I made the mistake of lending my car to my sister who drove about 50 miles with the parking brake on.... And yes it beeped at her the whole way and she didn't think anything of it..... What kind of damage could have been done? Brakes seem to work fine although the parking brake barely works now.
View 19 RepliesHow many miles can be driven after the computer tells you have zero miles left to empty? Or rather how many gallons do you think is left in the tank after the computer says you're empty?
View 19 RepliesWhen I was at Luscious Garage earlier today for a transmission service, the technician told me that my parking brake is out of adjustment. Sure enough, I checked the factory service manual when I got home and found that the spec is 8-11 notches at 67.5lbf. My own test revealed that it was taking between 15-17 notches on mine!
View 7 RepliesIt seems about once a week the rubber cover that goes over the food pedal for the parking brake comes off. I've been careful to replace it correctly but it still keeps happening? Btw it's a 2010 v with atp ...
View 9 RepliesToday I stopped at the post office to check my mail. I put the car in park and didn't shut off the engine - this is what I always do. When I returned a few moments later the car would not go into reverse (this was after releasing the parking brake) and the traction control symbol came on. The car would go into drive but that didn't work much as I was up against a hill (or almost against it). Shutting the car off and turning it on again solved the problem. The parking space was badly potholed; I'm assuming I had less than full contact on one wheel which caused the traction control to kick in which prevented reverse from engaging. And to be clear - it's not that it went into reverse but didn't go anywhere; reverse simply wouldn't engage (I did not try neutral),
View 13 RepliesI always apply my parking brake whether im parked on an incline or not. Sometimes if I disengage the parking brake, and set my car in Drive on a flat surface, my car does not advance (I'm not pressing the gas). This tells me that my parking brake is sticking! If I apply the gas slowly, I hear the brakes "clunk" off and I finally get going.
View 4 RepliesI have been experiencing this problem for sometime now. I notice it especially when the battery shows low and after stopping at a Stop sign. Also when I go uphill.
View 17 RepliesInfo: O2J 1.8t, Peloquin LSD, clutchnet 6 puck, VF mounts
Getting a vibration on driver's side during either accel or load up a hill after driving for 20 miles. It's related to distance driven versus engine warm or cold. I can feel it in the pedals, definitely driver's side.
Things checked:
-axles, replaced driver's side, no change
-transmission is full of fluid, looks good
-motor mount bolts tight
-called Peloquins, they said the diff would cause issues while turning and would occur anytime under load, not just when cold
Wheel bearings have about 15k on them and were INA's, and those shouldn't vibrate only on accel or load. I thought about the dogbone, the poly bushings in it are about 35k miles, but makes no sense why it would appear after driving 20 miles.
I have a beautiful 1987 560SL. My husband and I bought it about 17 years ago and lovingly refer to her as our mid-life crisis car. Truth be told, we're a bit past "mid" life now and have decided to sell it and let someone else enjoy her. Last summer she started to have an annoying issue and we "thought" it was fixed, but right after I started advertising, she started acting up again.The engine simply dies while driving. It always seems to happen when I've only driven about 5 miles and going rather slow - 20 to 30 mph. She'll start back up after a try or 2 and be fine. We took her to a local shop and the mechanic said one fuel pump was shot and the other was not working properly so we replaced both and all seemed fine the rest of the summer. We garage her for the winter as we live in the Rockies and she's not the most practical car to be driving in the snow and ice. This summer she started right up and was doing well until a few weeks ago - same problem.
View 7 RepliesHad my car parked outside of work for about 12 hours yesterday, and in the NYC cold front, the parking break must have stuck on slightly. When I started to move, despite the fact I'd released the parking break, I received a warning in the MFI that said PARKING BREAK FAILURE TO RELEASE. I pulled the handle again and heard it pop just a little more off. Everything worked great after that. If I hadn't received the alert I probably would have driven off with it on. I'd probably have noticed the hesitation and checked the break again, but the alert was useful. Some of the warnings in the MFI can appear to be a pain at times, but it's amazing how thorough a job VW has done monitoring the cars systems and giving real time information if something doesn't work. You just have to make sure you don't get info overload from it all!!
