So I replaced the front strut and the popping is still there. When I removed the old strut it seemed like that would be the problem as there isn't any play in the ball joints and tie rod end.
View 12 RepliesEvery time I am on the road I get this flat noise coming from the front like if the strut was out of air or something like that. It is a very annoying sound and only on certain bumps of the road.
View 6 RepliesI noticed that it started recently and does it consistently... When I accelerate from a stop there is a creaking/popping noise that comes from the front of the car. It is difficult to pinpoint but you can make it do it every time and it only happens from a complete stop. My '12 only have 6k on it.
View 12 RepliesSo I'm coming from the MK5, MK6, & CC/B6 Passat world. On those cars, they were notorious for having the front subframe "clunk" noise. The suframe would shift back & forth, creating a "clunk." This was VW's fix: [URL] ....
Anyways....I've noticed this about 5 times now I'm on my '13 Passat V6.....when I go to back up into a parking spot. And that's the ONLY time it's done it too.
Going from Drive, I put it into Reverse and then turn the wheel a little (NOT even all the way) and hear a "pop" or creak/clunk....definitely from the front. So my guess is that it's the subframe shifting. Only 400 miles on the car too, btw.
I have some noise coming from the front suspension. It is a popping/sorta creaking noise. I hear it mostly when turning, but sometimes while going straight. It is not a grinding sound, nor is it a high pitched sound. I took it to my mechanic, but they drove it and could not replicate the noise. They inspected the front end, and said everything looked fine. But I still hear the noise. The car has a little over 40k miles on it. No problems with the tires...no irregular wear, and no wandering. I looked at the front end, and didn't find anything obvious. I cannot replicate the noise just by pushing on the fenders up and down.
View 64 RepliesWe have a 1999 Passat GLX 2.8 auto. I recently put on a new inner and outer tie rod as well as a lower forward control arm. The issue that we are experiencing is that when accelerating or braking hard there is a popping/clunking noise coming from the driver front area. When accelerating or braking normally/ smoothly it is fine. But, as I said accelerate or brake hard it will make a single pop or clunk and that is it, just once when braking hard or accelerating quickly.
View 2 RepliesI just got a H&R Sport Cup Kit installed along with new strut mounts and bearings on my 2001 GTi. My front right side strut is making a popping sound whenever I accelerate or brake slightly hard and sometimes when hitting a bump in the road. What's causing the sound? Could it be I have a bad strut? Also the left side is fine and doesn't make noise at all..
View 10 RepliesI busted a spring and apparently a strut. The mechanic said I'd need to replace the front suspension, and offered to do it for 1000$ which I thought was very high. Now I am debating whether to simply get a cup kit or coil overs. I am leaning towards the cup kit to save money. Now I am curious what you guys think regarding the H&R cup kit and where I could get the best deal on them.
View 23 RepliesRecently I have noticed a rattling noise from the left front strut. Looking up parts online I can see the strut, as well as an upper strut mount, either of which might be the culprit.
View 2 RepliesHeard popping noise right front when wife pulled in driveway. Leaving Monday on 1290 mile trip to Erie,Pa. Took to dealer to check out noise. This is result. No hassle at Dealer at all.
View 3 RepliesHere's one I haven't heard of before on a Prius:
As I was closing my front driver's side window this afternoon I heard a pop or bang, and I noticed the window was closed, mostly, but it didn't fit right and the top rear of the window was out of the frame, up above where it should be, and the front, sloping portion of the window was below where it should be.
I put it up and down a few times, and eventually managed to coax it back into position, but it didn't stay there when I opened and closed the window again. It feels to me like whatever connects the glass to the motor and gizmoss that lift it up and down has broken or come undone.
I fear that it is a dangerous condition, because the window might pop out completely at high speed. Unlike the last time I remember having a car with a window disconnected from its mechanism (the 60's or so), we no longer have window frames to make sure they stay in place when the machinery breaks. Also, it has always seemed to me that the car's aerodynamic shape puts pressure on the doors and glass at highway speeds.
Anyway, I'm going to get this in to the dealer as soon as possible, but I wanted to ask:
Am I paranoid not to want to drive it at speed until I get it fixed?
So I've had my R now for almost 6 months now and my PSS10's have been in it since day 1. I bought the car approx 4 months used with 8200kms on it. It's now at 16600km's.
