Prius (2004-09) :: 2005 - Leak In Front Axle Sealing
Nov 28, 2014
Just picked up a 2005 Prius a few months back with 60k miles on it. It had an open recall related to the steering column so I took it to the local dealer for inspection. Well, they found it has a front axle seal leak and had a couple questions for the forum related to that.
1) It has not dripped a single drop of fluid in the time I have had it, so where would I look under the car to see the leak?
2) Anything else I should have them replace while they are repairing this issue?
View 3 Replies
Advertisement
I have an F250 4.2 diesel 4x4 double cab. Its a2005 model. I noticed an oil leak from the front left axle. It looks like its leaking from the axle tube. See pic attached. Is a seal probably worn? How big a job is this to fix.
View 4 Replies
A Lexus dealer in NJ told me my 2005 GX470 front axle boots leaking, they gave me a quote to re-build both side.
View 9 Replies
My '04 Prius is currently at 134k miles and I've noticed for a while that the front suspension feels and sounds "loose" over small bumps and imperfections on the road.
I also just started noticing some squeaking noise coming from the axle/hub when I first drive off in the morning.
I first thought the loose feeling could be worn out shocks, but I'm starting to worry that it would be something else.
View 8 Replies
So we have an oil leak in our 2005. It is coming from the front of the engine on the passenger side. The oil was changed on May 15th. And it has only leaked since then. Any thoughts on what it may be? What part of the engine deals with oil in that part of the engine compartment? We will take it back to the place that last changed it and have them check it out as well.
View 2 Replies
Check out the pics. 99 f250 4x4. I have a leak in my front axle shaft. It looks like it is coming out of the dust cap on the end of the front shaft. I am pretty sure it is differential fluid from the smell. Is there a seal before the dust cap? Is the shaft hollow with fluid in it? I thought it was just in the differential and if it leaks it is at the seals where the axle goes into the differential not at the otter end.
View 2 Replies
I have a 2003 Escape Limited 4WD with approx 163K on the clock. It developed a tranny leak from the front driver's side axle. The seal is new and in good shape as I just replaced the axle and seal a few weeks ago. (I checked the shaft size and surface finish of the axle and it is in spec.)
I just removed the axle tonight and discovered that the problem seems to be the bushing just inboard of the seal in the tranny. The axle has movement up and down when inserted. (Not good!) This is allowing the fluid to leak from the seal.
Here are my questions. Is this a simple DIY fix using a slide hammer type of puller (or similar), or is it time to take it to a tranny shop. I can not seem to find a replacement part listed anywhere.
Also, with this much mileage, should I have the tranny reworked as a precaution if this repair requires dis-assembly or should I just address the leak and think about dumping it? I would prefer to keep it as my kids are now driving age and this is primarily their vehicle. (It has been a great little truck!)
View 14 Replies
Check out the pics. 99 f250 4x4. I have a leak in my front axle shaft. It looks like it is coming out of the dust cap on the end of the front shaft. I am pretty sure it is differential fluid from the smell. Is there a seal before the dust cap? Is the shaft hollow with fluid in it? I thought it was just in the differential and if it leaks it is at the seals where the axle goes into the differential not at the otter end.
View 14 Replies
99, F250, 4X4, V10, 72,000 miles. I have had the front axle seals replaced three times in the past 3000 miles, and the right continues to leak. My mechanic screwed up three times?
View 10 Replies
I just realized this leak under my 2007 Prius not too long ago. Attached is an image of the leak, and I circled where it is coming from. It is coming from the front of the car. Is this an issue?
View 7 Replies
The car was low and I added enough oil to bring back to full. 1800 miles later, engine dipstick reading at end tip of dipstick. Added a quart, was full. Drove around 80 miles. It was low again. It has a huge film of oil spray all over the back end and it seems to be leaking a lot of oil. It's in a kind of square patterning the driveway. Not just one drip. This is my first Prius.
2005 Prius Package 3 132k
View 7 Replies
I just bought a 2005 Prius a couple days ago and have spent the weekend discovering "hidden" little issues. One was that after a heavy night a rain there was a small pool of water in the very back of the car underneath the cargo area near the wire that runs from the traction battery. In fact the little prongs holding a slim white (electronic) box connecting to the battery were rusted out.
