Prius (2004-09) :: Metal Rattling Noise From Brakes Right Front When Going Over Bumps
Apr 17, 2013
I'm pretty sure I know what the problem is since when I hit the brakes it stops. When I took the left side tire off and right side I compared and there is a thin metal sheet that has room to move on the right, but is tight on the left. When the brakes were done before maybe it didn't seat correctly or something. Just wondering what that plate is called so I can order one and change it. Driven that way 2 years, but it bugs me when the window is down and people probably think my car is falling apart. Maybe I'll search for a brake diagram.
Edit: I think they might be called "anti squeal shims". I saw a picture of them, so maybe they didn't put enough high temp grease, but the left side is tight and the rights side you can move a couple milometers side to side so I'm sure that's the jingling noise.
View 13 Replies
Advertisement
Ive got an 07 Malibu ls. For quite some time now I have had this frt end noise. Its a tapping rattling noise on fine bumps. Here is the strange thing. It only happens in the winter and then only for a while when I start driving. It kinda goes away as I keep going. When its very cold it doesn't quite go away but gets lots less as the car is driven for a while. Ive checked everything in the front end including sway bar links. Ive made sure the brake calipers arent loose. Ive had it checked out at a reputable shop. Of course as soon as the car is inside a warm shop, it wouldnt make the noise anyways. They have not been able to pinpoint it either. What was the solution?
View 2 Replies
My 2012 Plug-in spontaneously started making a metal scraping/rattling noise in the middle of a low-speed drive around the neighborhood yesterday. Seems to be coming from the left front wheel area. I've checked thoroughly under the car and in the front wheel wells for anything that could be dragging/rubbing, and I can't find a culprit there.
It occurs while coasting in EV mode, so not ICE/exhaust related. The car doesn't pull to one side or the other. Only 9K miles, so I wouldn't suspect a hub bearing or any other significant wear to be causing this.
Possible clue or red herring: the dealer replaced the the left front tire and did an alignment two days ago, and the noise occurred within 15 miles of driving after that service.
View 6 Replies
My truck is making a metal on metal rattling noise when going over undulations or the type of vibration when you drive over a rumble strip.
It seems to be coming from underneath the engine area, but not quite sure. The sound is like a kettle lid clanking on the actual kettle when the water's boiling if you can hear what I mean. No noise when just driving.
View 14 Replies
2002 F-250 7.3 4x4 ...
I have a rattling noise coming from the front suspension (both sides) when going over small bumps. Most people point to ball joints, but I find my case odd because I just replaced
Upper/Lower ball joints
Track bar
Tie rod ends
Shocks
Front U joints
Drag link
I did not touch the leaf springs or the sway bar, except to grease the links, which otherwise looked good.
View 3 Replies
2008 GX470.
I replaced the front calipers with aftermarket ones from Auto Zone. They came with new slide pins, clips and the anti rattle spring. I put in new OEM brake pads with the calipers. I reused the existing shims as they were in good shape.
Now when I hit a bump the front left pads are rattling. The anti rattle spring is installed properly. The only real issue I noticed is that the slide pins move back and forth very easily and there is a little bit of wiggle room for them in the holes through the caliper.
View 2 Replies
First issue started a few weeks ago. When turning left at a speed > 20mph or when turning wheel quickly I get a rattling noise, which is more prominent with the driver window down, so it sounds like it comes from the driver side front wheel, but not quite sure. It is fairly loud as I have had pedestrians look at my car when turning because they can hear the rattle.
Second issue started this morning but has persisted every time since. When the car is cooling down, we get that whirring noise, which I presume is thr coolant pump. That noise also happens now when I enter the car, and it is accompanied by a knocking noise as if somebody is hitting the outside of the car repeatedly. This is quite unnerving as it sounds like something is hitting the bodywork of the car. It stops immediately when the normal whirring stops.
I had the steering and water pump recall done in november last year, could this be related to that? Forgot ti add the car has done 49000miles....
View 14 Replies
When I'm driving over sharp bumps I hear what sounds like a small chain jingling around. I took off the hubcaps and jacked up the car to see if anything loose. I grabbed the exhaust pipe and shook it, but it didn't make any noise. I couldn't see anything that would cause it. The front right strut's rubber cover is off so could the strut make that noise?
I just read a few posts with similar problems, but one was a compression sound and another was a knock, and another was a metallic hick up. Mine is literally like a loose high pitch chain noise and change rattling in your pocket. No uniformity to the sound. But it also only happens over quick small bumps not large ones like speed bumps.
View 5 Replies
I have an 04 rx 330 with air suspension. The swaybar end links have just been replaced on the front and a rattling noise persists.
The noise happens over large and small bumps at high and low speeds at normal and low vehicle height. When the height is at "HI" the noise is louder and it feels as though the front end is shaking loose over bumps at 10 km/h+.
I took it in and was advised to replace the end links, they did so and returned it claiming the noise was gone. The air compressor and struts are in working condition.
I have done a search through the forum, not extensive... I was wondering which other components come loose/wear and cause a clunk/rattle/shudder noise.
Also, tires are new and at approx. 32-34 psi.
