I have a 2009 Prius. Last summer I noticed that the outside temperature gauge was not working properly. I asked at the wonderful dealership I go to and no one knew anything.
View 10 RepliesI have a 2004 Pontiac Montana with about 107500 kms on it (VIN: 1GMDX03E24D183870) and the coolant temperature gauge is not working properly. Sometimes when I start my van, the temp gauge is pinned at MAX temp and stays there the whole trip...other times it's pinned at MIN temp...and other times it seems to work OK.
When it's pinned at MAX temp, I check the actual temp that the on-board computer is seeing, by using my OBDII scan tool...and I get about 87 degrees C when I'm halfway into my trip (i.e. - when the van is at operating temp), which seems OK. All the other analog gauges are working perfectly.
I read a lot about the issues with "connector C305" on the Internet on the Montana vans...could this be the problem?
My fuel gauge is not working properly. I ran out of gas while going down the road with the fuel gauge still at 1/4 tank. What do I do to fix this problem?
View 1 RepliesSomething strange started happening to my '04 Prius yesterday and it happened again today. We are experiencing unseasonably warm temperatures here in Western Oregon for October and when I left my house this morning at 6:30 am, it was about 55 degrees. I have a half hour drive to work on a mixture of expressway, freeway, expressway again and then the two-lane highway.
Anyway, yesterday (and today) when I'm almost to work, my temp. gauge drops down to 37 degrees. This causes that yellow light to start blinking indicating that the engine will not shut off because of cold temps. It will warm back up to 45 degrees a minute or two later. Why is this happening? It for sure is not 37 degrees outside. Is my temperature sensor going bad? Is this exhibiting the behavior of a sensor going bad?
I have a 2004 bought in 2003. It recently logged its first 100k miles. My problem with it is not easy to describe. It is actually running more like a non-hybrid car. I can feel and tell the hybrid system is operational, and I can hear the electric motor whine when coasting, down, etc. However, I don't think it is running as it should or as it used to. It happened on highway while cruising about 70 mph. I hit the accelerator to pass someone, and I felt that something changed. I'll try to describe it: think of a half-clogged pipe. The water can barely gets past the obstruction. You keep applying pressure, and suddenly the clog dissolves under pressure, and water begins to flow freely, and the pressure goes down. So it felt like that. Now the accelerator pedal is lighter, car is faster to respond, yet I think something is wrong because the car isn't itself anymore.
I don't like problems like these because they are very difficult to diagnose, let alone fix. For a while I also have not heard the inverter pump whine after shutting the car off as I did in the past, but the last time I got out of the car today I heard it. I believe it was replaced five years ago after a collision with a Trailblazer wiped out half of the front end ( but with no power train damage). I checked the VIN for the inverter pump campaign, but my VIN was not in the range.
Right now my problem is that the car feels a lot faster than it has ever been. When I lift off the accelerator, it doesn't begin to coast as it used to. No warning light of any kind out of the ordinary is present on the dash, although it did have the red triangle on during start up with a message about the parking gear not being engaged properly. That warning went away after the change in performance occurred. Related?
I guess I will take it to the dealer to see if there are any codes stored. After my 30 mile commute this morning, no whining, buzzing or any kind of noise was present after I shut off the car and I got out. There is still no warning light.
I have a 2009 Prius base model, and I've been having two different brake problems.
View 8 RepliesI've had this problem a while but now i want to get around to fixing it.. my boost gauge is always at 0 now and sometimes when i drive the car it starts working but it starts like sticking... like when i didn't have my chip it would go up and down really fast between 10 - 15psi... i heard from a friend that you can take it apart and re-adjust some screws or something so it works like a charm... right now its just like frozen at 0 psi when i drive it doesnt go down or up.
View 4 RepliesWhen stuck in traffic jams, and my 2004 Prius shows 2 bars on the HV battery charge, it attempts to start the engine to maintain the charge on the HV battery. What was happening was the engine would attempt to start and then it would immediately die. It would keep repeating this process, over and over again, and would not charge the HV battery. Once I started driving out of the traffic jam, the engine ran fine and it charged up the HV battery while I was moving down the road. I decided to clean the throttle body. My charging problem did change due to me cleaning the throttle body. Instead of starting and immediately dying, over and over again, the engine no longer dies.
