My car started giving me trouble I ran the scan tool and it told me that cell 6 was bad on my battery. I replaced the cell and put the battery back in now the check engine light is on and the problem triangle is on and the car wont start and only shifts into neutral but when I check for codes i get nothing .
View 6 Replieslast week I got a whole array of warning lights, including the triangle of death. Took it in to my local mechanic who diagnosed it and told me it was the HV Battery. So, as a temporary fix, we did some DIY and just replaced the bad cell. Everything went well, just some minor troubles toward the end with the engine not turning on, which we fixed by switching the orange switch on the battery and disconnecting and then reconnecting the 12V battery. It was driving great, until u got to work this morning and all the lights came on again. What am I missing?
View 13 RepliesI have two Prius's, a 2008 and a 2005. My 2005 with 129k miles on it is the one in question. Recently I got a check engine light with the code P0A80 and P3016. I purchased a pair of tested to be good cells from Ebay which finally arrived in the mail yesterday. Today I finally got around to installing it and everything was pretty self explanatory... One of 28 cells tested to have 6.24v in block six and all the others had between 7.98-8.00v all around. I went ahead and replaced the bad cell with the new one and put everything back together and now the car will not start.
Cliff notes: Replaced bad cell in main battery back due to CEL P0A80 and P3016.
Car will not start, only turns on...
Getting error message on the radio screen about the Park position is not correct and to park the car on a flat level ground with parking brakes and try again.
Have charged the 12v battery to make sure it has enough juice in it.
I took my 2005 Prius to dealer and was told both battery computer and battery CPU were bad (easy $4,000.00 fix). So, I pulled big battery, located bad cell and replaced with similar voltage (7.9 VDC used cell). After re installing, the car will only go to neutral and will not start. Note, before tear down, car would start and run (I drove home from dealer). Before pulling big battery I could reset trouble lights for short time by removing ground to AUX 12V battery. Now, lights don't change and are always on. Car will not start or run and will only go in "Park" and "Neutral" and "B" does not show on dash like usual.
View 19 RepliesTested and replaced 2 bad battery cells in my 2007 Prius... Got everything put back together and now all dash lights are on and engine won't start... When i try to shift into drive or reverse it goes directly into park... I tested the battery without removing the safety key and the inside terminals are at 220 volts and the outside terminals are at 0 volts as shown by photo... Maybe due to a fuse somewhere?
View 19 RepliesI have 2007 PRIUS with 187,OOO miles, I just replaced one bad cell today and the master warning,vsc,charging system warning light went off then come back on but it's charging .
All bars are green. Blue light is ON.
My Ion won't start under -15 degrees C but when things warm up turn the key and it roars, dealer says when it won't go call us. What to do? Battery cell freezing or something else I should know about?
View 30 RepliesThe guy that I use to rebuild my batteries has recently commented that most of the bad cells he has replaced have been on the driver's side of the battery farther away from the cooling fan. He has since started rotating the cells as preventive maintenance as part of the rebuilding process.
I am interested in other peoples experience regarding where they are finding the defective cell/cells.
I have a Prius for a company car. They have replaced the battery twice now and the thing only has 44000 miles on it. Got in it again after leaving an account this morning and it would not start. I let it sit about twenty minutes then it started. All my radio stations go out and every day I have to reset the clock. They have sent it in twice now and cannot find an issue but it keeps happening. Today was the fourth time in less than two months.
View 18 RepliesI am a new Prius 2010 owner - One question - I read in the manual you should not carry your remote control near your cell phone since it could cause decrease battery life. Does it matter if cell phone is off? I always carried by Camry remote control in my purse with my off cell phone. Camry is 7 years old and battery still works.
View 2 RepliesPurchased an 04 Prius with 140k miles and bad HV battery. Used torque app and pulled original codes for bad HV battery. I was able to drive/limp the car home for tear down and replacement. After installing a used HV battery that had 80k from and 08 car. It will start but shutdown after a few seconds. I was able to put it in to drive and move it but it still dies. Energy display shows no battery status and now I get the connect to air conditioner communication warning. The battery's are reading 15.2 volts each from the torque app these are read in pairs so seeing 14 readings all within .1v of each other. I am not getting any codes from the computer.
View 19 RepliesI have a 2005 Prius recently replaced the hybrid battery. Not so happy with it, my mpg b4 was 49-51 mpg, now I only get 40-45 mpg. I notice the car is a little weaker and the ICE rev higher everytime I accelerate.
