Prius (2010-12) :: DRLs Are Dead After Reinstalling Bumper Cover
Feb 9, 2013
Ok here is my situation:
After removing my bumper cover and reinstalling it, my DRLs are dead. The harness is reconnected and the turn signals distress signals work.
I unplugged the left DRL, turn signal to see if the right would work and vice versa and I still cannot get either to come on.
I checked the fuse and that isn't popped.
I turned the car to the DRL marker mode and auto mode and everything works except the DRLs.
I even took the bumper cover off again and inspected the harness.
View 3 Replies
Advertisement
2013 Prius IV.... I just noticed that my right side rear bumper cover has a 1/4 inch gap between the bumper and the quarter panel. I think it's from me sitting on the bumper while tying up my shoes or something. When I apply downward pressure on the rear bumper, the gap widens. The left side is tighter, but does gap out when downward pressure is applied. In any case, the gap is annoying.
View 19 Replies
Looking for the sequence and clip locations on a 2010 Prius III rear bumper cover to be able to remove and install a new bumper cover. What is removed and how many clips are involved?
View 8 Replies
Dealer did repair work on front bumper. Now, after reinstalling a new front bumper, I noticed water starting to form inside the fog light assembly after it has rained. Dealer says this is normal due to our tropical weather. This has never happened prior to the repair work that was done.
View 12 Replies
I had a low impact accident with my 2010 LS460 where the body shop replaced the bumper cover, collision cushion behind the bumper and a new grill. Below are the picture from their finished work, however I know my car should look better than this. What could be wrong/missing to cause the grill and bumper to not align correctly with my car?
View 7 Replies
Have an '04 Prius and banged up the front bumper cover. Wanted to know if a Toyota Matrix front bumper cover from the same year would fit on it (without extensive mods, I know anything could fit, but would it bolt right up?).
View 4 Replies
I was recently in a fender bender where I was rear ended. My rear bumper cover became detached on the left side and the spoiler underneath it (left side and center parts) became detached. I lost several pieces of hardware in the crash. I was able to clip the bumper cover back in on the left side, and aside from that, I don't believe any bolts, screws, etc. are missing for the bumper cover. However, the spoiler seems to be missing about half of its hardware.
View 3 Replies
I have the 2012 Prius and wanted to know if there was a way to mod the DRL to stay on with the headlights?
Can I just run the DRL to the parking lights (tapping a wire from the DRL to the parking lights)? Will it pull too much volts?
View 6 Replies
I have a 3rd gen Prius (registered in late 2009, but technically a 2010 model), with European "Premium" package including HID low beams and LED daytime running lights. The car has "auto" setting for lights, so I think it should be able to automatically turn on low beams in dark. At least dashboard lighting and the touch & go screen automatically dim, so there must be a sensor (the black dot in last photo, I think).
The problem is that low beams are always on (except in "parking lights only" mode). There is no difference between "auto" and "headlights on" setting. My guess is that this is because of the Nordic legislation requiring headlights being always turned on before 2010 (after 2010 daytime running lights were required/permitted in EU). Whether this behaviour can be changed through OBD programming? It really bothers me to run HIDs on daytime, because in the end all the extra energy is coming from fuel, and also because they have limited lifetime (and probably expensive to replace).
View 10 Replies
My 2012 Prius has a DRL out. When you turn the DRL's on it flashes for a second but won't stay on. I also appears there is water in the housing.
View 1 Replies
how to remove it.My wife backed into my truck and put a dent in the corner of it so I am hoping i can pop it out.
View 4 Replies
I need to remove the front bumper cover of my Mk6 GTI. I think I know how to do it.
View 1 Replies
How do you take off a front bumper cover on a b5.5 wagon? cant find anything on the internet, I am trying to replace headlight lamps. pictures would be great too.
View 5 Replies
I have a 2012 SE v6 with 1600 miles on it. About a week ago, I noticed my bumper cover pulled away from the corner of the headlight and there was a noticeable gap. I pushed on it, and heard a click. The bumper stayed in place. After a couple days driving, it came loose again. I didnt touch it so the Service Writer would see it first hand. Of course, his first instinct was to puch on it, but I got loud quickly, so he kept his hands to himself, and heard me out. I knew if he clicked it back into place I would be SOL. He admitted something needed to be done, not just click it back.
When I picked it up, he said it was a known issue, and there is a TSB on it. He claimed they replaced a bracket. The invoice reads, "ADDED FELT TO TIGHTEN FIT". Yeah, Im sure that will hold just long enough for them to wash their hands of it.
View 14 Replies
I have a 2012 Camry and was wondering how to remove the rear bumper cover? Someone backed into me so I have a shallow dent I want to pop out of the plastic.
View 6 Replies
Replacing bumper cover, is there anything I would need to replace underneath it or is it just a simple swap out?
View 4 Replies
So I'm trying to remove the rear bumper cover on a '15, but it has been a royal pain. I went in thinking that the procedure would be similar to what it is on the '14, but it is way more involved. The biggest issue I'm having is removing the large plastic triangular side bracket. It has these weird T-nuts fastened to the body, which you cant remove, and the whole thing looks like it would need to slide upwards to get it off, but you wouldn't have enough room because the shape of the body just gets in the way.
View 1 Replies
Replace the front bumber cover on gx? Mine has a crack and I can get another one but wasn't sure how difficult it would be to swap it out, I guess the toughest part would seem to be the fog lights.
View 6 Replies
Looking for a DIY for this part? It is part number 5 in the illustration.
View 5 Replies
I was searching for instruction how to replace the chrome trim that appears to be a seperate piece of trim on the rear of the Phaeton. Mine has some issues on the passenger side and would like to remove it to have it either repaired or replaced.
View 11 Replies
I have a 2013 Accent GLS and I have to replace the rear bumper cover. Any detailed instructions on how to do this?
View 2 Replies
