Just replaced the HiD bulbs in our 2005 Prius for the first time. Unhappily, though both bulbs operate, the driver’s side bulb has no “low beam.” Could this be a defect in my installation? (Of course, I realize that I can resort to the old bulb-swapping routine, and I will do this if necessary, but given the effort required to perform that trick I thought it best to ask here first!)...
View 2 RepliesJust installed a new clockspring on a 2009 Prius base model because half the buttons on the steering wheel weren't working and the airbag warning light was lit up all the time. I took a guess on the airbag light being caused by the clockspring since the buttons were dead on the steering wheel and the cruise control was usually dead also. The good news...airbag warning light is off and the buttons and cruise control are all back! Bad news is...now the vsc light comes on after going less than a mile down the road.
View 5 RepliesMy car had a new bumper installed, and now they can't get it to start. When you hit the button to start, the red "immobilizer" anti-theft light blinks for a moment like the key is not in the car.
This is true even if the key is inserted into the dash. The remote key still can open and close/lock the doors just fine, so this is strange.
They did mention that they had to recharge the battery for some reason. I don't know why the battery had died for them, but it is charged now. (Headlights, etc work fine).
My mechanic installed a new Hybrid battery in my 2005 Pruis using the repair manual and a video that showed him how to do it. He also replaced the harness and the ECU battery. When he tries to start the car all of the lights light up on the dash but no ready light on the start button and the car will not start. The instructions did not say anything about this issue so he is lost! He thinks the smart key and the ECU have to be synced in some way but doesn't know how to do it.
View 6 RepliesI purchased a new 12 volt battery from Toyota and installed in my 2009 Prius. My car wouldn't start. So, next I tried to jumpstart it. I pressed the Power button (the light was GREEN) but it wouldn't start. I pressed the Power button again (The light was AMBER) and the hybrid drive engaged and the CHECK ENGINE light came on; however, the engine didn't start, the dashboard didn't light up and the READY indicator did not appear.
Next, I grabbed the Owner's Manual and went through the Troubleshooting sequence. Engine still wouldn't start.
So, I don't know squat about cars, but I'm trying to learn. A couple months ago our 2004 Prius' right (passenger) light went out. The driver's side works fine as well as BOTH the HI beams. I checked according to priuschat forums about the fuses and they seemed to look fine, not blown or broken. I read somewhere about the 40A amp, but I can't find where it should be.
View 12 RepliesI decided to install a new Optima yellow top battery because I performed the battery check and found the voltage low and therefore believed my 2008 was still running on the original OEM 12v battery. Much to my surprise I found a non-OEM battery installed and the vent tube elbow missing!
View 10 RepliesGot the new tires the other day (Thursday) from a tire chain store. As I was driving off, I noticed the tire light warning turned on and then moments later, it turned off. I thought maybe it was just that. Today (Saturday) the tire light went on again. Brought the car back to tire store and the service manager checked the pressure, the tires were all low pressure, 29-30 psi instead of 35s. He re-inflated them all but the tire light will not turn off. So next step was he used a scanner tool which he attached close to all the tires.
View 6 RepliesJust put in a new 12v battery but when I try to connect the ground cable, I'm getting sparks, indicating a current draw. And the horn starts blowing nonstop.
View 6 RepliesI recently had to put a clock spring inside the steering wheel. I aligned it and calibrated it, however, after this change, the VSC light keeps coming on. I have disconnected the battery, I have used the paperclip on the obd connector and calibrated, but it keeps coming back on after driving a few miles. The car runs great. Along with the VSC light, the vehicle warning light comes on also.
View 1 RepliesI had the red triangle pop up on my Prius. I codes I got P0A93 and P1121 I needed a new control valve and inverter water pump. I installed both the valve and the inverter pump filled it with new coolant and bled both systems.
I went into maintenance mode so I could run the motor and bleed out all the water. My question is the red triangle is still on in my car when I start it up.. Is there some way to clear the red triangle or does it just go away on its own? Not sure what to do.
Recently, I bought a new-to-me 1994 Jaguar XJ6 which had a small laundry list of things that needed work. Amongst them was to have the waterpump and belt replaced. Long story short, after getting it back from the shop (I'm a repeat customer) and 50 miles down the road, I checked things out under the hood. I saw that there was a small bit of coolant sitting on top of the pump where the mating surfaces meet. It appeared that was some weeping from the gasket. I'm a little perplexed because this shop hasn't done wrong by me before, but there's a first time for everything. Is it possible that the cold weather in North Dakota (routinely -10) is a factor? It doesn't appear to be a catastrophic leak by any means, but I intend to keep my eye on in it. In the mean time, I made sure the bolts nearest the leak were adequately tight and put some red RTV sealant where it was leaking. Is it possible this problem will "go away" or do I have to try to shake down the shop and get them to re-check it/fix it? Frankly, I'd rather not have to deal with them again, but I paid them good money to get it fixed.
