Prius (2004-09) :: 2008 Started To Stall Out
Mar 24, 2012
My Prius has started stalling out. I had the codes read a couplt days ago..needs plugs or gas cap gaskets. I disconnected the ground cable to clear codes instead of going to dealer and being charged to clear check engine light. After doing this the car has stalled out twice. The first time I tried jumping it didn't work until I disconnected and reconnected the ground cable, it started after about 5 minutes of being hooked up to my other car.
Took it for a drive to charge it further after about 15 miles everything was working fine, the hybrid monitor was showing good charging. Then all of a sudden the triangle light comes on and all the other stuff, check engine etc. Takes a few more miles to stall out. I did the same thing with the battery as before leaving it disconnected for about 5 minutes. Reconnected and it starts up and ran fine to home. ?? Did trying to clear the codes the first time cause these problems???
View 5 Replies
Advertisement
So yesterday i was driving fine and all of the sudden the car started jolting like it was going to stall and the check engine light came on. I pulled over popped the hood to see if there was anything i could see and got back in and took off no problem and the light went off. I starting pushing it and accelerating it to see if it would come back on and it didnt. Today it started doing the same thing but this time the light stays on and every time i change gears it does that jolting like its going to stall.
Its a 2004 gli 6 speed gli 1.8t ....
View 7 Replies
My Driver's side headlight recently started 'switching itself off' - which I understand is a pretty common problem. I'd already had the Passenger side replace a couple of years ago - by the dealership. But this time I figured I'd do it myself.
View 2 Replies
Let me describe this perplexing issue. I have a speratic rough idle problem. When it happens it's almost like the truck wants to stall. Once going the truck is fine. There has never been any acceleration issues, but for a short time the truck would kind of lunge off idle. It hasn't done that for quite some time. I've replaced the fuel filter. There are no vacuum leaks that I know of. I've tried higher octane fuel. I've tried injector cleaner for a month. What should the fuel pressure be and what is the test port located? Is the fuel pump in the tank? If so, whats that big log looking thing behind the gas tank that the fuel lines run to? Also, there are no MIL codes...
View 14 Replies
I have a 2007 F150 It will stall out when I go over a speed bump. It has happened several times and getting worse. No codes stored. It will also skip between 40 and 50 mph.
View 3 Replies
My mom gave me a 2004 f150 lariat with a 5.4l and were having an issue with the engine when coming to a stop the engine wants to stall out and runs like a bag of hammers and sounds like its going to explode then i give it a shot of fuel and it runs fine for a a while and then does it again. I brought it to the local dealer and he said it was either the vct or the cam phaser bank 2 so i changed both and it still does it just wondering before I keep getting intake cam sensor code retarded and a bunch of other codes but we replaced the cam sensor already.
View 2 Replies
I was driving when the truck made a terrible noise and while pulling over the check engine light went on as well as low oil pressure. I turned off truck and checked but no evidence of any leakage at all. Checked oil stick and was dry. Let sit for an hour and checked oil stick to find about 1/2" showing. Added oil to find that now it was overfull, drained oil back and stick showed proper level. Attempted to drive and it was fine until I came to a stop wherein it would stall with "low oil pressure" showing and check engine light on. Brought to shop and they said engine is very gunked up, they said they could try oil flush but probably will not work. They most likely will have to remove the valve cover and such to physically look at engine and take it from there... (I have always used type of oil stated on the cap, used synthetic and changed every 5-7k miles - showed diagnostic codes p0011, p0340, p0345 and p0021).
View 14 Replies
I recently bought a 2006 STX with the 4.6 engine. Occassionally, when stopping at a light, the engine will stall. I took it to the dealer where I bought it and he put it on the computer and found that once on a test drive the RPM's dropped to 490, but it did not stall. He said everything checked out fine and thought it might be a carbon build up, since the truck only has 27,000 miles on it and was driven only around town. He suggested a couple of tanks of higher octane fuel and a fuel additive to remove the carbon.
View 10 Replies
My 04 F150 has started having a rough idle. While in park the engine will stall out with the A/C off. Also when in drive the truck will idle close to 1000rpm's. I had to the fuel filter cleaned and also the MAF sensor cleaned. Also did a vacuum check on it. Pulled the code and it's throwing a Lean Code. What else should I be looking for?
View 12 Replies
I have a 2007 F150 XLT, Supercab 6.5' bed, 4x4 5.4 Automatic with 67000 miles on it. Its not a Flex Fuel
Over the past couple of weeks it would get go through random rough idling spell or stall going down the road. If it was sitting it would idle clear down to 200 RPM's and just sound like an old 'chitty-chitty-bang-bang' car, not a modern marvel of Ford engineering!
I noticed it particularly does it this on an incline. Initially I fixed it by just coasting to where it was flat. I normally keep it above half a tank so i dont think its a fuel pump not getting fed. So I replaced the fuel filter yesterday hoping it was full or clogged, no changed.
This morning it would start at all, I removed the negative terminal on the battery, rolled to the level, tried it 30 times. Nothing. I checked all of my connectors under the hood and the 2 below the cab under the plastic cover. Everything was connected. I disconnected the fuel pressure sensor and it fired right up and runs smoother than since I've owned it.