View 4 RepliesSuddenly all these lights came on in a 2012 Elantra . Had at the dealer and they checked wheel speed sensors, wiring to sensors and said all those are ok and the abs module is bad. I replaced the module, bled the brakes and the exact same lights are still on with the same codes coming up. Tech is confused as I am.
View 5 RepliesWhat is the procedure for adjusting the parking brake shoes on a 2011 Rx 350? How many clicks from tight should it be?
View 5 RepliesI recently noticed that when I release the parking brake on our new 15 F-Sport it make a loud noise. It's hard to explain, but it kind of sounds like a spring being released with a clunking sound. (Sorry for the weird description).
When I press the brake to set it I am not pushing it all the way to the floor or forcing it at all. I am just using normal pressure to apply it.
The closest car wash is less than two miles from our home and we often bring the GX home directly from the car wash and park it in the garage. We've noticed that the parking brake remains applied when we start the GX the next morning, even though the foot pedal releases. Presumably, the parking brake components were wet from the car wash and enough rust/corrosion forms overnight so that the springs to release the brake can't overcome the 'stiction'.
The GX "squats and grunts" when we put it in gear, but doesn't move. Shifting into reverse solves the problem ... there's a loud 'pop' from the rear of the vehicle as the brake releases, the GX starts to move, but in reverse, which we quickly stop with the service brake, then we shift into forward and drive off ... did I mention that we back into our garage?
I may already have confessed that we are heavy parking brake users ... every time we park the vehicle, even if just temporarily while we step out of the vehicle to get the mail, etc. We use the parking brake so much that the cable stretches and every year our dealership has to re-tension.
I just installed a stereo in my daughter's 2010 Accent and tapped into the emergency brake wire to disable the DVD option when the emergency brake is engaged. Everything works fine except that the emergency brake light on the dash stays on dimly after releasing the emergency brake.
View 10 RepliesI am installing a Parrot Asteroid Smart into a 2010 XLT without sub or sync. I will also be hooking up a reverse camera. All wires are ran and the harness is built. I have two wires that I am having problems with to make everything function correctly.
Coming from the Parrot, I need to tap into the Reverse Gear and Park Brake. They are separate wires. Where can I tap into these wires? On the side of the shifter I do see three wires but I am not sure where they are going.
The other day I backed out of my garage and didn't notice that the parking brake was still engaged. The car rolled out without a problem.
Only when I put it in drive did I realize that the parking brake was on, since the car didn't roll forward. I also got an audible alarm.
Went to leave for work this morning and released the parking brake and she wouldn't budge. Had to give it quite a bit of gas to finally move, along with a big popping sound. It was cold out, and haven't been using the PB in cold weather lately but did yesterday and this happened. Is there something that needs to be done with the brake? Thought I might have to get towed.
View 1 RepliesAlways? Never? Sometimes? Depends on circumstances like grade?
View 19 RepliesI've always found the handbrake parking brake in the Prius not to be very effective (there's always a huge lurch back whenever I take my foot off the brake and I'm parked on a hill).
Today I had to swap the two cars in my driveway around. I backed out from the carport and into the street, then drove back up into the driveway. The driveway's longish with a mild incline.
I had the parking brake applied throughout by accident. (The car's new to me and I'm still getting used to the starting and stopping procedure).
Given it seems to be a pretty weak brake already, is it likely I've done any damage to it? I know I wasn't driving with it on for a long time, but in other cars with better handbrakes I've loosened the brake doing that. Should I go and get it tightened, or what?
I have the weekend clear. My husband is gone -- so no second-guessing.
I WANT to adjust the parking brake. I ordered the Chilton manual nearly two weeks ago. As of tonight it is sitting in Hermiston, Oregon, about a three-hour drive away. I don't suppose it is getting delivered to my house tommorrow (Saturday).
I have checked out a few online spots that tout instructions. They are either pretty vague, or somewhat scary. I have adjusted the PB on my old Toyota Corolla....many times.