Prius (2010-12) :: Headlights Low Beams Out?
Nov 3, 2015
I noticed tonight that my low beams are both out, and they were both working yesterday. Fuse #19, a 40A in a cluster of two 30A fuses appears fine when I look at it AND my horn and backup lights work just fine too. In the owner's manual it say that fuse position #19 controls the low beams and the horn (which is working) and the backup lights. SO, that says to me the fuse is ok because the other items are working.
FWIW, I can use the high beams, but recognize they're on a different fuse anyway. Also, I replaced BOTH headlamps with new Sylvania bulbs about 6 months ago when one of them went out. Could both low beam headlamps have burned out at the same time???? Is there some other fuse that controls them both other than the #19 fuse inside the engine compartment? Could this also be a problem in the control stalk switch on the steering console?
View 6 Replies
Advertisement
2010 Prius... Both of the outside clear poly carbonate headlight surrounds have melted sections in front of the high and low beams.
View 19 Replies
I have a 2010 prius the basic model I turned the lights and both headlights went out they only worked on high beams.
I changed the bulbs no luck they still only work on high beams checked fuses they looked good is there anything else I can check?
View 2 Replies
My limited has lost it's low beams when the switch is set to head lights but not when set to marker lamps. They still shine at a reduced output then. I've read this may be an issue with the BCM?
View 1 Replies
Anytime I turn the headlights on, the high beams go on too; I cannot switch off the high beams unless I turn off the headlights entirely (I have been driving with the low beams on during the day for the 5 years I have had the car)
I can find no reason for this; I'm inspecting the fuses (with little expectation). The only thing I can think of is the control switch or wiring. I have standard headlamps, not hid.
View 3 Replies
I have a 2010 Prius IV that constantly burns out the low beam bulbs. I have replaced these at least 8 times in the past few years. Sometimes they will both fail at the same time, sometimes individually. These bulbs should last for a year or more, not months! And I do not use cheap aftermarket bulbs, they have all been OEM quality bulbs.
View 6 Replies
Started my car this morning (2010) and both low beams aren't working. When set to on, only the daytime running lights come on (and yes I made sure the light switch was turned all the way). High beams work fine. Turned car off/on but still no good.
View 10 Replies
2010 Prius owner here. Both low beams stopped working unexpectedly last night. High beams still work, but when I switch to low beams, I just get the park lights.
View 3 Replies
How to adjust the Headlights on a 2006 Touareg. I am importing my US Reg Touareg to the UK and need to adjust the beams to UK Road Regs...
View 1 Replies
I just bought our 1st. Toyota 03 celica GT 5speed.113000 well cared for miles. My biggest concern is the headlight adjustment. The high beams are similar to aircraft landing lights but the low beams seem to cross with the left side too far to the center. I found the up-down adjuster (wish it had the cab operated feature) but can't find the left-right adjustment.
View 3 Replies
I have had my 91 ST for about 6 years. Bought it with 55k miles on it and the motor blew up on me at 165k. I had the motor replaced and when I got it back one of the headlights was out (low beams). I replaced that and got nothing, replaced the other one and still nothing. Even tried swapping bulbs around and no luck. Checked fuses and all look fine.
Talking with my mechanic who did the engine work about this and he started thinking it might be the dimmer switch. I ended up getting one and replaced it, moving one wire at a time off the old one to the wiring connector. Got done and nothing still. Now my Hi-beam indicator doesn't come on either. He is looking at this again and thinks the switch might be bad but can't confirm the wiring either. The diagram he has from work shows all the wires being different colors from any of the wires in the connector, even from other pieces.
Looking for any diagram that would tell us what wire pins from the dimmer switch and other parts of the combination switch go into the connector block under the steering column.
I really need this car back soon. Having to drive my Silverado 1500 crew cab to work and that is a 90 mile round trip every day. Want my 35+mpg Celica back.
View 1 Replies
Recently got the car and after my first wash, there was alot of water inside the headlight then both my low beams went out. The next day, one of them came back on and i tested the other side with a new bulb but still no luck. What should i look in this situation? 2008 model
View 3 Replies
I recently got this car from a friend, and when checking all the lights I noticed that only the high beams work, not the low beams. I replaced the lamps, and checked all the fuses, but the low beams still don't work.
View 3 Replies
The normal lo-beams won't turn on no matter what I do, but the brights still work. The bulbs are good, the fuses are good. I've tested and changed those. They're good. 2008 Santa Fe ....
View 13 Replies
I have a 97 chevy blazer, that has no headlights. the daytime running lights, dash and marker lights all work but not the headlights or high beams?
View 4 Replies
I have a 1941 Oldsmobile and when I hit the headlight dimmer switch to select high beams my headlights cut out . My car has all original wiring and I suspect a short at one of the terminal blocks. I am unsure how to troubleshoot this problem. I cannot select my model number below I have a model 76 Dynamic Cruiser.
View 19 Replies
My headlights seem to be off. The beams are spread too far apart, leaving a dark spot right in the middle. It is a 2016 and I just noticed it tonight. I have been trying to find the horizontal adjustment. Is this it? I have tried to turn it but did not notice any difference. Which way am I suppose to turn the left and right one to have the beams move closer to each other?
View 7 Replies
So I bought an 01 GTI last week with a decent amount of things pre-modified including a Jetta front end swap? Anyway the guy I bought it from knew absolutely nothing about what had been done to the car other than the fact that there was an HID kit installed and it was set up to run high beams only.
I figured I'd remove the HID's until i drop some cash on a pair of nice projector housings. I removed them and plugged up some nice sylvania bulbs as per the OEM standard 9007, and figured I'd have no issues... They are still stuck on high beam only... What could be causing this?
View 1 Replies
I just ran into an issue with my 08 Sonata. Tonight while I was en-route to a emergency call, I came very close to hitting a dear. The low beams are angled almost to the ground and I don't know how to angle them up. I have to have my fog lights lit to see the road signs when my high beams are not on. Also need to know how to angle those as well.
View 8 Replies
I bought a used 2002 Camry (at a discounted price because of a few dings and dents) and the headlights are not working. The high beams and turn signals work but not the headlights. I changed the bulbs, checked all the fuses and got a new relay but still nothing. I brought it to an electro-mechanic and he told me the ECM was busted and that he could maybe grind it down. This seemed odd to me so I called my old mechanic in the states who said he has never heard of an ECM causing headlights not to work and suggested I install a toggle switch. Does this sound like it could work? Could I do this on my own? I'm pretty handy but am a little hesitant to try any electrical work on my car as I have no experience with electrical work.
View 3 Replies
I have a 2001 F53 chassis Coachmen Mirada. My low beams, and only the low beams, blink off and back on ea. 2 seconds, and the low beams stay on with highs on. I have confirmed with a friend who has the identical model that the lows should go off. The dip is momentary and happens regardless of anything else. The highs don't blink and do go off when they should.
The headlight switch seems to work normally. The multi function switch does turn the highs on and off as it should. Both sides behave the same. The Daylight running lights are separate and work fine. The high and lows are 2 different bulbs. Where do you think I should start checking? With previous cars I was led to believe that a headlight that goes off meant a breaker being tripped due to a short or bad breaker. I can't find a breaker to check.
View 14 Replies