View 6 RepliesThis is what’s wrong with my 1998 Honda CR-V manual transmission. When it’s off, the gear stick works normally. However, when I start the car, the gear stick gets stuck and won’t move to change gears. It happened before a couple times and if I warmed the car up for about 10 minutes it worked normally again, and normally the next time I drove it. However, this morning, the gear shift would not work even after warming it up, except when the car was turned off.
View 5 RepliesSo I had an issue with my hid lights, I replaced one ballast and 2 new bulbs and they work fine now but the passenger side is stuck on high beam. When i turn on the brights only the driver side gets brighter, how to fix this? I only replaced the driver side ballast
View 3 RepliesJust bought a 2006 with 80k miles and HID headlights on it and noticed while parking in the garage last night that only the passenger side high beams work. Upon closer inspection and having my fiance flip the beams on and off I could see that the reflector on the drivers side didn't move at all.
This is after i just had a brand new driver side lens, bulb and ballast installed as when i bought it the headlight had a lot of condensation built up inside it. So I'm not really sure if the highbeam was working before this was all replaced because the bulb went out right after i bought it.
I have a problem with our oldest Prius, a 2005 Package V. I have had an ongoing problem with the warning triangle and the headlight icon coming on and off for a few years now. Anyway, after locating the post about repairing the sensor, I finally got around to checking out the headlight height control sensor and when I opened it up, I found it to be badly corroded/ unrepairable. My local dealer wants $500+ to repair the system and I really don't need the leveling function anyway.
My headlight level has been stuck it the same position for a long time, but as luck would have it,. they are at a perfect level....Always pass State inspection, illuminate the road perfectly etc.
The problem that I now have is that the two warning icons stay lit all of the time. Is it possible to disconnect or jump wire the Headlight Level Control ECU or something else in the wiring system to disable/turn-off these two warning lights? I disconnected the corroded Height Control Sensor, but the warning lights stay lit.
I have a 2006 Prius that I purchased with no upgrade on the headlights. There was an upgrade available for high intensity lights, but, I didn't get them. The low beam on the passenger side headlight just stopped working. Two questions:
1. I was just told by the Toyota dealership that to replace the headlight, the entire front end of the car would need to be dropped. They just told me that with them supplying the bulbs, the cost would be about $250 plus tax. If I supply the bulbs, only about $200 plus tax. My owners manual indicates that this is a do-it-yourself project. Is this true or is the dealership trying to make money off of me?
2. When I do replace the lights, I would like to put in something that would put out more light than what I have now. I have been told to be careful because many replacement lights throw off so much heat that the housing around the bulb could melt. Also, I have read that some of these replacement bulbs have a very short working lifetime of 1-2 years. Obviously, I would want to keep away from them.
We just bought our first Prius about six weeks ago. We purchased a used 2008 model with 83,000 miles. So far we have loved the vehicle. Tonight as we were driving home we noticed that the left headlight was out. I ran some quick tests and determined that the left high beam, low beam, and side marker light were all unresponsive. The left blinker is working fine. I checked the fuses for the left lamp (separate fuses for low and high beam) and all seem to be in good working order. Everything on the right side of the car is working fine.
View 9 Repliesi have a 2005 prius got it 2 years ago when it hade 120,000 miles now has 211,000 runs good but last week on my driver side the tail light and low beam light stopped working at the same time the high beam works fine what could it be?
View 19 Repliesi just got my edelbrock performer rpm intake and my holley 4 barrel installed but it won't run...the only way i can get it to hit and run at all is to floor it like it's flooded...then it'll run for a second but will never rev up and get going like it should...so i watched some vids on youtube for setting mixture on holley's wich i was pretty sure about anyway...turned the idle mixture screws in to snug and then out 1 and a half turns. is this a symptom of a bad vacuum leak or is it something to do with the carb maybe not enough fuel?
it's a holley 4160...list-6619...which is 600 cfm...it's on a 302 with 3 speed.
My 2006 Prius (Model NHW20) has a strange headlight problem. On the passenger side, the high beam light is out but the regular headlight works.
On the driver side, the high beam is working but the regular headlight is out.
I don't think it's the fuses but I'm not sure. No amount of interchanging the following fuses changes anything about the issue:
1. 10A H-LP HI RH
2. 10A H-LP HI LH
3. 15A H-LP LO RH
4. 15A H-LP LO LH