It hasn't had any CEL lights, until I disconnected that sensor. Should I drop the tank and clean it? Is there any special gasket kits or connectors I should be aware of? Should I just replace that sensor? Is it connected with a chain of sensors I should check first?
View 2 Replies
My car was driving good when i had an accident just the fender and door was hit, but i loved the car in the body shop for 1 1/2 years now i went to pick it up and the battery is low, the gas engine start and stall in 3 or 4 seconds . Can i tow the car with the wheels on the ground and been pressing the brakes a little to re charge the battery, 2007 prius 120000 miles.
View 7 Replies
99 grand am,v-6 SE-2.my car has recently started to stall at times. Mostly in the afternoon when it is hotter. Runs for about 20 min. and then looses power and stalls. Will not restart unless I turn the key off and back on. Sometimes I have to do this about 10 times before it stays running. Each time I turn it back on the fuel pump pumps up within seconds. Stalls at idle and at part throttle. When it starts to stall you can here it sucking air big time. When it runs it runs great.there are no codes. Once it starts to stall it never recovers, just takes longer sometimes.
View 4 Replies
Last week my truck started to stall a little bit. As I drove it a little longer, it stalled all the way out. It started back up fine but when I gave it some gas, it cut off. This happened several times. I popped the hood and noticed the throttle body was a little loose. Thinking air may have gotten into the system,I tightened it back up. I started it up,put it in gear and it seemed to drive fine and it started stalling again.
While I was on the interstate, it would cut off, cut back on,cut off and then cut back on. Finally it completely stalled out. I had to have it towed to my house. I hooked my code scanner up to it and it through code 44 (O2 sensor) and code 54 (Fuel pump relay or something like that). What could be causing my truck to run this way.
View 14 Replies
I just had my 25k service a month ago. Left car in MSP airport lot for a week and when we were driving home to Duluth last night, the check engine light came on and started flashing and the engine started to stall and run very rough.
Drove slowly to get home, noticed HUGE burning smell under hood, opened it and this part under engine on left side was a glowing fireball red cylinder. 1.8t, have all my maintenance done at dealership. Car ran fine for 126 miles on the way home and it just came on and started flashing
View 14 Replies
This car started to stall sputter. I replaced the ignition module and it worked for while then nothing at all but still cranks. I checked all of the fuses and every thing was working. What I have found and i think this was the whole problem. The wiring harness that goes from the ignition module to the crank sensor, the wires were twisted and frayed and most likely grounding out on the frame and making the computer to shut down. So far after replacing the wires it started right up. Have not had a chance to take it for a test run to re learn the computer because my brake line busted.
View 1 Replies
I have a 99 Mazda b3000 v6 that has recently started to stall whenever in idle. Check engine light is on and the following codes popped up (P0176, P0135,P0141, and P0155). I'm sure one of these codes has to be related to the problem but I am clueless when it comes to troubleshooting. Also it started stalling after I filled up the tank. Not sure if that has anything to do with it, check engine light was already on before that.
View 2 Replies
My 2008 prius suddenly quit on me while driving the dash went out when it did, however the lights and locks work, when I push the start button I get nothing.
View 14 Replies
I was driving my f150 going down the highway. Cruise set at 110kmh. All of a sudden truck started shaking And sounded horrible. Shut off the cruise. Floored it.it misses fired like no tomorrow and no power, looked down check engine light was flashing. Then all of a sudden everything normal. Now its intermediate and light solid on. So I thought I will just I will hook up the code reader. And NOTHING it didn't turn On. No beep nothing. Tried 2 readers no connection. Trucks a 2005 ford f150 fx4 5.4 217600km on the clock
View 2 Replies
This was happening on my 2008 a couple of months ago and also now on my 2013 I noticed sometimes when I get in the car I push the button once and as usual then I have to push the button the second time and it only goes in neutral and assign comes up and says shift to park position starting so I don't get it this only happens once in a while. Then a couple times later or a couple days later as usual I pushed the button one and everything works fine right into the drive what gives?
View 8 Replies
New here but long time lurker. I have a 2006 e350 with 6.0, bought it from a friend not long ago. The work that has been done to it the last 50,000 miles is as follows.. New hpop, all new injectors, egr delete, sct tuner, stand pipes and dummy plugs. I had it for a week and would get a no start hot once in a while. This issue had become worse and the truck started to stall as the RPMs dropped. Reading here i replaced crank sensor and the stalling stopped but the no start hot continued. I took it to a local diesel repair shop and they did the following..
Use a test ipr (no change), replaced ipr pigtail (was cracked) air test (leak under pass valve cover) replaced stand pipes and dummy plugs on this side. They said no leaks and I was good. Truck worked as its supposed to for 1 day and the no start hot issue reared its head again. Took it back and now they say the hpop is bad. The pump that was put in about 50,000 miles ago was a bostech? do these go out? Sangauge reads good ficm, but seams ipr doesn't climb that quick.
View 14 Replies
So I have a 2006 f150 a wile back the steering started going stiff when I would come off the highway. so after some forum searching, I decided to buy a new steering shaft to repace the universals that see up. then the pump started squealing when we turned befor I could install the new shaft. so I replaced the pump and didn't put the new steering shaft in yet. now when I rev the motor past 2000 RPM the pump wines like when you turn the weeks to far to one side on an old truck and it is still stiff when I come off the highway. Could this be the rack
View 14 Replies
