Prius (2001-03) :: 2002 - Won't Start - Chip In The Key?
Mar 16, 2012
I was at Walmart today and FINALLY remembered to get a couple keys made for my 02 prius. I have been taking somewhat of a gamble considering I only got 1 key when I bought it.
I tried the keys in the trunk. Cha Ching! Unlocked and locked the doors. Cha Ching! Put the key in the ignition and turned it. Cha Ching! Went to start the car and Nothing!!
I could turn the car into accessory and into the run position, but it would not put the car in ready mode. At first, I thought my battery died. I took a deep breath and put the "Toyota" key in and she started right up...
View 3 Replies
Advertisement
I have an 2002 7.3 powerstroke. It has a super chips installed, set on heavy tow mode. When throttle is on the foot and I start up a hill check engine light comes on. Code is for icp fault or uncontrollable. Also happens on cruise but more often on the foot. Have to reset to get check engine light off. Light stays off til I go to pull a hill again. I am also pulling a horse trailer with 1-4 horses. Could the programmer be causing this?
View 4 Replies
I own a used 2002 Prius and have only been driving it for about two months. In the last week it has given me some trouble on start up. I turn the key, but the engine will not start. Unlike some of the other comments I've seen here, I'm not getting any warning messages when my car won't start. I turn the key and the dash lights either come on half lit or not at all, the computer screen doesn't light at all when this happens. If I hold the key in the start position for a few (up to twenty seconds) it will eventually turn over and start, but that seems to be draining the big battery and doesn't seem like the best way to start the car. This happens about 2 out of every three times I go to start the car and it doesn't seem to matter how long I've had it parked - could be an hour or overnight. Conversely, it could be sitting for a day and a half and start without issue. All in all, there seems to be no obvious condition that would cause this, and I was curious to know what I should troubleshoot and in what order. As with many people these days, money is scarce and I don't have the money or time to keep it in the shop for a week for diagnostics, especially when it might be something I can easily fix on my own.
View 8 Replies
My Prius is in better condition than when I started, the following condition remains a mystery.
View 19 Replies
I pulled the traction battery...remanned it with great success computer very happy with results... drove it for a week. Took it to Walmart to have oil changed... Got in car , started fine...new oil made motor even smoother....then in 200 yards at traffic light , motor died with unusual sound... pulled over and restarted...but would die. Lights all over dash on.
made it back to oil bay...engine would not restart.
pushed inside and would start and then die... then was rattling when dying
checked aux battery with testers , both indicated dead cell 10.25 volts
tried to substitute a new battery via heavy jumpers... got it to start then die..,..then no try at all
I have read forums ,,,that indicate after 3 tries on a dead aux battery , computer will immobilize it
Have tried replacing with a new lawn tractor battery .but seems the car is immobized . Read codes with Mini VCI, and was able to clear all codes but the immobilizer code.
View 14 Replies
I just purchased a 2002 Prius from a government auction. The car had to be jump started at the auction yard. It ran for awhile and then died before I could put it on the dolly. I jumped it again, load it and towed it home. When I got home I jumped it and drove it off. I tried to charge the 12V battery on a 2 amp current, but it wouldn't charge so I replaced it with a new battery. Now the car won't start at all. Don't worry, I did not reverse polarity at anytime. Here's what is happening now....
View 2 Replies
I'm not so sure what is the problem because when the ac light flashing and I'm closing the ac switch and turn it back on the ac start to cool again but start flashing after few min.
View 14 Replies
Pulling into parking lot and the triangle and exclamation light appear on dash. Drive about an additional hundred feet with what felt like lower power and no noises.
- Check 12V after about an hour and it reads 12.4 volts.
- Read codes and get P3125 sub code 325.
- Temperatures and HV battery numbers all looked good.
- Clear codes and immediately code comes back with no start, nothing. Did this many times.
This code and sub code lead to the inverter failing. Being that there was no noise as a MG2 stator failure this also leads to an inverter failure right as the MG1 motor starts the engine? Inverter pump still running good as it was recently replaced along with ATX fluid. Within the last two weeks two HV modules have been replaced.
