Pontiac - Grandam :: 2003 - No Cold Start / Crank But Never Fire
Oct 5, 2015
I have a 2003 Pontiac Grand Am, 3.4L V6. The engine runs perfectly as long as it is kept hot. If allowed to cool completely it will crank and crank all day but never fire. However, if I disconnect the battery for at least 30 minutes and reconnect it, it fires right up every time. I have good fuel pressure when it will not fire, but it seems as if the injectors will not fire. Suspecting the injection driver, I replaced the ECM/PCM. The exact same problem still exists.
View 8 Replies
Advertisement
2003 Pontiac grand am 3.4 car cranks has great fuel pressure and spark will not start when ambient temp under 75 deg without hot shot then fine the rest of day..have replaced fuel pump map sensor cam sensor air temp sensor.
View 1 Replies
My 2003 Pontiac Grand Am often doesn't start in warm weather. The engine will crank but not start, but if I then leave the key in the run position for exactly ten minutes, the security system seems to calm down and I can switch it off then start the car (a kind tow driver taught me that trick). This doesn't happen in the winter in Pittsburgh, but might happen one start out of six in the summer.
I had the ignition cylinder replaced once, and it took care of the problem for about a year. After it came back, I was told to do exactly the same thing again. At first I decided to punish the dealer by spending another summer loafing in parking lots, but this year I can't take it any more. Should I replace it again? Should a dealer warrant the longevity of the repair?
View 2 Replies
I have a '95 pontiac grand AM with about 208,000 miles on it. About a week ago, i noticed it was getting harder to start when the engine is cold. When the engine has warmed up, it starts up right away, however, the engine begins to sputter and sounds as if it is going to die. The engine still sputters while driving and the car begins to jolt back and forth. When I come to a stop, the car sounds as if its going to shut off. Today, I started the car and it was sputtering so I turned it off and then wasn't able to start it for about 40 mins. I let the car sit for about 20 mins and then tried it, started right up. What could be causing the sputtering and engine throbbing? What's wrong?
View 6 Replies
I have a 2002 Pontiac Grand AM GT with 151,000 miles (I have had the car for 6,000). I recently just changed the oil with 5w-30 which is the 3rd oil change I have done and have used the same brand and viscosity. It seems the oil is a little overfilled this time (maybe 1/4-1/3 of an extra quart). I noticed a knocking coming from the engine (closer to bottom of engine than top) on a cold start. It sounds like a rock being knocked against a hard surface. I can only hear the knocking if I am outside of the car, if I am in the car I can't hear it at all. The knocking lasts for maybe 20-30 seconds. If I press the accelerator (when in park) the knocking goes away, and if I let off the accelerator then it comes back. I can't really test to see if the knocking persists while driving since I can't hear it from the cab.
I know I should do all the routine maintenance when getting a used car (spark plugs, etc), but I bought from a friend who put spark plugs on maybe 25,000 miles ago.
I read that maybe I should be using different viscosity of oil in the summer (even though the manual says 5w-30 all year, I live in North Central Nebraska)? Is the knocking maybe due to the slightly overfilled oil? Should I try to drain that excess out? Should I just go ahead and replace the spark plugs and wires as well?
I drive ~750 highway miles a month and hope I can get this car to last a few years. So far it seems pretty good, have only had to change the ECT sensor and thermostat on it, suspension bushings still look good. I just never heard this noise before and it kind of freaked me out. I probably would have never heard it but I just happen to start the car and needed to grab something from the garage.
View 12 Replies
2003 Pontiac Grand Am GT, 3.4L V6...It only starts if the battery has been disconnected for at least an hour and then is immediately reconnected prior to use. Once the block is hot, however, it starts flawlessly and repeatedly every time. When the block cools, it won't start again unless I disconnect the battery and wait an hour.
View 2 Replies
I have a 2003 Pontiac Grand Am it will start once but after that if you turn off ignition it will not start again until it has sat for a long time.
View 1 Replies
My 2001 Pontiac Grand Am gt won't start. Turning the key gets no crank. Also there is no power that seems to be in the car at all. Nothing on instrument panel. Battery is good and all Ignition fusses are good.
