Prius (2004-09) :: 3 Brake Dash Warning Lights Came On After Got New Brake Pads / Rotors
Apr 25, 2013
i have the brake (!) the ABS and the VSC lit up after i got new bearings and new brake pads and rotors, the car was also stalling before the mechanic removed these bearing "dust cover" circles that must have been causing speed sensor interfernce bc the spedometer was stuck on 0....so the car seems to be done stalling after those were removed and all the big lights went off then i hit the brakes a few miles later and those three lights came on...
View 2 Replies
Advertisement
I noticed the front brake pads were touching the rotors when I was painting the brake calipers. I had my e-brake engaged and in park. I'm assuming the e-brake only brakes the rear wheels because the front rotors were still movable. Although the car still rides fine but I'm not sure if this is normal.
View 1 Replies
How to remove the front brakes pads and rotors on my GMC Sierra 2008 - 1500 - crew cab - 4X4.
View 2 Replies
So my car has 36 or so thousands miles and well the rear brake pads and rotors were SHOT! The rear rotor was falling apart and huge chunks were coming off. The issue stands now that I can't spread the rear caliper for anything, the ebrake is off too. I tried to use the C-Clamp trick but it honestly didn't even budge. I also opened up the bleeder and master cylinders cap just to cross that off the list when trying to compress. This is the hardest caliper I've ever had the misfortune of dealing with and I fear that the passenger side is not going to be any better. Aside from spending more money or renting the "tool" is there anything else to check because the C-Clamp trick has work on mine and my father trucks calipers.
View 3 Replies
I'm getting sick of having my rims getting dirty after one hour of driving because of all the brake dust that the OEM pads give off. I keep hearing from shops that ceramic brake pads are not only more quiet but will put out much less brake dust. On the other hand, Lexus is telling me that if I do that, I will forsure damage the rotors but I really feel like they just want me to keep the car stock which is why they're saying that.
Are ceramic brake pads a bad idea with stock rotors?
View 4 Replies
OK, I just got back from having pads and rotors install on my '99 Passat. I was expecting this to clear up the brake and abs light problem but it did not. The brakes still feel mushy and the ABS light still comes on.What should I check? In the brake forum people suggested bleading the brakes, is this the next step? Any quick how to?
View 3 Replies
Here is the problem. When I reversed the car out of the driveway i noticed it would not reverse freely. It felt as though something was blocking the car (as though the handbrake was still on).. When i turn left and right going slowly it feels like the car is jerking and the brake pads are sticking to the rotors.. Its the same when i reverse but I only feel it when im going slowly and the sound gets louder when turning left or right...
I checked all my break pads and rotors.. Im thinking it could be something with the haldex system... Hope not.. My haldex fluid was changed at 80k and im at 88k now..
View 4 Replies
We're on a road trip and the alarm tone goes off. The dash displays the brake warning and the red triangle (and the touchscreen has a car outline with an ! in the upper left). Also, the cruise control no longer operates. We return to El Paso and the dealer utilizes several hours and two diagnostics to tell us the Hybrid ECU needs to be replaced. Unfortunately, they can't get our Prius back to us until Monday, the day we are supposed to be back home starting work the next day.
We plan to call the other dealership in town in the morning. But is it safe to drive our Prius in this state? Can a regular garage make the repair? My father-in-law, an automotive repair professional back in Missouri, says that he isn't surprised if an ECU needs to be shipped from a Toyota distribution center since the part isn't regularly kept in stock by an auto repair shop.
View 4 Replies
I have a 2004 V6 with 20s and close to 32K miles, never driven off road. Last Friday this warning "Check brake pads" started to show sometimes. I believe the dealer changed them before, but if he did not, how much should it cost me to replace them?
View 11 Replies
I changed the front brake pads, took all the precautions during the change, did not disconnect the 12 v battery, pumped the brake pedal 12 times, started the car and no warnings. Now the brake pedal is a little spongy, if I press the pedal to the floor the VSC/TRAC light comes on, to reset it I have to press on the pedal again and the brakes do work.
View 11 Replies
Ok so we just replaced our front and rear brake pads and had the rotors turned. Our rear brakes are fine but both our front brakes now make a clunking/popping noise when we brake.
View 4 Replies
Title says it all. Occasionally when I try to start my 2007 Prius (70k miles), the master warning light along with the brake, ABS, and VSC warning lights all come on. I'll turn my car off and then turn it back on and it will start right away.
One thing that I notice is that it seems like the headlights and/or the MFD is dimmer than usual when this happens. I'll turn off the headlights, turn on the car, wait for it to start, and then turn on the headlights and everything will work correctly.
View 10 Replies
I have a 2009 Prius with 73,000.I turned on my Prius after a quick stop at a drug store today to find my brake light and ABS warning lights on. In addition, braking was rough. I have to step on the brake much soon and "deeper" to stop. After a quick search of the net I learned I wasn't alone. Here are the codes I received-
C1241- I just replaced my 12v battery about 1 1/2 years ago so I'm confused about 1241. I checked the levels. The are normal. The battery showed levels of 14 to 14.1v throughout the test. Maybe I don't understand the code?
C1247- Stroke Sensor
C1377- Capacitor malfunction
Before I take my car to Toyota, I would like your opinion on what actually works to correct the problem. I cleared the codes and the car works fine right now. If I continue to clear the codes will the car work? I searched the forum the one person seems to believe the to repair replacing Stroke sensor is the best/only fix.
