Prius (2010-12) :: Does Reverse Beep Go Back To Default Setting After Disconnecting Battery


Feb 23, 2013

I had the reverse and seat belt beeps changed by the dealer before I took delivery. Now I want to install some mods which would entail disconnecting the 12-volt battery. With pre-2010 Prii the beeps would go back to the default settings. Will this happen on the 2010+? I don't want to make another trip to the dealer.

View 10 Replies

Advertisement

Prius (2010-12) :: How Car Could Be Left Without Disconnecting Battery

I was just wondering... I am in the navy so i'm called to go away quite often sometimes for extended periods.

I have read that the 12V battery will discharge itself if it the car is not being used frequently because it has the memory for everything (radio channels, time, trip meters, etc)

My question is how long is it safe for me to just leave the car parked in my driveway without disconnecting anything and when should i disconnect it?

View 10 Replies

Lexus RX 2010-15 :: How To Change The Default Screen Setting

Don't know how to change the default screen setting so that it stays in either radio or Media screen. It automatically reverts to map after pressing the radio or media button.

View 3 Replies

Prius (2010-12) :: Cannot Turn Off Reverse Beep?

The technician at Toyota showed me the options. You could either have a continuous beep or the intermittent beep, but you do not have the option of turning it off. I told him it was possible, but how?

View 19 Replies

Prius (2010-12) :: How To Disable Reverse Beep

Looking for the instructions for disabling the reverse beeping on a '11 prius?

View 2 Replies

Prius (2010-12) :: Way To Deactivate Continuous Beep When In Reverse?

If you are tired of that irritating continuous beep while in reverse, I can take care of that for you. I can customize your Gen 3 (2010-2015) prius to only beep once while you put your car in reverse. Process takes about 5 min and can be done anywhere. If you are around the Vacaville, Fairfield California area, we can meet up and I can customize your prius for you. Hit me up if interested.

View 5 Replies

Prius (2010-12) :: Change Reverse Beeping From Continuous To One Beep?

A couple months ago I bought a 2010 with the basic trim package. How to change the Beeping in reverse from continuous to "one beep". The owner's manual says that you have to take it to the dealer.

View 5 Replies

Prius (2010-12) :: Scan Gauge II - How To Change Reverse Beep

I could have sworn that I read somewhere on here how you can use the Scan Gauge II to change the reverse beep, but like they always say I cant find it now.

View 12 Replies

Prius V (Audio/Electronics) :: Bluetooth Audio Connecting / Loading - How To Default Maps Setting

Everytime, I get into my V I play my various podcast (via iPhone). However, its takes about a minute (as compared to my wife's RX which connects instantaneously). Why it takes such a long time? Bluetooth is always on and its be "paired".

Also, when I turn off audio, the screen simply shows blue screen with "audio off". Is there a way that I can always default to the map screen instead of going to apps --> maps --> show map? Not a biggie, but a nice to have for me.

View 3 Replies

Prius (2010-12) :: Key Battery Low Beep And Message On Display When Turn Off The Car

Everytime I finish driving, and turn off the car, I get "key battery low" beep and on display message....

View 11 Replies

Prius (Gen 2) :: Disconnecting The Battery To Change Out The Tail Light

I need to replace tail light assembly on 2005 Prius. Some instructions say you should disconnect negative cable on battery before doing this, then do some initialization after reconnecting the battery. Is it necessary to disconnect the battery to change out the tail light assembly? If so, what is the initialization process that must be done?

View 2 Replies

Prius (2004-09) :: 2005 - After Disconnecting Hybrid Battery Won't Start?

My 2005 prius will not start. We had some body work done to it after a deer ran into me. They did a small amount of welding and had disconnected both batteries. Now the car will not start. It can be put in auxiliary mode but if you try to start it with your foot on the brake, it flashes some lights for a few seconds and then goes dead. Is the hybrid battery too low to start the car? It was pretty low. before the batteries were disconnected. Or did they possibly do something wrong when they disconnected the hybrid battery? Final question would be do they have to do some reprogramming after disconnecting the hybrid battery?

View 11 Replies

Prius (2010-12) :: How To Set Auto Dim Mirror Default To Off

I have the Gen3 with auto dim mirror. The factory default is ON everytime the car starts. I prefer to keep it at Off by default because it is too dark for me during day time. I may be misreading the instructions Page 93 on the Owner's Manual and I can't get it to stay on Off by default.

View 2 Replies

Prius (2010-12) :: Screen Default To Be Audio / Not Map?

Is it possible to leave the audio screen on all the times. Usually it is the map that is always on, and when I press the audio button, it reverts back to map after a few seconds.

View 3 Replies

Prius (2010-12) :: Hum / Buzz Coming From Back End (Battery Pack Area)

On more than one occasion, when I have gone in my garage at around 5 a.m., I hear a hum/buzz coming from the back end of my Prius. It has to come from the battery pack because the sound seems to come from under the back end of the car and is not as audible when I open the hatch.

View 2 Replies

Prius (2010-12) :: Noise Coming From Back Seat Battery Vent?

A few weeks ago I started to notice that the battery vent fan was turning on way more than usual. I've had the car now for five years (34K miles) and I've only heard the fan go on a handful of times, even in the hot Las Vegas summers. Once I really started to pay attention to it I noticed the noise only started once I hit about 30-35 mph and got louder as I went faster. As I slowed down, the noise would get quieter and eventually stop as the car came to a stop.

This week I caved and brought the car in to the dealer to get checked out and they did an inspection of the vent, fan and did a complete diagnostic on the hybrid system and batteries. I was worried about damage to the traction battery if the vent fan was malfunctioning or clogged. I'm out of warranty with no extended coverage so I was pretty shocked that the dealer didn't charge me a dime to do the tests. All the tests came back clean and they said all the systems tested above average and that the fan was operating normally so I shouldn't worry about it.

But the noise still persists and it's starting to drive me a little batty. It has never made this much noise before. Is there something else that could be going on that the dealer missed? Maybe the noise I'm hearing is something else and it only sounds like it's coming from that area?

View 19 Replies

Prius (Gen 2) :: Turning Off Beep While In Reverse

Cannot any instructions of how to do it. there are a few links that are supposed to tell you, but those links did not lead me to any instructions.

View 8 Replies

Prius C :: Beep In Cabin When In Reverse?

New noise maker means they turned off that "cabin" beep nonsense when in "R"? With our ZVW30, the ONLY indication that the last of the gas is gone is the 'power flow' arrows disappear. I'm wondering if Toyota might have brought back something to let the driver know the last of the gas is gone.

View 10 Replies

Prius V :: Turn Off Beep When Reverse Selected?

Is there a way to disable the beep when reverse is selected?

View 19 Replies

Prius Plug-in 2012-15 :: How To Disable Back-up Beep

I've had my PIP for a week now My main complaint, so far, is the back-up beep, which of course does nothing for safety but distract the driver. On my 2005 Prius, which I traded for the 2012 PIP, I could go through a [somewhat complicated] procedure to disable the beep, but it doesn't work for the 2012. but any fix one can implement oneself? On general principles, I resist taking it into the dealership for the fix.

View 3 Replies

Prius (Gen 3) :: Unable To Disable Reverse Beep Using Bluetooth OBDII?

I picked up a bluetooth OBDII scanner and plugged it up, and tried following the instructions found on this forum. Only problem is, every time I run 3b ac 40, I just get a return of NO DATA.

View 2 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved