Prius (2004-09) :: CEL With P0138 And P2195
Jan 31, 2011
Another Check Engine Light, P0138 and P2195.
View 10 Replies
Jan 31, 2011
Advertisement
Prius (Gen 2) :: Diagnosed P0138 And P2195 - Squeal When Driving / Wheel Alignment
I have just bought a 58 plate (late 2008) Prius T-Spirit, 32k miles . These are a couple of issues I am having (car was bought 7 days ago, issues appeared after a couple hours of driving home from dealer)
Engine Warning Light on. Diagnosis says P0138 and P2195 relating to fuel mixture and 02 sensor. If codes are cleared, they reappear when accelerating quickly uphill etc
Wheel alignment issues. I have to have the wheel around 15 degrees to the left when driving to go in a straight line, getting worse at higher speeds.
Squeak/ Squeal when driving. This happens very intermittently below 35mph. Sometimes when braking, but mostly through normal driving.
Camry :: P0138 And P2195 - Location Of Sensors
I plan on changing the 2 sensors from the codes p0138 (bank 1, sensor2) and p2195 (bank 1, sensor 1). Any visual picture on here to locate these sensors?
2007 Xamry XLE V6
Ford F-150 (2004-2008) :: Got Codes P0058 / P0138 / P2270?
I have a 2004 f150 5.4 with 78,000 miles and i have a engine light on so i had my bud do a scan and 3 codes came up P0058,P0138,andP2270 i was hopeing yall could explain the problem and point me in the direction to fixing this problem.
View 3 RepliesLexus RX 2004-09 :: CEL Appeared When Merging On Highway - Code P2195
Last week I was on a dive trip and my RX remained parked outside for a week. As I was returning home and I was merging on the highway my CEL appeared; I used my scanner and the code was p2195, which I cleared. My RX was driven for about 5 minutes before merging onto the highway.
On my way home I needed to stop for gas, I filled up and them merged onto the highway and the CEL came on again. I used the scanner and the same code p2195- which I cleared.
I completed my drive home, and have only been doing short city driving since then an no CEL's.
Ford F-150 (2004-2008) :: Codes P0053 / P0132 / P2195 And P2196 After Manifold Swap
Had my friends shop replace my passenger side exhaust manifold on my 2004 FX4. Two studs at the front broke flush and one other broke but was sticking out of the head. To get room they did the trick of unbolting the trans mount and the passenger side engine mount and moved the engine over. All is back together but started throwing the 53,132, 2195 and 2196 codes, engine seamed to run fine though. Before bringing it back in I decided to check for any simple things, vacuum leaks or connectors that might have been knocked loose. At first I thought this was a good candidate for a vacuum leak but it turned out to be a vent for the front hubs.
My next thought was that maybe the pass side upstream oxygen sensor got knocked during the work and was now shorting out. It is very tight on that passenger side! Truck has 102,000 miles so they were at the end of their lives. I decided to just replace all 4 with OEM units. I used one of the oxygen/mapp gas torches from the hardware store and a 7/8 in wrench. The drivers side was easy and I did not have to remove the drive-shaft like some write-ups discussed.
Although doing that would give plenty of room. Pass side downstream is fairly easy, upstream was a bit tougher. I took out the inner fender skirt and loosened the trans dipstick tube. That gave just enough room for my large hands to reach in and turn the connector so the sensor side of the plug faced out. I used a pick and fashioned a hook out of a coat hanger to pull the connector apart. That ended up being the hardest part. Putting a good amount of heat into the sensor bung quickly made all the difference in getting them out.
Here is what the upstream pass side sensor looked like. Could not see it from below or from the wheel well.
The codes are all gone now (were coming back after one drive before) so I think the sensor was the issue.
Camry :: 2007 2.4L - Code P0138 And P0606 After Replacing Exhaust
A few days ago I managed to replace the front and intermediate exhaust pipes using new hardware and new gaskets. Prior to this (see my other thread about the rusted flex line), I did get P0137, but that was probably due to the fact the pipe broke before the O2 sensor, giving it a strange reading.
Two days ago after replacing the exhaust with Dealer parts, ensuring everything was tight, and putting the old O2 sensor back, I started the vehicle up, and upon idle, there were no lights whatsoever. Today several minutes after I started driving, I received the check engine light, and with the code reader, came up with the codes P0138 and P0606.