It now revs up, and slows back down to idle over and over again when sitting still with 2 bars of charge. The display does not show any charging going on during this revving up and slowing down episode. I need some more hints as to what to check out. I am studying electrical diagrams of the vehicle, but I need a synopsis of which system starts the engine for HV charging, and which system keeps the engine revving at the same RPMs during charging while not in motion. The throttle body cleaning made my 257 K mile Prius run like a scared deer again. I just need to get her charging while sitting still again. 12 volt charging system is in the 14+ volt range and 12 volt battery with no load is around 12.2 volts.
I have a 2003 Impala with about 122,000 miles on it. On my recent fill up I by accident put in mid grade over the normal unleaded, now I now that won't cause any engine issues that I am aware of, but after doing this fill up my gas gauge is not working properly. When I start the car in the morning the gauge will go to where it should given the mileage I have driven to this point but as I drive the car the gauge goes up to almost full then down some but never back to where it should be. what might be causing this floating incorrect reading by my gas gauge.
View 19 RepliesWe spend summers away and our 06 Prius stays in the garage. I connect a battery minder and it keeps the 12v battery charged with no problem. I also turn off the switch under the steering column that works with the remote.
When I started the car after two months and driving for a few blocks, I noticed the MFD showed the battery at a low of two purple lines. After a while, it charges up normally. The car has 47000 miles and the 12 v battery has never been changed. Would that have something to do with it or am I being concerned over nothing?
2003 Chevy Malibu 3.1 temperature gauge stopped working last night, this morning having trouble starting, no check engine light fans do turn on have heat, replaced the coolant temperature sensor but gauge still not working?
View 1 RepliesHow do you know if the inverter coolant pump/reservoir is bad after the recall was performed?Since it doesn't produce any codes but can reduce the electric-drive if getting too hot, how do you convince Toyota to give it a second look?
View 5 RepliesThe outside temperature gauge and park distance system on my Phaeton isn't working. In place of the temperature reading on the dash it just says --.-C I've had it scanned at my local Bosch diagnostic garage and it showed a fault on all six front parking sensors. I can't recall whether he mentioned the temperature sensor as well but I put a new one on anyway as they are cheap and easy to get at. It made no difference. They were very busy so didn't have an opportunity to do any further investigation or dis-assembly and I was in no rush so am taking it back next week.
I have checked the two block connectors which the wires from the parking sensors and temperature sensors go in to and that seems properly connected. Is there another connector somewhere or is there a fuse that protects these somewhere as there isn't a fuse described in the manual as being related to these?
My sister drives a 2005 Nissan Altima. I am not real familiar with Japanese OEMs but I do most of my own repair work on my car (which currently has issues of its own). What's wrong and how do I go about making the repair...
View 8 RepliesI borrowed a friend's small Toyota truck for a few days of easy chores, and made a point to check the fuel at the beginning: the gauge showed 3/4 full. Four days and only 25 miles later, when I got in to return it, I noticed the fuel gauge was not working, I'm certain there's no fuel leak, I would have noticed that: the truck had been parked on my property the entire time, driven only a few hundred feet from one spot to another moving firewood around, so I would have smelled the gas if there was a leak.
When I added a couple gallons of fuel, the gauge didn't budge. Once on the road, I realized that the engine temperature gauge was also dead - no change on the gauge after 10 miles. So I have two non-functioning gauges which failed on my watch. This may not be directly my fault, but as my friend is kind enough to lend the truck whenever I need it, my contribution is to provide maintenance.
Is there anything in common between the two gauges which would explain the synchronized failure? Or is this total coincidence? This one is outside my experience, so don't know where to start. It's a 4 cylinder, 5 speed manual, base model truck, about 150k, generally runs just fine. There are no other gauges, and I don't recall what warning lights there might be, but I didn't see any after I realized there was a problem. Would the whole instrument cluster die at once, or could this be something like a bad ground for the cluster? I don't mind investing effort into tracking down and solving a problem, but if it needs a new cluster, that will cost more than I'd like to contribute, yet the problem occurred while I was using the truck (gently). My total use of this truck for all the times I've borrowed it is certainly less than 300 miles, so I'm reluctant to fund the entire repair if this is something that just comes with age.
