My 2005 Prius has 95k miles on it. I've been hearing a cluck-cluck-cluck noise from near the front driver side wheel. I had an independent mechanic test drive it, who said the wheel bearing needs replacement. Should I have it checked out by a Toyota dealer? They're so much more expensive, but are is it worth taking it to them?
View 15 RepliesI have a 05 Prius. Developed a low hum noise some time ago. It now is so loud can't hear the radio. Sounds like a heavy agressive truck tire rolling down the road. When turning the steering wheel from right to left quickly, noise level changes. Does this sound like a bad wheel bearing and if so what am I looking at for repair costs?
View 5 RepliesFirst issue started a few weeks ago. When turning left at a speed > 20mph or when turning wheel quickly I get a rattling noise, which is more prominent with the driver window down, so it sounds like it comes from the driver side front wheel, but not quite sure. It is fairly loud as I have had pedestrians look at my car when turning because they can hear the rattle.
Second issue started this morning but has persisted every time since. When the car is cooling down, we get that whirring noise, which I presume is thr coolant pump. That noise also happens now when I enter the car, and it is accompanied by a knocking noise as if somebody is hitting the outside of the car repeatedly. This is quite unnerving as it sounds like something is hitting the bodywork of the car. It stops immediately when the normal whirring stops.
I had the steering and water pump recall done in november last year, could this be related to that? Forgot ti add the car has done 49000miles....
Our 2011 w/140,000 miles has a variable front end noise that I suspect from past experience with other vehicles is a bad wheel bearing. I've seen posts of the procedure for replacing the Gen 2 bearings that requires the hub and bearing be pressed out and new bearing back in which would limit the DIY'er, but looking at the replacement parts diagram for the Gen 3, it appears that the hub and bearing unit is bolted in with 4 bolts and may not need a hydraulic press to install.
View 4 RepliesI gotta a roaring noise coming from my right front while turning. Planning on replacing just the wheel bearings tomorrow & not the whole hub assembly(2008 2wd). Is there a thread that lays out the steps and other parts I may need? I've seen alot different stories on the net on how to do it. Everthing from I can press new bearings to I have to do 4x4 hub conversion. Seems to be some confusion.
View 2 RepliesSo on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 RepliesAs the weather got hotter, I have started to drive with my windows half-down when driving through city for short distances, otherwise I use AC. What I noticed about one month ago was the noise coming from the wheels when going over bumps. It is really annoying and sounds like when you shake metal balls in a pocket.
Firstly I thought that it was coming from the brake calipers, so I replaced all the shims (actually, I have replaced rotors and pads also as they were pretty rusty and I got a good price on them). However, the noise is still there. Yesterday I got my tires replaced for the summer ones and as I was checking afterwards if the bolts are tightened correctly, I noticed that if I shake the wheel (really hard) then I can replicate the noise. To have it summarized.
What I have tried already: Replaced rotors, pads and shims on every wheel and ensured that all of the bolts are tightened correctly. And I have also googled about this problem but every finding was about the shims not fitted correctly.
What are the symptoms: Strange metallic noise coming from the wheel (every) when going over road surfaces that are not perfectly flat and with windows down (when they are all up, I cannot hear anything). I can replicate the noise if I shake the wheel (with car on the ground).
I have taken video of the noise and hope you car hear it, but I think it is pretty noticeable. It sounds like the bolts are really loose but I have ensured 10 times that they are tightened and also as I wrote previously the noise is coming from every wheel. You cannot see it on the video but I'm filming with one hand and shaking the wheel with another (pretty hard), that's why the whole video is shaking.
I have been getting increased noise coming from the back of my car for the past month. So I jacked up the car and spun the tires and heard grinding noises in the rear right. I have a 2012 ToyotaPrius plug-in with 33,000 miles. When driving the car around 40 miles an hour there would be a howling sound coming from the back of the car regardless of the type of pavement I was driving on.
So I took it to the dealer today and they had it up on the rack in about an hour later they came to me and said it needed new tires and it would be about $700 and that this was likely causing the noise. I said that there was no way that it was the tires so I went and showed the mechanic how old the sound was coming out of the back right wheel. He listened with his stethoscope on the wheel bearings and said that he did hear some noise in there but still thought it was the tires.
