Prius (2004-09) :: Error P0100 - Noticed Oil In The Sensor
Aug 13, 2015
I have DTC code P0100 so I got to the camshaft position sensor and noticed oil in the sensor. I can't imagine an electrical sensor is a good place for oil.
View 7 RepliesI have DTC code P0100 so I got to the camshaft position sensor and noticed oil in the sensor. I can't imagine an electrical sensor is a good place for oil.
View 7 RepliesAn OBD tester is reporting error code P1100. Checking online I have discovered that it is in reference to a Barometric sensor that is reading out of range. However, I cannot find any identification of the Toyota part number, its location, and whether or not it is a DIY replacement
View 1 RepliesI just found a HUGE water leak in the back of my 2004.
View 12 RepliesI've read several reports about failed water pumps. Well, Pearl stated leaving drops of pink coolant on the garage floor a few weeks ago. I thought perhaps I had overfilled the overflow tank so I just ignored it. Finally warmed up so this morning had a look. Water pump! Pulley had lots of pink decoration all over it.
View 4 RepliesGot the p0051 error code and its calling for a o2 sensor. What brand does lexus use? I rather get one on line but dealer quality.
View 12 RepliesI have a 2004 MK4 Golf 2.0l that's been throwing a CPS error code. My brother was going to come down to visit for a weekend. He had done some diagnostic work and had me order a timing kit and a camshaft position sensor from ECS.
So, with my assembled parts, I brought the car in to a reputable shop. Anyway, the guy does the work and now the car is ready and saying that the CPS took nearly 4 hours more of work.
My truck is just turning over 100k miles and I still love her like she was new. Recently I've noticed accelerator hesitation (especially in slow traffic) that wasn't there before. Also something new, the fuel system no longer bleeds pressure when I remove the cap to gas up. I think the lack of fuel system pressure has something to do with the hesitation. I did the easy thing and replaced the gas cap. I asked the dealer and they checked fuel pump(s) output pressure and said they were normal.
View 11 RepliesI see black particles inside the car whenever i drive, i don't know if this is coming thru vent or from outside, or something gets burnt inside which is throwing this . I don't smell anything burning.
View 5 RepliesFirstly let me say that the car is still running perfectly and giving great MPG, but I just wanted to document some early signs of traction battery weakness.
View 13 RepliesI replaced the MAF a week ago but the code P0100 is still there. Car runs fine in the highway but I do notice acceleration issues. I got the knock sensor but I cannot find it in my nissan altima (2000). The car shakes while stalling, at a red light, and pretty much as soon as I stop. Putting the car in N will work a bit but won't stop the shaking. Should I focus on the MAF again or should I keep trying to replace the KS? Where it is?
View 3 RepliesThe wifes camry all of a sudden tossed up CEL. Codes read P0100, P0110, and P0420. Car has about 125K miles, runs fine. I cleaned the MAF sensor with CRC cleaner just for that, pulled EFI fuse to reset, came back on immediately when started.
I was thinking of getting a used one from pull-a-part, but they only have 98 camrys at the moment. Any chance MAF is the same?
Left my 2002 SF 2.4 with someone to replace clutch. Calls me after the job to say it doesn't run!
Codes P0100 and P0340.
Maf is new. I had a Cam sensor in stock. Nil fix.
Have changed out recently;
Fuel Pump
Coil packs
CPS
MAF
and just now, the Cam sensor.
It starts right up then shuts off, does not slowly sputter and die.
I asked him to go over the wires and connectors. He could have stressed a cable while pulling the tranny. I do have the old MAF that I could try, but doubtful it would fail at the same time as a clutch job. Now wishing I had done the clutch myself!
Check engine light came on yesterday evening. Advance read the codes as P0100 and P0171. The guy said something that it may be related to the mass air flow sensor. The car seems to run fine.
View 2 RepliesMy car has been fine with no changes besides tires last week, its a 2006 Prius and yesterday I got lights on my dash, went to auto zone for a read out and got an HV error code. I was wondering what is the most affordable route for my car to get repaired. I don't notice any mpg differences and everything still charges and recharges as if the errors don't exist.
View 19 RepliesDriving to work today, was changing from one CD to another with the steering wheel controls, when the current CD indicator started flashing and the error message "CD Error" appeared. Unlike other, similar threads I've seen, the CDs were all able to be ejected, reloaded, and ejected again, but will not play.
View 10 Replies2005, Gen 2 got check engine light. I've turned it off, will see if it reappears.
View 5 RepliesIts a 2009 Prius with about 75K miles on it. I have scangauge on the dash as well as mini-VCI. It is setting PO456 code time after time. I reset it, but it comes back in about 50 mils of driving. Its not the gas cap, I turn it until it clicks every time. Something is wrong with evaporative emissions system, which I wouldn't care about, except it might mask some other fault code that is more serious, as it keeps check eng. light on all the time.
View 7 RepliesHad my Check Engine light come on so I went by a local AutoZone to see if they could read the code. He said it was P0137, but what his reader can't tell is which one it is.
A co-worker pointed out where it was on my 2006 2.4, but I'm not sure if it's the sensor in the engine bay or the one closest to the catalytic converter. The engine bay looks easy to change out but I'm in no condition to be crawling around underneath.
Which sensor the P0137 is referring to?
HV battery problem. I have Prius from 2007. In The car occur na error U0293 - Lost communication with Hv ecu.
View 9 RepliesI was driving home the other day and my CEL came on... I checked the gas cap and waited a few days to see if it cleared. When it didn't clear I had the codes read and it came back with 3 instances of P0505.
View 2 Replies01-d5 190-45-c
01-dc 190-75-5
01-dc 1c6-0f-f
01-de 1c6-2b-1
The aux battery was changed about 9 months ago and the only problem I currently have is the tag lights are not working.