Prius (2004-09) :: Metallic Rubbing Noise In Left Rear
Mar 13, 2011
First the specs: 2008 w/38K, not sure which package but nothing fancy. This morning got in the car and started off and hear a metallic rubbing noise coming from the left rear of the car. Sounded like it came from around the wheel area. Temp was coolish around 36 degrees. The noise only happened for the first few minutes and only when going real slow, like 5 or 10 mph, and only when I was turning right.
Sound was like the the sound you get when a brake pad is worn way down and scrubbing on a rotor or drum. Also, the sound would speed up as I sped up until a certain speed then would go away. I actually stopped and restarted to be sure I could make it happen again. Once the car warmed up I couldn't reproduce the noise. Drove the car later in the afternoon with temps in the high 40s and no noise. Also, I never use the E brake so can't imagine that would have any impact
View 10 Replies
Advertisement
So I have an 06 mercury mountaineer it was making a rubbing noise from the rear left tire area so I replaced the bearing took the merc for a test drive and as soon as I applied pressure to the accelerator the TCS kicked off all power and it left like the brakes on the front left engaged (accompanied by some nasty grinding noises). I have taken it apart replaced the hub assembly and the cv axle, nothing looks to be out of place and everything is clean I cant think of anything else it could be..
View 5 Replies
My 04 gli makes a rubbing noise when accelerating thru hard left turns.. but weird enough i can take the same turn at the same speed in neutral and have no noise at all. I changed both front wheel bearings and cant seem to find the answer. I brought it to vw and they checked the whole suspension struts springs cv's tie rods ect. and they all checked out good they said. the car used to have a exhaust and i just recently put it back to stock, could the exhaust make the noise perhaps?
View 1 Replies
I had this problem before on my 2009 RX350 and took it to the dealer - they were stumped at first but eventually figured out it was the spare tire making noise every time I made a turn into a driveway or went over a little hill/bump.
They did something to adjust it or tighten it and the jack etc. and it went away. Now the sound is back, big time. How to adjust the spare to get rid of this. Also if there's a hack to pad or insulate the spare that would be great.
I also found another thread on a similar thing but it's talking about struts, shocks and trailing arms on 3rd generations. [URL] ....
View 4 Replies
Our 04 Prius makes a really scary metallic noise at the top of the engine when it is engaged. All maintenance has been performed within 100 miles of the warning light. We are the original owners and the car has 160k miles. No pulleys are touching their surroundings. Make no mistake, this a LOUD noise that has been growing with time. No warning lights,,,oil level is fine,,,and no metal visible on the dipstick. Sound is originating at the top of the engine and is not a "knock". It is more of a metal on metal type of noise.
View 4 Replies
While driving through a tunnel today I noticed a metallic rattling noise upon acceleration. It goes away immediately when I let me foot off the gas and when I park the car and rev the engine the sound does not occur.
A few days ago, I had to rapidly accelerate and it felt as though I lost power for a split second. I am not sure if these are related, but I am hoping its not some sort of transmission issue (unless that is covered under the hybrid warranty. What was the diagnosis?
View 1 Replies
The rear left side is rubbing over bumps with 2 adults in the back...
Specs are as follows :
Rays VR G25
19x8.5 ET45
19x9.5 ET42
Goodyear AS2 Front - 225/35/19, Rear - 265/30/19
Lowered on HKS Max IV GT
Really want to keep the lowered look and in fact I want to lower the rear 5mm more. Thinking of changing to 255 in place of the 265 for the rear.
View 7 Replies
This has going on for a few months now off and on. Whenever drive my F hard I notice this metallic click when i go to shift hard into second. The metallic click seems to be coming from the front of the car. I also get it if I'm around 3600rpm in and stomp on the pedal in first or second. It also happens when I shift into reverse. What it could be??
It also happens when i floor it and let off and do not change gears mainly in first and second. Sometimes i get a double click also.
At first I thought something could have gotten trapped in the engine bay and it only accelerated to a high enough speed to cause an audible noise but seeing as it been 3 or 4 months I don't think its the problem. It does not seem to effect spend and it does not make the click all the time.
View 14 Replies
Noticed this morning that my Honda Civic is making a metallic scraping noise while moving -- happens when not braking. Appears to be coming from the left front. I noticed it at very low speeds. It isn't exactly the "wah-wah-wah" grinding sound that changes a little in pitch as the wheel rotates that I'd expect from a bearing. I've been through a bunch of Youtube videos from people diagnosing various wheel- and brake-related problems and haven't found one that matches mine yet.
View 3 Replies
When I drive my prius and make sharp turns or any sort of UTURN, the wheels lock up, automatically brake and there is a grinding noise as if the wheels are rubbing and there is a beeping noise. I took my prius back to the dealer for warranty repairs and the problem persists. is this a normal thing?
View 1 Replies
So, I put my RCs with Eagle F1 DSG3s back on and now I have noise. I thought there was some rubbing, so I spaced them out tonight, but the noise is still there. I thought it could be my alignment, so I got an alignment, still noise.
