I decided to install a new Optima yellow top battery because I performed the battery check and found the voltage low and therefore believed my 2008 was still running on the original OEM 12v battery. Much to my surprise I found a non-OEM battery installed and the vent tube elbow missing!
View 10 RepliesI own a 2004 F-150 FX4 5.7L V8, I notice this morning that I had gear oil coming out of my rear Axle Vent Tube. What would cause this issue? I'm kinda at a loss as to what would cause it.
View 3 RepliesMy mechanic installed a new Hybrid battery in my 2005 Pruis using the repair manual and a video that showed him how to do it. He also replaced the harness and the ECU battery. When he tries to start the car all of the lights light up on the dash but no ready light on the start button and the car will not start. The instructions did not say anything about this issue so he is lost! He thinks the smart key and the ECU have to be synced in some way but doesn't know how to do it.
View 6 RepliesI purchased a new 12 volt battery from Toyota and installed in my 2009 Prius. My car wouldn't start. So, next I tried to jumpstart it. I pressed the Power button (the light was GREEN) but it wouldn't start. I pressed the Power button again (The light was AMBER) and the hybrid drive engaged and the CHECK ENGINE light came on; however, the engine didn't start, the dashboard didn't light up and the READY indicator did not appear.
Next, I grabbed the Owner's Manual and went through the Troubleshooting sequence. Engine still wouldn't start.
Just put in a new 12v battery but when I try to connect the ground cable, I'm getting sparks, indicating a current draw. And the horn starts blowing nonstop.
View 6 RepliesI own a 2005 Prius with about 145,000 miles on it. I love it. However, I've noticed that lately, the vent in the back by the window will come on and make a lot of noise. Some research has told me that this is the air vent for the battery that is in the back, and usually comes on when the temps are higher and the battery is starting to get a little overheated.
View 11 RepliesI had a loud whine from the rear axle of my 04 SCREW and had the bearings replaced at the dealership. It has been about a year/12k miles since it was done and I just noticed that the vent hose is missing. I'm not sure if they left it off or if it fell off on its own. Anyway, my question is, do I need to replace the fluid once I put a new hose on? I'm not sure how much if any dirt or water might have gotten in there. Also, where does the hose go up to? I figure it must clip to the frame somewhere.
View 5 RepliesMy front differential on my 97 Silverado Z71 sometimes vents some fluid out of the vent tube. I end up smelling it in the interior while driving. The vent tube top is above the top of the radiator and has the little cap on it. The first time it did it, was during a heavy rain. I had it in 4wd on the freeway doing around 60-70 mph. I figured it was because I was in 4wd. It did it yesterday after a 35 mile drive on the freeway again, but I was in 2wd the whole time. Outside air temp was over 100 degrees and I am using Royal Purple fluid. I checked the level a couple of weeks ago and it was below the fill plug about 1/2 inch.
View 5 RepliesI was pulling a motorcycle trailer down the interstate about 75 mph for about 4 hours. When we got home I noticed it looked like there had been an oil leak. I looked underneath and it appears like tranny fluid spewed out of the top vent tube on the tranny. I have a 4x4 with a Automatic overdrive. It was tranny fluid and it does not appear that it was low on the stick when I checked it. We were pulling some hills and it would downshift but it seemed to be working fine. Seems to still work ok. We had the tranny rebuilt about 50,000 miles ago.
View 4 RepliesMy 98 mountaineer keeps throwing rear end oil out the vent tube.. Why does it keep doing this?? its been doing this for a while and had to change an axle seal, I think because of this. It stopped doing this for a little while after I changed the seals and put in new oil.. Its not over full.. When it stopped I figured it was because the oil was old and was foaming or something.. But now its back to doing it again... The tube is not plugged.. Why does it keep doing this???
View 3 RepliesI have a 1999 Chevy Silverado 6.0 Ltr C2500 Auto tran Large Gas tank 120,000 miles. My gas tank filler tube vent hose has come off of its attaching point. It is still connected to the filler tube. I can not see where it connects on the other end. The small hose is long enough to reach the rear bumper on my truck noticed it hanging over the differential on the ground. Where to reconnect it to. I do have a check engine light showing. I fear my truck is falling apart slowly.