View 1 Replies
Apparently my 2008 Prius decided to tell me in it's own way the same thing by showing me these lights this morning.
So they turned on while in a drive through, around the corner from my house. All except the master warning light. 5 minutes after the initial ones, the master light came on. And the braking power disappeared. I immediately got it home and shut it off..
After some research, I performed the 12V Aux battery test on screen in the car.
Confirmed -11.8v while ON, and 11.4 V when in ACCESSORY mode. So the 12v battery more than likely is the culprit for this problem.
View 4 Replies
I was driving down the highway today and the brakes light (!), vsc, and master red triangle warning lights came on, along with a car with an ! in it on the main display screen. There is no noticeable difference in noise, mpg, or breaking performance. From reading through previous forums a bad 12v battery seems to be a common problem. Mine was replaced ~8 months ago. About 2 weeks ago the serpentine belt snapped and the car was drove ~2 miles to my home where I replaced it along with the bad water pump and also the thermostat. Could that have caused my current problem. 130k miles on the car...
View 6 Replies
My case involves a 2005 Prius with 55k miles on it with the problem of the master warning light (triangle with !), yellow brake light ( (!) ), airbag, and VSC lights coming on whilst driving. The car drives just perfectly fine without any discernible problems. Scan tool did not detect any codes. Tested the 12v auxiliary battery and it is strong with both voltage and amperage (even went as far as temporarily jury-rigging a fresh v12 battery in parallel with it to see if it would alleviate the problem). Inverter coolant pump runs well, coolant changed with appropriate Toyota Super Long Life coolant (50/50 mix) and system bled. Despite some drivers' concerns over disconnecting the 12v battery to reset the lights, this was done and the lights would go out, only to have them come on again after about 5-10 minutes of driving. Asides from the lights coming up, the car itself seems to be asymptomatic. Hybrid system appears to be running smooth and fine, SOC is good, asides from the lights the car drives very well.
View 9 Replies
I bought this prius and it runs and drives great, no issues until a couple weeks into ownership and the car refused to "ready" up. i figured out real quick it was the 12v battery....BUT instead of replacing it i was trying to be cheap and charged it to verify for sure, worked great for about a week until it wouldn't start the car again and gave me the "park on level ground" warning. i got passed it after a few presses of the start button but the master warning, VSC, Brake (!), and airbag lights came on. I replaced the 12v promptly and this did not remove the lights. 2 weeks later the lights are still there and I have tried resetting the brake/airbag lights via pins 4 and 13 and failed at getting the lights to go out. a scan tool will delete them for about 10 seconds.
The codes I was able to pull via blink were:
(!) 11
ABS 42
VSC 51 45
airbag 23
I cleared them with the "press brakes 8 times" method, lights remain and codes pop up
VSC 51
airbag 55 57 23
View 13 Replies
My 2005 Prius with 116K on it has been having some uneven acceleration lately and today the Triangle warning light, the check engine light and the brake light came on at the same time. I had about 1/2 mile to go, so I proceeded slowly and called the dealership which had performed a routine oil chg two days ago. They said that if the lights weren't flashing then I could drive it. They recommended that I take it to AUTO ZONE and put it on the analyzer. This elicited these codes: P3019: no definition and P0A80: replace Hybrid Battery.
I have an appointment in 2 days and I'm wondering about a salvage HV battery since the car is 7 yrs old and over 116K miles.
View 4 Replies
I keep getting the C1344 and all the lights. I checked and changed the rear shoes and the light keeps coming back, although not immediately. It takes just a little while.
I didn't notice any signs of leaking fluid, though I was able to squeeze the LH wheel cylinder in pretty easily by squeezing on the top of the shoes. The drums were not scored and were in spec so I didn't turn them. I never cracked any brake lines loose.
View 9 Replies
I drove my 2005 Prius 2 hours and parked it for 5 hours. No problems on the trip down. I got back in it and it started up just fine. I was sitting in the parking lot with my foot on the brake (hadn't moved yet) and the following occurred:
The brake pedal seemed to push back on my foot
The red exclamation point illuminated
The yellow exclamation point illuminated
The ABS light illuminated
The VSC light illuminated
The red parking brake light illuminated (not shown)
All of these lights point to the skid ECU. It seems like my skid ECU is toast or something called the ABS & BA & TRAC & VSC Actuator is an issue (never heard of it but I see it connected to the skid ECU). I did a visual check of what I could and everything seemed in order. I pulled a bunch of fuses and I didn't notice any that were blown. (I didn't pull them all but will tomorrow)
After not finding anything, I drove back home. As expected, I had no regen but the bigger problem was that I had no power assist on the brakes. A few times I actually did skid and the car brakes really bad without regen or power assist. If it was raining or snowing I could definitely see a hazardous situation.
I'm kind of at a loss here. Tomorrow I'll pull the kick panel down and see if the skid ECU is getting power but I can't think of anything else that would cause this situation.
View 19 Replies
So, I changed the front brake pads on my 2007 Prius blindly, and in doing so I bled the lines (I also had the key in my pocket!). Now, the ABS light, VSC light and (!) light all are on and continue to stay on while driving. Is this something as simple as resetting the codes? Is the vehicle safe to drive to a repair shop to set strait?
View 2 Replies