It happens when I'm going straight and when I turn left, but not at all when I turn right, things get quiet. It sounds like a a rubber rubbing noise but i took the wheel off and I couldn't see any wear... Could it just be tire noise??
View 24 Replies
Tonight I left my wife in the car as I ran inside a store, when I returned she said the car was making a weird noise. I didn't hear it until later after we were moving, but she was hearing it sitting still, no engine idle (battery at 5 bars) but A/C was running. I am suspecting maybe it has something to do with A/C.
The noise sounds like a low grumble rubbing. She said at first she thought someone was rubbing something against the car. But it seems to be coming from the passenger side dash, like behind the top glove box.
View 3 Replies
I've noticed that when I take right or left turns at slow speeds I hear a series of clunks. Sounds like a pipe rolling in the bed. Guessing it has something to do with the rear springs??
View 2 Replies
I recently acquired a B4000(for a steal!), had it almost a month now and im starting to notice a few problems, all driveline related (I think).
1. Have a "grinding/rubbing" noise in a LEFT turn only. It is a 4x4 and I haven't turned a bolt on it yet, save for very minor stuff. Since this particular model has some costly parts, I'm trying to prevent buying unnecessary parts! I have a set of 31 x 10.50 on it, and even though there is some minor tire rub, im 90% certain this is not the case.
2. Has a somewhat "hard" shift when going into O/D(I think), doesn't do this all the time, I wonder if problem #2 and #3 are related.
3. Appears to be about 1in slack in the rear driveline, wondering if it is the rearend, and specifically the spider gears or pinion?
4. Also seems to be just a LITTLE slack in the front left CV axel, is this something I should be worried about? the front right is good and tight, Tcase shifts like its suppose to.
View 10 Replies
I have a 2009 Toyota Corolla and it's making a loud grinding metallic noise on the front left side. It does it while I drive the faster I go the louder it gets. When I turn to the left it makes it louder, when I turn right the noise decreases. PG&E have been breaking the roads by where I live and there's a lot of little rocks I drive thru. I'm wondering if that's the problem?? What do I do?
View 4 Replies
Just started hearing a thumping/ rubbing sound when I make left turns (nothing moving forward or right turns). Thought it might be a tire rubbing but I can't see anything. Starting to think maybe a bad cv joint. Is their a way to check if a cv joint is bad? How hard would it be to replace a cv joint and shaft?
View 3 Replies
Just got my 2013 RX 350 CPO and been driving it for 2 weeks without any problem. But today when I was trying to steer my wheel all the way to the left (car was parked) and I heard rubbing noise coming from wheel base. It only happens when making hard left steering not right.
I read online and seems like it's a common problem for wheel bearing for Lexus cars.
View 8 Replies
My dually has started to make a rubbing or grinding noise just about every time I make a turn, left or right. What this could be, truck has 8500 miles on it.
SD Dually
View 9 Replies
I was recently in a fender bender where I was rear ended. My rear bumper cover became detached on the left side and the spoiler underneath it (left side and center parts) became detached. I lost several pieces of hardware in the crash. I was able to clip the bumper cover back in on the left side, and aside from that, I don't believe any bolts, screws, etc. are missing for the bumper cover. However, the spoiler seems to be missing about half of its hardware.
View 3 Replies
I have developed a sounds that sounds like metal on metal. Not a grinding but more of a "swish swish swish" light metal rubbing when the truck has been running a mile or two. I can barely hear it over the radio but its very noticeable when the window is down. It is not affected by the pressing the brakes and it gets louder and faster in direct portion to speed. It will occasionally leave and start right back up. I touched the front rim around the hub and it was hotter than I wanted to hold onto. It didn't burn but it was hot. It was 105 degrees that day. Here is what I have done.
I replaced that front hub in 2010 and probably have 50K miles on it. I did the 3-9 test and there was no noticeable play. I spun the hub and while it seems to spin ok it does seem a little dry.... I will pull it tomorrow and see what it looks like.
I pulled the calipers off and the brakes pads are at half way and there is no burnt smell. I spun the rotor and it seemed flat and straight. I do have a small tiny lip all the way around them on both sides but I figured that's normal with 265K. I pulled the pins and they were dry but they didn't seem to be sticking. I cleaned them up with the boots and am going to replace them when I get some brake grease tomorrow. I have not looked real hard at the caliper but I plan on pressing that with a C-Clamp tomorrow to check it. Since the rotors and pads looked OK, I assumed there was not a stuck caliper although haven't ruled it out. The axle behind the hub seem to spin freely before I removed all this stuff and the hubs are not locked.
I think I covered it all .. I also thought it could be a rock or stick but nothing came out of my caliper or rotor when I took them off ..
View 14 Replies
Over the course of the past week or so, I've been getting an odd noise from the rear driver side of the vehicle. It's kind of a metallic clicking sound, but the clicks are rather erratic. As I accelerate, the duration between clicks decreases. It's not a "click.. click... click..." noise either. More like, "click click... click... click click click... click click..." If that makes any sense at all. I'm thinking that my wheel bearing is going out, but I don't know for certain. What I might be looking at?
View 12 Replies