View 2 RepliesOk, I have a 98 F150 XLT, standard cab, 8 ft. bed, 2WD with limited slip - if any of that makes a difference.
The rear axle vent tube is literally blowing oil out the top, where it's loosely connected to the bed. It does this every few weeks. I pulled the hose and ran a rifle cleaning rod down it to make sure it wasn't plugged ... it wasn't.
It seems like it's building up pressure somewhere, then blowing all at once, but why?
My mechanic installed a new Hybrid battery in my 2005 Pruis using the repair manual and a video that showed him how to do it. He also replaced the harness and the ECU battery. When he tries to start the car all of the lights light up on the dash but no ready light on the start button and the car will not start. The instructions did not say anything about this issue so he is lost! He thinks the smart key and the ECU have to be synced in some way but doesn't know how to do it. (none of the books covered this.
View 1 RepliesI replaced the battery because I was getting the red triangle with no screen powerup. This is a slight improvement but I'm stuck as to what the "Problem" indicator on the MFD is about.
I've checked the battery in maintenance mode, reading 12.6V.
Install new HV Battery in 2005 and now I have no dash display lights.
View 2 RepliesIs it possible?
View 1 RepliesMy toddler spilled an open bottle of water from her rear facing car seat on the passenger side of my brand new Prius III. From what I can make out, her car seat and the sides of the passenger seat took most of the damage. But there were a few drops of water on the spokes of the battery vent. I cleaned it up and tried peering inside the vent to see if water got in but I couldn't tell much as it was dark out. We had to drive it back home as we were 20 miles away. What should my next steps be? Should I take it to the dealer in the morning to have the battery checked out? Can I remove the vent cover and wet vac it?? What signs should I look for? Am I looking at having to replace the battery!
View 15 RepliesA few weeks ago I started to notice that the battery vent fan was turning on way more than usual. I've had the car now for five years (34K miles) and I've only heard the fan go on a handful of times, even in the hot Las Vegas summers. Once I really started to pay attention to it I noticed the noise only started once I hit about 30-35 mph and got louder as I went faster. As I slowed down, the noise would get quieter and eventually stop as the car came to a stop.
This week I caved and brought the car in to the dealer to get checked out and they did an inspection of the vent, fan and did a complete diagnostic on the hybrid system and batteries. I was worried about damage to the traction battery if the vent fan was malfunctioning or clogged. I'm out of warranty with no extended coverage so I was pretty shocked that the dealer didn't charge me a dime to do the tests. All the tests came back clean and they said all the systems tested above average and that the fan was operating normally so I shouldn't worry about it.
But the noise still persists and it's starting to drive me a little batty. It has never made this much noise before. Is there something else that could be going on that the dealer missed? Maybe the noise I'm hearing is something else and it only sounds like it's coming from that area?
I just bought 05 prius from a dealer I don't know the history was told all it needed was a hybrid battery.
Now I have a 05 that I drive with known good parts so I pulled my hybrid battery and installed it in the new car the monitor showed engine charging inverter then going to the battery. However the bars on the battery graph start dropping. only code is a engine code 2102.
I also noticed the old A/C condenser in the back.
I have a '99 F250 SD 7.3 & im going on a trip next weekend so I thought I'd pull the exhaust pressure sensor & clean the tube in an attempt to get better mileage. Found the sensor & unplugged it. Went to the manifold & started removing the tube when it fell off. 6" from the manifold it's broke & the rest is completely missing.
Autozone doesn't carry this tube so, how important is this sensor?
I have a F-250 4WD with 7.5L which has a MC/Holley 4180c sitting on top. It was getting very poor mpg (like 5-6 miles/gal) and then was getting harder and harder to start. This progressed rather quickly to not starting with fuel coming out of the primary vent tube. I suspect it has to do with the primary float stuck open. I was considering rebuilding the carburetor. Is this over reaction prematurely or is there something like float adjustment that may rectify all of the symptoms described. If a rebuild is in order what is the information I would need to ensure getting the correct rebuild kit. Info that I have so far from research is it is Motorcraft ID #E5HE-9510-MC.
View 6 Replies