Have a 2000 Forester with 114K. Had to replace driver's rear wheel bearing at 100k & again at 110k; when replacement bearing started to fail, ABS light came on because wheel was not spinning true! Replaced passenger's rear wheel bearing at 105k (this one is getting noisy now).
Hard to believe I got 2 "bum' bearings! Not a difficult repair, but this will be 4 bearings in less than 2 years. The car's driven on paved roads & with little load, so it's not from harsh road conditions or heavy loads.
99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
At about 20k on my 07 I started hearing a faint whup whup whup between 35 and 50 mph's on the front driver's side area. At 60+ pretty quiet. It has gotten real loud at the present 30K. I suspected the tirers as I know the Integrities are complete junk but as a test I did a rotation and exact same noise.
I thought thats not good but found it hard to believe something else was bad as I had no vibration and no pull whatsoever in steering. Long story short I bought a new set of tires Kumho KR21's at stock size and oh crap exact same noise.
I've been having a lot of noise coming from the front left tire, and I finally had it diagnosed as a bad wheel bearing today.
I noticed that the front wheel bearings are sold individually while the rear wheel bearings are sold as hub assemblies. Is there a certain way that the front wheel bearings have to be removed and pressed on? I'm trying to see if this is a DIY repair.
I have a 2006 Prius (150K miles) with a noise coming from the drivers left wheel. It is a hollow metallic squeak that only occurs while the vehicle is moving. It sounds like the wheel is making brief contact with something metallic at the same point on every rotation. The pitch of the squeak increases with the speed of wheel rotation. It does so while rolling, with breaks and without. The noise gets louder when turning right, and softer when turning left, though it begins to get louder again when the wheel is turned hard all the way left.
View 1 RepliesI just got a new Sonata and I find the car has a noise like bad wheel bearings in front, it sounds like driving on really rough pavement.. I have changed the tires and still get this..
View 1 RepliesSo.. Today coming back from work, I felt clucking sound from front wheel when going from 5-15mph. I even felt that when I had my left foot on the foot rest area. Its appeared during the driving from work to home and check whether if there is any rock or tree branch on tire or wheel but no...
So after 30mins later, went to gym and the the sound was completely gone.. Would it be because of bad wheel bearing or suspension or ball joint issue?
2012 ISF
Front wheel bearings making noise. Can I buy replacement bearings/races/seals, or must i buy a whole new hub front assembly?
View 3 RepliesI hit a curb in my 97 corolla now it's making a noise in the front driver side wheel well driving down the road, what it is?
View 6 RepliesMy front wheel bearings on my 2007 Prius are loud. I think its the drivers side. Where can I buy prius OEM parts online and part #s?
View 4 RepliesTruck has 1800kms on her, pretty much brand new but there is an odd clicking noise on the front drivers side wheel when I adjust the steering from left to right and vice versa. Its quiet if I am going straight, but it sounds like there is a linkage loose. Its not too loud or noisy, but having problems with tierods/knuckle assy?
View 1 RepliesMy car is a 2000 Corolla CE I bought 2 months ago with 45k miles. It does not have ABS system.
Before I took the mechanic:When I brake, there would be a "clamping" noise from the drivers front wheel sometimes. It sounds like the caliper "clamping" noise. The brake cylinder would also click the first time (and maybe second) the pedal is pressed.
The mechanic replaced the both front calipers, put new brake pads, installed rear drums and shoes, and changed brake fluid.
The brake pedal is now high and when I brake....it does brake but it's not like "instant stopping power" like new brake pads. Is this normal? (maybe I have to break them in). Also, the master cylinder is still clicking (I pump the brakes since my car has no ABS)....it clicks the first 2 times I pump. Is that normal?
Edit:Since the repair, I drove it for the second time. This time the brakes brake more "instantly". The clicking of the master cylinder is still there however, could this be due to air in the hoses?
Lowered my car yesterday. 23" FTG. I'm now hearing a clicking noise from my drivers side front wheel.. I mostly hear it when my foot is off the gas and I'm just coasting (usually at slower speed). Also, it gets louder (worse) and is accompanied by what sounds like a rubbing when I take turns.. Is it axle bind? Or should I be concerned?
View 1 Replies