Prius (2010-12) :: High Engine Idle Speed - 2500 RPMs
Jan 17, 2011
Had a first-time issue with my car today. Background, 2010 II bought in June, just short of 15K miles, never had any kind of mechanical issue.
While en route to work this morning, I was about halfway into my 15 minute drive to work, when I noticed my engine was idling very high, I would guess 2500 rpms. It started doing it while I was driving around 35 MPH, then continued doing it while I stopped at a traffic light, and continued when I continued driving to a speed around 50 MPH. The high idle while stopped was not transferred to the wheels, so it was not a safety issue as it would be in other cars.
When I got back up to 50, curious to try something, I hit the ECO mode button and the car returned to normal. I took ECO back off and the car was still fine. I had no further problems.
I would point out that this morning was about the coldest temp that the car has experienced. Outside temp ranged from 7 to 10 degrees.
View 14 Replies
Advertisement
!995 honda accord, 5 speed. Idle is fine until the engine warms up, then fluctuates between 1500 to 2500 rpms. The idle control valve was cleaned- no change. Valve was also replaced -also with no change. Put old valve back on. Computer was disconnected after cleaning and also after each valve change.Would the next step be to remove and clean the fast idle thermo sensor? Also how do you check the coolant lines coming in. Anything else I would need to check, clean or replace.
View 2 Replies
I recently purchased a 2013 elantra.
I have noticed that there is engine vibration and noise felt in car and pedal when accelerating at around 2500-3000 rpm's before it shifts. Is this normal behavior? It just does not seem as smooth as it should be. I have only put about 600 miles on the car.
It has been very cold, but it does not go away after warming up.
View 10 Replies
I have a 1998 Ford Escort which I drove about 450 miles in frigid weather over about 8 hours in mid January. After arriving at my neighborhood and getting off the expressway, I couldn't get the idle on the car (manual transmission) to go below 2500rpm's. Further, upon taking off, the car was trying to stall, and I was forced to feather the clutch through town driving and keep the throttle up so it wouldn't stall, even with the clutch in. The weather at the time was about -7 degrees (f). The next day the weather continued, and thee car would start, jump to the same idle for 10 seconds, then drop suddenly to 500rpm, then stall out. I wrote the car off, cleaned it out over the next week, and then I tried to run the radio while doing so last weekend. I got the car to start, and run normally. I think it may be a computer issue, but it may also be the temperatures. The car has 207,000 miles on it.
View 3 Replies
I got an old 1989 F-150, manual, in-line 6 engine, with an 8-foot bed. I use it for hauling landscaping equipment, as i am starting a business. i will likely start hauling trailers with it this summer, but I also just want the engine to give me more power.
What are some things I could do to up the HP, or a better truck in general. I'm not looking to make it into a 350Hp monster, just get a little more out of it. What can I replace or add that would do this?
First, the idle dies on me when i put it in neutral, or gets stuck at 2500rpms. is this a vacuum leak, or the idle-air control valve?
View 9 Replies
I bought a 2006 F-350 4WD Lariat SRW with a little over 200,000 miles on it. The truck seems to run perfectly, except when pulling a load (9,000-10,000 lbs) down the interstate/highway. Sometimes, when pulling above 65-70 mph for an extended period of time (45 minutes to an hour) the truck will all of a sudden idle down and won't get above 2300-2500 RPMs (even if you put it in neutral and floor it). It's not enough to shut it down, but it won't let the truck accelerate as fast as normal. Killing the truck and cranking it back makes it go back to running normal for a little while, but the periods of it acting up get shorter after each killing and restarting. I took it to the Ford place while it was acting up, and they thought it was a turbo problem. They cleaned the turbo and said everything looked fine, but the same problem arose after leaving the shop. They've been stumped at 3 different Ford shops, but one said there's a 95% chance a new turbo would fix the problem. What might be wrong?
