Ok after finding out I had a bad battery @ Toyota shop they also say the scan is reading an exhaust leak ( I could hear that one ) they also say there is a misfire on cold starts should I worry and what could it be or is it a misread from the other two ?
View 4 Replies2001 V6 Passat with 125k miles throwing a P0430 code.
Having trouble on cold starts, takes about 10 minutes to finally get it to turn over. When it does the idle is extremely rough. For the first 1/4 mile the car bucks, stutters, and misfires. After that it runs fine and starts fine when already warm. I am noticing slightly decreased gas mileage but nothing major.
Valve cover gaskets were replaced 2 months ago, but were leaking oil for at least a year before I could afford to have them replaced. I am still noticing some oil leakage, however not as much as before. I have had both O2 sensors replaced twice in the past 5 years. Timing belt was replaced at 98k. What might be causing the starting issues?
My Prius is in better condition than when I started, the following condition remains a mystery.
View 19 RepliesBought a 2006 (later production) with 25,000 miles over the weekend. Couldn't pass up the price and the warranty (1 year left + CPO). Picked up the car Saturday at noon..... had to drive to DC for business and the CEL came on when I turned on the car this morning. I researched at lunch that it could be a cold start misfire but I am already pretty heated about this. When I get home tonight I am going to plug it in to my OBDII scanner and see what I can pull. If it is something bad.... I am giving it back to the dealership.
View 24 RepliesCouple months ago I noticed that my car was experiencing rough idle, stuttering exhaust note during cold start. RPM is very stable!
Forward 4-5 months to last week, starting to notice vibration and it seems like the situation has gotten worse. The car returns to normal after 1 minute or so depending on how long it has been sitting there for. For example, If I park there for 30 minutes and try to start the car, I can feel a little vibration for up to 10 seconds. If it was parked for overnight, then the problem lasts up to one minute and then clears out. Now it's throwing a P0302 error which is cylinder 2 misfiring.
It's really like magic, the car would idle pretty rough and suddenly clears out.
I put in 4 brand new ignition coils and plugs, all OEM stuff and still hasn't worked.
This problems started during the winter time and I can clearly notice it's gotten worse and finally last week it threw the misfiring code.
I feel like something is failing or building up slowly. My car is a 2009 GTI TSI which has the same engine as the MK6 GTI.
The last couple of times that I've started my W12 after sitting over night or longer I've noticed a misfire for 10-20 seconds and then it cleans up. Today the engine icon illuminated and after returning home I ran a VAG-COM scan which revealed these DTC's. There are 7 found faults at address 11.
My question is this- What exactly is causing this misfire issue? I'm assuming there is a faulty piece under the hood begging for attention but I don't know which item it is.
Everything else seems to be performing as it should but I see a few other faults showing up. Are any of those faults anything that needs looking into?
VCDS Version: Release 11.11.6
Data version: 20121223
Chassis Type: 3D - VW Phaeton
My 2010 gti has a p30030 misfire cylinder 3 only on cold starts. Swapped plugs and coil packs, still only on 3. Took a look inside every cylinder and found that there was some oil in the cylinder only cylinder 3. So much blow by that it kind of collected in the cylinder? Carbon cleaning needed?
View 7 RepliesI get a cold start ignition miss on cyl #2, then goes away (with a little revving), car then runs 100%. No problems during hot re-start. 2005 1.8T AWM. I replaced all four plugs (NGK OEM), all four coils (OEM latest rev), Coolant temp sensor (temp gauge was flaky). No other codes other than Cyl#2 miss and Random Cyl miss. Could I have a leaking (fuel dribbles out) injector on Cyl #2, causing a too-rich misfire when the car is cold started??
View 6 RepliesI have a 2009 VW GTI 6spd (42k miles) that has been misfiring at idle for about a month now. I can feel the engine shaking and see the CEL flashing at 900 RPM and eventually an EPC light comes on and makes the car run very sluggish. The EPC light turns off if the i turn the car off and back on. The car runs fine and without any misfires after start up which has me stumpted as to what it could be.
