2002 Prius with 94K gave me today P3130, after I tested the Inverter Water Pump I found out that it bad but until I go to the dealer in order to buy the part $147 he was closed. the question is can I drive with the car like this bac home (65 miles) and if I turn on the A/C the Engine will work all the time right? And also after replacing the Inverter Water Pump how can i tell if the problem solved?
View 14 RepliesI have a 2001 Toyota Prius. The inverter cooling pump was dead and I had the P3130 fault code. I replaced the pump and the refilled the fluid. After more than 4 or 5 times bleeding the system, now the pump sounds funny. It sounds like a water fall and look like it has too much air!!!! I can’t see any turbulence in the reservoir tank either.
There are 2 bleeding valves on the front side of the Inverter. Which one should be used to for bleeding the system? Both?
Does the system have any thermostat that could cause problem? Does it use the same radiator as the main one? What could cause having NO turbulence? I think the new pump will be dead too if it can’t make the turbulence.
Toyota ticked me off. I had them repair the ac on my Prius and during this time I read bleeding the inverter coolant can be a pain. They said they would flush and fill the inverter coolant for me. Over the weekend I get a P3130 error saying inverter overtemp. I did not have "turbulance" in the reservoir when I first bought this car and didn't know much at the time. Now, with getting the code I looked into this deeper. I told Toyota that this repair had been skipped and they denied it. Ends up the fluid was lower than it should and the tech said the pump wasn't working. "How did you bleed the system then". They gave me 2 gallons of coolant and I told them I will repair this myself now.
View 7 RepliesIn service manual doesn't show the limit time to change the water pump of inverter unit. What is the limit time or limit mileage for change it?
Example, engine's water pump has the limit around 200,000 Km(125,000Mile). But why inverter water pump no limit using time?
On my way home in stop and go traffic the whole dash lit up with about 4 miles to go. Car was running as normal so I immediately thought inverter pump so got home and checked for circulation and there was good circulation. Pulled code with my obdII scanner and code P3130 came up. Cleared codes to restart and check circulation of fluid to verify and there was NO CIRCULATION. So, went and ordered the Toyota part #G9020-47022. Is there something else I should check before just changing the pump like a relay or electrical? Is there another place to get the coolant as the dealer has it at $32 gallon which is crazy. Then, if I do end up changing out the pump which I am almost sure I will have to which is a good way to burp the system as I have read this can be an issue. Does all the fluid (parts guy says two gallons) need to be changed out or just what spills out.
View 13 RepliesI had the red triangle pop up on my Prius. I codes I got P0A93 and P1121 I needed a new control valve and inverter water pump. I installed both the valve and the inverter pump filled it with new coolant and bled both systems.
I went into maintenance mode so I could run the motor and bleed out all the water. My question is the red triangle is still on in my car when I start it up.. Is there some way to clear the red triangle or does it just go away on its own? Not sure what to do.
While driving home last night the Red Triangle, CEL and the Hybrid Warning lamp, (on the MFD) all lit up. The cruise control also shut down. We stopped and checked the manual to identify what the symbols meant. We were approximately 90 miles from home, drizzling rain and it was about 60 degrees.
View 18 RepliesI own a 2006 JDM prius with 323,000 km. The inverter coolant pump failed recently (got P0A93 code and no agitation in coolant reservoir). I ordered a replacement on eBay and am awaiting arrival. I may need to do some light driving in the in the interim and am thinking about installing a 10 inch fan in the space between the inverter/transmission and radiator to keep things cool. Is this wise or should I just let the car sit until the new pump gets here?
Also, I am burning oil...I usually have to top up 1 to 2 quarts in between changes. Is there anything I can do without tearing down the engine? A friend of mine suggested using Lucas oil stabilizer the next time I change oil...could this have any negative implications?
After the warning light & triangle went on in my 2003 Prius, it turned out the inverter pump was bad. It was replaced. Now I am steadily losing MPG as I drive the car. From before the replacement, it has gone from 42 - 44 down to 36. This is in a few days time.
After I got home, I saw that the dealer put on the service ticket that the car might need a new inverter. There was no reason stated for that, and the service rep never mentioned it. In fact, the service rep said that the hybrid system would not be damaged if I drove the car with the warning light, since the hybrid system would shut itself off before any damage would be done.
There is a small leak in the radiator but on inspection, the coolant level is full (actually, while still hot, it is overfull), so I don't think that is the problem, at least not yet.
I bought an 01 Prius with 148k miles. It had code P3125 which mean bad inverter. I replaced the inverter with one from a junk yard with 81k miles. As soon as I was done the car started right up, and I didnt get electrocuted!
Right after the car started I got codes P3115 P3001 and P 3191. I cleared them out and turned off the car for a min.
When I started the car again I got codes P3030 and P3001.
This car has an extensive service history, It has a new Cat and exhaust, a new accessory and HV traction battery that are less than 8 months old. Crank position sensor is new. fuel tank is new.