View 5 Replies2005 Prius I picked up a few weeks ago decided to eat both of it's batteries for lunch and leave me high and dry. I replaced the aux battery yesterday which I was lucky to get at cost at the toyota dealer since the aux battery was original. Put it in and all was well with the car for the rest of the day. Got in it today and headed out and was welcomed with the big stupid "!" triangle, the regen brake warning, check engine light, "PROBLEM" written on the display with a picture of a "!" inside a car outline, and some severely reduced performance. So I looked online and found a place with a bunch of low mileage batteries out of smashed up 2009's.
View 19 RepliesI have a 2008 Prius, MFD died one day, screen completely dark and all buttons on it are unresponsive. I used a voltmeter to check the 12v battery which had troubles last winter (had to jump it once) and it was at about 10.6v so I just replaced it with an Optima battery. Sadly the MFD is still blank.
The MFD actually came on for a second a couple weeks ago which led me to believe it was still functional and just not getting enough power from a failing 12v.
I have a recently purchased 2005 Prius- Mileage-150.3k having several lights on the dash: ABS/VSC/Engine Check/ Brakes, etc. See attached screen shot. Initially, I got into the shop and had the codes read out several codes. In all, I was informed the root cause was a bad 12v and bad hybrid batteries. By this time , the car was still moving, though not very smoothly. however, less than a week thereafter, the car couldn't start again.
We decided to replace the 12v first, hoping to get it back to start but it wouldn't. I've checked the fuses in the engine compartment as well as on the steering column- all okay. I've checked battery voltage, it's now at 12.3v. When I try to start, the Ready light would simply flash for 2-3 seconds before going off. I've rechecked battery connections as well as the brake controls by the 12v battery- all well tightened.
I've attached some pictures of what it looks like. Sometimes there are no lines and just black but the display button still overlaps. Everything else seems to be working. I think this happened when I got the 12v battery replaced. I am also not sure I have a nav dvd. How do you eject those DVDs?
View 2 RepliesI purchased a 2005 Prius with 54k miles with a rebuilt title July 2011. About a month after I purchased it (from a private seller) I started to hear a slight grinding noise. It turned out it was the transmission/transaxle. I drove it for about 4 more months since I knew I had to replace the trans anyway. Next, I sourced a used transmission from the guy I purchased the car from. I installed the trans myself. But, it wouldn't run right at all afterward... it wouldn't go over 5mph and it would jerk. I took it to a Toyota shop and was told that it now had a dead 12v battery and HV battery.
I had both replaced. It still had the same issue with drivability. I took it to the dealership for a proper diagnosis and was told the transmission was the issue. So, I purchased another used transmission and installed it. I was very careful to make sure everything was installed correctly. So, now the car won't drive at all or even go into park. Attached is a picture of the current screen, which says "The transmission 'P' lock mechanism is abnormal. Park your car at a flat place and apply the parking brake completely." So, did I get another bad transaxle?
As I see it - my choices are
1) put in another used transmission, which I could do (3rd time is a charm) ,
2) spend more money to diagnose the car again or
3) sell it as is and get nothing for the car
I have a 2007 Prius. We left for vacation for 2 weeks. Came home. Started the car and then all the lights came home. I thought the battery must have drained. But the lights are all on with a new battery. Is there a way to clear all these?
View 8 RepliesMy 2007 Prius suddenly lost power and all lights on the dash board light up. I had a "problem" error as well. Eventually a message came up stating there was a transmission P lock mechanism problem.
Long story short, realized the 12volt was dead and replaced it. However, the car is still not running after replacing the battery. It went once around the block fine, and then the same thing happened with all the lights (check engine, VSC, brake system, and !) and P lock mechanism warning. Disconnected the battery for 15 minutes and tried again. No luck.
I am not sure if I need a new fob.
My smart key quit working. I have replaced the battery, and checked the button under the steering wheel. The little red light on the fob does not blink or light up when I push it. I think I recall this light coming on when a button is pushed.
So from the beginning the car wasn't coming on. It gave me error "p" said my parking break was not working properly and needed to be on a flat surface in order to work. We jumped it and replaced the battery shortly after that. The car will turn on but the actual engine is not turning on. The display screen has a little car with a red exclamation going through it. The dashboard also has all the lights on. We have tried to jump it from the relay at this point but it wont start now to where before it would.
View 6 Replies