View 4 Replies
My car won't start and I'm trying to figure out why. What is going on. The kind of car I have:
2003 Pontiac Grand Am
2.2L, In-Line4, VIN(F) DOHC
Has about 160,000 on it
Issue I'm having:
Car turns but won't start
"Service Engine Soon" light is on
Tried to jump it (made sure to let it charge for awhile) to no avail
Was low on gas but was not empty -- we filled it up and it still won't turn
Specifically for this model, it is not the Security Bypass issue (where you reset it after 10 minutes)
Recent work history:
On 2/4/14, I took my car to the shop after the check engine light was blinking when I tried to go above 25mph:
Replaced Spark Plugs
Replaced Air Filter
Replaced Ignition Coil Pack
Replaced Spark Plug Boot (Coil to Plug)
Replaced Ignition Control Module
Replaced Fuel Filter
When I drove my car away, the "Check Engine Light" came on. Took it back, this is what they did:
Access computer for codes : "P0172 system to rich on bank 1"
They told me that there was a possible injector leaking down and recommended a fuel injector cleaning. They said I was ok to drive it for awhile and did not have to do it right that moment.
I did light driving on the car but left it in the burbs as I live in the city. When I moved five months later, I brought the car back to the city. I noticed my air conditioning was not working (will blow heat just fine but will not blow cold).
I changed my oil not long after bringing it to the city, in that same month. Besides the air conditioning, I haven't had any real issues and have done local driving through the city.
I took the car out on Friday, drove to Madison, and drove back the next day with no issues (300m trip). This morning we took the car out to the burbs to visit family (20m) -- now it won't start. What it could be?
View 1 Replies
I just got a 96 Grand Am for second vehicle, but it won't blow any air (hot or cold), I checked fuses they all look good. I'm thinking possibly blower motor, but wanted to get some feedback before I start plugging away.
View 5 Replies
Whenever it's cold outside (I live in MN, so it gets really, really cold), my car fills up with a very strong gas odor. It only happens when I am at a stop as well. I have taken it in, and have been told that nothing is wrong. The smell is so strong that I have to roll down the windows and my friends are refusing to ride in my car! I am worried that it's dangerous.
It's a Pontiac Grand Am from 2005. 102,000 miles, roughly.
View 2 Replies
I just picked up an 02 Supercrew. It came with a “Ford” remote starter. I imagine it was a dealer install for the previous owner. Anyways when I try to use the remote starter, it will crank the engine over but not fire. If I manually start the truck it fires up immediately. How come the remote start wont fire?
View 7 Replies
Friend's 2000 7.3 wont start, just crank and crank tried to fire but nothing in the cold leave it plugged in and it starts leave it in a shop over night and it starts with a shot of either, he is a truck driver and the truck will sometimes sits for 6 weeks at a time this time 2 weeks before I touched it. He wanted me to install a fuel pump so I did and started the following:
Cracked fuel lines to see if I had fuel psi at both heads
I tested glowplugs they all read at 0.3 on all 8
I have power to harness as the same at both sides of the relay
RPM tach jumps
Oil psi gauge rises
Using my phone I can read hpop and 2000 at cranking (how accurate that is im not 100% sure)
All fuses good
View 7 Replies
Have a 2000 F-150, 5.4L. Once recently in a parking lot, it would crank but not fire or start. Wife called me to come get her. By the time I got there, she said it started "after she loosened the gas cap & re-closed it." But, it started fine for next several weeks. Yesterday it didn't. I read a bunch of threads here on possibilities. Many troubleshoot items I checked out or had done.
Chilton manual says you can get limited error codes from the light on dash flashing - MIL - Malfunction Indicator Lamp Method.
For now, I'm trying to find the 2nd, separate, one-wire lead "near or with the (main) Diagnostic Connector." They call the single wire / connector the "Self-Test Input connector" (STI). You're supposed to use a jumper between that STI & the upper, right connector of the main diagnostic connector. Then you (may) get flashes corresponding to codes via the key on, engine off method.
I see no such single wire lead or connector anywhere near there. Not up under the dash either - stuck my head under there & used mirror. There's a separate connector (not in use) clipped on the L side of the main diagnostic connector, but it has 5 pins inside. I took pics, but forum says I "may not post attachments." Been a member for yrs. That extra 5 pin connector faces toward firewall.
There's an "empty hole" - 1/4 in. (facing forward) in the bracket that holds the main diagnostic connector. Just above the main connector. Not sure if something was ever there
If no one knows how / if the Malfunction Indicator Lamp Method works or where the jumper goes, I'll be forced to buy a code reader w/o researching which are decent or crap (around $200 or less). I maybe? could wait to order one online (if knew which one). Also have AutoZone, O'Reilly, Advance, NAPA, PepBoys & others locally.