View 18 Replies
Well I went to have a guy at work scan my truck to see why my o/d light is flashing His scanner wouldn't connect so I unhooked my ts chip still wouldn't after that Now with the chip unplugged. I can't start with it on I can't start...
My cel is on and my theft light just blinks. My wait to start never comes on but my glow plugs do start up and warm up. All I have is cranking but that's it?
View 14 Replies
This has been happening for awhile now. I will drive somewhere, distance isn't a problem, and then after I'm done, I'll go to start my car, and it won't start. It won't turn over or whatever the term is. The starter tries, but won't bite. Sometimes it will start and I can drive for a bit before it will die about a block or 2 later.
View 7 Replies
My 2002 Hyandai Sante Fee will not start up every time I put gas in it. The mechanics cannot find the problem. I had to change my starter two times in 6 months because I keep flooding the starter to start it up. What this might be?
View 12 Replies
We have 2 Hyundai a 2015 Sonta and a 2002 Elentra I am having problems with the 02 Elentra
I have a 2002 elentra that cranks but will not start it tries to but wouldn't start. It started fine before this and it did start once but ran really rough and only for a few seconds.
View 4 Replies
Just bought a used but in pretty decent shape, 2002 Santa Fe, with 6 cylinder engine, 112K miles. I read the post about the vehicle that was hard to start after filling up - but this one is hard to start all the time - every time. Cranks fine, but once cranking, have to pump the gas pedal several times, and then it chugs just a second and then starts running. Slilght smell of gas if the hood is up, just after starting. Once running however, it runs perfectly on city and hwy. I have one mech that tells me "definitely the fuel pump" and another that tells me "definitely the purge valve" - this of course just from me describing the conditions, they have not actually seen it.
View 3 Replies
My 2002 Elantra GLS seems to have some sort of heat related problem.
I live in Arizona, where temperatures routinely reach well over 100. In the morning my car will start fine, after driving it for some time and parking somewhere, if I try and start the car within a couple hours of driving it, it will crank but not start. Lifting the hood to cool it seems to expedite this to get it started.
I had a mechanic friend of mine hook up his OBD computer at his shop, nothing out of the ordinary. He suspected either a crankshaft or camshaft position sensor. No check engine light, nothing out of the ordinary on his computer check. I removed spark plug wires for cylinders 1 and 4 and I have spark while cranking when it fails to start. My mechanic friend said the spark would rule out a faulty crankshaft position sensor. I have also tried spraying starting fluid into the intake manifold, and it has no effect. The battery has been replaced within the last two months, connectors are new as well.
View 12 Replies
When I start it up it won't idle untill you give it gas to 2500 rpms and slowly let off the pedal to 1000 rpms to keep it running and itll stay running. When you turn it off you have to redo it all over again. The plugs and wires were replaced. It started doing it couple days after the back 3 plugs and wires were replaced. Just got the fuel pressure regulator replaced and it still wont start up without giving it gas.
View 6 Replies
My GF has a 2002 Elantra, and recently, she's had a remote start kit put in her car. Previously, though, we were moving something in/out of her car and broke the shift knob and the rod became bent, so we had to bend the rod back to be able to put the car back into park. (The car is an auto).
Recently, she's had a couple rough/no starts from her car. There have been a few times where she would come over to my house and the car would not restart soon after she turns off the ignition. However, the car will start rough about 3 hours later and run perfectly fine once it cranks. This doesn't happen often, but enough to be troublesome.
The problem with this though is the fact that sometimes it starts and sometimes it doesn't, and it runs PERFECTLY fine. The lights are not dimming, the battery is not dying, the car has not required to be jumped. While having these problems we drove the car around for about 5-6 hours and it was perfectly fine. Her dad thinks it's the alternator, but the battery hasn't been losing any charge and the battery hasn't been dying. There has been one time where her father moved the shifter up and down and put it back into park and the car started just fine. Could this be related to the shifter, and how the car isn't reading that's it's fully in park to relay ignition? Her dad said he tested the alternator and it was "bad," but like I said, if the alternator was bad, her battery would be losing charge, and that is definitely not the case.