View 8 Replies
My check engine light came on today and while driving, the idle (RPM's) were very high. At about 80KMs, it was about 3500 and when I accelerated, the engine would race along with the RPMs. While stopped, idling seems fine. I couldn't get over 80KMs/Hr without the idle going too high.
What it could be? Haven't had time to check codes as it is long weekend and garages are now closed till tuesday.
View 13 Replies
2002 HD 2500 6.0 - Pulled into Wal-Mart, everything was fine. Came out 20 min later, started right up, but felt like it stalled, it was actually still running, (barely). Shut off, restarted, same. Used pedal to bump idle up to normal 500-600 RPM, it was smooth, no misfire or roughness. Drove home, approx 5 miles, and had to keep the idle up at every stop.
Could be IAC? How can I test it/What checks can I do in the darkness, by flashlight? No garage, but I do have tools, and basic test light, dmm, etc. First thought was fuel pressure, but it runs fine going down the road.
View 3 Replies
Truck: Ranger
Year: 1990
Engine: 2.3 Lima
Trans: 5 Speed Manual
Miles: 83,445
Recently Replaced:Oil Pressure Switch
Oil Pan Gasket
Crank Position Sensor
Spark Plugs
Plug Wireset
Ignition Control Module
Driver Side Coilpack
After I got done with all of this crap on my Ranger, I noticed that it was driving great! But...today I was on my way to school and BAM! My engine idle started hitting (presumably because I do not have a tachometer) about 3000RPM and lowering down to about 2500RPM and from there, every time I am not in gear it decided to fluctuate between 2500RPM and 3000RPM. Crazy style too.
Now, I got to school, and getting closer to it at a stop light the truck basically died. It was almost at 100'ish RPM. I gave it gas, and BAM. I hear a continuous hissing noise from under my hood. Haven't diagnosed it fully yet because I just got home and its 12AM.
Now, every time I stop at a light or in traffic or whatever it may be, I have to give it gas every other second, like a small push on the pedal, to make sure the truck doesn't die. Also, every time I am out of gear and my RPM's are at an 'idle' state, I get continuous hissing from somewhere, I get no power loss or anything, just really weird idle RPM's and hissing when my foot is not on the gas basically. It is strange. I think It is some sort of Vacuum leak but I am not sure.
To get a better picture of the 'hissing' noise, it is the same hissing as you would hear when letting the air out of a tire. That is the best way I could describe it.
View 3 Replies
1995 Tacoma with 2.7 EFI engine has high idle speed. When cranked cold idles at 800 rpm but as it warms up idle speed increases up around 1600 rpm. Does not idle down when clutch is fanned, have checked for vacuum leaks and have also checked most sensors. The exhaust manifold is cracked and I am not sure if this might be part of the problem. I am not convinced issue is not vacuum related but not sure of a definite way to resolve this question or issue.
View 5 Replies
I have a 2003 Malibu with 57000 on it. It recently started to high idle at roughly 2500 RPM. Could the throttle position sensor have gone bad? It will do this after it warms up.
View 3 Replies
I have a '93 Thunderbird 3.8 v6, auto trans, that was a great running car until I had the water pump replaced. So, I got the pump replaced and then 1 day later the car started to idle around 2500 rpm. It would hit about 45mph without even giving it any gas. I swapped out the mass air flow sensor for a new one. This brought the idle down a little bit. A month later, it shot back up.
View 2 Replies
I am a new buyer' bought my prius 2008 about a week ago. the is something i cant understand, when a the engine runs at idle speed, the fuel consumption monitor shows 99.9 km/liter ! ! ! and it's also calculated at the average... is it something i should worry about ?
View 6 Replies
2004 2.4l engine has high idle speed aprrox. 1000rpm.
View 2 Replies
Ranger often wants to idle at 2,500 to 3,000 rpm. I'm glad its got a clutch! This is a long term intermittent problem that is getting worse. I have replaced the the IAC twice. I have unplugged the IAC when the engine is in high idle and the engine idles normally. But, starting the car with the IAC unplugged makes car run rough. That makes me think the IAC is not getting the right voltage input from the pmc (eec). Mine is a 2002 with the 3.0 engine. Throttle plate seems to be closed.