I've taken it to San Tan VW in Gilbert, AZ 3 times.
1st time they said it needed a 40k mile service to correct the misfire which included oil change, fuel filter, air filter, spark plugs, fuel injector clearner and a tire rotation They said spark plugs was causing the misifre so i replaced the plugs but the misfire was still there.
2nd time they said the injectors have carbon build up and recommended to run 2-3 bottles of fuel injector cleaner + octane booster per tank for about 2 tanks and that will fix the issue. That didnt work either.
3rd visit they came to the conclusion that it had massive amounts of carbon and needed a "walnut blast". They recommended to look else where for cheaper labor rates on the blast.
Also, need to understand why the car only misfires at 900 RPM if there is carbon deposits at all times.
I'm needing cold engine misfire. 2001 escape 3.0 engine 190300 miles on it. I changed the plugs, cleaned the fuel injectors, new air filter, new fuel filter, cleaned the pcv valve and new ideal control valve. When the engine is cold it starts right up but wont idle right and misfires sputters some to but run the rpm's up and it smooths out. drop to idle and it misses. Now when the engine gets to operating temp it seems to run fine. What am I overlooking to find the problem?
View 5 RepliesI have about 140,000 miles on my car, a 2006 Toyota Prius that misfires at idle when cold, and for the last 10,000 miles the engine has been using between 1 and 2 quarts of castrol synthetic 5w30 oil between the 5,000 mile oil changes. My check engine light naturally stays on constantly now and the engine also appears to misfire on acceleration also.
For the first 60,000 miles I had the oil changed at various places every 3,000 miles using nonsynthetic oil that was recommended in the car manual. Since then I have been getting the oil changed at the dealer where I bought it new and they switched to the synthetic oil, so I asked the service department, why the misfire? They said the new type spark plugs are very sensitive to oil burned in the firing chamber, causing the misfire. They told me to check the oil often which I do and the engine has never been more than a quart low.
Is there a spark plug I can use that is not as sensitive to the oil, or should I be looking for a junk yard engine or is it cheaper to have my engine taken apart and repaired. Will it damage the engine further to keep running it, there does not appear to be any smoke coming from the tailpipe.
From new I got mpg in the 40's now I am getting 33 to 34 mpg.
1991 Buick Regal, 3800 V6
Having a rough idle on a cold start. After some research and closer inspection of the vehicle, I'm quite certain I have at least one leaking injector that is flooding a cylinder and causing the car to misfire on a cold start. I'm also not at the gas mileage I should be at.
So I'm wondering, is fuel injector replacement as straightforward of a job as it looks? Any major issues I could run into in doing a replacement?
I'm planning on replacing all six injectors (I can get them for $50 each buying online with a discount code), but given that the vehicle is so old am I better off just replacing the faulty ones? I'm assuming pulling the spark plugs and seeing which cylinder is wet will tell me which I need to replace.
And one more question: Is there a way to depressurize the fuel system when I park the car for the night, thus preventing fuel (or most of it) from leaking into the engine until I get this fixed? I've read that just unscrewing the gas cap can depressurize the system.
Car dumbie back again with another question.The diagnostic for my check engine light indicates numerous cold start misfire codes. The cylinders are OK. That was checked during the diagnostic.The fuel intake is carboned up. It is recommended that I clean the intake manifold. Does this mean cleaning the fuel injectors, the throttle body or both? 2006 Passat VW....
View 1 RepliesOften, when starting it will run rough and throw different misfire codes. Most of the time it smooths out in short order (a minute or less). When it doesn't smooth out quickly, it smooths out when I clear the code. Also, rarely it will start very hard. I have to wimd out the starter pretty good to get it to start. All that I have done is cleaned the MAF sensor.
View 3 RepliesI've been driving my wife's 2001 Ford ZX2 for the last ~9 months.
Early on in taking over driving it I noticed that it was difficult to start, so I had the battery checked. One place said it need to be replaced, but I wanted confirmation so I had it checked at two other places--it was in the normal range. So then I thought it probably needed a tune up since, as far as I know, it had never had one (has ~50K and I know it should've been done earlier). But, that didn't seem to fix it either.