View 1 Replies
I have a 2013 F150 with 80,000km+ Original front brakes. When I am driving around and hit any bumps, I can hear a rattle. A slight pedal will make the noise go away.
The pads still have lots of life in them, so besides replacing them, what can I do? Or, is it actually something else? I have a 100,000km warrentee.
View 4 Replies
I got some coilovers installed last night, they are ksports. i have them on fairly low height as of now but i have noticed every time I hit bumps, I hear a kthunk (metal hitting metal noise) from my front driver side. is it from the coilover nuts itself or something wrong with my control arm? the sound ONLY comes from the front DRIVER side.
View 4 Replies
What we have is a 2011 F-350 with the ambulance package (obviously) and it has started making a very annoying sound from the front end. It has been into two different Ford Dealerships and they have not been able to remedy this issue. What happens is, when we are backing and turning, the front end makes a bad metal on metal grinding noise. When going straight down the road no issue just turning while backing. I know this is an ambulance and has the ambulance package but I think from the cab forward should just be all ford right?
View 2 Replies
I have a question about my C Four with 16" wheels. When the steering wheel goes all the way to a stop there is a thunk that feels like metal on metal. It is like there is no rubber bump stops. If this is normal. I am used to cars that have a nice cushioned bump at the steering limits.
View 1 Replies
Have a 2011 SE with just over 21k miles on it.
Problem #1: When ever I go over bumps, go down my drive way, I hear this rather loud noise coming from either the roof or right rear. It sounds like someone is hitting metal with a hammer.
It happens when I'm turning the wheel or just driving straight.
Problem #2: Also when I am going over a speed bump, when the rear of the car goes over it, the suspension gets squeaky. Speeds are about 2-3 mph~
Unfortunately, it is no longer under factory warranty so taking it to the dealer is my last option.
View 5 Replies
I have intermittent metal on metal grinding noise. Seems to happen when I am at highway speed. Seems to go away when I put it on 4 wheel drive or slow way down. On one occasion though, the grinding noise did not stop even after putting on 4 wheel drive - had to stop completely before it went away (did not come back after I drove off again). Diagnostics so far....
Unhooked the vacuum lines on passenger side actuator and hooked up vacuum gauge. Vacuum held at 20 psi and drops and raises slightly as the truck is being revved. Takes about 10 seconds for vacuum to drop to zero once truck is stopped. Putting it on 4 wheel drive drops it to zero immediately. Exact same scenario on the passenger side.
This leads me to believe my IWE solenoid is ok. So also my check valves. Next opportunity I get, I will raise one wheel, remove the vacuum line on that wheel and apply vacuum with my pump. Want to see if it will turn my half shaft.
2004 F150 FX4 ....
View 7 Replies
I commute 180 miles a day, 6 days a week. I noticed metal on metal grinding noise(more noticeable) at high speed above 75mph especially on asphalt road. I'm sure noise is there at low speed but not enough to notice. My car has 50,000 miles. Tires? Electric motor?
View 7 Replies
I recently worked on a 2006 with 140K miles that presented with the following symptoms:
The hybrid battery was at 1 bar; the ICE would not start; the car was in Ready, but there were no codes. As I let it roll off the flatbed wrecker in Neutral, it felt lumpy. If you have ever pushed a car (or run out of gas in one) with a manual transmission that was in a high gear, engine off, it felt just like that.
I popped the hood and could see that the engine crank was turning while the car was being pushed in Neutral. What else turns with the wheels? MG2, or more specifically, the MG2 ring gear. What is the only way that the wheels could turn the ICE crank? The planetary carrier pinions were locked to the ring gear.
Surprisingly, while I was looking at things, it did manage to start the ICE pushing it around must have freed the carrier pinions, so I let it charge the hybrid battery. It was basically the worst metal-to-metal noise that I have ever heard! I pulled the drain plug and saw about a teaspoonful of large metal chips on the magnet. The fluid condition itself was very good, not the black factory fill that I am used to seeing come out.
View 19 Replies
I have a 2011 Prius with about 32K miles on it. I've been hearing light metal on metal grinding noise for a few days now. So I decided to take it to a stealership and they told me my ceramic pads and brake rotors both need to be replaced for all 4 wheels. I thought Prius brakes don't need to be replaced for 100K miles.
View 7 Replies
I had the front struts replaced. I looked at the strut diagram and replaced most of the parts associated with the front struts. The rear shocks were also replaced. New brakes were installed on the front and rear. The front rotors were replaced. Mileage 124000 miles.
I thought this would might solve the squeaking when I went over a speed bump in the parking lot. It did not. How to fix the squeaking.
View 3 Replies
While driving over bumps my front end makes horrible rattling sounds. The car also bounces somewhat wildly when i push down while it's parked. I figure its time to replace the suspension as it's got 125k miles on it. My question is exactly what parts do i need to buy? I am going to do both the front and back. I see names of parts thrown around all over. bushings, struts, springs, bearings etc... so what parts do i need to buy?
1997 pontiac sunfire 2.4L coupe
View 15 Replies
Front end noise over bumps / Bouncy fuel gauge....Lets see how it goes. Brought the car in for a few things to have fixed under my CPO warranty.
View 8 Replies