View 3 Replies
I broke 2 snap ring plier on this thing, what is the make and model of snap ring pliers used to remove the snap ring off axle in hub ? I have some others but too beefy won't move in there. They need to be long but strong. I've heard Snap On Item: SRPC9000A works but I don't know of any Snap On guys around here and I need to get this thing done.
View 10 Replies
Unable to decode the B6 axle code on my f150,5.4 L,FX4 2005. Clearly located on the drives side door is the label 'axle' directly below that is B6 ! Unable to locate a listing for this code any where?
View 3 Replies
I recentily bought a 05 prius with 153k on the speedo I asked the dealer about if fluid should be changed out, they said they have never done one, what should I do and if I do it how?
View 3 Replies
Put new backing plates, parking brake shoes, springs, etc on my 2004 F350 DRW 4x4. Replaced the inner hub seals and axle o-ring. Filled with Ford Rear end lube and went for a test drive. All was well. Went out last night to take her out again and I've got diff lube running out of both sides on the inside of the rims. Did Ford sell me the wrong seals? Could I have installed the seals wrong? Ford seal part number is 4C3Z1S177A. Axle is a Dana 80, confirmed by reading the tag on the diff.
View 2 Replies
had a leaking rear driveshaft seal at the axle and replaced it and fluid. 75W145 full synthetic as recommended. it was changed at 128000 and I've started to get an axle whine over 25 MPH up to 65-70MPH. quites down around 80 MPH. I just checked it after 2 months (whine just started) with 133000. Any TSB. does this fall under TSB 05-23-3? Noise sounds like I've got really aggressive tires on the truck. Only have Dayton HT all season. Did not add the XL3 additive. Would this work at this juncture.
View 5 Replies
Tried searching, but I couldn't find any good write-ups on how to replace a front CV axle. The boot on mine is ripped and spraying grease so I figure I should just replace the whole axle while I'm in there. In a previous post, I also found out that replacing the CV axle (joint?) is easier than replacing just the boot.
View 1 Replies
So I was driving yesterday and I hear a grinding noise near the front axle. I pull over and a plastic panel is hanging off near the front of the car. I go to the family mechanic to have him put it back on, and since one of the clips are missing, he tells me to go to the dealer to get a clip and have them fasten the panel.
This morning I go to the dealership. The service advisor gets me right on a lift and comes back about 20 minutes later with a slip of paper. He tells me that the piece is the door from the under body plastic protection that protects the oil reservoir. There are no sides of it that seem to have been ripped off a larger piece, just holes to be screwed in. He tells me the whole entire piece needs to be replaced, end of story. He did not offer warranty coverage (I have 20K on the car) and was not interested in speaking to me further on the topic. The parts desk pulled up a diagram of the car and showed me the panel as part of one big piece underneath that needs to be replaced.
I am going to seek out another dealership on this, but I wanted to pose this to you all as well. First, do I even need to replace this small piece of thin plastic? Second, if I do, can I buy just this small piece and not the entire under body panel. I noticed some threads about the poor design of the oil door, and perhaps this is what this is? I do not have access to a floor jack or garage, so all of my service (free toyota care) has been done at this specific dealership. Here is a pic of the piece.
View 19 Replies
I have an 04 Limited, 6.0 PSD, 4x4 which I need to replace the front inner axle seals, the right side is leaking out the shaft. I have watched a couple of YouTube videos on how it is done but would like to get some first hand knowledge and recommendations.
First, how important is it to check the backlash before beginning the removal of the gear assembly? Do I need to remove the pinion gear as well or just the gear assembly?
How difficult is it to get everything back on place once the seals are replaced? I have not done this type of repair before and am concerned I might miss something.
I am planning to replace all the ball joints at this time also, this was the primary reason for this maintenance in the first place.
View 8 Replies
I changed out the blower fan this morning as the a/c was weak and at times, the fan could not get going without manually spinning the blades to get it started. Easy project and now the fan has much more power. Decided to vacuum out the car after I was done which only took about 10 minutes. I know that I had disturbed the wiring under the front seats by brushing up against it with the vacuum tool while trying get under the seat. This is not the first time that this has happened... I checked all the connections. Should the 'problem' clear itself after 3 restarts? Car now has 244,882 mi.
View 3 Replies
