I just recently purchased a 2001 Prius with 92,000 miles on it and the check engine like comes on frequently. I have a scangauge and I scan for codes and it comes up P0000. I clear the codes the light goes off and everything seems to be ok. I'm not even sure where to start "looking" for something to be wrong.
View 17 RepliesPurchased a used 2005 Prius with 30,000 on the clock. Have put 5,000 miles on the car with no problems. Recently the check engine light came on and my Scan Gauge indicated a trouble code of "P0000". Cleared the code and four days and 500 miles later the check engine light returned with the same code. Car runs great even with the light on. Have check the fuel cap which was and is tight.
View 2 RepliesCheck engine light is on and my code reader is giving me a P0000 code that is not listed in the Bentley's list of OBD II codes. My nose is telling me it's emissions related as the exhaust smells too rich. And the car is nearly stalling at idle. Suspect #1 is the MAF but the OBD II code does not support this.
View 13 Repliesengine light in its obviosley on! reset it drive while driving it at 2500 or above engine light stays off.
it isn't misfiring unless it's under 1200 ish. then I am getting code p0000. what should I be looking into?
Suddenly today, I get a "Check Engine" light while driving. Scangauge II says it's a P1430 error. I found two different suggestions, but where these are located on the car.
P1430-Electric Air Pump secondary Failure
P1430 -Vacuum Sensor for Adsorber and Catalyst System Circuit Malfunction
I have a 2001 Prius with 210,000 miles. The inverter and traction battery were replaced last year. I started getting triangle and check engine lights about a month ago and the scan tool read p3191 p3006 p0300. The car would barely start in the mornings and the dash lights would be dim. I replaced the 12v aux battery today and all the symptoms went away. Driving home the triangle/check engine light popped on again and I stopped at Orielly's to use their scan tool. It now only reads P3006. I called a local mechanic who suggested to drive it a bit and clear the codes because the battery needed to equalize. Is this true?
View 8 RepliesI have a 2003 Prius, I had an accident and after it was fixed the check engine light started coming on. It would go off after a couple of days. The first time I took it to Autozone and the codes were P3150 & P3130, but the next day the check engine light went off. A couple of days later the light came back on....went back off....next week it stalled on the highway, but it started back up, now the codes it's reading are P1636 and P3002. It still starts up and will drive, but I'm afraid to drive it.
View 2 RepliesMy Check engine Light comes on with a P0410 Code. It used to come on every 6 months and I would get it cleared. Now it is coming on about every month. I can't find much about it. Is this something I should get fixed right away. where is it located?
View 4 RepliesCheck engine light on, car stalled once. Pulling code p0320 "Engine Speed Input Circuit Malfunction." Tachometer works intermittently. Where do I start?
View 2 RepliesI own an 04 Hyundai Elantra with around 196,000 miles on it, and have run across a problem I haven't had to deal with before. A few days ago, my check engine light came on while driving. I didn't really notice much, but when I started it again it began idling roughly. I got it home and pulled the code, which was P0341 (camshaft position sensor). This isn't the first sensor I've had go on the car (I replaced an oxygen sensor and throttle position sensor a couple years ago), however I ran into two problems:
1. How likely is it that it's the sensor that's bad as opposed to something like the timing belt or VVT adjustment?
2. Since the sensor isn't horribly expensive, I decided to try replacing it, but I can't get any socket to fit on the bolt that secures it. I've heard it's a 10mm, but nothing seems to fit snugly. Maybe there's just so much crud and corrosion that it's ruined the head. I tried using an extraction socket, but no luck.
Recently got check engine light fault code p0320
2005 3.5 with 172k miles
I just got this very nice Elantra 04 with 64k on it. Yesterday suddenly I got the check engine light on. Today I went to Auto zone and they have checked my car and it showed code P2626. But there are more than a few suggestions about what could be. I don't know what to do. See the attachment below.
View 1 RepliesCheck engine light was on for some time when I had filler neck and cap replaced. Computer sensors did not re-set until 501 mile mark, when light came on again. Checking the web, I find that some who appear to have knowledge of problem say it could be hoses, sensors, valves, or evap canister--the charcoal canister.