* The truck shows a check engine soon light, so should be a code already. * Yes, I tried her loosen / tighten gas cap trick.
* Also put a slow charger on for a while & even used the fast start setting on charger. No go, but engine turns really fast.
* Crawled under the gas tank & listened for fuel pump to activate when key is turned to Run.
* Fuel pump made a small noise - more like a relay or "clicking" - not a whine or whir.
* Checked most fuses - under dash & hi voltage box - that have anything to do w/ fuel pump, PCM & several others - mentioned in similar threads here.
Can't really check relays & don't want to just start replacing parts. I don't have a code reader & reluctant to buy one from local store w/o some reasonable research. (I don't mind buying one, but...). If I could drive it to the auto store, I wouldn't be asking this. Chilton's doesn't say if this malfunction indicator lamp method will work if a vehicle won't start. But, a code is already thrown.
View 6 Replies
Have a 2004 Grand am that was having some problems starting:
1) The last 10 times it would start cold, but it would take about 5-10 seconds of turnover before actually starting.
2) After it started, it would start fine the rest of the day.
Now it will not start at all. Today is the coldest day of the year so far... 43 degrees. It tries to turn over. The security light came on once, but did not come on again (i know that's a common problem). (note: I have not seen it in person, but will later today). Either fuel or spark.
My thought: either fuel pump, fuel pump relay, sensor, wires/plugs, etc.
View 1 Replies
2004 Pontiac Grand Am GT, 3.4L V6...It only starts if the battery has been disconnected for at least an hour and then is immediately reconnected prior to use. Once the block is hot, however, it starts flawlessly and repeatedly every time. When the block cools, it won't start again unless I disconnect the battery and wait an hour. I did a bunch of tests without first disconnecting the battery: The fuel bar is pressurizing properly, the crankshaft position sensor works, the ignition control module has power, the plugs and wires are in good condition and have the right resistance. The coils are fine.
I did an OBD-II scan as well, no codes. However, unless I go through the disconnect-wait-reconnect procedure, there appears to be only a weak spark. I don't think it's the ignition security feature. There's no security light, performing a security reset does not fix anything, and the car starts repeatedly and reliably as long as the block is hot. I was wondering if it might be a failing sensor that has a thermal dependence? Should I look at the powertrain control module? The ignition control module?
View 6 Replies
I have A 2004 Pontiac grand am and am trying to install a non factory stereo. The previous owner cut the adapter wires to the original radio and had them taped together so I had to wire the new CD player directly to my car and run an ACC wire to the fuse box. Well now after I have done this my blinkers don't work nor do my wipers and my car won't start.
View 17 Replies
My girlfriend has a 2003 f150 4.6lt pick up its a great truck most of the time. Problem is when the temp gets in the neg double digits it becomes very hard to start it cranks fine but doesnt want to fire. When it does fire it might stall a few times before it stays running. The last cold snap we had I replaced the battery and in the summer the starter got changed. I have heard that this model of truck are known for hard cold starts. I am just wondering if this is true and any other thing besides block heater. It is strange that my 89 gm pickup will start no matter what temp and I'm having problems with the newer truck.
View 1 Replies
I have a 99 pontiac grand am that sometimes won't start and lately it is cutting out when I am stopped and idling at stop lights/signs. And today it just died when I was driving, it started right back up, then died again about three times, then it seemed to be fine, I drove it for about 2 miles and it just died and won't restart. We have replaced the fuel pump, fuel filter, ignition switch, fuel relay fuse twice, air filter, and some sort of module.
View 5 Replies
Our Grand Am runs well when it decides to start! But occasionally when the key is turned all the way on, the starter may take a few minutes to engage, or not at all. Usually it just starts right up, but not every time, so it is not reliable. The key lock cylinder has been replaced.
View 5 Replies
After the cold hit last night I turned my car on and it starts to shake a lot, also white smoke so I drove it to work while driving it takes forever to pick up speed and jumps speeds on rpm while shaking a lot and then I got off work and now its so hard to turn the wheel now(I put in steering fluid) and still shakes badly. I smelt burning kinda before work and I no I'm due for oil change so I just put oil in atm bcuz I have no time to take it any where atm since I work to full time jobs. Also the Trac off light is on and my service engine light is blinking.
View 2 Replies