I then had the fuel filter replaced. Nothing. I generally turn the key over for a few seconds before I actually crank it to let fuel in. It is now taking 3 times each startup to do this. And, right after starting it feels like the car is struggling to get gas (as if the fuel filter is completely stopped up or a fuel link is kinked).
Once the car is warm it cranks over on the first time (as if nothing is wrong). The last time I was at the shop they told me I need to have my fuel injection system cleaned. I have doubts about this--they based it on mileage not any sort of actual diagnostic or inspection. I use quality gas and run a fuel injector cleaner at each oil change.
Toyota read the codes wrong and told me that I need a new hybrid battery. That is incorrect info. Codes P0300 P0301 P0302P0303. The codes mean misfire in cylinders 1 , 2 and 3. I have had injector cleaned in the past new spark plugs. If I drive it it gets warmed up and shuts down. It will restart and run maybe 7 more miles the same. The brake light comes on and I have to restart it.
View 9 RepliesGeneral misfire when the engine light comes on. This error has been occurring almost daily, sometimes it pins it down to cylinder 3. My wife's nephew who is a mechanic says it could be the sensor, but I have only been getting around 30 mpg though the car seems to run alright. I did go ahead and get the plugs replaced, as I was told it could be a bad plug but the error light still comes on as before and the mileage appears no better. What could this be? I am retired on fixed income and dread the very idea of an expensive diagnostic & repair session with a dealer service. Their solution for about everything wrong has been to replace the gas tank (three times already in the life of the car). Last time that did not fix what was going on with the car..
View 10 Replies2001 Prius (242,044 miles) with transaxle error code! Red triangle with exclamation mark, check engine light, PS error, Main battery error, and little red car with exclamation mark error. One week ago car gave random misfire codes with a burnt smell... could have been from my car or could have been a smell from the car next to me. Cleared codes and they never came back. This week I get the CODE OF TRANSMISSION DEATH the dreaded P3120 along with a 5 minute wait by the side of the road until I could restart it and drive the 5 miles back to the house. Cleared the code but it came back the next day with another total loss of power and another 5 minute wait on the side of the road.
After I turn off the car and wait a few minutes it will usually start back up and I can continue on my way... sometimes for a few miles and sometimes for 10 miles. My question is this... could this problem be something other than a bad transmission (transaxle) or should I be looking for a used transmission on ebay? I have also heard that it is possible that the MG2 might be bad and that it can be swapped out without pulling the motor so how can I test and confirm my real problem. I plan to repair myself one way or another... Other than all these warning codes and exclamation mark warnings symbols she drives great until she stops producing power and coasts to a total stop.
Had this code show up after the warning light came on and then the light went away after two day, the car seems to be a little sluggish now. I have read that this is a random engine misfire and it could be a bad plug..
View 1 RepliesMy check engine light came on the other day, with no symptoms or problems. Today I stopped at the Auto Parts store and had the codes read. They were P0440, P0441, P0446, and P0301. They are for the EVAP system and misfire.
I had read here that one of the codes could be for the gas cap so I tightened it and then, also as read on here, disconnected the negative 12 V battery cable to perhaps clear the check engine light. I was curious.
When I started the car again, I now have not only the check engine light, but the red triangle exclamation point. How would you proceed? The 12 volt battery is around 5 years old. The entire exhaust system was replaced last year.(not O2 sensors though)
The hybrid battery was replaced at 70,000 miles and I now have 110,000 miles on it. I really wonder why disconnecting the battery and reconnecting it caused more error lights to appear? Also, the Auto parts guy said his code reader was fine for my car but I seem to remember here that there may be a special Prius one.
I have a Chrysler Neon 2001 and due to the recent cold weather in Montreal i had issues starting it. The battery seems to be functioning properly but when i try to start it, there wont be any sound what so ever, also i found a broken plastic pipe which im not sure what its there for ( I have uploaded a photo of it).
Link to picture : [URL] ....