Ever since I've had it, there's been a front end suspension noise that reminds me very much of the typical upper strut mount bearing and bushing noises. It's like a popping sound.
It only happens at low speed(parking lot) but with most moves like fwd, rev, turns and straight lines. The upper strut mount bearings and bushings were just replaced < 2 weeks ago, but it still does it and just as bad.
I put lowering springs on a few months ago and a pop/clunk has developed. There is a tiny lip of pavement just past my garage door and it clunks as I back out at an angle over it. Worse case I can check the torque on all of the bolts.
View 2 RepliesThis is driving me insane. I get popping and static from the front right speaker in my PIPA. It happens with the radio off. I can't make any sense of it. Happens typically at 30+ MPH. I know I will go into the dealer and they won't be able to duplicate it.
I have installed the nav bypass, but I don't think that could have any affect on it. I have also had side view mirrors and illuminated door sills installed. None of these have anything to do with the audio system.
I have been frustrated with my Elantra's handling from the time I purchased. I feel that the car is setup poorly and has design/OEM part issues.
I have improved the rear-end "hop" issue by replacing the OEM rear shocks with the KYB Gas-A-Just's -- a big improvement in handling the bumps. But the rear-end solid axle on such a light car is just crap...
I have developed quite a bit of 'clunking' noise in the front suspension.
I am considering replacing the front-end shock-strut assemblies with KYBs -- I'd love to hear if it made a big difference. Also wondering if I should change-out the 'sway bar link' while replacing the shock/struts.
I'm just so frustrated with the way this car handles (I've driven Subaru's, Honda's, and VW's) compared to other cars. I feel it's a combination of low-quality OEM suspension parts, rear solid axle, light weight, crappy electric steering settings, and tires that are too wide and too low-profile for such a light car. (I have the limited with 17 wheels).
Like the title says... Do any lowered mkvi's have any noises or popping sounds coming from your car's front suspension? The reason I ask is on my MKV R32 I had H&R springs on stock shocks and at low speed full lock turns I had a slight poping noise. Everything on the R was installed right and it only had ~3-4k miles on it when the springs were installed. After doing research it seemed like a fair amount of lowered MKV's had this noise and it was thought to have something to do with the strut bearing.
View 8 RepliesIt's been extremely cold in the northeast recently (<20 degrees), and I've noticed that my suspension has been very noisy (clunking type noises) when I'm driving on uneven roads or bumps. Is this normal? Is there something I can do to alleviate it?
View 9 RepliesI've had my R sitting on KW variant 1 coils for about a month now. When I first installed the coils, I adjusted them WAY too low for my liking (looked flawless but wasnt practical for my driving conditions). On my first couple of drives, I noticed a "popping" sound at very low speeds (like when exiting a parking spot) when turning my steering wheel. It was as though my wheels would turn to a certain point and "pop," it sounds like something popped out of place. If I move my steering wheel back and forth to repeat the popping sound, the sound does NOT repeat (it only happens once in awhile).
With the car stationary, I have looked into the wheel wells with my friends turning the wheels and I dont see anything rubbing. I have since raised the car VERY slightly (still sits on about a 1/2 finger gap) and still, when I first get in the car in the morning and pull out of my garage, I hear this slight pop.
I am planning on doing the "tab mod" on my fenders this weekend because I am rubbing on the tab on high speed turns, but I don't think this has anything to do with the popping. The car drives fine and my friends and I have installed coils tons of times without any problems.
My 2006 sonata 85,XXXX miles on the car and after putting the new rims on the car. I am feeling a bit of popping from my power steering at low speeds when turning. The Power steering has been squeaking for quite some time. I have never changed out the power steering fluid and was wondering if this could be the cause!
View 7 RepliesI just had some H&R springs installed and my front suspension is making a funny noise.
It sounds like the front springs are clanking around..
2001 vr6 manual... I have a popping noise that comes from my suspension. it is in the front, and it has gradually gotten worse over the last month or so. It used to happen when i back out of my drive way only, but now it happens when accelerating from a stop, quickly braking or turning at low speeds. Recently its getting worse and i can start to feel it in my steering wheel sometimes. It doesn't feel like a wheel bearing. Is it bushings? Tie rod? CV Joints? Strut Mount?
View 2 Replies