park, about 1300 RPM, but sometimes shooting up to 3000 when I shifted into park and then dying down. The code goes on and off intermittently. Not that big of a deal at first. Then I started noticing that if I revved it in park it would take forever to die down to 1300, and sometimes would fluctuate around 2000. I also noticed hesitation while accelerating around 1500 RPM and the transmission hunting for gears while accelerating, as well. I noticed my throttle cable was very slack so I tightened that, and bought myself a throttle position sensor, thinking that might be the problem, but didn't install it yet.
I was driving on the freeway yesterday in cruise control and then I started losing power while my foot was on the gas. With my foot on the gas, the throttle would cut out every second. I was basically one second of throttle, one second of no throttle, all the way down the highway. Almost impossible to drive. This continued even after I turned cruise control off. I limped my way to Home Depot and installed my TPS in the parking lot, and drove most of the way home with no issues, although I still noticed a slight hesitation while accelerating. Alas, I tested cruise control again and then the throttle on/off problem started again, then I could barely drive the thing, even after cruise control was off again. I'll be returning the new TPS to Autozone today, since apparently that's not the problem. What's my next move?
I had plugs and wires changed to try clear code. Car seemed to do some better but while trying to go up a steep hill car started stuttering and jerking. Power went out of car and check engine light started blinking fast. After let the car sit for bout 45mins car started running fine again and light stopped flashing but remained on. Code read cylinder2 misfire again.
View 1 RepliesWhen i got my 2000 jetta vr6 it has a CEL for misfires. Searched this board and google already. Im thinking injectors (havent checked yet) I noticed something weird the other day. At a light i get the CEL flashing. Then after a bit it will come on and stay on. I plugged in my generic reader and deleted the codes. When the CEL is on I get loss of power and hesitation. When its deleted the car runs better. I get my power back. I looked in the coolant tank and see no bubbles. Could this be the ECM? Im still going to get injectors but want to buy the gasket and anything else I am going to need to put it back together. I already cleaned the MAF, replaced some vac lines, coil pack, wires and checked plugs (gapped at .28) ...
View 4 RepliesSymptoms:
-Car "Surges" at any speed. Loss of power is significant.
-Check engine light is on , DTC code = P0420
Tried:
-Fuel injector cleaner
-Spark plugs replaced around 40k miles ago
-Checked for leaking valve cover gasket (oil in plug wells) None
Can a clogged fuel filter cause this? At idle the car is fine, the symptoms seem to only occur when car is under load (In drive). My son drove this car an it always seemed empty meaning he never put much gas in it.
I had plugs and wires changed to try clear code. Car seemed to do some better but while trying to go up a steep hill car started stuttering and jerking. Power went out of car and check engine light started blinking fast.after let the car sit for bout 45mins car started running fine again and light stopped flashing but remained on. Code read cylinder2 misfire again.
View 10 RepliesMy Nissan Maxima GLE 2000 is showing CEL with code of P1320 ONLY, and the car is running rough/or loss of power. The shop that checked for the code advised that it could be something related to Ignition, and also provided me with the system generated list of reasons for the code. Before I decide to do anything, I wanted to check what option I have to address this in a most cost effective manner:
1) Is there a quick way to check which coil would have gone bad ?
2) Is it advisable to change 1 LH and 1RH at a time, and see if it fixes the problem ?
3) Could it be cam shaft sensor that could have gone bad ? Are there any symptoms of cam shaft sensor failure to isolate it to one way or the other ?
So I'm not sure if I bought a lemon, but i picked up a F-350 6.4 Turbo Diesel two days ago and the check engine light came on yesterday. It's giving me a P0088 Code as well as the P0088pd. It's got 131,000 miles on it so no warranty will cover me.
I'm tracking the TSB put out telling the techs to replace the HPFP, but they mention a loss of power. I've only had the truck for two days, but I've driven them for work before and I can't detect any loss of power. Besides the code, everything seems to be running fine.
What can I can try out before running out and changing the HPFP? I'd rather not cut so deep into my savings if I don't have to.
Having 3 new codes coming up. P0306-misfire on cylinder 6, p0158, p2272. Use my truck as a daily driver for work. Driving along before 80km/h is not to bad but can still feel a little loss of power. If i step down on gas the truck has no power and sounds like maybe cat converter is plugged. If truck is pushed to limit she will make it to her 4000 rpm and will change her gears. So i'm just glad its not tranny.
View 3 RepliesWe have a 2010 Prius with ~120k miles and a supposed oil leak; about half a quart for the last 500 miles. Ongoing for some unknown period of time. I haven't seen any oil on the ground for the past week. Furthermore, the engine coolant is very low. The dealer believes the "seepage" is due to head gasket, which would cost $2400 to repair.
This isn't my car (my gen 2 runs great), but it reminds me of my beloved 1996 Subaru which had to be let go because of an expensive head gasket and emissions failure. We expected the Toyota engine to last much longer. So far, the Prius hasn't thrown any check engine lights. Is this unusual? Any signs I can look for that might confirm the head gasket leak or suggest a less expensive diagnosis?
I've been having a problem over the past month with my base 2014 Elantra (33k miles). Sometimes when I go to start the car there is a complete loss of electrical power. One of a couple of scenarios will occur:
1) Key Fob will not unlock/lock doors:
*There is no power to anything (no dash lights, interior lights, car won't crank).
2) Key Fob will unlock/lock doors:
* Either all interior lights will be on and when I attempt to crank everything shuts off (no dash lights, interior lights, etc)
* Or Clock and radio are reset, car starts fine
* The battery checks out as far as voltage/charge.
* There are no visible fuse issues.
* There are no check engine lights.
I have had it in the dealer the past 4 days and they haven't been able to reproduce the issue. So far I have been able to eventually get it to start by opening and shutting doors, which would lead me to believe it is a loose connection somewhere, but again the dealer hasn't been able to diagnose anything.
Ok I've been plagued with this very random misfire/power loss/hesitation problem going on a couple of months. You could drive the truck anywhere from 50-300 miles without having an encounter of this problem. It seems to do it now mostly on contiguous long trips over like 30 miles. It one time threw up a P1131 code which quickly went away on it's own. This is a list of stuff that has been recently changed: plugs, wires, coil packs, air filter, pcv valve, fuel injectors, tps, idle air valve, MAF cleaned, fuel filter, and egr valve.
I sprayed with brake cleaner for vacuum leaks around the intake tonight after driving a continuous 50 mile round trip it messed a few times on the way back. When I sprayed the EGR valve mounting area it idled rough when it was hit with brake clean and idled up. So there's a leak there. Or is it stuck? It will be driving normal and usually when you come to a stop the engine will start missing really bad and then when you take off there's no power at all. You keep your foot on the gas and eventually it will feel like all the power is just turned on.
If it does it while you're driving highway speeds it will feel like you've lost a cylinder but it's not as dramatic as when you come to a stop and it starts missing. I can't be 100% but I don't think the EGR wasn't leaking before I replaced it and it was still doing the same thing. I'm wondering why the Check Engine Light won't pick up an obvious misfire when you can you actually feel it. And why if it was the vacuum leak would it only start doing it after many miles of driving?