View 7 Replies
I had a rough idle and now car wont start. 2002 elantra, 4 cylinder. replaced tps, replaced fuel filer, cleaned IAC. I can hear fuel pump car wont stay running...
View 22 Replies
I have a 2002 Hyundai Elantra 2.0 5spd manual GT with 90k miles. I just bought the car 2 weeks ago. The previous owner claims he did regular maintenance on it. He said the timing belt and water pump were done around 65k miles but didn't have paperwork on it. Has brand new tires. Battery is a year and a half old. I just replaced the spark plugs and plug wires a few days ago just because I don't know when the last time the previous owner changed them. 3/4 showed normal wear and were probably needing to be replaced. One of them (the one all the way to the drivers side) had a decent amount of corrosion built up in the wall leading down to the spark plug and then around the fitting for the 5/8 socket had quite a bit of corrosion around it to. The end of the plug looked like the rest of the plugs however. Before I installed the new plug I cleaned it up. As far as I know there isn't any other mechanical issues. He said he had the clutched replaced too. Which I find a little odd because it doesn't even have 100k miles on it yet and if it wasn't driven like a race car, that clutch should last a lot longer I would think.
My girlfriend was driving it home from work today and it died on her when she stopped at the off ramp of a freeway. I showed up and pushed the clutch pedal down as hard as I could and it fired right up. However, I walked away then she called me back because she couldn't get it to accelerate after that. Unfortunately I didn't actually try to drive it at that point which was stupid so it's possible she just didn't have it in gear all the way however it appeared that she did. It then shortly after died and hasn't started since. I'm getting power to everything else in the car including headlights and some lights and everything else I can think of. It won't even attempt to crank. It just does nothing when I try to turn it over.
I believe a few people recommended changing the crankshaft sensor. I have read that if the crankshaft sensor goes bad it will have the problem I am currently facing. At this point I'm assuming my girlfriend just didn't have it in gear and that's why it couldn't accelerate because if that wasn't the case, then that sounds to me like it's slipping and the clutch needs to be replaced. Anyways, other than the crankshaft sensor, I am thinking possibly the starter or alternator. I know it has a MAP instead of a MAF sensor and I know where it is but I'm not sure if that would cause this issue because I figured it would at least turn over. If it was the alternator if the batteries were dead I would charge them and if it died again that would be a strong indicator it was the alternator. But the batteries didn't really read low and I threw them on the charger anyways and it said it was fully charged shortly after I did that, and then I tried starting it again and still nothing. So right now I'm leaning towards the starter or this crankshaft sensor. My buddy said to take a screwdriver to the starter and try to jump it but how exactly to do that to test it. I have read multiple things online for other vehicles that the crankshaft sensor being bad will cause the car to not start.
View 6 Replies
I have a 2002 Hyundai Elantra GLS with over 215,000 miles. About a month ago, I started my car and it revved up & down from 2 to 4 rpm. I took it to my mechanic and replaced the TPS, thinking it would fix it. What to do next. My mechanic fixes cars, but doesn't do it professionally. I don't have the money to take it to a dealership.
Now, after doing a tune-up and changing out other sensors the RPMs came down to 3 and will stay at 3 rpm when I start the car. When I drive it, it pulls on it's own without touching the gas pedal and is hard to brake. What else I need to fix or replace?
View 6 Replies
2001 Prius
polarity got reversed on dead battery. Main fuses OK so did I toast all the CPUs?? or not...
View 9 Replies
2002 2.7L. Engine seized. Bought a replacement also from a 2002. Tried to start today and no spark. I just replaced the physically broken crank position sensor. That seemed like it would be an obvious and easy fix, but still no spark. The broken sensor had frayed/shorted wires. Could that have damaged the PCM /ECU? There is a 2003 Santa Fe at U-Pull-It that was running when it came in. Will the PCM from that work? I am running out of time. I have to have this running before I leave on a flight tomorrow night. I do have a code reader (if I can find it) but I can't imaging it would have any codes if it hasn't started since I had the battery out. Not sure how that works.
View 4 Replies
