Prius (2004-09) :: 2007 - Metal Part In The Key Fob Is Broken
Dec 10, 2013
The metal key that comes out of the Key Fob is broken, is it replaceable from anywhere other than Toyota? The key fob is perfectly fine no issues with it.
View 1 Replies
Dec 10, 2013
Advertisement
Prius (Gen 2) :: Metal Hardware Pieces For Brakes Have Broken
The little metal hardware pieces for my brakes since I've had the car they have broken three times within a year recently. A mechanic who was the last to replace them said the brake pads were fine and wasn't sure why they keep breaking. Going to add a picture of the piece I'm talking about.
When driving my Prius when below 40 mph the two front tire area makes an awful clanking sound because of the hardware breaking.
[url]...................
Ford 6.0L Power Stroke Diesel :: Metal CAC Tube Part Number?
I found 2 Ford OEM part numbers for what seems to be the same identical metal CAC Tube for the drivers side.
6C3Z-6C640-AA
and
6C3Z-6C646-BA
I wanted to place an order today for my '06 but want to make sure it's the right one. What is going on here? (maybe one is for a '03-04) I Don't know...
Passat (B6) :: Metal Part Of Front Wheel Scraping When Driving At Slow Speeds
When driving at slow speeds and when I go over a bump in the road, I'll hear something like the metal part of the wheel scraping something as its turning. Only comes from the front drivers side wheel. It's audible enough that people usually turn to look when I'm in a parking lot.
Took it to the dealer, they 'test drove' it. Said they couldn't hear anything. Then said that whatever I'm hearing is 'normal suspension noise'. So after leaving it a full day at the dealer, nothing has changed. Since when is ANY suspension noise normal? But I don't think its the suspension. What to do? Take it back? Take it to another dealer?
Golf/GTI VI :: Metal Ball Rolling Noise In Rear Part At Moderate Speeds
Some of you may have seen my thread on my new car: [URL] ....
Its got just over 500 miles on it and I have noticed that at moderate speeds(40-50), if i turn, I hear a noise in the rear part of my car as if there's a metal ball rolling inside. I've already checked and there's absolutely no loose objects or any objects for that matter.
I checked the spare wheel bay, removed the spare, and found this beauty just sitting. Where it came from or why it was there.
Sonata NF (2006-10) :: 2007 - Metal On Metal Sound When Turned Right - Wheel Bearing?
I have a 2007 hyundai sonata, this car is my daily driver. I put 180 miles on it a day around trip. Currently has 180,200 miles on it. Last Friday on my trip home when i turned right I heard a metal on metal sound. I slowed down went straight and it went away. Talked to a few people and I think it may be the wheel bearing. Even if I hit a road reflector it starts up. It's the front left wheel. Get on the breaks it goes away.
So my question is... Wheel bearing??? And can I replace the whole hub and fix the problem or do I have to try and press the bearing out?
Santa Fe (CM - 2007-12) :: Faint Metal-on-metal Sound When Put Car In Reverse
I have a 2011 Santa Fe AWD Limited. 90,000 miles. I have a strange sound I need identifying. At first I thought the sound was my AC depressurizing, but it's not that. It sounds similar, but has a faint metal-on-metal jingle sound to it, like something is rubbing or something is rotating and intermittently hitting something just slightly. The mechanic went in to change the water pump because it was leaking, and he thought that the water pump when rotating was rubbing because the rubber ring/gasket was failing, therefore making that sound. Not it. Tired rotated and new brake pads put on. Still there. To be clear, the mechanic never said he heard the sound. I just told him about it.
I can hear the sound when I turn the car on and put it in reverse start backing up. I can hear it when I let off the brake (driving and in park), which lead me to believe that it could have been the pressure in the Master Cylinder or ABS. I don't know now because it does it intermittently when I am driving down the road with no brake applied. When I park, I put the car in Park, get off the brake and just listen. And I can hear it. When it is in park it is more rhythmic, with two or three second breaks in between. kshhh kshhh kshhh kshhh. (I hope you like my poor attempts at sound effects.)
Is it the ABS system? Don't tell me it's transmission related. I just bought this car (used at 87,000 miles) and already had the struts done, the water pump and drive belt done. For what it's worth, this car's passenger and back seats vibrate at 60+. Not sure if that has anything to do with this sound, but thought I would mention it. New struts and tire rotation did nothing.
Ford Aerostar :: Rubber On Metal Like A Flat Tire - CV Axle Broken
Have a 95 aero E4wd. Have replace driver side cv axle and drove about 8 miles then the outer joint broke. Had mech change cv axle and drove about 2 miles and the inside broke.. Same mech replace it and drove 3 mile and heard like rubber on metal like a flat tire. The cv axle did not break and won't turn when in gear. Back to shop with aero. Lifted on lift and jacked up front and rear. Turned the driver side and the passenger turned with it also it turned easy. Started it up and placed in gear, all were rotation except driver side , it was hung up. What should be fixed on diff?
View 14 RepliesFord F-150 (2004-2008) :: Intermittent Metal On Metal Grinding Noise
I have intermittent metal on metal grinding noise. Seems to happen when I am at highway speed. Seems to go away when I put it on 4 wheel drive or slow way down. On one occasion though, the grinding noise did not stop even after putting on 4 wheel drive - had to stop completely before it went away (did not come back after I drove off again). Diagnostics so far....
Unhooked the vacuum lines on passenger side actuator and hooked up vacuum gauge. Vacuum held at 20 psi and drops and raises slightly as the truck is being revved. Takes about 10 seconds for vacuum to drop to zero once truck is stopped. Putting it on 4 wheel drive drops it to zero immediately. Exact same scenario on the passenger side.
