My wifes 2008 prius check engine light just came on. Its the control valve sensor. My question is, does that have any serious impact on safety? I've heard mixed on what this valve does (overheating etc).
View 6 RepliesI have a 2009 Prius and the check engine light came on last week. I decided to take it to a highly recommended auto repair shop instead of the dealer. The error cord was P1121 and they replaced some kind of coolant control valve. When I went to take the car home I noticed the check engine light was still on and they said there was another similar but different coolant valve that needed to be replaced. They replaced the other part and everything seemed fine.
View 10 RepliesMy check engine light was throwing the code P1121 for the coolant flow valve. Toyota replaced it under a warranty enhancement (I have 134k on it), and since then my mpgs have gone from 46 to 50.
My AC is working much better now, too. My theory is that the valve can be in a semi-failure mode for a long time before throwing a code. Now that My coolant is flowing the way that it should, heat is being dissipated more efficiently.
The check engine light on my '05 Prius has gone on and off a couple of times and is giving me a P1121 code, which I found out means "Coolant Flow Control Valve Position Sensor Stuck". Does this have anything to do with the hybrid electric coolant pump that was replaced under recall a while back?
View 5 RepliesIt's been a long week for me and my 2007 Prius. Brought it to the dealer after receiving my first ever CEL. I have 222,000 miles on the vehicle. The a/c was also blowing warm when the CEL came on. They checked that and told me that the compressor was "breaking up." Then they call me back to tell me that my 12V battery died. They asked me if I had problems with starting the vehicle. I said never. Never had any issues with the car in 222,000 miles.
Well, told them to replace the battery (no choice) and the car is 5.5 years old in Florida heat so it was ready to die. Very suspicious that it died while they had the vehicle, but what can I say. Told them to not repair the coolant flow valve or the a/c until I could investigate further on my own. CEL is now off. The a/c is blowing cool again.
The check engine light came on yesterday. 2004 with 115K. Auto Zone read the codes and they are as follows:
Definition:
Idle Air Control Valve control circuit.
Probable Cause:
Open or short circuit condition.
Poor Electrical Connection
Failed IAC motor
For several months now, my 2007 Prius has been making an intermittent buzzing sound from the engine bay. When I first heard it, I thought I had hit the little lines they cut into the road to let you know you've drifted over the center line - the sound is like that, a low-pitched buzzing noise. Today, the check engine light came on as it was making that noise. I put a code reader on the car and got P1121, a bad coolant flow control valve. Wondering if the sound and the faulty control valve are just coincidental or if the valve might make that noise when it fails? And if not the valve, what the sound might be?
View 19 Replies2004 Prius, 98K miles ... I recently replaced the coolant control valve (received code P1121) and added coolant. Trouble codes were cleared. I am now getting the red triangle intermittently. When I drive the car, after a few minutes, the red triangle comes on. I can shut off the car, and turn it back on, and the red triangle comes back after a few minutes. The car seems to drive normally.
View 3 Repliesi have a 2005 Toyota Prius that the air conditioner wont work in. it has Freon in it the compressor wont kick so I did some research and my cooling fans aren't kicking on so I did a by pass test and the cooling fans motor is good they just wont kick on. I just replaced my 2 cooling fan relays and they still wont kick on. the check engine light was on in the car when I got it. it throws the code P1121 coolant valve control. I got the part just got to get it put on. Could this part stop my cooling fans from kicking on or my ac compressor from coming on.
View 3 RepliesI was getting a check engine light with a P1112 code, so I had a mechanic replace the coolant flow control valve. There's a TSB on that and it seems to be the thing to do. But after the replacement, I'm getting overheat warning light whenever the engine needs to work hard. Also, the cabin heater only works when the gasoline engine is not running... when the engine is off, I get heat (though it's not as hot as I'd think when I have it on max heat), but when the gas engine kicks in, the cabin heat disappears.
View 8 RepliesSo I drive a 2008 and a couple months ago I started getting the Check Engine Light. Codes P1121 & P1116. Found out it was most likely related to a faulty Coolant Control Valve or Electric Water Pump. Since the pump was just recently changed I went ahead and got the valve changed.
The light is still coming and going but now when I go on the expressway that red triangle with the exclamation pops on with a little beep. Only pops on for a couple seconds and keeps coming back until I drive a bit slower.
I purchased a build Dec 05 1.3l Yaris several months ago. I recently started to get a check engine light, so I did a scan of the computer and it returned a P0012 error. Though multiple searches, I learned that this is likely due to the Camshaft Timing Control Valve Assembly or possibly the OCV filter.
Further searches haven't been able to reveal which parts I need to purchase to replace these items. I can only find details for the 1.5l engine.
The engine is: 2nz-fe, model: ncp90r-agmrkq
1. I don't even know where these parts are located on the car?
2. What part numbers do I need to purchase to replace?
I recently had someone run a scan on my 2008 prius, which just had a check engine light pop up on it.
It came back with the following code: P1118 MANF. CONTROL FUEL AIR METERING
I just bought a used 98 Acura 3.0CL. I've noticed that when the heat is cranked, it doesn't blow hot at all. I did some quick research and came up with two answers thus far; check the antifreeze coolant and that I may need to replace the heater control valve. Am I "warm" on the area?
View 19 RepliesEngine runs perfectly but "check engine" light" stays on due to faulty Emission Evap control pressure sensor (P/N; 89460-0w020). Problem is Toyota no longer makes this part and there is no after market for it. It appears I may have to "junk" a perfectly good truck.
View 9 RepliesThe check engine light came on in my 05 so took my local shop and they checked the code and said it was the Idle Sensor. They were not able to make the repair. Since then the light went off for a few days then came back on. I now notice the gas motor does not turn off when I stop at a traffic light.
View 14 RepliesI have an 04 gx with a check engine light on I had the code read at auto zone. That tells me o2 sensor bank 2 sensor 1. I have already changed the sensor they said it was and still have the code. What is the correct location of this sensor?
View 2 RepliesJust picked up a Toyota certified 2010 Prius III....less than a week later, the check engine light comes on. Took it right back to the dealer...in which they said its the air/fuel sensor. Toyota warranty services was closed, so they need to check tomorrow if its covered by the remaining warranty or not.
View 2 RepliesI have a 2004 Corolla with a Check Engine light on. The Toyota dealer diagnosed this as: "Oxygen Sensor Bank 1 Sensor 1 - slow to respond".
The diagnostic code is PO133. Elsewhere, I find that this code indicates:
The oxygen sensor is faulty.
The wiring to the sensor is broken / frayed.
There is an exhaust leak
Haven't noticed exhaust leakage, and I doubt the wiring is faulty.
1) Where is sensor 1?
2) Do I really need a new sensor, or can I clean the old one?
My check engine light is on and I think the inverter pump is shot. I have a some questions about how and when the pump is on. I have a mini vic on order and as soon as I get it hooked up I'll run for some codes. That is if I get it installed????
1- With the car in "ready mode" and at start up (car cold) should the inverter coolant pump be running.
2- With the car in "ready mode" Should I always see a water moving in the water reservoir.
I was driving home and all of a sudden my rpms are at 3.5 4k rpm wont shift to next gear. I put in in tiptronic mode and shift it to 8 it works fine. Then about 10 minutes later check vsc shows on dash traction control light is on check engine light is on and the light next to the check engine i think it is the abs light. I havent pulled the code yet.
View 1 Replies