Prius (2004-09) :: 2007 - Unusual Rear Tire Inside Wear / Car Is Shaking On Freeway At 75 Mph
Mar 2, 2016
So on my wives Prius which is an 2007 the rear tires are wearing more greatly on the insides that the outsides and they are wearing evenly on both the rear left and rear right inside. So not one is more worn than the other..
The tires are heavily worn, with that said the car rides extremely bumpy to the point the entire car is shaking on the freeway at 75 mph or higher. So much so it induces motion sickness which is odd for me. So also besides the alignment question, what else could be causing the insane amount of bumpiness? I balanced and rotated them yesterday but that didn't solve the issue.
View 6 Replies
Advertisement
I decided to get an alignment (for the first time since I took delivery of the car). I noticed some unusual wear on the inner and outer tire. I will post a before and after pic of the alignment. As you can see they were unable to correct everything.
The shop says that the prius does not have any way to correct camber in the front nor was there any way to correct the toe in the rear.
I cannot think of anything that would have messed up the rear left. The shop was saying these repairs will need either a new control arm or strut.
View 11 Replies
I have a 2005 Prius with 128,000 miles. At the last service the mechanic pointed out that the front tires were wearing significantly on the outside. I had them do an alignment but the before numbers were hardly out of spec. Everything was in spec except the front right camber - it was right at the limit (negative). Everything else was perfect. I would have expected only significant positive camber on both sides would cause both front tires to wear on the outside, when everything else was in spec?
View 8 Replies
I noticed the passenger front tire wearing on the inside, I have no camber plates. Presuming alignment is still good could this be from a worn strut mount?
View 1 Replies
About 5K miles after putting on 18x8.5 rims with 235-40 tires noted bad reverberating droning tire noise and noticed stairstep pattern of excessive wear on inside tread blocks, equal on all 4 wheels. Is this just from going from OEM ET47 to ET35? Is camber adjustment indicated and is camber adjustable also on the rear wheels? (Of course, noise and reverberation gone when OEM wheels put back on)
View 5 Replies
I realize that is vague. I realize it could be anything from a wheel bearing to a ball joint, tie rod, control arm/control arm bushing, etc.
Are there any very common front-end steering or suspension issues on 2012 escapes? When tires are inflated to 32-34psi, the car tracks straight, gets great mileage --but almost sounds/feels like it's got a CV or wheel bearing issue on the front right. Every time I hit the brakes while backing out of the driveway I can hear a slight bump or pop. When the car is parked (flat, tires straight) there is slight play left-to-right in the steering wheel.
I'm a German car guy. Have never touched this car. (Wife's car) Right tire is wearing bad on inside. Looking for some direction so I can assess. Car has 88k miles. This will be a DIY fix. Don't have any manuals or anything so just looking for a heads up where to start. Also is Haynes the best way to go? Is there a Bentley? Anything online/CD/DVD?
Play in steering wheel makes me think tie rod (fine because easy/cheap) but such excessive wear on the inside right front makes me think wheel bearing. Could it be both? This is AWD. Is this (like a Subaru) a CV joint where the front spindle passes through a strut base that everything attaches to --so there's an inner and outer wheel bearing?
Does anything up front require a press or can it all be done without a press?
View 3 Replies
I have a 99 F-250 extended cab superduty 4 wd with the 7.3. I also plow during the winter. Recently I've noticed wear on the inside of the left front tire. Brought it to a tire shop and had them check the front end and alignment. They told me that the specs were "within" tolerances" for my truck. I'm stumped as to why the abnormal wear if everything is supposedly good with the alignment.
View 5 Replies
This morning I had an unusual problem after starting up the car. When the gas engine kicked in, the car started shaking a great deal as if the engine mounts had come loose and the engine was moving around. I quickly turned it off and waited a few minutes. When I tried it again, everything was normal.
Thinking back, I'm not sure if I put it in gear before the problem occurred. Wonder if putting it in gear just as the engine is starting up could trigger something like this.
View 19 Replies
I have a 2007 Prius with about 77,000 km on it. Lately I've noticed that the car would make an unusual noise sometimes when driving at around 50 - 60 km/hr in stealth mode, with slight accelerator pressure such that the energy monitor shows power flowing from the battery to the motor (ie - not gliding or regen braking).
View 1 Replies
recently I replaced the front rotors and pads on my 02 Saturn SL2. I did this because there was a grinding sound coming from the front left wheel well and I had noticed a band around the rotor that looked gouged. All in all, about 30 minutes of work, following the Hanes manual. In the course of disassembling the front left caliper, I realized that the cause of the gouge in the rotor was from one of the tensioning clips on the caliper bracket. One of the flaps on the clip had bent back and was causing both the grinding sound and the gouge in the rotor. So naturally, I replaced all the tensioning clips as well. After putting everything back together, I took the car on a quick test drive around the block. The noise, while lessened, was still present. Furthermore, after I got to work this morning, I noticed that that there is the start of the same wear pattern on my brand new rotor.