This leads me to believe my IWE solenoid is ok. So also my check valves. Next opportunity I get, I will raise one wheel, remove the vacuum line on that wheel and apply vacuum with my pump. Want to see if it will turn my half shaft.
2004 F150 FX4 ....
Prius (2010-12) :: Metal On Metal Grinding Noise At High Speed Above 75mph?
I commute 180 miles a day, 6 days a week. I noticed metal on metal grinding noise(more noticeable) at high speed above 75mph especially on asphalt road. I'm sure noise is there at low speed but not enough to notice. My car has 50,000 miles. Tires? Electric motor?
View 7 RepliesPrius (Gen 2) :: 2006 Metal To Metal Noise While ICE Charge The Hybrid Battery
I recently worked on a 2006 with 140K miles that presented with the following symptoms:
The hybrid battery was at 1 bar; the ICE would not start; the car was in Ready, but there were no codes. As I let it roll off the flatbed wrecker in Neutral, it felt lumpy. If you have ever pushed a car (or run out of gas in one) with a manual transmission that was in a high gear, engine off, it felt just like that.
I popped the hood and could see that the engine crank was turning while the car was being pushed in Neutral. What else turns with the wheels? MG2, or more specifically, the MG2 ring gear. What is the only way that the wheels could turn the ICE crank? The planetary carrier pinions were locked to the ring gear.
Surprisingly, while I was looking at things, it did manage to start the ICE pushing it around must have freed the carrier pinions, so I let it charge the hybrid battery. It was basically the worst metal-to-metal noise that I have ever heard! I pulled the drain plug and saw about a teaspoonful of large metal chips on the magnet. The fluid condition itself was very good, not the black factory fill that I am used to seeing come out.
Ford F-150 (2004-2008) :: 2007 Cab Corner Is Bubbling / Metal Is Exposed
My 07 Lariat cab corner is bubbling. I really think this is a paint adhering defect as there was no rust underneath, just bare metal. It has now started to rust where the the metal is exposed. How to tackle this? I was contemplating paint matched linex all the way around the bottom, or taking to a body shop which would be expensive.
View 13 RepliesPrius (2010-12) :: Light Metal On Metal Grinding Noise
I have a 2011 Prius with about 32K miles on it. I've been hearing light metal on metal grinding noise for a few days now. So I decided to take it to a stealership and they told me my ceramic pads and brake rotors both need to be replaced for all 4 wheels. I thought Prius brakes don't need to be replaced for 100K miles.
View 7 RepliesPrius C :: Front Steering Wheel Thunk Like Metal On Metal
I have a question about my C Four with 16" wheels. When the steering wheel goes all the way to a stop there is a thunk that feels like metal on metal. It is like there is no rubber bump stops. If this is normal. I am used to cars that have a nice cushioned bump at the steering limits.
View 1 RepliesPrius (2010-12) :: Metal-on-Metal Whining Sound While Running
I own a 2010 Toyota Prius that recently developed a metal-on-metal whining scraping sound when moving. It does not make sound when the vehicle is stationary, and it's intermittent - which makes me discount the rock-in-disc-rotor idea (not eliminate it, mind you). It's quite loud when it occurs, able to hear it over the stereo. Luckily I was near work at the time, so I went there - but the shop can't even look at it until Monday evening - so I am a bit panicked.
View 8 RepliesFord Super Duty (1999-2016) :: Broken Metal Cylinder In The Gearshift Selector?
My automatic shift selector was extremely loose. Wasn't the two bolts up behind the dash. Turns out that there is a metal cylinder with a cutaway that seems to have fallen out of the selector housing. One of the edges of this cylinder broke off as you can see in this pic:
What is this piece called and can I get a replacement at autozone/pepboys/ect?
Prius (2004-09) :: Flutter Sound At Part-throttle
I recently bought a used 05' prius, and discovered a flutter sound (sounds like uneven tire) while on a smooth road. It comes from the engine compartment. I has no clue what IT can be.
View 4 RepliesPrius (2004-09) :: ABS Wire Connector Part Number
I need to get the part number of the wire harness connector that clicks into the right abs sensor connector. The code for the connector is A4 but I wasn't able to find any info about it online. This is for a 2009 Toyota Prius. car got into an accident and the wire harness connector was cut.
See the attached pics.....
Prius (2004-09) :: Rattle Noise Like Some Part Is Loose
I have a 07 prius with 60k Km. right now, everytime i go thru a hole, there is always a noise like something is loose. It also sounds like a rattles too. The noise seems to came from the front driver side tire (i have the right side driver japan version prius ). I assume it was the shocks / struts that needs replacement.
View 1 RepliesPrius (2004-09) :: Green Oily Gunk Covering Part Of Radiator
I noticed a 1'x2' square in the bottom passenger side corner of the radiator covered in green oily gunk. Ive had the 2008 for about 1000 miles (has 58k) so Im assuming its been there for a while. Seems like its impeding airflow. Its very green.
View 5 RepliesPrius (Gen 2) :: 2007 - Air / Fuel Ratio Sensor Connection Broken
I have been debugging DTC codes 2237/2238 and what sounds like detonation in a failed catalytic converter in my old 2007 Prius (375,000 miles!), I just removed the wipers and cowl yesterday to look at the air/fuel ratio sensor connection, and my connector appears to be melted somewhat, sides of the connector show signs of melting I am guessing that there is a connection problem stemming from this and the root cause of my DTC codes.
Can the four wires each side be removed so I can get the connector out to look at it carefully?
Can the bad connector be removed and the four wires be simply spliced together to get the air/fuel sensor working again? I did note that the colors of the wires going in are NOT the same as the colors of the wires going out.