Prius (2001-03) :: Changing 02 Front Bearing?
Mar 8, 2011
Need to change an 02 front wheel bearing. Can the the bearing be replaced without taking hub off? It slides or presses in.
View 4 RepliesNeed to change an 02 front wheel bearing. Can the the bearing be replaced without taking hub off? It slides or presses in.
View 4 RepliesThis past week I changed out the front wheel bearing hub assemblys on both sides. I'm curious if completely disassembled one of the units? If so what did you use to get the large nut with the 4 notches in it off?
View 2 Replies2001, F250, 4x4, 432,000 miles...
Seems this truck eats up bearing assemblies. Its like every 2-3 years, I'm having to replace one side or the other. And we talking like 30-40,000 miles....
BTW.... although I'm not out doing much 4x4 driving, this truck does do a lot of dirt roads, probably over 50%...
Need to change the hub and bearing(front) on their 2011 sonata?
View 18 RepliesI was going to put on some lowering spring on my prius last night but i couldnt figure out how to get the top bearing off. Looking for pictures or a guide or something?
View 1 Repliesnoise in my front end. I know there is a lot of stuff going on there so let me try. Noise is more like a groan not a squeak, tick, not an engine noise or a brake noise. Applying the brakes or turning the wheels does not make a noise. Best way to describe it to me it is like a bad bearing type of noise. The noise is starting to get louder.
View 19 RepliesI have a 2007 the front wheel bearing started humming real bad, changed it out. Can't seem to get the right front brake bled good. Did it three times. No air. Today locked up the left wheel upon putting on the brake, the right one ain't working. Is there any thing I can do other than bleed the left front again, check fluid?
View 2 RepliesI devloped a noise in the right front wheel. I thought it was a tire going bad so I rotated the tires & still had the noise. I was told by shop it is a wheel bearing. If that is the problem is that a DIY repair ?
View 5 RepliesI have the dreaded front wheel bearing noise front left had a monsoon last month in orlando. Went through a puddle. Did the front right 8 months ago,everythings fine I am doing uber. Can I spray some deep creep or oil in there to tempt calm the noise?
View 1 RepliesFor several days I could hear a scraping sound from the right front side. I thought it was snow packed in the wheel well at first, until there wasn't any snow there. Today I was driving on the Xway and the scraping became a buzz like a Cessna airplane. On the way back home I turned the steering wheel back and forth and sure enough the buzz came and went. That made it sure to me the wheel bearing was bad.
View 19 RepliesAt about 20k on my 07 I started hearing a faint whup whup whup between 35 and 50 mph's on the front driver's side area. At 60+ pretty quiet. It has gotten real loud at the present 30K. I suspected the tirers as I know the Integrities are complete junk but as a test I did a rotation and exact same noise.
I thought thats not good but found it hard to believe something else was bad as I had no vibration and no pull whatsoever in steering. Long story short I bought a new set of tires Kumho KR21's at stock size and oh crap exact same noise.
My wheel bearing in the rear went..as its roaring when driving and shop told me wheel bearing needs replaced. I am a bit handy. Is it a big job to change a rear wheel bearing on a 2002 ford escape 3 litre. What tools would I need...don't need a press for wheel bearing on this model, not sure....
View 1 RepliesTrying to change the front sway bar bushing with a PU version? Does it improve handling and steering feedback?
View 1 RepliesI changed the front brake pads, took all the precautions during the change, did not disconnect the 12 v battery, pumped the brake pedal 12 times, started the car and no warnings. Now the brake pedal is a little spongy, if I press the pedal to the floor the VSC/TRAC light comes on, to reset it I have to press on the pedal again and the brakes do work.
View 11 Replies2004 prius. I change the brakes on various cars all the time, and never had this problem. After I changed both sides, I started the car, and saw 4 lights:
- Red brake light
- The yellow exclamation light
- ABS light
- VSC light
The car now stops funny, and reading the service manual, it says that if there's a failure detected, that it will revert back to very basic braking (no abs, only fronts, etc..)... As I was exiting off the fwy, I realized this when one of my front wheels locked up, even and I was not stopping very well. Scared the crap out of me.
In any case, I can't see what I may have done which would cause a failure. The only thing I could think of is to bleed the brakes again, but I did this and think it's ok. Is there anything else I can check or is this something I have to get serviced? I saw another thread where they suspected the actuator, but it is somewhat a coincidence that it would go bad after I replace the pads? I'm not sure how the regenerative brakes works on a prius, and whether there's anything I could visually inspect to see if I bumped something???
I am going to have to change my brake pads (I am probably going to do the rear shoes as well). I was wondering if I should get my Toyota dealer to change the fluid as well. I have 116,000 miles on her. Lots of highway driving, and this is only the first replacement set, these pads last forever. The fluid has never been changed before.
View 6 RepliesIve got a 2002 f250 Sd 4x4 with 93000. Im getting severe vibration from the front drivers side at highway speed. I thought it might be a warped rotor but i cant feel it in the brake pedal, when I put the brakes on. How can you tell when the hub bearing assembly is going bad? The truck doesnt pull to that side either. I can hear it, and feel it more when i'm going around highway corners. When im driving through town, I can hear a "clunk,clunk,clunk" noise coming from that side also.
View 14 RepliesI have a 1998 1.8T with 180 000km's. The timing belt was done 3000km's ago. It seems to be in excellent shape except just this week I have heard a very slight squeak when I shut her off. I think maybe it is a fan bearing but I'm unsure...
View 1 RepliesJust had an oil change and during inspection they noticed that the drivers side wheel bearing is starting to go. They brought me back in the shop and I was able to feel the play in the bearing myself. Only a matter of time before it needs to be replaced.
How to replace the front wheel bearing/hub assembly? I don't have a press for the bearing itself so I'm assuming I can just replace the entire hub assembly. I have already replaced the drivers side rear hub assembly about 1.5 years back due to a bad bearing
So my front right Wheel bearing is making noise and its a used Knuckle so its w/e. Guess ill use tonight to do all my bushings and fluids n stuff.
View 6 Replies2006 Sonata with 90k ... When I make right turns the left front wheel is making a rubbing sound with the motion of the wheel. It's not doing it on a straight line, just turning right. I've talked to a couple of my friends and they are telling me it's a wheel bearing. I have a service manual but it's not really going into detail on what I'm in for. I work on motorcycles all the time and my good friend said he has a press if I can bring him the knuckle and the OEM bearing. Looking for a little guidance before I take the wheel off and get started. Are there any special tools involved, etc...should I do the other side while I'm doing this also...
View 11 Replies