What could be causing the P3030 and the P3001?
Pulling into parking lot and the triangle and exclamation light appear on dash. Drive about an additional hundred feet with what felt like lower power and no noises.
- Check 12V after about an hour and it reads 12.4 volts.
- Read codes and get P3125 sub code 325.
- Temperatures and HV battery numbers all looked good.
- Clear codes and immediately code comes back with no start, nothing. Did this many times.
This code and sub code lead to the inverter failing. Being that there was no noise as a MG2 stator failure this also leads to an inverter failure right as the MG1 motor starts the engine? Inverter pump still running good as it was recently replaced along with ATX fluid. Within the last two weeks two HV modules have been replaced.
I'm trying to be detailed as possible.
View 12 RepliesI've been having issues with my beloved 2003 with a little over 130k with warning lights going on and off. I went to O'Reilly's they gave me the codes P3130 and P0303. One of codes states "misfiring on all cylinders," they didn't have a description for the other one.
Dealership won't tell me anything about what the codes mean. The warning lights are an exclamation point inside a triangle, check engine, and what looks like a thermometer in red.
Just got the oil changed a little over a week ago, dealership said they didn't notice any problems. Warning lights came back on last Thursday and just disappeared about an hour ago.
On my 05 Prius (65K miles) I recently had my local Toyota dealer replace both the inverter water pump (for free per recall) and main engine water pump (~$500 based on their recommendation because of some coolant leakage). 1 week later, I got the P1121 code coming off and on intermittently.
My dealer says that the work they did is not related to P1121.
I had my hybrid water pump replaced (free, under recall) about a month ago. Now the check engine light comes on intermittently, and it's with error code 1121 (Coolant flow control valve sensor stuck). I've seen other people on this forum hypothesize that the work could cause this error (if not bled properly, leaving air in the system). But my dealer said the work had nothing to do with this error and I need to replace the control valve. How to suggest to my dealer that it could, in fact, be due to their work and that I think they should fix it for free?
View 15 RepliesSo got this P0A93 code when I was driving on the highway about 65mph, scared to me death when big yellow warning light came on so I returned home and turn the car back on after 30 mins the code and all the warning lights were gone I checked under the hood felt the pump everything was good. I just got done 90k maintance on the car from dealer. So my question is that could be computer error or it could be water pump malfunction? On warranty manual the warranty for inverter with converter covers under 100k so dealer should be able to cover the water pump if it's broken? I driven the car today again at normal temperature and full blast AC on, then again no engine check light on and warning light no message.
View 4 RepliesI have an 2002 which I bought new. It's got low millage, just over 92,000. I took it into the dealer for a free state inspection and was told that the water pump is leaking. Given the age I'm not too surprised although I don't know what the reliability is like on that part.
I want to verify myself that the water pump is actually leaking before having it replaced but don't know where it is or what to look for. Googling hasn't been too useful - I get lots of hits about the inverter pump, not the water pump.
I have not seen any signs of leaking on the ground under the car. There was no mention of the water pump leaking when I took it to the dealer at 90,000 for an oil change, with my original service advisor.
Is the water pump something that I can fairly easily inspect? Where do I find it and what do I look for?
If you drive in 100 degree F weather, use your AC and drive up steep hills. Check your inverter coolant system for trapped air. The inverter pump cannot pump air. I had the LSC about 6 months ago and apparently the mechanic rushed the job and there was still an amazing amount of air in the system, I did this yesterday. Today I checked it again and no more air showed on my clear plastic tubing. Although I had to top the reservoir with 2-3 more ounces, so air could have expelled out of the reservoir and I would not notice it.
View 5 RepliesI went to the workshop of Toyota in Iraq to repair the car. But do not have engineers repairing Prius cars. And they examine the device to detect faults only... These numbers faults
(P0A0F)Engine failed to start.
(P261C)water pump.
Having seen the rather catastrophic outcomes that are possible with inverter coolant pump failure, I've thought a bit about adding a flow sensor in the coolant path. I even went so far as to buy a flow sensor, which would probably do the job. However, it's somewhat heavy, and then there's the plumbing job to take care of. Seemed somewhat challenging to pull off.
Since this aborted endeavor, I began thinking about ways to detect surface turbulence at the top of the coolant tank, and am now thinking that might be easier to pull off, even if it requires programming a PIC to do the monitoring. My current thought is to install an LED and optical sensor in the cap, and measure light intensity received.
I'm a new owner of a used 2008 Prius. Car only has 67K miles and other than the leak, appears to be in good shape.
I noticed the coolant was low in both reservoirs, filled it up (with the proper SLLC), but a day or so later the check engine light came on. Took it to mechanic (dealer is 2 hours away), he read and cleared the codes, then found the leak. Appears to be leaking where the lower hose attaches to the pump, so not sure if it's the pump or the hose that's the problem. I've also noticed that the pump seems a bit noisy for a few minutes after shutting off the car (of course, I'm new to the Prius so not totally sure what "normal" sounds like).