Started my car this morning (2010) and both low beams aren't working. When set to on, only the daytime running lights come on (and yes I made sure the light switch was turned all the way). High beams work fine. Turned car off/on but still no good.
View 10 Replies2010 Prius owner here. Both low beams stopped working unexpectedly last night. High beams still work, but when I switch to low beams, I just get the park lights.
View 3 RepliesOur 2015 Prius 4 with 8,900 miles just suddenly stopped chirping and turning the lights off upon locking. The courtesy lights also no longer work (the lights worked last night as I approached the car but not tonight. The locking chirp/beep worked 3 hours ago but not now. Also headlights no longer go out after double clicking lock on either of the 2 fob.)
View 13 RepliesI have a 2010 prius the basic model I turned the lights and both headlights went out they only worked on high beams.
I changed the bulbs no luck they still only work on high beams checked fuses they looked good is there anything else I can check?
2005 Jetta Gli 1.8t. It decided to do some funky things on me today. I has been running perfectly fine up until I went out for dinner.
When I came back to start her up. Everything worked except for: Radio, Low Beams (both) Fogs, windshield wipers/fluid, rear defrost button, turn signals (but hazards worked fine) and the fan for my heater.
What was working, oddly enough are the amber lights, tails and brake lights, all other lights including the high beam, but ONLY in the position when the stalk is pulled toward the driver. (Have to hold it to keep the high beams on).
It's not the battery because my car wouldn't have started at all if that was the case. It's not the alternator because I disconnected my battery and the car ran just fine and never died. I checked all the fuses of the things that went out but nothing seemed out of the ordinary and all of them seemed just fine.
Where to look next or what to do. I have no check engine lights, or any lights for that matter so I have nothing to scan.
I have 2010 Prius, package 2. My horn stopped working a few months ago. I never got around to seeing whats wrong with it. I am not sure if it is the fuse or what ever. Where the fuse box is? Or what it can be? I did have a back up camera installed shortly before it went out...
View 2 RepliesI bought the 2012 Prius three in Apr, and the navigation was working fine, when i entered a destination. When I entered a destination, it would say, "Please drive to the highlighted route" and it would tell the turn by turn directions and in case you miss the turn, it will immediately say "Route Recalculation" and then guide you to the next turn.
Somehow this stopped working and there is no voice guidance!!! Now when I enter the a destination, it will not say anything. If you are driving in the right direction, no turn by turn voice guidance. If you miss the turn, then it will say "calculating the route". This is driving me nuts since 2-3 weeks. I must have pressed some button or deactivated it unknowingly.
I took it to the dealer and the service technician could not figure it out. They said that they have to call the Toyota Technical Service to find out ( looks like only they can call, not the owner).
They said they tried to reset it to the factory setting, but that didn't work. Not sure if they know what they are doing. I think these technicians are mechanics, but not familiar with the software and the electronic components and their operation.
I have a 2010 Gen III Prius with Nav (GPS).
View 3 RepliesMy cruise control all of a sudden stopped working today.
View 7 RepliesI replaced all the interior halogen lights, parking lights and license plate lights with cool white LEDs. They look good and all was fine until the last step while installing the license plate lights. I plugged one side then turn the light switch on to verify the polarity to see if bulb would come on which it did. Same process for the second license plate light but this time around after turning on the light switch to see if it was plugged in right, I noticed the brake lights didn't come on. So I flipped the switch around a few times and nothing. Now the DRLs do not come on either as well as the parking lights. The only lights that work now are the head lights and interior lights. What happened how do I fix???
View 10 RepliesAll windows except the drivers window stopped working last night. And the front passenger window is down 2". Wouldn't ya know it before I got home it started raining. Stopped by a store and got a large box of cling-wrap to wrap the top of the door in plus stayed off the interstate to get home without soaking the inside but where do I start looking for the problem? Why the drivers window works fine but not the others. Seems they should all be on the same circuit. Everything else seems to be working fine, door locks, etc.