P0138 is O2 Circuit High Voltage (Bank 1, Sensor 2), which is the sensor I removed and put back.
I assume that this sensor needs to be replaced, and I assume that this has caused the P0606 ECM code as well.
Before ordering a new sensor, is there anything else I should check? I did make sure to plug the old sensor back in properly, and checked all the connections on the exhaust to ensure they were tight. All parts were Dealer parts, and nothing else was touched, changed, or modified.
The car sounds, and drives great since the exhaust change.
Lexus RX 2010-15 :: P0138 And C1241 Codes With Error Messages On RX350
My wife suddenly had error messages today, Check AWD System, check engine, traction. Carista reports P0138 O2 sensor high circuit voltage bank 1 sensor 2and also C1241 ABS low battery positive voltage. I get the O2 sensor or wires could be bad, but the C1241 could be expensive ECU. Think both could happen at same time or just a thrown code? Reset turned warnings off but Carista reports permanent for P0138.
View 5 RepliesJeep - Grandcherokee :: 1998 - P0138 Code / O2 Sensor High Voltage
I drive a 1998 Jeep Grand Cherokee, 6 cylinder engine, with about 120,000 miles on it. I used a code scanner and pulled a P0138 code-bank 1 sensor 2 O2 sensor high voltage, if I'm correct. First of all, it looks like this sensor is after the catalytic converter, right? So I think I either have a bad 02 sensor or a bad catalytic converter. What are the consequences of driving around without fixing this? Will I see any reduction in fuel economy, or any potential long-term problems elsewhere?
View 2 RepliesCamry :: 2005 - Check Engine Light Is On / Code P0138 (Rear O2 Sensor)
My 2005 Camry check engine light is on. The trouble code is P0138, bank 1 sensor 2 oxygen sensor. Engine is the 2AF-ZE. Not a California emission car. Car is Japan built. It has two O2 sensors. What is the correct OEM part #? I believe it would be a Denso?
View 2 RepliesDodge - Dakota :: 2002 - Throwing P0132 / P0158 / P0135 / P0138 Codes
My 2002 Dodge Dakota Extended Cab pickup is throwing several different 02 sensor codes. The first one was P0132. I reset the CEL and it ran good for about 1800 miles (100,140) on the odometer now. Now I'm getting a P0158 code and CEL went off after a few miles. Now it's back to a P0135 and P0138 code. Are the 02 sensors really bad or is there an underlying problem with the wiring or the computer. The truck runs like new when the CEL is off. The P0132 has never shown up again. The engine is the 3.9 V6 and is 2WD.
View 3 RepliesCamry :: 2007 XLE 4 Cylinder - P2195 Code (A/F Sensor B1 S1)
2007 camry xle 4 cylinder engine, 2.4 liter I'm getting a P2195 code, which is the A/F sensor B1 S1. I have a few questions:
1. Any diagram of the location?
2. I've been trying to figure out the correct part number, so I can search for a replacement. I've found 4 or 5 different numbers already. What is the correct part number?
3. Should I only by the OEM part? Or do the aftermarket brands like Denso work?
Elantra XD (2001-06) :: CEL With Different Codes P2195 And P2414 For O2 Sensor
Its been cold here in CT for the past three days. It's been in the negatives... My engine light came on last night with a p2414 so I ran it, looks like front o2 sensor (could be a couple of things), so I cleared it and waited. Today it came back with p2195 and p2414. A different code for the same sensor. But my question is this. Before I replace the o2 sensor. Is there anything common for this car that would throw this code?
View 21 RepliesAvalon 2005-12 :: Check Engine Along With VSC Lights Came On - P2195 Error
I own a 06 limited and my Check engine along with VSC lights came on. Autozone read the code and it is a P2195 error. According to AZ the O2 sensor cost $500, according to websites the fix is O2 sensor and manifold ~$1800. I don't have that much money. The dealer told me that it was ok to drive with warning lights on. I checked the MAF sensor and it is clean. The O2 sensor or A/F sensor Stuck Lean - bank 1 sensor 1. If I want to do the work myself, any diagrams, picts, instructions etc......
