Prius (2010-12) :: Air Flow And Recirculate Modes In Auto
Oct 9, 2012
What are the selection input for these? I have seen them go back and forward on its own. I have also been told that there is an in-cabin humidity sensor but have seen no documentation on it. Does that switch between fresh and recirculate?
View 2 Replies
Advertisement
Is it "safe" (meaning for the car) to change driving modes while driving? I understand that all it really does is change the way the throttle pedal works but just want to make sure that I don't have to be stopped to change modes.
View 8 Replies
why sometimes when I start my car it defaults to recirculate and other times fresh air?
I almost always leave it on fresh air but when I start the car it's often on recirculate. AC is off when this happens.
Same thing happens on my wife's Highlander but in no other car have I had this problem.
View 14 Replies
I own a 2007 Prius with almost 125K miles. I've had AC issues with this car since I bought it with 97K miles, and there's one thing that I just realized. I have a sneaking suspicion that the fresh air/recirculate mode is not quite working right. I have a feeling my car might be stuck in fresh air mode, or if not stuck, that the baffle is not closing all the way when I place it in Recirculate mode. Is this an easy thing for me to check, or does it involve taking apart the dash or something more involved?
View 6 Replies
I took my Prius Two to its first car wash today, afterwards, the air flow from the vents became minimal, almost non-existent. How could this be? The car is barely two months old. Prior to the car wash, I had the AC and air blasting to the highest, I didn't change any fan settings, and now there's barely any air coming out. I can hear the fans churning and running, but there's no air!!! Do I take it to the dealer?
View 2 Replies
This is the first winter with my 2012 Prius, and I've been suspicious of the climate controls. Today, my passenger complained that there was not heat going the to feet. I've always worn insulated shoes/pants so I didn't really notice before.
I jacked up my fan, increased the temperature and changed the aim to the feet/knees only. I then put my hand to where the gas pedal is. I couldn't feel any air flow at the feet. There was still plenty of air coming out of the upper side vents that blows towards your chest. The upper vent got hot, but not the feet.
Why there's no/little airflow to the feet? I'm thinking of checking my carbon filter but it is too cold be pulling out parts. I'm now suspicious if my car's air direction function works properly.
View 7 Replies
I remember when I was turning on my AC, outside air was closed and when I was turning it off it was switching to recirculated air mode. Now its not functioning like that.
View 8 Replies
I know the owners manual says 87 octane or higher. I'm only on my third tank of gas but yesterday I think I heard some "pinging" when I needed to catch up with the traffic flow. So far I have been using 87 octane from Raleys Aisle One. (Sacramento area) I think it's a generic gas but not sure where it comes from.....
View 19 Replies
I recently got a prius plugin. In last couple of weeks I have noticed that when I am EV mode and speed crosses over 65, my HV mode kicks in. But I can see the EV mode running in parallel with HV until the EV runs out. During this point, I see both the EV miles and HV miles piling up and it seems like doubling the miles in EV & HV. I saw this four or five times in the last two weeks.
View 19 Replies
my 2007 Prius has been sounding a bit under the weather lately. There is a grinding scratching noise. This happens in either EV or HV modes and is most noticeable when bearing right. The tires are on their last treads, and a bit scalloped but that seems to me to be a different sound.
View 5 Replies
- handbrake = parking brake foot thing - the thing that applies rear wheel brakes when stationary;
- manual = stick-shift etc.
- service brake = normal foot brake/big middle pedal
Driving scenario: Short pauses, quick lights etc - no problem, the car is held on the normal brake and the drive knows I have my foot on the brake so shuts all drive down.
Discussion point here - at lights, longer pause in heavy traffic, level/railway crossing etc. The sort of pause where you want to take your feet off the pedals and wait.
With a manual I would put the car in neutral, apply the handbrake and wait. Then when moving again, car into gear, hand brake off balanced with clutch bite and accelerator.
The car was left in drive all the time & knew if the handbrake was applied not to try and engage forward torque/ride clutches etc. Never needed neutral on the Audi multitronic.
With Prius III when I pull up, if I leave the car in drive and apply the handbrake, then take my foot off the service brake the power modes display shows the car putting torque through the drive train - i.e. battery->motor->wheels & you can feel it pulling slightly in creep mode against the handbrake.
View 12 Replies
So after figuring out that my 08 is in power mode and will not automatically go back to econo mode ... how can I manually change modes on a GEN II? I know there is a way as I got it in that mode and can't get it out!
View 19 Replies
I had read that the auto leveling only works when you first turn on the lights. But, I have caught mine doing it in traffic. When I come to a stop behind a car, a second after the front end bounces back, I notice the beams dip down half of an inch, on the car in front of me. I have seen this a few times. Seems the auto level feature is always at work. Is this new for 2012?
View 5 Replies
I have the Gen3 with auto dim mirror. The factory default is ON everytime the car starts. I prefer to keep it at Off by default because it is too dark for me during day time. I may be misreading the instructions Page 93 on the Owner's Manual and I can't get it to stay on Off by default.
View 2 Replies
I have a Viper SmartStart and sometimes forget to turn the AC down to LO and leave it in Auto. Is there any way to set the car to always start up with those AC settings?
View 8 Replies
We have a 2010 Prius, and I can't remember if AUTO just works on AC. or is suppose to work for controlling heat also. (Doesn't seem to) Nothing in book, and search turns up nothing.
View 19 Replies
I am trying to install an auto dim mirror. The listing said it was OEM from a 2010 -2012 Prius.
View 9 Replies
I have a 3rd gen Prius (registered in late 2009, but technically a 2010 model), with European "Premium" package including HID low beams and LED daytime running lights. The car has "auto" setting for lights, so I think it should be able to automatically turn on low beams in dark. At least dashboard lighting and the touch & go screen automatically dim, so there must be a sensor (the black dot in last photo, I think).
The problem is that low beams are always on (except in "parking lights only" mode). There is no difference between "auto" and "headlights on" setting. My guess is that this is because of the Nordic legislation requiring headlights being always turned on before 2010 (after 2010 daytime running lights were required/permitted in EU). Whether this behaviour can be changed through OBD programming? It really bothers me to run HIDs on daytime, because in the end all the extra energy is coming from fuel, and also because they have limited lifetime (and probably expensive to replace).
View 10 Replies
I own 2010 3rd gen European Executive Prius which is equipped with fabric Toyota's alarm VSS1. I read in manual it is possible to set Automatic doors lock function (over 12mph) , but is not described how to enable that function. How I can activate this function?
View 2 Replies
The scenario: I recently filled up at a station that, according to the attendant, had just lost electrical power but power had been restored. The pump was flowing agonizingly slowly, so I asked the attendant what was up, and he said the system needed 20 minutes or so to reboot before the pumps would flow at the normal rate--sounds kind of specious to me, but I was in no hurry, so I figured so what, I'd wait it out.
Well, eventually the tank filled up, and then some. The pump's auto-shutoff failed to work (my guess is that the flow rate was so slow that the back pressure failed to build up to the point to trigger it, but, whatever...). Gas was dripping everywhere by the time I noticed it (since it was taking so long, I wasn't paying close attention).
View 18 Replies
I'm just doing something wrong.
View 6 Replies