Prius (2010-12) :: Driver Seat Clicking In The Middle Of Back
Nov 3, 2010
I have a '10 IV and my drivers seat clicks in the middle of my back. It seems that it may be the top of the lumbar cushion going bad.
View 10 RepliesI have a '10 IV and my drivers seat clicks in the middle of my back. It seems that it may be the top of the lumbar cushion going bad.
View 10 RepliesI just got my 2013 a few months ago and this just started. I'm a little heavier than most people (230lbs), but I don't think that is the problem.
Sometimes when I make a turn (not hitting a bump) or go over a bump, I hear a clicking sound from underneath my seat (towards the rear)... Tried adjusting the seat and messing around with a few settings, but the "clicking" sound persists....?
The middle sliding seat has jammed and I cannot get it back into the regular sitting position. I don't see any obvious obstructions, but there are a couple of springs not attached, and I may be missing a connecting rod.
Any pictures of how a "normal" mechanism should look like?
I got into our car (2013 RX 450h) and the seat was completely pushed back. I had been the last (and only ) driver of our car and had not adjusted the seat. I managed to reach the brake pedal, started the car, pushed the L1 seating position and my seat re-adjusted. I then put the car into Drive and when I stepped on the accelerator, it would not move.
The parking brake was not on, there was nothing obstructing the car. I turned it off, turned it on again and it was then fine. I had last driven it 3 days prior, the battery was fine, the outside temperature was registered as 30 degrees, so not excessively cold. We park in a garage although it is not entirely closed off from the outside air.
Experienced this with the car no moving despite being in drive and stepping on accelerator?
I've noticed that when the Prius is shut off a few minutes later you hear a clicking noise from under the drivers seat. Sounds almost like a solenoid. It only happens when the car is shut down.
View 2 RepliesI have a 2014 Prius v that I bought new in January 2014. I've had this persistent rattle which seemed like it was coming from the back seat behind the driver. I've taken the rear seat partially apart and glued and shimmed things to no avail. I've emptied the entire contents of the rear storage area and it still rattled on. Anyhow I've had this rattle for six months now. Turns out the noise is coming from under the car just ahead of the rear tire where some body type plastic which juts down about 2". This piece rattles when against the frame just ahead of where one would put a jack for lifting the car. I've temporarily stuffed some old paper napkins, which were handy, between the plastic piece and the frame. Noise is gone! I'll eventually remove the napkins and then load up the area with silicone. I'm doing both sides of the car just in case.
View 6 Replies2003 Ex, EB, bench style middle row. I have owned less than a year.
Purchased with a broken latch assembly the drivers side middle row...promptly replaced for $70. Today, it is broke again, less than a year. I am going to do some more investigating as to HOW this happened TWICE.
Chipped, broken housing on their middle latch assembly? It breaks the black part first, which holds the guts in alignment....once the black part slips down or up to far...the guts do not function.
I heard a fan sound coming from the back seat after driving in traffic for 45 minutes. It was coming from the vent in the back seat. I didn't know that that vent had an electric fan. I assume it was the battery being cooled. I have never heard this sound before.
View 5 RepliesI got some manual of the internet on how to take out the bottom off the back seat. I got it off and installed the seat covers. How do I reinstall the seat. Instructions say attach rear hooks then push down to attach front. I attached the rear hooks but can not just push down on the seat to install the front. Sitting on it does not let it latch on. How to make the front latch on? This is on 2010 Prius. I got the u tubes going inside the white connectors but they will not latch on. Is there a trick? Seat is faom and Styrofoam so I don't want to just push down as I might break something. It's GT covers that I am installing.
View 1 RepliesMy RX350 is over 4yrs old with 105k km on it. I notice lately when I drive off the seat moves back a bit and when braking hard it moves forwards. It is about quarter of an inch movement but it is noticeable. I guess it is not under warranty now. I looked under the seat but can not find where this is coming from, I am assuming it must be a loose bolt that needs to be tightened.
View 4 RepliesA few weeks ago I started to notice that the battery vent fan was turning on way more than usual. I've had the car now for five years (34K miles) and I've only heard the fan go on a handful of times, even in the hot Las Vegas summers. Once I really started to pay attention to it I noticed the noise only started once I hit about 30-35 mph and got louder as I went faster. As I slowed down, the noise would get quieter and eventually stop as the car came to a stop.