What sense inputs does PMC use to determine idle air position? Also replaced TPS sometime ago but that didn't work either. Sometimes turning off the a/c will knock the idle back to normal but not always. Turning the car off completely usually resets idle. But the high idle comes right back after accelerating. Drove the car today and idle would stick and stay high when clutch pushed in coming to a light. However. as the car slowed to a stop the idle would come down when rolling 1-2 mph. ??
View 13 Replies
My 2008 Accent started to stutter between 1500 and 2500 rpms. Now the check engine light has come on, and the engine is idling rough.
View 3 Replies
I have a Chrysler Sebring 2005Engine cuts out at 2500 spurts stutters can't go above 35 mph...But still runs... No cruise available will not come on.. Engine light on... Which I guess from what I read is normal In "limp mode" Got it home.. Shut it off.. Starts back up.. I'm thinking cam/crank shaft sensor? Both of those are new.. And an ECM all from a prior problem.. Or fuel pump.?? Not enough pressure to keep up with demand..
View 4 Replies
When I accelerate (particularly during heavy throttle) I hear a sound that sounds like a diesel engine between 2000 and 2500 rpm's. It almost sounds raspy in nature.
View 24 Replies
1993 Geo Prizm, manual transmission: Intermittent failure to start over a two year period, gradually becoming more frequent. The engine turns over every time the key is turned to start the engine, i.e. the starter motor/battery/battery connections work flawlessly. Once started the engine runs flawlessly without misses or shut downs. The only possible problem may be the engine idle speed that seems at times to be too high even after the engine is warmed up. Without predictability, the engine may fail to start when the key is turned.
Remember the engine still turns over normally. It just does not fire up. Two options exist for my predicament. That which is resorted to the most because of the speed of recovery: step out of the vehicle and push start the car by popping the clutch. The other alternative which I have been forced to utilize before because of the physical impossibility of push starting (i.e. if I had been able to push, I would have popped the clutch to start) at the time has been to wait for a protracted period and re-attempt to key start the car. This has been successful a couple of times.
View 1 Replies
I was driving today and had just gotten off the highway. I was going at no more than 10MPH when I heard some high pitched sound. At first I couldn't figure out what it was and thought maybe it was some outside noise. It quickly got louder over the span of the next few seconds and then I realized it was the engine. I had the pedal barely down so was definitely in electric mode.
I quickly glanced at my Scan Gauge and actually saw the RPMs go from 1200's up to 3400 in no more than 10 seconds. I have never had the car rev this high, probably just 2400s when I'm on the highway going 70's. By this time I was getting very perplexed and worried, and had my foot completely off the gas pedal. I immediately pulled to the side of the road and parked (hit the P button). The car seemed to go into park mode fine and then over the next few seconds the RPMs went back down to 992, and I made it back to the house no problem.
View 18 Replies
I have a 1997 Ranger with a 3.0 v6 with a super high idle.
It idles at 2500 RPM when the IAC is plugged and a steady 1100 when unplugged. I have replaced the IAC twice now (dropped the first replacement. long story) and and have also checked for vac leaks with no results.
After about 2-3 minutes of idling at 2500 on a cold start it will drop down to 1100 (same as when IAC is unplugged), but after a 10 minutes or so drive it will idle steady at 2500 with minimal if any dropping in RPMs. This is driving me crazy not only because it sounds horrible but also because of the fact it's burning through fuel like it's going out of style.
I have checked the MAF sensor and it looks brand new (not the original owner) along with the O2 sensor. I have been meaning to check the TPS voltage to see if it's working correctly but without a working multi-meter it's making it difficult to do anything.
I'm at a loss with this right now and because of all the previous repairs i have done to it and the others that still need to be done i don't have the biggest budget to fix this problem nor the money the truck is using in gas.
View 14 Replies