Mechanic who did original smoke test and recommended replacement of filler tube wants to replace evap canister without checking anything else. What should I do? At wits end, and car needed to pass inspection 2 days ago. Car has 157,000 miles or so...
I have an 01 Explorer Sportrac with a 4.0, 105,000 milles. Got the check engine light with the EGR low flow code. I get this code about once a year and a new DPFE usually takes care of it. I get the sensor from Advanced Auto which explains the short life I am guessing. Last time i replaced the sensor the light came back on a couple weeks later.
After highway driving smoke starts pouring freon under the hood, passenger side, but by the time I get the hood opened its done. Cant tell where it is coming from. Could a faulty DPFE cause the smoke or do you think the EGR valve may be sticking? I was going to try a Ford DPFE this time but I hate to just throw parts at it. Where do the smoke is coming out of, air filter box????? cant see anything else over there related to the EGR system......
I recently had the engine light come up on my Hyundai Elantra 2003. I read the code with my cheap little code reader with the torque lite (free) app on android. It threw the P0128 code which means a faulty thermostat.
Here's the web link to all the details on the code: [URL] ....
I have checked the coolant level and its good. The strength of the coolant is good to -40 Celsius. The engine fan is not running at all. I recently changed the thermostat. I'm leaning towards faulty ECT. The car takes forever to blow hot air too. It has done weird readings in the past with the temperature gauge in the cab.
I just bought a infrared temperature reader of Amazon and want to check the temperature where the water comes out of the engine past the thermostat and compare it to the reading on the torque app readings. I'm thinking it won't match.
I bought an 04 elantra a few weeks ago. The check engine light is now on and I get code P0420 listed twice with my code reader. I have replaced the downstream O2 sensor and reset the codes only for them to return again. It is my understanding that this is going to be a convertor problem. My question is that from the research I have done it looks as though this car has two converters. One at the exhaust manifold and then another in the tailpipe. Which one is going to be the most likely causing my Check engine light to come on. Or do I need to replace both converters.
View 5 RepliesMy check engine light came on the other day and the code stated the the "throttle position is open" so after researching and everyone telling me that i need to change the sensor. I did everything after was fine running better but today only after 3 days replacing it i get the same problems. car has no get up and go hardly can push to 20 mph and when in idle i press the break it starts to bog down and almost want to shut off! and can be really loud...
Santa fe 05' 3.5L ....
Mystery issue with my 2001 Accent GSI (5-speed manual, 1.6 L). I'm getting a P0300 error code and the Check Engine light (the light is like an old friend, I miss it when it's not on). This happened four months ago and I replaced the ignition coil - seemed to fix things - but now the light and the error is back with a vengeance. Car stumbles and runs rough. Changed the plugs and plug wires, but no difference.
BTW, there's a small pin hole in the upper part of the gas tank (just enough to give it a gassy smell when the tank is full) but I don't think the hole would be big enough at this stage to cause the check engine light to come on in the same way it does if you leave the gas cap off or loose.
I have a 2003 Elantra GLS. I am intermittently Check Engine light and error code is P0113 - Air Intake sensor issue. I can't locate where the sensor is. I don't see any wire coming of the tubing that connects the air filter to the engine.
View 18 Replies2004 Elantra AT ... 6 months ago top of the radiator cracked caused it to overheat and blow the head gasket and warp the head. Repaired that and compression is fine now. It ran great for 4 months but now it randomly stalls. at or near idle. Seems to do it more at operating temp rather then cold. Occasionally the check engine light will pop on and the code reads (random misfire). It acts just like it has been shut off. But immediately restarts.
View 3 RepliesI've read many threads in here, but I didn't find problem of my car. It's Toyota Prius-3 2010, check engine light on and code is P0401. EGR Valve works well, I cleaned pipe, gasket, cleaned throttle plate and everything but nothing works.
I have (light on) it maybe 1 year or more, the light goes away and come back,I'm in Los Angeles and all they time is sunny day and weather is nice, I've seen 3 times, when i drove in rain evening and morning I didn't see light on.. then, couple days and comes again. I think maybe EGR cooler has to be replace? or I do not know why in cold weather time light goes away..