This week I caved and brought the car in to the dealer to get checked out and they did an inspection of the vent, fan and did a complete diagnostic on the hybrid system and batteries. I was worried about damage to the traction battery if the vent fan was malfunctioning or clogged. I'm out of warranty with no extended coverage so I was pretty shocked that the dealer didn't charge me a dime to do the tests. All the tests came back clean and they said all the systems tested above average and that the fan was operating normally so I shouldn't worry about it.
But the noise still persists and it's starting to drive me a little batty. It has never made this much noise before. Is there something else that could be going on that the dealer missed? Maybe the noise I'm hearing is something else and it only sounds like it's coming from that area?
What maybe causing a metallic clicking from my back seat. It sounds like it's coming from the center of the rear bench seat. It happens sporadically. Just started when it got cold out.
View 3 RepliesIs it ok to install a convertible car seat, in forward facing position, in the middle of the rear seat?
I only ask because i noticed the LATCH tethers at the bottom on the left and right side, but not a pair in the middle. However, there is oddly 3 top anchors on the backside of the back seat. So the middle anchor is making me wondering whether it's ok to use the LATCH anchors in the middle position.
If it matters, we have a Britax Marathon 70. My wife wants us to drive an SUV for our trip and I want to use the prius... The huge SUV has LATCH anchors in the middle position as well as the side positions (i.e. for a total of 6 anchors, or 3 pairs, in the SUV vs. the 4 anchors or 2 pairs that I see in the prius).
Prius four with heated leather seats noticed especially on the drivers side seat bottom on the side bolster just as you slide in not the center section. I noticed it when new, it looks like a maybe wire between the leather and seat foam.
View 4 RepliesI have a question as to the sc430 reclining position.. my Sc430 will not recline far back as I would like for my normal driving position.. My GS300 reclines far back as I want.
View 14 RepliesHow to remove the back of the driver seat on ES350? I need to install the headrest DVD player.
View 1 RepliesI just bought an 05' Touareg a month ago, and already put 6,000+ miles on it (drove it to CO from PA, and back for a snowboarding trip), and im loving it.The CD player already stopped working (already being replaced), but the thing that is driving me nuts is the front seats, ESPECIALLY the driver seat.
I am 5'8" and prefer to have it at the highest adjustment (again, manual seats), or near the top at least. However, i have to put it all the way up just to know if its where i left it because it keeps SINKING back down. It averages about 1 pump per day, and more if I'm driving it a lot (because there is more weight on it). I took it to the dealer and they cannot reproduce it because they are only willing to wait around for an hour. I am going to have to leave it overnight, untouched, for a few nights just to prove it to them... which sucks because I shouldn't have to. I am not imagining things, and why would i make this up.
I hadn't adjusted it back up in a few days, and it took 10 pumps to get it back to the top where i put it in the first place! I am the only one that drives it, and no, someone isnt playing tricks on me. However, I hope not because my worst fear is that they replace it, and that its just a bad design and it still does it. EVEN MY PASSENGER SIDE SEAT DOES IT! just not as bad, or maybe it does I just don't know because I am not using it (driving of course). That is a weird coincidence if you ask me... so I am worried its just a poor rachet design. If so, I am not leaving there til i get electronic seats. I already have the service manager involved because the service rep tells me he doesn't know what to fix. Again, these are manual seats, not electronic... so its nothing to do with those memory buttons you electronic guys have.
How do you stop the seat from going all the way back on its own when you turn the engine off?
We have two kids in car seats in the back and it gives them no room to get out.
I have a '95 BMW 325. The driver's seat reclined and will not come back up... not digging the gangsta posture or the extra ab workout to sit up straight (luckily I don't have to drive very far at the moment). The motor to go back seems to work (obviously) but makes no noise when the button is pushed to move it back up. What do I have to do to fix this?
View 1 RepliesI drive with the seat slider in the full back position. I'd like to gain another inch or so....just enough to where I'm not touching the rear seat. Not worried about rear passengers. How easy would it be to either reposition the seat anchor points or modify the seat itself to do this? Also, has anyone tilted the front of the seat up a little to give more thigh support? I was also thinking of shimming or otherwise raising the front half of the seat maybe 1/2 inch to give my legs a little more support.
View 22 RepliesMy drivers seat won't disengage from the track on the right side rail next to the console.
Looking for a shot from the manual before I take it apart?