View 8 RepliesElantra XD (2001-06) :: CEL Came On - P2195 / P0420 And P2096 Fault Codes
Check engine light came on while driving home from work. The car seems to be running fine but I got the following codes p2195, p0420, p2096. I have a 2006 elantra with 184000 miles. Should I just replace the upstream oxygen sensor or is there a more likely problem? I rather not spend the money if this combination of codes is likely has a different cause but replacing the sensor appears to be the quickest and easiest solution.
View 5 RepliesFord Ranger / B-Series :: 2006 2.3L - Code P2195 / O2 Sensor
I have a 2006 Ranger 2.3l 4 cylinder that is have emissions problems the code the tech gave me was P2195 an I bought the o2 sensor just where it is, and the auto stores didn't have a manual for the year of my truck.
View 2 RepliesFord A/C :: Warm Air Started Blowing - Error Code P2195
Just the other day my A/C had started to blow hot air, so I looked online and was told to try and re-charge it by a few people so I went and bought a can of that r-134a recharge and as it was on the low port the gauge was not reading like any of the guides I saw, as it did not stay at just one # it would go from 25 then back up to 40+ then slowly back down and just kept going up and down, I am assuming as the compressor was kicking on.
So I did not charge it at all because the PSI said to be in my car at the temp was 45 and if it was doing this but going 25-40 and back I did not want to over fill it.
So then this morning after doing that last night my engine light comes on, but I was told that the a/c will not effect this but I had it checked and I got an error code (P2195) "lack of heated oxygen sensor bank 1 sensor 1 H02S11 switch sensor indicates lean" with a few causes that may be the reason.
Should I go ahead and charge the a/c? will this cel code have anything to do with the a/c? and also why was the gauge changing like that and not at one steady number? Could it be because the car is running hot and maybe I need to check the anti freeze/coolant?
Camry :: 2003 V6 - CEL On Reveals Code P2195 - O2 Sensor Part Number
Any resource that I can use to find the part number of the O2 sensor on my wife's 03 v6 Camry.
I have a check engine light, scanned by code scanner to reveal P2195. This OBD code is supposedly sensor 1, bank 1 "stuck lean" which is the upper O2 sensor on the left side of the engine (closest to radiator with transverse mounting).
So it should be easy to change if this is the issue but I'm having a hell of a time finding the right part number. Too many choices.
Lexus GS 2006-11 :: 2007 - Getting Errors / P0031 / P2195 / P2238 / P0137?
2007 GS450h Lexus owner, and have got a few error codes appearing on her They are as follows:
Quote:
P0031 - Powertrain
HO2S Heater Control Circuit Low (Bank 1 Sensor 1)
P2195 - Powertrain
O2 Sensor Signal Stuck Lean bank1 Sensor1
P2238 - Powertrain
2) O2 Sensor Positive Current Control Circuit
Low bank1 Sensor1
P0138 - Powertrain
O2 Sensor Circuit High Voltage (Bank 1 Sensor 2)
Am I right in saying, these are all just a dodgy bank 1 sensor 1 (engine bay) and possible sensor 2? Is replacing them myself feasible?
Toyota - Sienna :: 2007 - Code P2195 For O2 Sensor Signal Biased
I have a p2195 trouble code with my 2007 Toyota Sienna CE. This is O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 1. I am assuming I'll need to replace this sensor. It's a little confusing but if I am reading my Haynes manual correctly, the repair goes as follows:
The sensor for 2007 and later models will be in the exhaust pipe after the catalytic converter. To remove it, it's necessary to remove the passenger seat, disconnect and snake the pigtail through the grommet in the car floor. Then, disconnect the O2 sensor from underneath the van and replace.
Corolla / Matrix 2009-13 :: Got P2195 / P0031 Obd Codes - Replace Both Sensor?
Both the P2195 (Oxygen sensor or A/F sensor stuck lean - bank 1 sensor 1) and P0031 (Oxygen sensor heater control circuit low - bank 1 sensor 1) were pulled on my 2009 LE (77K miles). Is it safe to assume that the upstream b1s1 sensor is the culprit?
I believe I've found the OE Denso part 234-9056 - is this the right one?
General question about O2 sensors - is it recommended to replace both the upstream and downstream at the same time, or is it not necessary to do that?