Having a problem with my temperature gauge inside the truck. No matter how far or long I drive, the needle barely moves off of cold. Would the thermostat be the likely suspect? If not, what else could it be? There is no "check engine" light on and my ODB2 reader reads a temp of around 70c solid. If it is the thermostat, where is this part located in the car and would I need to replace JUST the thermostat or are there gaskets/housing-type things involved as well.
View 7 RepliesI have a 2005 mk4 gli and the other morning I went out to start my car for work and all I got was crank no start. I then realized my fuel pump wasn't priming when I opened the driver door. After work I came back and checked the fuel pump fuse and swapped the relay with another I had, still nothing. A buddy of mine decided to check the connector at the fuel pump for power, using a power probe I believe he hit all or the majority of the wires with 12v of negative and/or positive power. He then unplugged the connecter and plugged it back in and the car fired right up. But I noticed that my fuel gauge, engine temp gauge, and outside air temp readout were all not functioning. I've searched and searched without being able to narrow down a solution.
View 19 RepliesI have a 1992 Aerostar 3.0L end my temperature gauge on the dash doesn't move at all. Stays all the way to the left. I read on other forums that to make sure the gauge and the wiring are ok, i need to connect the wire that goes to the sensor unit to the negative of the battery. Gauge should go all the way to hot when the ignition switch is put to on position. That was exactly my results. So, i replaced the temp sensor unit but still gauge doesn't move. I didn't use any sealant on the threads when i installed the sensor. Connector looks ok. The engine warms up fine. I really don't know what else to think or do.
View 11 RepliesTemperature gauge quit working after changing the thermostat and coolant.
With the engine off, I disconnected the single wire from the temperature sending unit and switched on the ignition without starting engine. The gauge pointer stayed in at the Cold mark. Using a Jumper wire, I grounded the sending unit wire and the needle on the gauge went to the Hot mark.
I quickly turned off the ignition, and replaced the sending unit with a SW-2328 (F1SZ-10884-A) Temp Sender. Warmed up the engine, but still no reading on the dash gauge.
Basically my coolant temperature gauge either reads as the hottest it can be, or the coldest. It doesn't jump around a whole bunch, but it's always all the way to one end or the other. From what I've read there seems to be a lot of different temperature sensors, so I get a little confused with all of the abbreviations, but I'm fairly certain I checked the correct one, next to the thermostat housing.
Using a multimeter I checked the resistance of the sensor, and it was around 600 ohms about 30 minutes after it had been driven. I'm not sure if this is where it should be or not, but it was rising as the truck cooled off.
Anyway, I'm not sure if I just tested the sensor incorrectly or if there could be another issue. A friend of mine suggested that the thermostat may have gotten stuck or something, but it doesn't seem like the gauge would switch at all if that were the case. What I should check to try and fix this.
Husband brought car in for regular oil change and told them I was having a problem with my gas gauge not registering properly. They claimed I probably didn't fill at least 4 gallons for it to register. So, they sent him home with that answer and if I continue to have problems to bring it in again and they would have to do some expensive troubleshooting. I have owned the car for 4 years and I was infuriated at that response since I only started having this problem recently and knew how to pump gas.
After doing some reading (not on here unfortunately) I didn't like what I was reading, that it is a "mystery" and could cost alot for them to figure it out. So, since I didn't have the time or money to deal with it, I decide to just keep track of it by the travel information screen. This was working out fine and the gauge started working again for a few months.
Recently, I filled up 8 gallons and the damm gauge craps out again and only registers 4 bars. I have a full tank, drive 92 miles and the gauge dropped to one bar during that time...I know I can't fill it cause I would take maybe 2-3 gallons (due to gas pricing)...so I decide to see what would happen.