What could be causing this problem to reassert itself?
View 2 Replies
I just had the tie rods replaced and a front end alignment on my VW Golf. The tires that were on the front were moved to the back because of some wear on the inside edge. The tires currently on the front look brand new, but the car pulls to the right more than it did before I had any of the work done. The place where I got the work done told me I would need to replace the two tires with wear but they are still in mostly good condition. They are telling me now the pulling is because the tires on the rear have wear. Can wear on rear tires really cause my car to pull so significantly to the right? The tires are only two years old. I do not want to replace them yet. The car front wheel drive.
View 2 Replies
I've been noticing some (a lot) of oil on the inside of my rear tire. I went ahead and drained my diff fluid to check if the was any left and there was but I replaced it and cleaned the tire (hoping I just drove through something) and it's back again already. I don't know much about axles, what seal usually holds stuff back in there? What parts should I expect to replace other than the seal and any brake components effected? I noticed a creak/crunch coming from that area but seems to crunch with suspension articulation so not sure if it's related but I have the feeling it is.
View 14 Replies
I just bought a used 2007 Santa Fe Limited. It has 78,000 miles on it. I have gone bumper to bumper looking for problems and am pretty happy about the condition. HOWEVER, I have noticed a shuddering/bobbling, fairly faint, when going over slightly rough roads a low speeds. The tires are shot. But they are all exactly the same ... meaning the same wear more so on the outside. I believe they were rotated properly, but something is wearing the outside prematurely. Is the shuddering/bobbling the culprit? What is the most common issue for the Shuddering/bobbling at low speeds on slightly rough roads?
Next, I want a quiet ride. Handling is not a concern. Should I go with a slightly wider tire or slightly taller tire? Lastly, I need new mats. I want them to be the same as what came with the car. Do I have to go to the dealer or are there some vendors with better deals on factory mats.
View 9 Replies
So my strut mounts are shot and I wanted to add adjustable rear control arms to eliminate tire wear. So thinking of going with Bilstein HD's with the stock springs. Oh and BTW want to keep stock ride height since it is my daily. The only option I would consider for springs would be the euro version of the stock springs.
View 4 Replies
My 2004 Honda Accord Coupe has around 80,000 miles on it. Right now i am experiencing "chomping" or irregular wear on my tires. The inside quarter seems to be wearing at a significantly higher rate than the rest of the tire. However the outer edges have a very "wavy" wear to them as well. The right side of the car is much worse than the left side on both the front and rear tires. I do have direcitonal tires so i only rotate them front to back not side to side.
Research says that it is struts but when i asked my Honda technician he said to push down on the front and rear bumpers and if the car levels off within one and a half bounces it’s not the struts. I did that and it leveled off both on the front and rear. They don’t' appear to be leaking or have anything wrong with them.
So that left me thinking it was a balancing issue. I then went and got my tires balanced and the issue hasn't gone away.
View 9 Replies
Why are My Tires Wearing Unevenly?
View 2 Replies
Premature tire wear and faulty wheel alignment issues on 2004 Touareg V8 with 10,000 miles. My dealer informed me that my original tires, Continental 4X4 Contact 255/55R18s were about to need replacement and that there were known issues with the tire compound and alignment specifications. I have had the vehicle about 14 months. He said it was over twelve months but he would bring it up with the district representative. I told him that I thought this came under concealed defects and I expected VW to replace the tires and align all four wheels to whatever the current spec. Are there VW bulletins covering this I can obtain copies of?
View 1 Replies
Today I started noticing a squeaking sound coming from the brake pedal when braking slowly. After I put the car in park and inspected any noises from the outside, I realized that a squeaking noise was also coming from the rear brake drums of the car. It was perfectly find yesterday and this morning it started.
View 3 Replies
I've noticed over the past two mornings while driving to my office a sort of whirring sound for lack of a better word. It has only happened in the mornings. It has been low to mid-50s temp. The sound seems to be coming from the left side of the engine bay or inside the dashboard. Basically like a fan sound but this happens even without my HVAC activated. It doesn't seem like a big deal but the reason I mention this is because it's the first time I've even experienced this since buying my Touareg last year.
Interestingly, after shutting the engine off and restarting, the sound goes away. This particular sound is definitely noticeable, even with my stereo on.
View 4 Replies
I have Toyota Prius 2006. Last night suddenly the rear right door didn't open from inside and it still doesn't want to open from inside. It opens from outside OK but is not opening from inside regardless what we are trying to do. It only one door misbehaves, the right rear door. How to fix this problem and why it happened?
View 9 Replies
Hearing a slight clunk noise inside the back of thier gen 2? I've taken apart all the paneling used foam tape to secure things and took apart the spare tire area etc and the clunk persists. It seems to vary intensity every time I close the rear hatch.
View 4 Replies