View 4 RepliesI have a 2011 Elantra Sedan and my low-beams quit working. The high-beams work fine. I assumed the obvious and went to replace the bulbs but they appear to be intact and not burnt out. This led me to believe that it is related to a fuse or a relay. That being said, I cannot locate the fuse/relay in the fuse box under the hood that relates to this. What the fuse/relay is labeled as? I assumed it was under the hood but is it located in the fuse box in the cab?
View 4 RepliesI bought my Prius in November 2010. I replaced my headlights about three months ago when the right one went out. It went out again a few days ago. Then suddenly the diver side went out 2 days later. I also noticed that the right side parking light is out. The only lights that work are the high beams. I did check the fuses.
iPad ? HD ?
Is there a possibility of the radio itself overheating causing this issue. I experienced this the other day, was driving around and the volume control on the radio no longer worked. Could turn it off and all other functions worked but the volume could only be changed from the tracer buttons on the steering wheel. Shutting the car off and back on worked but for how long? Seems that this should be a recall since several owners have experienced this issue with the jbl stereo.
View 7 RepliesAny possibility that there's an off switch that I accidentally hit?
View 1 RepliesEverything was working fine until I started messing with camera settings in the service menu today . Now when I shift into reverse, it says "system not ready". Will not let me parallel park or reverse park now. I tried to reset the settings but maybe I don't know how to "save" settings.
View 5 RepliesI'm a new owner of an 05 Toyota Prius. Im loving the car so far, however, i am having an issue with my high beams not working. After doing lots of research it looks like the high beams on the Prius comes from the same bulb, what controls the high beams is the reflector.
My low beams and all other lights are working fine. After removing my bumper and looking through all the wiring I have noticed that their are two plugs that are not attached to anything. The lights look brand new, so my thoughts are that this car had HID lights and they were then replaced to non-HID lights.
How to get the high beams working. I don't see any HID ballast anywhere, so converting it back to HID would be costly since i would need new headlight plus ballast and bulbs.
I tried looking for wiring diagrams but can seem to find any.
Here is the link to some images: Prius Photos by Izzy25323 | Photobucket
I have a 2010 Prius IV that constantly burns out the low beam bulbs. I have replaced these at least 8 times in the past few years. Sometimes they will both fail at the same time, sometimes individually. These bulbs should last for a year or more, not months! And I do not use cheap aftermarket bulbs, they have all been OEM quality bulbs.
View 6 RepliesI noticed tonight that my low beams are both out, and they were both working yesterday. Fuse #19, a 40A in a cluster of two 30A fuses appears fine when I look at it AND my horn and backup lights work just fine too. In the owner's manual it say that fuse position #19 controls the low beams and the horn (which is working) and the backup lights. SO, that says to me the fuse is ok because the other items are working.
FWIW, I can use the high beams, but recognize they're on a different fuse anyway. Also, I replaced BOTH headlamps with new Sylvania bulbs about 6 months ago when one of them went out. Could both low beam headlamps have burned out at the same time???? Is there some other fuse that controls them both other than the #19 fuse inside the engine compartment? Could this also be a problem in the control stalk switch on the steering console?
2010 Prius... Both of the outside clear poly carbonate headlight surrounds have melted sections in front of the high and low beams.
View 19 RepliesI've got a 2010 Jetta TDI Sportwagen and the blower fan stopped working (again).
About 3 months ago it stopped working on the 1-3 setting and 4 worked fine. So I searched these forums and found the resistor pack was blown. Replaced it with the ~$30 official VW part and it worked fine until last week.
Now all settings are not working. I ohm'd out the resistor pack and they appear to be fine. I put a current limited 12v supply on the fan and it spun up without a problem. I checked the voltage coming from the car to the fan connector and it was at 0v.
From reading the forums this tends to point to a faulty switch. If it is a fault switch then why does the AC light turn on when I switch from 0 to 1?